| Abstract: | The results of a lithostratigraphic, tectonic and kinematic study of the Karoo deposits of northern Malawi are reported. The objective of the lithostratigraphic study is to correlate the deposits of the Karoo basins of northern Malawi with the well-known deposits of southern Tanzania, thus establishing a stratigraphic framework through which the timing of faulting can be constrained. The kinematic analysis of faulting constrains the opening direction for the Karoo graben in this area and provides basic data to discuss the Karoo graben development within the regional tectonic framework of south-eastern Africa. The studied faults are defined by moderately to steeply dipping cataclastic zones with a width of up to 15?m and are characterized by an array of slickensided fault surfaces with different orientations and slip directions. In this study, small faults (offset <10?m) and meso-scale faults (offset >10?m, but generally not exceeding 30–40?m) have been distinguished. Methods used to analyse the kinematic data include the 'pressure tension' (PT) method, which estimates the principal axes for the bulk brittle strain, and the internal rotation axis (IRA) method, which estimates the axis of bulk internal rotation and the overall sense of slip at the faults. A mass balance calculation reveals a volume increase of up to 16% during cataclastic deformation in the fault zones. The PT method shows an approximately east trending extension direction for faults that occur only in the latest Carboniferous (?) and Early Permian strata, whereas the fault kinematics from faults that cut middle Permian to Early Triassic rocks is characterized by a ESE to SE trending extension direction. The small faults yield essentially the same kinematic results as the meso-scale faults. In a transport-parallel cross-sectional view, the principal extension axes are at an acute angle of approximately 60° to the major fault planes. Given the moderate fault density, the relatively high angle between the orientation of the principal extension axis and the fault planes suggest only a moderate amount of horizontal extension across the Karoo graben of northern Malawi. Riedel structures in the fault zones formed within two conjugate sets of localized shear zones; slip on one set was top to the W/NW and, on the other, top to the E/SE. The two conjugate sets of Riedel structures have an acute angle about the regional shortening axes, implying that no pronounced rotation of the strain axes occurred. The internal rotation axes for the Riedel structures reveal a largely bimodal distribution and inferred weakly monoclinic to orthorhombic symmetry. Therefore the overall deformation during Karoo rifting in northern Malawi is interpreted to be close to a coaxial deformation with a limited amount of horizontal extension. |
