| Abstract: | The New Jersey Department of Environmental Protection and Energy (NJDEPE) has been developing cleanup regulations that focus on remediation, rather than extended delineation, and on integrating regulatory requirements with technological developments. To this end, the NJDEPE, under the regulatory aegis of the Environmental Cleanup and Responsibility Act (ECRA), is monitoring an innovative treatment technology pilot test at a TCE-contaminated ECRA site in Hillsborough, New Jersey. The purpose of the study is to determine the applicability of pneumatic fracturing extraction (PFE) as a source-removal technique for extracting volatile organic compounds (VOCs) trapped informations with low permeability. The technology being pilot tested is pneumatic fracturing extraction, a process for enhancing permeability to promote in-situ removal and treatment of VOCs. The patented process uses high-pressure air injected into an isolated subsurface zone at controlled rates and pressures. At a critical point, the geologic material ruptures, and fractures are created that radiate outward from the fracture location. At the pilot test site, formation air flow was increased from 400 percent to 700 percent. PFE is a key component of the overall remediation strategy at the Hillsborough site. Consistent with proposed NJDEPE regulations, a ground-water pump-and-treat system will be installed for plume migration control. Once the pump-and-treat system has been established and shown to be effective, a more aggressive source removal program will be implemented using PFE. This program will include construction of a vadose zone PFE system and evaluation of the use of pneumatic fracturing to remove saturated zone residual dense nonaqueous phase liquids (DNAPL). Preliminary calculations suggest that if source zone concentrations can be reduced to 10 ppm of TCE, then TCE groundwater concentrations may be reduced to background levels at the property boundary compliance points. |
