温和的高温高压条件对磺化沥青可生物降解性的影响

在氮气氛围下,采用温和的高温高压对模拟磺化沥青废水进行预处理,考察了预处理时间、温度和压力对磺化沥青可生物降解性的影响,得出最佳工艺条件为预处理时间40 min,预处理温度220 ℃,预处理压力7 MPa,采用最佳条件预处理后的磺化沥青废水经活性污泥处理后,COD去除率达80.0%,COD_B/COD为0.82,一级反应速率常数达0.123 5 h^-1。对预处理前后磺化沥青的表征结果显示,经高温高压处理后的磺化沥青主要成分仍是烷烃和芳香族化合物等,但发生了脱磺水解反应,长链烷烃和苯系物的含量大幅下降,低分子量直链烷烃含量升高。     

燃煤锅炉炉膛高温腐蚀原因及对策

从300MW机组锅炉水冷壁管的高温腐蚀情况出发，阐述了产生高温腐蚀的原因，并提出了切实可行的预防措施。     

报废汽车电器电子产品回收利用方法初探

在分析国内外报废汽车电器电子产品分类、回收利用现状、存在问题和严峻的环境影响基础上,与常规电器电子产品处理方案进行对比,对其进行资源化探讨,并提出了相关建议.     

高速钢磨屑的再生利用综述

指出了回收利用高速钢磨屑的意义,简要叙述了国内外几种不同的再生利用技术,且对高速钢磨屑今后的进一步回收利用和发展前景提出了自己的看法.     

电力机车在高海拔条件下运行初探

在高海拔地区运行的电力机车，由于使用地点的气压低，机车内发热部件的散热、绝缘等性能受到了不良影响，因此对其发热部件的温升限值及各部件的绝缘耐受电压值要作相应的修正。而对与试验处于同一海拔高度运行的电力机车，则温升限值可以不作修正，各部件的绝缘耐受电压值不受此限制。     

Utilization (recycling) of iron and steel industry by-product (GGBS) in concrete: strength and durability properties

Due to exponential growing in urbanization and industrialization, byproducts from industries are becoming an increasing concern for recycling and waste management. Ground granulated blast furnace slag (GGBS) is by-product from the blast-furnaces of iron and steel industries. GGBS is very useful in the design and development of high-quality cement paste/mortar and concrete. This paper covers the properties of GGBS, reaction mechanism, and its effect on strength and durability properties of concrete. Properties covered are sorptivity, microstructure, compressive strength, splitting tensile strength, flexural strength, permeability, sulfate resistance, freezing and thawing resistance, corrosion of concrete.     

Use of steel fibres recovered from waste tyres as reinforcement in concrete: Pull-out behaviour,compressive and flexural strength

The increasing amount of waste tyres worldwide makes the disposition of tyres a relevant problem to be solved. In the last years over three million tons of waste tyres were generated in the EU states [ETRA, 2006. Tyre Technology International – Trends in Tyre Recycling. http://www.etra-eu.org]; most of them were disposed into landfills. Since the European Union Landfill Directive (EU Landfill, 1999) aims to significantly reduce the landfill disposal of waste tyres, the development of new markets for the tyres becomes fundamental.Recently some research has been devoted to the use of granulated rubber and steel fibres recovered from waste tyres in concrete. In particular, the concrete obtained by adding recycled steel fibres evidenced a satisfactory improvement of the fragile matrix, mostly in terms of toughness and post-cracking behaviour. As a consequence RSFRC (recycled steel fibres reinforced concrete) appears a promising candidate for both structural and non-structural applications.Within this context a research project was undertaken at the University of Salento (Italy) aiming to investigate the mechanical behaviour of concrete reinforced with RSF (recycled steel fibres) recovered from waste tyres by a mechanical process. In the present paper results obtained by the experimental work performed up to now are reported. In order to evaluate the concrete-fibres bond characteristics and to determine the critical fibre length, pull-out tests were initially carried out. Furthermore compressive strength of concrete was evaluated for different volume ratios of added RSF and flexural tests were performed to analyze the post-cracking behaviour of RSFRC. For comparison purposes, samples reinforced with industrial steel fibres (ISF) were also considered.Satisfactory results were obtained regarding the bond between recycled steel fibres and concrete; on the other hand compressive strength of concrete seems unaffected by the presence of fibres despite their irregular geometric properties. Finally, flexural tests furnished in some cases results comparable to those obtained when using ISF as concerns the post-cracking behaviour.     

