联合改良剂对桉树吸收重金属的作用——以矿区土壤中Cd、Zn和Cu为例

通过5种矿区土壤的盆栽试验,研究了联合改良剂对桉树部分生理指标、根中Cd、Zn和Cu的含量、以及土壤中Cd、Zn和Cu的BCR提取形态的影响,探讨了其对矿区土壤还林的作用.结果表明,与对照相比,施用改良剂后桉树的生物量和叶绿素含量的增幅分别为-7.6%~158.8%和-0.7%~23.1%,丙二醛含量的降幅为2.6%~37.9%,其中部分处理的生物量和丙二醛含量的变化达到显著水平（P<0.05）;土壤中有效态Cd、Zn和Cu的含量分别下降12.5%~63.8%、1.6%~54.7%和16.2%~57.6%,桉树根中Cd、Zn和Cu的含量分别下降3.1%~56.6%、-1.5%~21.3%和9.3%~50.1%.土壤对桉树根中Cd、Zn和Cu的含量有显著影响（P<0.05）,改良剂的配比或施用量无显著影响（P>0.05）,但在5种矿区土壤中G3降低桉树根中Cu含量的效果优于G1和G2;在重金属含量最高的2种土壤中,G1降低桉树根中Cd和Zn含量的效果优于G2和G3.研究表明施用联合改良剂能降低桉树对重金属的吸收,有利于矿区土壤的还林.     

Fractionation of Cu, Pb and Zn in certified reference soils SRM 2710 and SRM 2711 using the optimized BCR sequential extraction procedure

Sequential extraction of metals from solid media is a common analytical tool used in environmental and exploration geochemistry. A number of procedures exist, but without harmonization and standardization, meaningful comparisons are tenuous without baseline data. A newly developed, standardized sequential extraction procedure (optimized BCR) was applied to two contaminated certified reference soils from Montana, US (SRM 2710 and SRM 2711) for Cu, Pb and Zn. Four operationally defined fractions were isolated, acid extractable, reducible, oxidizable, and residual (by aqua regia). Fraction-specific concentrations, percentages and recoveries for Cu, Pb and Zn were used to explore differences between the optimized BCR procedure and three other sequential extraction schemes with published data for SRM 2710 and 2711 (i.e. Tessier scheme, Geological Survey of Canada scheme and the original BCR scheme). Results indicate significant differences between the four schemes, even for schemes that are closely associated (i.e. the original and optimized BCR schemes). Order-of-magnitude fraction-specific concentration differences were observed, especially for Pb in the reducible fraction. Differences between schemes are worrisome because trends varied between metals, between fractions and between reference soils. These data reinforce the need for increased adoption of standardized sequential extraction procedures and further examination of different solid media.     

Antimony smelting process generating solid wastes and dust：Characterization and leaching behaviors

A large amount of solid waste has been produced by the antimony smelting process in the＂World Capital of Antimony＂, Xikuangshan area in China. This study comprehensively investigated the physical and chemical characteristics of the various solid wastes, as well as the leaching behavior of the solid wastes, which included water-quenched slag,arsenic-alkali residue, desulfurized slag and blast furnace dust. These four types of waste were enriched in a variety of heavy metals and metalloids and more specifically with As and Sb levels up to 8.6 × 104 and 3.16 × 105mg/kg, respectively, in arsenic-alkali residue. For desulfurized slag and water-quenched slag, the leaching concentration of Sb significantly exceeded the acceptable limits during the leaching tests using the toxicity characteristic leaching procedure and the synthetic precipitation leaching procedure. In addition, As leaching in arsenic-alkali residue was extraordinarily hazardous, being three orders of magnitude higher than the regulatory level of As. According to the results of the extraction tests, all the tested wastes were classified as hazardous waste.     

Concentration and chemical speciation for the determination of Cu,Zn, Ni,Pb and Cd from refuse dump soils using the optimized BCR sequential extraction procedure

The optimized BCR sequential extraction procedure (proposed by the Standards, Measurements and Testing Programme (SM&T) of the European Union) was applied to seven topsoil samples from refuse dump sites for the determination of Cu, Zn, Ni, Pb and Cd. The metals were partitioned into four operationally defined chemical fractions: acid extractable, reducible, oxidizable and residual, and analysed using flame atomic absorption spectrophotometry, FAAS. The results were compared with total metal concentrations obtained using HNO₃, HClO₄ and HF digestion procedures. Results for total metal analysis ranged from - 15.55 to 43.45 for Cu, 37.15 to 222.35 for Zn, 5.15 to 12.10 for Ni, 10.30 to 93.05 for Pb and 0.35 to 3.75 for Cd in μgg⁻¹ dry weight. The results of the partitioning study showed that zinc prevailed in the more soluble fractions and was distributed between the acid-extractable (32.4%) and the reducible (40.3%) fractions, whereas Pb was distributed mainly in the reducible fraction. Copper and nickel were predominantly associated with the reducible and residual fractions - 53.4, 33.3 and 51.1, 24.1% respectively. The ranking of the four fractions for the partitioning of cadmium was: reducible > residual > oxidizable > acid extractable. The percentage recovery for all metals when comparing total metal concentration with the fractional sum of the optimized BCR procedure, were of the order: Zn(93%) > Pb(83%) > Cu(78) > Cd > (68%) > Ni(63%).     

