Sensitivity of Ozone Production to the Nmhc Composition,Aerosol Back-Scattering and High Chimney Emission

Abstract

In this paper, three sensitivity studies are designed to analyze the effect of the NMHC (Non-Methane HydroCarbon) composition, the aerosol back-scattering and the high chimney NO _x emission to the photochemical prodution of ozone by using a one-dimensional photochemistry-diffusion model under a favourable meteorological condition. Measurements of the NMHC composition in Taipei indicated that the percentage of iso-butene, cis-2-butene, trans-2-butene and benzene in a unit volume was much higher than of those observed in other major cities. the high ratio of benzene was directly linked to its high percentage in gasoline. As to the unusually high amount of iso-butene, cis-2-butene and trans-2-butene, more researches are needed to identify their source. Concerns are raised as to how productive is NMHC composition is to the photochemical production of the surface ozone. A rough estimate shows that the total reactivity of the Taipei NMHC composition is about 1.21 × 10^?9 cm³ s^?1 which is 1.6 times that of the Los Angeles (LA) NMHC composition, while the simulated noon peak will be different by 28 ppbv, i.e. 18% more than that simulated with a LA composition.

Meanwhile, high aerosol loading is a serious problem in Taipei. the attenuation of the UV radiation by aerosols cannot be ignored. A numerical simulation shows that the noon ozone level will decrease from 178 to 141ppbv, i. e. about 21% reduction, with deterioration of the visual range from 85 to 5 km.

In the southern Taiwan, industry parks are mixed with the populated Kaohsiung city, hence the large emission of NO _x from high chimneys cannot be ignored. in this study, NO _x is assumed to be emitted in the layer between 235–460 m high with an emission rate of 0.05 or 0.145 ppbv/sec. the results show that the NO _x emitted from the elevated stack lead to a considerable reduction of surface ozone. Such conclusion is obtained due to the fact that a one-dimensional model is used in this paper. Whereas, if a three-dimensional regional model was used, then a higher productivity of ozone downstream would be simulated.