钢厂烧结烟气高硫高尘SCR工艺受硫酸氢铵影响的分析与对策

将高硫高尘选择性催化还原（SCR）工艺应用于钢厂烧结烟气脱硝,分析了硫酸氢铵（ABS）的形成原因、影响因素及常规工艺控制,并提出了应对措施。研究结果表明,NH₃、SO₃和温度等是影响ABS生成的主要因素。最低连续喷氨温度应高于ABS分解温度且不低于310 ℃,可有效抑制ABS生成。根据数值模拟结果,在高温烟道至反应器入口的弯头处设置导流板可保证氨气均布。采用带前馈信号的串级控制模式调节喷氨量,控制催化剂吹灰器的时间频次,可有效防止催化剂失活和堵灰。工程实践结果显示,脱硝效率不低于94.1%,NO_x排放质量浓度不高于36.5 mg/Nm³,符合设计要求。     

中等温度SCR脱硝催化剂在高硫、高钙条件下的适应性研究

介绍了在模拟高硫、高钙灰的试验烟气环境下,钒钛系中温SCR脱硝催化剂在NH3/NOx、SO2、空速、O2、H2O等参数变化时对脱硝效率的影响.试验还对催化剂的抗毒性能、再生性能进行了初步研究,可为工业化的催化剂选型提供参考.     

A comparative study on valuable products: bio-oil,biochar, non-condensable gases from pyrolysis of agricultural residues

Journal of Material Cycles and Waste Management - In this study, pyrolysis of agricultural residues, such as rice straw (RS), wheat straw (WS), and sugarcane bagasse (SB), was performed in a...     

废钢铁在钢铁行业中应用前景研究

废钢铁是我国物资回收与再生资源利用体系中的重要资源,也是非常重要的战略性资源,是钢铁工业最主要的两种原料之一(另一种是铁矿石)。与铁矿石相比,废钢铁更符合绿色可持续发展的需要和钢铁行业超低排放政策的要求,未来废钢铁资源在钢铁工业发展中的重要性可能会不断提升。着重探讨了未来10年废钢铁资源产生量的变化趋势,以及对钢铁工业原料结构变化的影响。未来中国的废钢铁资源可能不仅能满足自身钢铁工业发展的需要,同时也可能为世界钢铁工业的发展提供重要的原料。     

甘肃典型地区电力接地网腐蚀规律与防腐对策研究

根据甘肃省地域气候、环境状况特点,选取典型变电站进行土壤理化性能测试,评价土壤的腐蚀性,并根据金属试片埋片失重法进行腐蚀速率及腐蚀性评价的验证,提出典型地区设计、施工、运营时的防腐措施。     

Horizontal environmental assessment of building products in relation to the construction products directive (CPD)

According to the European Construction Products Directive (89/106/EC), construction products must satisfy specified essential requirements (ER). To comply with ER 3, on hygiene, health and environment, the construction works must be designed and built in such a way that they will not be a threat to the hygiene and health of the occupants and neighbours, nor to the environment. Standardised test methods for the release of substances that are hazardous to health and environment need to be developed at the European level. A horizontal approach is considered the best route for such test development and consists of the development of a test method applicable for different products used in a certain scenario (across the fields of different Technical Committees). The work presented here regards the emission of pollutants towards soil and water and has been carried out on monolith products, based on three types of matrices: concrete, wood and metal (zinc). The aim of the work is to study the parameters (nature of leachant, temperature, liquid-to-solid ratio) that could influence the release behaviour of substances in water. The knowledge acquired from these tests will allow the identification of some parameters needed for the development of a horizontal test.     