Extraction of labile metals from solid media by dilute hydrochloric acid

Extraction of labile metals from solid media is environmentally more meaningful than a total digestion. A variety of reagents have been introduced in the literature, but dilute HCl has received the greatest attention. We compare metal concentrations liberated by a dilute HCl leach with the sum of the 3-step optimized (standardized) BCR sequential extraction procedure. This is the first study to compare these procedures over a range of grain sizes. Road-deposited sediments from 10 sites in Honolulu were fractionated into six grain size classes. Aliquots of individual fractions were digested with dilute HCl, the 3-step BCR procedure (‘labile’), and a 4-acid (total) procedure. Results indicated that the weighted labile concentrations of Al, Cu, Fe, Mn, Ni, Pb and Zn were statistically greater than those from the dilute HCl leach. However, regression analysis indicated strong statistically significant relationships between the two partial extraction procedures for all metals. On a whole-sample basis, the toxicity classifications for anthropogenic-enhanced metals (Cu, Pb and Zn) were similar between extractions. Taken together, results suggest that the application of dilute HCl to solid media provides a rapid, cost-effective, and environmentally meaningful approach for contaminant monitoring.     

生物质炭对土壤重金属形态转化及其有效性的影响

为了解土壤重金属形态转化及其有效性对生物质炭修复措施的响应,以Cd、Cu、Pb和Zn复合污染水稻土为供试土样,添加不同粒径(1 mm和0.25 mm)和不同施用量(0、1%和5%)的竹炭(BB)、稻草炭(RSB)进行为期1年的恒温((25±1)℃)培养试验后,检测土壤p H、有效磷含量及重金属DTPA有效态含量的变化,并采用BCR连续浸提法分析生物质炭对土壤中重金属元素化学形态再分配的影响.结果表明:稻草炭的施用显著(p0.05)提高了土壤的p H值,且在RSB-5%(0.25 mm)处理下效果最显著;稻草炭的施用显著(p0.05)提高了土壤的有效磷含量,且5%用量比1%用量效果更明显;而竹炭的施用对土壤p H值和有效磷含量均无显著性影响;RSB-5%(0.25 mm)处理对降低土壤中Cd、Cu、Pb和Zn有效态含量的效果最佳,分别减少了34.5%、50.1%、52.5%和52.1%;在细粒径(0.25 mm)稻草炭处理下,酸溶态Cd和Cu向可还原态和可氧化态转化,酸溶态Zn向可还原态转化;在粗粒径(1 mm)竹炭处理下,酸溶态Cu和Zn向可还原态、可氧化态和残渣态转化;酸溶态Pb在稻草炭处理下向可还原态和可氧化态转化,且细粒径比粗粒径效果更佳;竹炭和稻草炭的施用改变了土壤中上述重金属各形态的分配,且5%用量比1%用量效果更明显.     

广州市“南肺”果园土壤H g和A s的形态分析

采用Tessier连续提取法、BCR连续提取法和Leleyter连续提取法,研究广州"南肺"果园土壤Hg和As的形态分布和生物可给性。结果表明,果园土壤Hg和As形态分布都以残渣态为主;3种方法的土壤生物可给性分析均表明,Hg和As生物可利用态的含量较少;生物不可利用态是主要形态,其次是潜在可利用态。     

太湖表层沉积物中重金属的形态分析

采用BCR三步分级提取法和ICP-AES测定了太湖沉积物中8种重金属不同形态的含量，初步评估了太湖沉积物中重金属的生物有效性，探讨了沉积物总有机碳（TOC）与重金属不同形态之间的关系。     

Concentrations and chemical forms of potentially toxic metals in road-deposited sediments from different zones of Hangzhou, China

The 25 road-deposited sediments were collected from five different land-use zones (industrial, residential, commercial, park, and countryside) in Hangzhou, China. The concentrations of metals (Cd, Co, Cr, Cu, Fe, Mn, Ni, Pb, and Zn) in these samples were determined using the ICP-AES after digestion with the mixture of HNO3-HF-HCl (aqua regia), and chemically fractionated using the modified BCR (the European Community Bureau of Reference) sequential extraction procedure. The highest metal concentration level was detected in the sample from industrial zone and commercial zone having heavy traffic. While the lowest metal level was noted in the street dust sample from residential zone, park, and countryside zone. The mobility sequence based on the sum of the BCR sequential extraction stages was: Zn (80.28%), Pb (78.68%), Cd (77.66%) ＞ Cu (73.34%) ＞ Mn (67.92%) ＞ Co (41.66%) ＞ Ni (30.36%) ＞ Cr (21.56%), Fe (20.86%). Correlation analysis and principal component analysis were applied to the data matrix to evaluate the analytical results and to identify the possible pollution sources of metals. Factor analysis showed that these areas were mainly contaminated by three sources, namely lithology, traffic, and industry.     

新化矿区煤矸石中微量元素赋存形态及浸出特征

利用BCR连续提取法和浸泡实验,对贵州省新化煤矿区不同风化程度的煤矸石中微量元素As、Cd、V、Zn、Co、Cr、Cu、Ni、Pb的赋存形态及浸出浓度进行研究。赋存形态研究结果表明:在煤矸石中As和Cd元素主要以酸溶态、可还原态和可氧化态形式赋存,而其他微量元素V、Zn、Co、Cr、Cu、Ni、Pb主要以残渣态形式赋存;除了V元素的赋存形态含量百分比不受煤矸石风化程度影响外,其它微量元素的赋存形态的含量百分比均会受到煤矸石风化程度的影响。煤矸石的浸出实验表明:浸泡时间是影响煤矸石中微量元素释放的一个重要因素;在浸泡过程中,大部分微量元素在浸泡前期的浸出浓度受煤矸石风化程度的影响,Zn和Cu元素则是在整个浸泡过程的浸出浓度均受到煤矸石风化程度的影响;不同粒径大小的煤矸石在浸泡过程中,除微量元素As和Co的浸出浓度不受煤矸石粒径大小的影响,其他微量元素在浸泡前期和中期的浸出浓度均与煤矸石的粒径大小呈反比。