Matrix effect on the performance of headspace solid phase microextraction method for the analysis of target volatile organic compounds (VOCs) in environmental samples

Solid phase microextraction (SPME) is a fast, cheap and solvent free methodology widely used for environmental analysis. A SPME methodology has been optimized for the analysis of VOCs in a range of matrices covering different soils of varying textures, organic matrices from manures and composts from different origins, and biochars. The performance of the technique was compared for the different matrices spiked with a multicomponent VOC mixture, selected to cover different VOC groups of environmental relevance (ketone, terpene, alcohol, aliphatic hydrocarbons and alkylbenzenes). VOC recovery was dependent on the nature itself of the VOC and the matrix characteristics. The SPME analysis of non-polar compounds, such as alkylbenzenes, terpenes and aliphatic hydrocarbons, was markedly affected by the type of matrix as a consequence of the competition for the adsorption sites in the SPME fiber. These non-polar compounds were strongly retained in the biochar surfaces limiting the use of SPME for this type of matrices. However, this adsorption capacity was not evident when biochar had undergone a weathering/aging process through composting. Polar compounds (alcohol and ketone) showed a similar behavior in all matrices, as a consequence of the hydrophilic characteristics, affected by water content in the matrix. SPME showed a good performance for soils and organic matrices especially for non-polar compounds, achieving a limit of detection (LD) and limit of quantification (LQ) of 0.02 and 0.03 ng g⁻¹ for non-polar compounds and poor extraction for more hydrophilic and polar compounds (LD and LQ higher 310 and 490 ng g⁻¹). The characteristics of the matrix, especially pH and organic matter, had a marked impact on SPME, due to the competition of the analytes for active sites in the fiber, but VOC biodegradation should not be discarded in matrices with active microbial biomass.     

Contribution of sociodemographic characteristics, occupation, diet and lifestyle to DDT and DDE concentrations in serum and adipose tissue from a Bolivian cohort

The organochlorine pesticide p,p′-Dichlorodiphenyltrichloroethane (DDT) was widely used in the early 1960s-70s for vector control in tropical and subtropical areas of South America. Due to its persistence, DDT has a high potential to bioaccumulate in the food chain and living organisms and is a major public health concern, especially in South America.The main purpose of the present study was to investigate predictors of serum and adipose tissue concentrations of p,p′-DDT and its main metabolite, p,p′-dichlorodiphenyldichloroethylene (p,p′-DDE), in an adult cohort (n = 112) from Santa Cruz de la Sierra, Bolivia, using multiple linear regression models. These models explained 29.3-47.8% of the variability in adipose tissue concentrations of p,p′-DDT and p,p′-DDE, respectively, and 32.9-47.0% of that in serum. Main exposure predictors included age, occupational class, residence, diet, smoking habit, and accumulated breastfeeding time.This is one of the few studies to explore predictors of human exposure to these chemicals using a multivariate approach in a South American population. Results show that predictors of human exposure to p,p′-DDT and p,p′-DDE in Santa Cruz de la Sierra may diverge from those found in other populations of the world, due to particular sociodemographic and lifestyle characteristics of this region.     

ICP-AES法测定大气降水中微量金属元素

利用电感耦合等离子体原子发射光谱法(ICP-AES)对降水中的Al、Ba、Cr、Fe、Ni、Ti和Zn 7种微量金属元素进行了同时测定。通过信噪比选取了这7种元素的最佳分析谱线和最优仪器测试条件。在此条件下,7种元素的线性相关系数r均大于0.999,6次测试样品的相对标准偏差均小于5%,Al、Ba、Cr、Fe、Ni、Ti和Zn的检出限分别为0.79、0.34、0.33、0.25、0.54、0.08和0.85μg/L。空白加标回收率为93.24%~100.88%,该方法操作简单、准确、快速,适用于大气降水中多种微量金属元素的同时测定。     

A hybrid method for quasi-three-dimensional slope stability analysis in a municipal solid waste landfill

Limited space for accommodating the ever increasing mounds of municipal solid waste (MSW) demands the capacity of MSW landfill be maximized by building landfills to greater heights with steeper slopes. This situation has raised concerns regarding the stability of high MSW landfills. A hybrid method for quasi-three-dimensional slope stability analysis based on the finite element stress analysis was applied in a case study at a MSW landfill in north-east Spain. Potential slides can be assumed to be located within the waste mass due to the lack of weak foundation soils and geosynthetic membranes at the landfill base. The only triggering factor of deep-seated slope failure is the higher leachate level and the relatively high and steep slope in the front. The valley-shaped geometry and layered construction procedure at the site make three-dimensional slope stability analyses necessary for this landfill. In the finite element stress analysis, variations of leachate level during construction and continuous settlement of the landfill were taken into account. The "equivalent" three-dimensional factor of safety (FoS) was computed from the individual result of the two-dimensional analysis for a series of evenly spaced cross sections within the potential sliding body. Results indicate that the hybrid method for quasi-three-dimensional slope stability analysis adopted in this paper is capable of locating roughly the spatial position of the potential sliding mass. This easy to manipulate method can serve as an engineering tool in the preliminary estimate of the FoS as well as the approximate position and extent of the potential sliding mass. The result that FoS obtained from three-dimensional analysis increases as much as 50% compared to that from two-dimensional analysis implies the significance of the three-dimensional effect for this study-case. Influences of shear parameters, time elapse after landfill closure, leachate level as well as unit weight of waste on FoS were also investigated in this paper. These sensitivity analyses serve as the guidelines of construction practices and operating procedures for the MSW landfill under study.     

