铝合金微电偶腐蚀机理与数值模拟研究进展

综述了铝合金微电偶腐蚀在机理研究和数值模拟两方面的研究进展,针对独立微电偶的腐蚀机理表征、多元微电偶空间随机分布相互作用规律、结构/载荷因素与铝合金微电偶腐蚀驱动力间的竞争机制等3个方面进行了展望,期望为铝合金微电偶腐蚀研究提供方向参考。     

烧结烟气脱硫颗粒物的变化特性

利用静电低压撞击器(ELPI)对石灰石-石膏法脱硫前后烟气中的细颗粒(PM2.5)进行采样分析,获得细颗粒浓度与粒径分布特性。对脱硫前后细颗粒形貌和主要元素进行扫描电镜(SEM)、离子色谱(IC)和电感耦合等离子体发射光谱仪(ICP-OES)进行分析。结果表明,石灰石-石膏法对于烟气中的细颗粒数浓度的脱除效率为负值,脱硫后出口烟气细颗粒数浓度增加4.95倍;细颗粒的形貌发生很大变化,脱硫前细颗粒以单个球形或团形态分布,脱硫后颗粒相互堆积形成致密不规则层状结构;化学组成分析表明,细颗粒中主量元素Al、Fe和Si的含量稳定,但水溶性离子Ca2+和SO42-含量增加明显,分别由3.5%、6.45%增加到8.76%、32.73%。     

文丘里洗涤过滤型FCVS性能评价述评及建议

通过调研对国内外文丘里洗涤过滤型FCVS性能评价进展进行了阐述与比较,指出国内开展文丘里洗涤过滤型FCVS出厂性能评价不全面,需进一步开展相关性能评价技术研究;FCVS在现场的安装质量如何,随着时间的推移性能变化如何,并未开展试验验证,结合法规要求等,建议开展FCVS现场试验评价技术的研究.     

Second organic aerosol formation from the ozonolysis of -pinene in the presence of dry submicron ammonium sulfate aerosol

An indoor chamber facility is described for investigation of atmospheric aerosol chemistry. Two sets of α-pinene ozonolysisexperiments were conducted in the presence of dry ammonium sulfate seed particle: ozone limited experiments and α-pinene limitedexperiments. The concentration of gas phase and particle phase species was monitored continuously by on-line instruments andrecorded automatically by data sampling system. The evolution of size distribution was measured by a scanning mobility particlesizer (SMPS), and α-pinene consumed was measured using GC-FID. Secondary organic aerosol (SOA) produced for seed-free systemis 100% organic in content, resulting from a sufficient supersaturation of low volatility organics to produce homogeneous nucleationfollowed by condensation to the aerosol. Secondary organic aerosol produced in seeded system is a mixture of organic and inorganicconstituents, initially forms via condensation onto the inorganic particles, and subsequent growth occurs via absorption into the organicsurface coating the inorganic core. Although the formation process and the size distribution for seed-free system and seeded system isdifferent, the ultimate mass of SOA formed is equal, and SOA yield for the two system located in the same regression line when usingone-product model, suggesting that the presence of dry ammonium sulfate seed has no measurable effect on the total aerosol yield, and the dry seed particle acts solely as a site upon which organic deposition occurs.     

工业燃煤链条炉细粒子排放特征研究

链条燃煤锅炉是当前我国工业锅炉的最主要应用炉型,其容量占到了工业锅炉总容量的85%,是重要的大气污染物排放源之一.本研究在3个地区选取了5种典型容量的链条炉,应用自行设计的二级稀释系统现场测试其细粒子（PM_2.5）和各种气态污染物的排放特征.结果表明,链条炉烟气中的PM_2.5质量粒径呈单峰或双峰分布,第1个峰值在0.14 μm处,第2个峰值在1 μm后;湿法除尘和旋风除尘对PM_1.0的细粒子仍具有有效的去除效率;在相同或相似除尘控制技术的条件下,PM_2.5的排放水平随锅炉容量的增大而减小.在PM_2.5中,SO^2-₄是最丰富的离子,质量分数在20%～54%范围内;C是最丰富的元素,质量分数在7.5%～31.8%之间,其次是S,质量分数为8.4%～18.7%.采用碳平衡法计算得出PM_2.5、NO_x和SO₂的排放因子分别为0.046～0.486 　g·kg^-1、 1.63～2.47　g·kg^-1、 1.35～9.95　g·kg^-1,这为建立我国的工业锅炉排放清单及大气污染来源分析提供了必要的基础数据.     

