首页 | 本学科首页   官方微博 | 高级检索  
     检索      

无机-有机复合絮凝剂的制备及絮凝性能研究
引用本文:林亲铁,张淑娟,徐文彬.无机-有机复合絮凝剂的制备及絮凝性能研究[J].环境科学与技术,2007,30(9):18-20.
作者姓名:林亲铁  张淑娟  徐文彬
作者单位:1. 广东工业大学环境科学与工程学院,广州,510006
2. 中山大学环境科学与工程学院,广州,510275
基金项目:广东省社会发展科技攻关项目
摘    要:以硫酸铁、硅酸钠、硼砂和聚丙烯酰胺为主要原料,制备了无机-有机复合絮凝剂。采取正交实验设计方法,以COD去除率为指标,研究了Si/Fe摩尔比、Si/B摩尔比、聚丙烯酰胺浓度三种因子对复合絮凝剂处理印染废水效果的影响。结果表明:复合絮凝剂最优制备条件为:Si/Fe为1.5/1、PAM浓度为250mg/L、Si/B为3.5/1;采用最优条件下制备的复合絮凝剂处理印染废水时,最佳投加量(以SiO_2计)为90mg/L,最佳pH值为8.5~9.0,絮凝效果明显好于聚合硅酸硫酸铁。

关 键 词:聚硅酸  复合絮凝剂  COD
文章编号:1003-6504(2007)09-0018-03
修稿时间:2007-04-20

Preparation and Characterization of Poly (Silicon/Boron/Ferric and Polyacrylamide) Complex Flocculants
LIN Qin-tie,ZHANG Shu-juan,XU Wen-bin.Preparation and Characterization of Poly (Silicon/Boron/Ferric and Polyacrylamide) Complex Flocculants[J].Environmental Science and Technology,2007,30(9):18-20.
Authors:LIN Qin-tie  ZHANG Shu-juan  XU Wen-bin
Abstract:Some conditional experiments for preparation of poly (silicon/boron/ferric and polyacrylamide)complex flocculants and its flocculatiun for removal of COD_σwere conducted and discussed. Preliminary results showed that the optimum synthesis conditions were molar ratio of Si/Fe 1.5/1,concentration of PAM 250ppm and molar ratio of Si/B 3.5/1.Treatment of printing and dyeing wastewater by complex flocculants showed that the optimal amount of complex flocculants were 90mg/L(SiO_2)and the optimal pH range was 8.5-9.0.
Keywords:polysilicate  complex flocculants  COD_σ
本文献已被 维普 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号