Waste wood recycling as animal bedding and development of bio-monitoring tool using the CALUX assay

Animal bedding made of waste wood samples from seven different plants in Japan were chemically analyzed in terms of persistent organic pollutants (POPs) including polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/DFs), coplanar polychlorinated biphenyls (Co-PCBs), drin compounds, chlordane compounds and various inorganic toxic compounds (Cr, Cu, As, B, Cd and Pb) to investigate the chemical characteristics and levels of contamination. Further investigation was conducted to determine the success of applying the Chemically Activated Luciferase Expression (CALUX) bioassay to the waste wood samples in combination with a cleanup procedure for the detection of dioxin-like compounds in order to develop the CALUX bioassay as a rapid and cost-effective screening/monitoring method and a contributive tool to risk management in the waste wood recycling process. For the cleanup procedure, crude extracts from wood samples were prepared by dimethylsulfoxide (DMSO)/n-hexane extraction, and then the extracts were processed by silica gel-44% sulfuric acid reflux treatment at 70 degrees C for 60 min to yield the bioassay fractions. The presence of POPs and inorganic toxic compounds were confirmed in most of the litter samples. In particular, Co-PCBs in one sample (litter dust) showed a high concentration level (1200000 pg/g, 240 pg TEQ/g), suggesting the potential for contamination from demolition waste. The CALUX assay-determined TEQs (CALUX-TEQs) were significantly high in the sample after DMSO/n-hexane extraction, probably due to labile aryl hydrocarbon receptor (AhR) ligands such as PAHs; however, they were remarkably reduced through a single silica gel-44% sulfuric acid reflux treatment. The ratio between CALUX-TEQ values and WHO toxicity equivalent values (WHO-TEQ) obtained by congener-specific chemical analysis ranged from 0.058 to 22 and show comparatively good agreement. Underestimation in some samples, however, was observed where WHO-TEQ values of Co-PCBs contributed greatly to total WHO-TEQ values. Reasons for this gap could be lower CALUX assay-determined relative potencies (REPs) than the WHO-TEFs for these congeners or AhR-antagonistic effects of non dioxin-like PCBs which coexist at higher concentration than Co-PCBs. The CALUX assay is proposed as a promising application in the recycling process of wooden materials.