热喷涂防腐涂层在生物质锅炉中的研究进展

简要介绍了常用热喷涂技术,基于对热喷涂防腐涂层在燃煤锅炉防腐工作中的研究进展,进一步分析了热喷涂涂层在生物质锅炉防腐中的现状,介绍了金属涂层中的NiCrTiFe系列涂层、陶瓷涂层及金属陶瓷复合涂层、纳米涂层等现有技术比较成熟的涂层,对热喷涂防腐涂层的发展趋势进行了展望。     

Short-term leaching study of heavy metals from LD slag of important steel industries in Eastern India

Journal of Material Cycles and Waste Management - Considering Linz-Donawitz (LD) slag as a waste material for its bulk utilisation, there is a possibility that heavy metals will leach to...     

石灰石—石膏湿法脱硫装置磨损腐蚀问题分析

分析了目前国内现有石灰石—石膏湿法脱硫装置的磨损防腐问题,简述了在运石灰石—石膏湿法脱硫装置的主要磨损腐蚀环境及相应的防护措施。     

Accumulation of dechlorination daughter products: A valid metric of chloroethene biodegradation

In situ reductive dechlorination of perchloroethene (PCE) and trichloroethene (TCE) generates characteristic chlorinated (cis‐dichloroethene [cis‐DCE] and vinyl chloride [VC]) and nonchlorinated (ethene and ethane) products. The accumulation of these daughter products is commonly used as a metric for ongoing biodegradation at field sites. However, this interpretation assumes that reductive dechlorination is the only chloroethene degradation process of any significance in situ and that the characteristic daughter products of chloroethene reductive dechlorination persist in the environment. Laboratory microcosms, prepared with aquifer and surface‐water sediments from hydrologically diverse sites throughout the United States and amended with [1,2‐¹⁴C] TCE, [1,2‐¹⁴C] DCE, [1,2‐¹⁴C] DCA, or [1,2‐¹⁴C] VC, demonstrated widely variable patterns of intermediate and final product accumulation. In predominantly methanogenic sediment treatments, accumulation of ¹⁴C‐DCE, ¹⁴C‐VC, ¹⁴C‐ethene, and ¹⁴C‐ethane predominated. Treatments characterized by significant Fe(III) and/or Mn(IV) reduction, on the other hand, demonstrated substantial, and in some cases exclusive, accumulation of ¹⁴CO₂ and ¹⁴CH₄. These results suggest that relying on the accumulation of cis‐DCE, VC, ethene, and ethane may substantially underestimate overall chloroethene biodegradation at many sites. © 2007 Wiley Periodicals, Inc. *

1 This article is a U.S. government work and, as such, is in the public domain in the United States of America.

     

A study of the oxidative degradation of polyolefins

The oxidative degradation of polyolefins in the presence of transition metal catalysts is well known in the patent and technical literature. It has been suggested that a properly designed oxidatively degradable polymer could be used in limited lifetime articles and also on those whose primary method of disposal is composting, wherein the thermal activity is used to accelerate the oxidation process. The results of a detailed study of transition metal reactivity in the presence of numerous oxidation promoting species in polyolefins are presented. The oxidative degradation of these polyolefins was demonstrated at moderate temperatures under air and in a simulated compost environment. Approaches to determining the ultimate fate of these materials are discussed.     

上海市生活垃圾产业发展的思考

以构建生活垃圾产业为研究目的,通过对生活垃圾物质流和价值流的分析,探讨了生活垃圾产业发展的条件,提出了上海市生活垃圾产业构建的基本框架,并对上海生活垃圾产业的发展提出了对策及建议.