| 钛管的一次压扁成形工艺 |
| |
| 引用本文： | 李健,刘爽云.钛管的一次压扁成形工艺[J].装备环境工程,1998(1). |
| |
| 作者姓名： | 李健 刘爽云 |
| |
| 作者单位： | 西北工业大学
(李健)，西安华伟钛制品厂(刘爽云) |
| |
| 摘 要： | 此文研究了钛管装入聚胺脂芯棒后一次压扁成形的工艺特点,分析了以往空心管成形所存在的问题。在实验的基础上完成了不同规格钛合金管材的一次压扁成形。
|
| 关 键 词： | 钛管 聚胺脂芯棒 模具 压扁 |
Technique of Pressing Titanium Pipe to Oval Cross Section in One Step |
| |
| Northwestern Ploytechnical University Li Jian Xian Hau Wei Titanium Ware Factory Liu Shuang Yun.Technique of Pressing Titanium Pipe to Oval Cross Section in One Step[J].Equipment Environmental Engineering,1998(1). |
| |
| Authors: | Northwestern Ploytechnical University Li Jian Xian Hau Wei Titanium Ware Factory Liu Shuang Yun |
| |
| Institution: | Northwestern Ploytechnical University Li Jian Xian Hau Wei Titanium Ware Factory Liu Shuang Yun |
| |
| Abstract: | The technique of pressing titanium pipe to oval cross section in one step with a polyester rubber core rod embedded in is studied in this papr. The problems in shaping hollow pipe with normal way are analysised. Basing on examization,some ordinance of titanium pipes were pressed to oval cross section in one step. |
| |
| Keywords: | Titanium pipe Polyseter rubber core rod Die Press to oval cross Section |
| 本文献已被 CNKI 等数据库收录！ |