一种有机硅改性丙烯酸防污涂料的研究

目的通过在丙烯酸树脂分子中引入有机硅,制备一种具有低表面能的有机硅改性丙烯酸树脂CP-CC021。方法探讨合成工艺中有机硅单体和引发剂含量以及添加纳米级Si O2粒子填料对涂层性能的影响规律。结果获得了最大接触角的最佳工艺条件,添加纳米Si O2粒子增大了涂层的表面粗糙度,在涂层表面形成了大量微-纳结构状的突起,显著提高涂层的疏水性能。结论有机硅单体(VTMS)质量分数为23.0%,引发剂(AIBN)质量分数为0.50%,纳米Si O2粒子添加量(质量分数)为7.4%,得到的涂层接触角为126.1°。     

多相流中细长颗粒数值模拟研究综述

纤维干燥尾气中的飞灰含有大量的木质纤维、砂光粉和其他粉尘。从形状来看,木质纤维属细长颗粒,和研究较为成熟的球形颗粒在许多方面存在较多差异。目前,国内外学者们已对细长颗粒在多相流中的悬浮、沉降及流化方面开展了大量数值模拟研究,取得了一定的进展;在此基础上,继续完善木质纤维的运动特征、推导出其在换热器表面的碰撞沉积模型是下一步的主要工作。     

杭州灰霾天气超细颗粒浓度分布特征

利用快速迁移率粒径谱仪(FMPS)对杭州2013年12月6～11日连续灰霾天气和灰霾消退过程超细颗粒进行监测,分析颗粒物浓度变化和粒径谱分布特征及其与气象的相关性.结果表明,颗粒物日变化特征为夜晚数浓度较高,凌晨数浓度开始降低,08:00和18:00上下班高峰期出现一个小峰值,体现出明显的交通源峰值,表明交通排放对大气污染影响较大.灰霾天气下颗粒物最高数浓度达到8.0×104cm-3.粒径谱呈双峰分布,峰值粒径分别为15 nm和100 nm,粒径在100 nm附近的粒子占大多数,粒子以爱根核模态和积聚模态为主,平均数量中位径CMD(count medium diameter)为85.89 nm.而在灰霾消退过程,颗粒物数浓度降低,峰值粒径向小粒径演变,粒径在100 nm附近的粒子逐渐减少,核模态粒子增多,大于积聚模态,平均CMD为58.64 nm.气象因素中能见度和风力与数浓度主要呈负相关,相关系数R分别为-0.225和-0.229,相对湿度与数浓度正相关,相关系数R为0.271,冬季大气比较稳定,水平温度与数浓度的相关性较小.研究灰霾天气数浓度分布和气象因素的综合影响对其形成机制及控制有重要意义.     

铁屑去除酸法地浸采铀地下水中硝酸盐的试验研究

在酸法地浸采铀过程中,硝酸及硝酸盐的广泛使用使硝酸盐在地下不断累积并扩散到地下水中,这给矿区地下水造成了一定程度的污染.本试验以铁屑为还原剂,对该地下水中NO3--N的去除进行了批试验和动态试验研究.试验结果表明,铁屑可有效去除地下水中的NO3--N,其去除率随pH值的降低而逐渐升高;溶液中共存的Ca2 、Mg2 对NO3--N的去除影响不大,而SO42-、HCO3-的存在可明显降低NO3--N去除率;铁屑最佳投加量为120 g/L,铁炭最佳体积比为1∶1;二级柱可以明显提高柱子的稳定运行时间,在55 h内NO3--N去除率可保持在93%以上,去除效果较好.     

Potential effects of particulate matter from combustion during services on human health and on works of art in medieval churches in Cyprus

Indoor and outdoor particulate matter (PM_0.3-10) number concentrations were established in two medieval churches in Cyprus. In both churches incense was burnt occasionally during Mass. The highest indoor PM_0.5-1 concentrations compared with outdoors (10.7 times higher) were observed in the church that burning of candles indoors was allowed. Peak indoor black carbon concentration was 6.8 μg m⁻³ in the instances that incense was burning and 13.4 μg m⁻³ in the instances that the candles were burning (outdoor levels ranged between 0.6 and 1.3 μg m⁻³). From the water soluble inorganic components determined in PM₁₀, calcium prevailed in all samples indoors or outdoors, whilst high potassium concentration indoors were a clear marker of combustion. Indoor sources of PM were clearly identified and their emission strengths were estimated via modeling of the results. Indoor estimated PM_0.3-10 mass concentrations exceeded air quality standards for human health protection and for the preservation of works of art.