火灾中均布荷载作用下钢筋混凝土方板的极限分析

本文利用有限差分法确定了火灾时钢筋混凝土板的温度分布，并基于塑性铰线理论确定了火灾时钢筋混凝土方板的破坏机制，根据高温下混凝土和钢筋的力学性能对火灾过程中塑性铰截面的弯矩及板的极限荷载进行了分析，可为建筑结构的耐火设计提供依据。     

Carbon taxation,OPEC and the end of oil

I develop a differential game between an oil cartel and an importer investing in research and development (R&D) to reduce the cost of a green substitute to oil. In equilibrium, the cartel is forced to deter the substitute, which thus imposes a price ceiling falling over time. Credible carbon taxes are below the Pigovian level, implying the importer cannot internalise the full pollution externality, much less capture resource rents. Without carbon pricing, the importer curtails long-run pollution using a costly R&D programme. Normatively, climate policy will be more expensive if relying on green R&D programmes only.     

Is there really a green paradox?

In the absence of a CO₂ tax, the anticipation of a cheaper renewable backstop increases current emissions of CO₂. Since the date at which renewables are phased in is brought forward and more generally future emissions of CO₂ will decrease, the effect on global warming is unclear. Green welfare falls if the backstop is relatively expensive and full exhaustion of fossil fuels is optimal, but may increase if the backstop is sufficiently cheap relative to the cost of extracting the last drop of fossil fuels plus marginal global warming damages as then it is attractive to leave more fossil fuels unexploited and thus limit CO₂ emissions. We establish these results by analyzing depletion of non-renewable fossil fuels followed by a switch to a clean renewable backstop, paying attention to timing of the switch and the amount of fossil fuels remaining unexploited. We also discuss the potential for limit pricing when the non-renewable resource is owned by a monopolist. Finally, we show that if backstops are already used and more backstops become economically viable as the price of fossil fuels rises, a lower cost of the backstop will either postpone fossil fuel exhaustion or leave more fossil fuel in situ, thus boosting green welfare. However, if a market economy does not internalize global warming externalities and renewables have not kicked in yet, full exhaustion of fossil fuel will occur in finite time and a backstop subsidy always curbs green welfare.     

Pharmaceuticals and personal care products found in the Great Lakes above concentrations of environmental concern

The monitoring of pharmaceuticals and personal care products (PPCPs) has focused on the distribution in rivers and small lakes, but data regarding their occurrence and effects in large lake systems, such as the Great Lakes, are sparse. Wastewater treatment processes have not been optimized to remove influent PPCPs and are a major source of PPCPs in the environment. Furthermore, PPCPs are not currently regulated in wastewater effluent. In this experiment we evaluated the concentration, and corresponding risk, of PPCPs from a wastewater effluent source at varying distances in Lake Michigan. Fifty-four PPCPs and hormones were assessed on six different dates over a two-year period from surface water and sediment samples up to 3.2 km from a wastewater treatment plant and at two sites within a harbor. Thirty-two PPCPs were detected in Lake Michigan and 30 were detected in the sediment, with numerous PPCPs being detected up to 3.2 km away from the shoreline. The most frequently detected PPCPs in Lake Michigan were metformin, caffeine, sulfamethoxazole, and triclosan. To determine the ecological risk, the maximum measured environmental concentrations were compared to the predicted no-effect concentration and 14 PPCPs were found to be of medium or high ecological risk. The environmental risk of PPCPs in large lake systems, such as the Great Lakes, has been questioned due to high dilution; however, the concentrations found in this study, and their corresponding risk quotient, indicate a significant threat by PPCPs to the health of the Great Lakes, particularly near shore organisms.     

HALT试验技术的研究

高加速寿命应力试验（HALT），是一种通过施加阶梯强化应力于试品，达到快速发现产品潜在缺陷，操作设计边际及结构强度极限的试验方法，主要应用于产品研发设计阶段。由于该方法效果明显，目前已越来越多的电子电气产品制造商认可并推广使用，成为研发设计工程师提高产品可靠性的重要试验手段。本文简要介绍HALT试验的目的，并结合实际，探讨了HALT试验设备的关键性能指标。另外，基于日常实践经验，重点分析和讨论了HALT试验过程中应该关注的一些技术处置措施，从而帮助测试人员正确执行HALT。     

地下水有机污染调查采样精密度评估方法探讨

对国际标准化组织(ISO)在《水样采集与处理的质量控制指南》中提出的采样精密度控制方法不完全适用于地下水有机污染调查评价工作的部分进行了分析。在华北平原地下水有机污染调查评价工作的基础上,探讨了一种改进的采样精密度控制与评估方法,提高相关工作的质量控制水平。