Diffusion of HTO, Cl and I in Opalinus Clay samples from Mont Terri: Effect of confining pressure

Diffusion coefficients (T=23±2 °C) and accessible porosities for HTO, ³⁶Cl⁻ and ¹²⁵I⁻ were measured on Opalinus Clay (OPA) samples from the Mont Terri Underground Rock Laboratory (URL) using the through-diffusion technique. The direction of transport (diffusion) was perpendicular to bedding. Special cells that allowed the application of confining pressure were designed and constructed. The pressures ranged from 1 to 5 MPa, the latter value simulating the overburden at the Mont Terri URL (about 200 m). The test solution used in the experiments was a synthetic version of the Opalinus Clay pore water, which has Na⁺ and Cl⁻ as the main components (I=0.42 M).The measured values of the effective diffusion coefficients (D_e) and rock capacity factors (α) are: D_e=1.2–1.5×10⁻¹¹ m² s⁻¹ and α=0.09–0.11 for HTO, D_e=4.0–5.5×10⁻¹² m² s⁻¹ and α=0.05 for ³⁶Cl⁻ and D_e=3.2–4.6×10⁻¹² m² s⁻¹ and α=0.07–0.10 for ¹²⁵I⁻. For non-sorbing tracers (HTO, ³⁶Cl) the rock capacity factor α is equal to the diffusion-accessible porosity . The experimental results showed that pressure only had a small effect on the value of the diffusion coefficients. Increasing the pressure from 1 to 5 MPa resulted in a decrease of the diffusion coefficient of 17% for HTO, 28% for ³⁶Cl⁻ and 30% for ¹²⁵I⁻. Moreover, the diffusion coefficients for ³⁶Cl⁻ and ¹²⁵I⁻ are smaller than for HTO, which is consistent with an effect arising from anion exclusion.The diffusion coefficients of HTO and ¹²⁵I⁻ measured in this study are in good agreement with recent measurements at three other laboratories performed within the framework of a laboratory comparison exercise. The values of the diffusion-accessible porosities show a larger degree of scatter.