石墨相氮化碳协同UV-H_2O_2光催化降解亚甲基蓝

以三聚氰胺为前驱体,经热解—回流法制备了石墨相氮化碳(g-C3N4),采用XRD、FTIR、SEM、EDS、PL等技术对g-C_3N_4进行了表征。研究了g-C_3N_4在UV-H_2O_2体系中对废水中亚甲基蓝(MB)的光降解效果。实验结果表明,UV+g-C_3N_4催化剂+H_2O_2体系能协同降解MB,在初始MB质量浓度为20 mg/L、初始废水p H为5、废水体积为250 mL、g-C_3N_4加入量为0.10 g、H_2O_2浓度为0.4 mmol/L、反应温度为25℃的优化工艺条件下,紫外光照射70 min时MB脱色率达98.32%。g-C_3N_4催化剂具有较好的重复使用性能,使用5次后MB脱色率仍保持在95.10%。     

添加H2O2加速低合金钢海水腐蚀的主要影响因素研究

采用极化曲线、旋转圆盘电极试验和失重（质量损失）法研究了低合金钢在添加了H。o：的海水中腐蚀加速的主要影响因素。结果发现低合金钢在添加H2O2的海水中腐蚀加速主要受到了H2O2浓度、温度、搅拌速度和H2O2添加周期的影响。研究表明,搅拌速度不变、H2O2添加周期相同的条件下,在H2O2浓度为0．8mol／L的70℃海水中,低合金铜的腐蚀加速最显著;在试验的转速范围内,加速作用随搅拌速度增大变得更为显著;H2O2加入后350min内加速作用较明显。     

Iron-doped Mn-Ce/TiO2 catalyst for low temperature selective catalytic reduction of NO with NH3

The catalysts of iron-doped Mn-Ce/TiO 2(Fe-Mn-Ce/TiO 2) prepared by sol-gel method were investigated for low temperature selective catalytic reduction(SCR) of NO with NH 3.It was found that the NO conversion over Fe-Mn-Ce/TiO 2 was obviously improved after iron doping compared with that over Mn-Ce/TiO 2.Fe-Mn-Ce/TiO 2 with the molar ratio of Fe/Ti = 0.1 exhibited the highest activity.The results showed that 96.8% NO conversion was obtained over Fe(0.1)-Mn-Ce/TiO 2 at 180°C at a space velocity of 50,000 hr 1.Fe-Mn-Ce/TiO 2 exhibited much higher resistance to H 2 O and SO 2 than that of Mn-Ce/TiO 2.The properties of the catalysts were characterized using X-ray diffraction(XRD),N 2 adsorption,temperature programmed desorption(NH 3-TPD and NOx-TPD),and Xray photoelectron spectroscopy(XPS) techniques.BET,NH3-TPD and NOx-TPD results showed that the specific surface area and NH3 and NOx adsorption capacity of the catalysts increased with iron doping.It was known from XPS analysis that iron valence state on the surface of the catalysts were in Fe3+ state.The doping of iron enhanced the dispersion and oxidation state of Mn and Ce on the surface of the catalysts.The oxygen concentrations on the surface of the catalysts were found to increase after iron doping.Fe-Mn-Ce/TiO2 represented a promising catalyst for low temperature SCR of NO with NH3 in the presence of H2 O and SO2.     

UV/H2O2法处理焦化废水的试验研究

焦化废水是一种典型的成分复杂的难降解有机废水。实验利用UV／H2O2法对焦化废水的处理进行研究,探讨了不同反应时间、H2O2投加量、pH值等因素对COD去除率及色度降解效果的影响。结果表明．废水起始COD质量浓度为1334mg几时,H2O2投加浓度为45mmol/L,pH值=11,紫外灯照射60min,COD去除率可达70％以上;随着H2O2投加量的增加以及pH值的升高,污水的色度明显降低。     

H2O2对循环半干法烟气脱硫效率的影响分析

通过循环半干法烟气脱硫技术在某热电厂130t／h机组上的应用,分析了H2O2对循环半干法烟气脱硫效率的影响。结果表明：对于循环半干法烟气脱硫,在脱硫剂中添加少量的氧化性物质H2O2,控制H2O2水溶液浓度为1％左右增湿脱硫剂,在合适的运行条件下．当Ca／S（mol／m01）=1．1左右时,可以达到90％以上的脱硫效率。     

大型沼气工程中生物脱硫技术

随着我国对可再生能源的开发和利用的不断深入发展,利用畜禽粪便厌氧发酵产沼气是一种非常有前景的能源利用途径,但所产生的沼气中都含有H2S气体,由于它是一种腐蚀性很强的化合物,所以沼气脱硫是沼气利用的关键环节。本文以某工程调试与运行实例分析了大型沼气工程中的生物脱硫技术,以为同类型工程提供参考。     

A bioaugmentation failure caused by phage infection and weak biofilm formation ability

Two biological aerated filters (BAF) were setup for ammonia removal treatment of the circulation water in a marine aquaculture. One of the BAFs was bioaugmented with a heterotrophic nitrifying bacterium, Lutimonas sp. H10, where the ammonia removal was not improved and the massive inoculation was even followed by a nitrification breakdown from day 9 to 18. The nitrification was remained stable in control BAF operated under the same conditions. Fluorescent in situ hybridization (FISH) with rRNA-targeted probes and cultivable method revealed that Lutimonas sp. H10 almost disappeared from the bioaugomented BAF within 3 d, and this was mainly due to the infection of a specific phage as revealed by flask experiment, plaque assay and transmission electron observation. Analyses of 16S rRNA gene libraries showed that bacterial groups from two reactors evolved di erently and an overgrowth of protozoa was observed in the bioaugmented BAF. Therefore, phage infection and poor biofilm forming ability of the inoculated strain are the main reasons for bioaugmentation failure. In addition, grazing by protozoa of the bacteria might be the reason for the nitrification breakdown in bioaugmented BAF during day 9–18.     

钻井废液的O_3/H_2O_2深度氧化处理研究

针对钻井废液COD高,成分复杂,难降解的特点,对经过破胶分离后的废水进行O3预氧化-中间混凝-O3/H2O2深度氧化处理工艺,考察了处理过程中pH值、O3与H2O2的加量、反应时间等。结果表明,当体系pH值为12,O3流量0.2m3/h,H2O2的加量700mg/L,反应时间50min时,原水COD由1462mg/L降至142mg/L,去除率高达90.28%。     

Fenton氧化法预处理垃圾渗滤液试验研究

采用Fenton氧化法处理长沙市黑糜峰垃圾填埋场垃圾渗滤液原液,考察了影响COD去除率的各种因素,包括初始pH值、FeSO4·7H2O投加量、双氧水投加量、反应时间及投加方式等,试验结果表明:在初始pH值为3、FeSO4·7H2O投加量为0.5%、双氧水投加量为18 mL/L、反应时间为100 min、投加方式为3次投加的条件下,可使垃圾渗滤液原液的COD去除率达40%左右,并提高了生化比,为后续生物处理改善了条件.     

活性炭纤维电极电还原产H2O2的实验研究

利用活性炭纤维作为阴极,比较了活性炭纤维电极和石墨板电极产H2O2的浓度,并对影响活性炭纤维电极产H2O2的因素(pH、电流密度和电解质浓度)进行了研究.研究发现,活性炭纤维电极电还原产生H2O2的浓度远大于石墨板电极.当实验在pH=3.00、电流密度8.89 mA/cm2和电解质(Na2SO4)浓度0.05 moL/...