利用Ethanoligenens harbinense R3连续培养的CSTR的启动与运行

采用连续流搅拌槽式反应器(CSTR)为实验装置,探讨了利用新型发酵产氢菌R3的生物制氢反应器的启动与运行情况.实验表明,维持反应器内pH在4.5左右、COD启动值为6000 mg·L-1、水力停留时间为8 h等条件,可在30 d内完成反应器内菌种对环境的适应并进入稳定运行阶段,此时系统氧化还原电位(HRT)稳定在-400mV左右.系统内的液相末端发酵产物中乙醇含量最大,占发酵产物总含量的65%,乙醇和乙酸所占比例为95%,系统呈现明显的乙醇型发酵特性.启动和运行阶段的积累产氢量为399.33 L,最大产氢量达15768.8 mL·d-1,最大氢气产率为49.94%.有机氮源可被微生物利用而无机氮源对产氢并无太大影响.使用有机氮源和磷源时积累产气量、积累产氢量和发酵液相末端产物与空白对照相比有所增大.     

ABR发酵系统运行特性及产氢效能研究

为解决连续流搅拌槽式反应器(CSTR)发酵制氢系统存在的不足,如单位基质氢气转化率低、因搅拌带来的耗能,抗负荷冲击能力不强等问题,开展了厌氧折流板反应器(ABR)发酵产氢的研究.结果表明,在35℃和进水COD 5000mg/L等条件下,ABR系统可在26d达到乙醇型发酵,其比产氢速率为0.13L/(gMLVSS·d),而在同样条件下, CSTR达到乙醇型发酵后,比产氢速率仅为0.06L/(gMLVSS·d).ABR通过生物相的分离,使产氢系统梯级利用有机物并达到深度产氢的目的.与CSTR相比,ABR具有较高的产氢活性、较低能源消耗等优点,是一种较为理想的有机废水发酵制氢反应设备.     

MBR+CSTR联合工艺处理精对苯二甲酸生产废水

通过MBR＋CSTR两段好氧法对精对苯二甲酸生产废水进行处理,取得了令人满意的结果。经过MBR反应器,CODCr由5000mg／L降为500mg／L以下,并且很好地控制了系统pH的上升。在CSTR反应器中CODe。能降至35mg／L,达到国家污水综合排放一级标准（GB8978-1996）。     

两级CSTR亚硝化启动及稳定运行试验研究

采用两级CSTR反应器对实际生活污水亚硝化的启动过程及稳定运行主要影响因素进行了研究.通过向生活污水里投加(NH₄)₂SO₄来提高进水氨氮浓度,并逐渐调整两级反应器的曝气强度至DO浓度分别为(1.5±0.12),(0.35±0.1) mg/L,历经45d即实现了亚硝化的启动,亚硝化率保持在90.3%以上,氨氧化率保持在91.2%以上.低氨氮生活污水运行时,通过第一级反应器中三组DO/ALR的效果对比,表明DO/ALR在1.2~2.0 mg O₂/(gN·d)时亚硝化效果最好.降低氨氮浓度以及增大HRT两种情况下导致ALR改变时,维持上述DO/ALR范围依然可以保证亚硝化的稳定.     

Fermentative hydrogen production from beet sugar factory wastewater treatment in a continuous stirred tank reactor using anaerobic mixed consortia

A low pH, ethanol-type fermentation process was evaluated for wastewater treatment and bio-hydrogen production from acidic beet sugar factory wastewater in a continuous stirred tank reactor (CSTR) with an effective volume of 9.6 L by anaerobic mixed cultures in this present study. After inoculating with aerobic activated sludge and operating at organic loading rate (OLR) of 12 kgCOD?m^-3·d^-1, HRT of 8h, and temperature of 35°C for 28 days, the CSTR achieved stable ethanol-type fermentation. When OLR was further increased to 18 kgCOD?m^-3·d^-1 on the 53rd day, ethanol-type fermentation dominant microflora was enhanced. The liquid fermentation products, including volatile fatty acids (VFAs) and ethanol, stabilized at 1493 mg·L^-1 in the bioreactor. Effluent pH, oxidation-reduction potential (ORP), and alkalinity ranged at 4.1–4.5, -250–(-290) mV, and 230–260 mgCaCO₃?L^-1. The specific hydrogen production rate of anaerobic activated sludge was 0.1 L?gMLVSS^-1·d^-1 and the COD removal efficiency was 45%. The experimental results showed that the CSTR system had good operation stability and microbial activity, which led to high substrate conversion rate and hydrogen production ability.     

长期储存亚硝化絮状污泥活性的恢复

为探究长期储存亚硝化絮状污泥的脱氮性能,采用CSTR反应器,接种4℃下储存了10个月的亚硝化絮状污泥,考察其活性恢复性能,并采用Mi Seq高通量测序技术分析了污泥中微生物菌群结构的变化情况.结果表明,控制DO为0.4~0.8mg·L~(-1)、pH值8左右、温度为(30±1)℃等条件,长期储存亚硝化絮状污泥的活性可以在15 d内迅速恢复,氨氮去除率和亚硝积累率均达到90%以上;此外,污泥颜色由接种初期的灰黑色迅速恢复至棕黄色,SVI值显著降低,MLVSS/MLSS升高,EPS含量明显增加.随着亚硝化性能的恢复,厌氧、发酵微生物被洗脱,Nitrosomonas等氨氧化细菌相对丰度显著增加,同时,Nitrospria等硝化菌的生长得到了有效抑制.经历长期储存的亚硝化絮状污泥可作为实现短程硝化快速启动的接种污泥,更有利于短程硝化工艺的实际应用.     

从全混流反应器热稳定性的角度探讨高危工艺的危险性

通过对全混流反应器(CSTR)热平衡条件下多态的分析,探讨热稳定性条件,并对一级不可逆反应在CSTR中的热稳定性进行定性分析;探讨不同反应热和活化能对反应过程热稳定性的影响,及其对反应器发生"飞温"事故要求紧急停车时的控制要求的影响,进而从反应工程的角度对高危工艺的界定提出新的思路。分析结果表明,工艺的危险性不仅与工艺的种类相关,更与工艺本身的热力学、动力学特征密切相关。通过对高危工艺的热稳定状况的分析,能够动态地揭示其在温度扰动下发生"飞温"或"熄火"的过程,从本质上把握高危工艺潜在的危险性,并能有针对性地制定自动化改造方案,提高化工企业的本质安全度。     

Use of bifurcation analysis for identification of a safe CSTR operability

Exothermic reactions are the most interesting systems for safety analysis because of their potential safety problems and the possibility of exotic behavior like multiple steady states. An operability and safety analysis of an exothermic reaction (hydrolysis of propylene oxide to tri-propylene glycol with consecutive reactions in a CSTR) with cooling is reported in this work. The information obtained from the bifurcation diagram is used to identify a set of unsafe operation points, which have been chosen on the base of requirement of maximal production of the process. An important information of safe reactor operation is the time in which the operator must handle a critical situation. For this reason, dynamics simulation of a failure in the cooling medium flow rate has been done and discussed for each of the selected operation points.