Comparative assessment of the explosion characteristics of alcohol–air mixtures

Explosion characteristics of five alcohol–air (ethanol, 1-butanol, 1-pentanol, 2-pentanol and 3-pentanol) mixtures were experimentally conducted in an isochoric chamber over wide ranges of initial temperature and pressure. The effect of temperature and pressure on the different explosion behaviors among these alcohols with various structures were investigated. Results show that the peak explosion pressure is increased with the decrease of temperature and increase of pressure. Maximum rate of pressure rise is insensitive to the temperature variation while it significantly increases with the increase of initial pressure. Among the 1-, 2-, and 3-pentanol–air mixtures, 1-pentanol has the highest values in peak explosion pressure and maximum rate of pressure rise and 2-pentanol gives the lowest values at the initial pressure of 0.1 MPa. These differences tend to be decreased with the increase of initial pressure. Among the three primary alcohol–air (ethanol, 1-butanol and 1-pentanol) mixtures, a similar explosion behavior is presented at the lean mixture side because of the combined effect of adiabtic temperature and flame propagation speed. At the rich mixture side, 1-pentanol gives the highest values in peak explosion pressure and maximum rate of pressure rise and ethanol gives the lowest values. This phenomenon can be interpretated from the combining influence of heat release and heat loss, since the flame speeds of ethanol-, 1-butanol-, 1-pentanol–air mixtures are close at rich mixture side.     

Limiting explosible concentration of hydrogen–oxygen–helium mixtures related to the practical operational case

This paper presents data on the limiting (minimum) concentrations of hydrogen in oxygen, in the presence of added helium, at elevated temperature and pressure related to the practical operational case. A 5 L explosion vessel, an ignition sub-system and a transient pressure measurement sub-system were used. Through a series of experiments carried out using this system, the limiting concentrations of hydrogen in oxygen and helium at different initial pressures and temperatures for the practical operational case were studied, and the influence of ignition energy and initial temperature on the limiting concentration of hydrogen in oxygen and helium was analyzed and discussed. The variation of ignition energy within the studied range is found to have a significant effect on the limiting concentration of hydrogen in oxygen and helium at lower initial temperature. However, when the ignition energy is higher than 32 mJ, the limiting hydrogen concentration remains almost changeless as the initial temperature increases from 21 °C to 90 °C. The limiting explosible concentration of hydrogen–oxygen–helium mixture decreases as the ignition energy increases when the initial temperature is lower. When the initial temperature is higher, the ignition energy has little effect on the limiting hydrogen concentration of hydrogen–oxygen–helium mixtures. When the initial temperature reaches 90 °C, the limiting hydrogen concentration remains almost changeless with an increase in ignition energy. The limiting explosible concentration of hydrogen in the mixtures, at the initial temperature of 21 °C and the ignition energy of 0.5 mJ, is 8.5% and that of oxygen is 11.25%.     

Experimental investigation of fast flame propagation in stratified hydrogen–air mixtures in semi-confined flat layers

This paper presents results of an experimental investigation on fast flame propagation and the deflagration-to-detonation transition (DDT) and following detonation propagation in a semi-confined flat layer filled with stratified hydrogen–air mixtures. The experiments were performed in a transparent, rectangular channel open from below. The combustion channel has a width of 0.3 m and a length of 2.5 m. The effective layer thickness in the channel was varied by using different linear hydrogen concentration gradients. The method to create quasi-linear hydrogen concentration gradients that differ in the range and slope is also presented. The ignited mixtures were accelerated quickly to sonic flame speed in the first obstructed part of the channel. The interaction of the fast flame propagation with different obstacle set-ups was studied in the second part of the channel. The experimental results show an initiation of DDT by one additional metal grid in the obstructed semi-confined flat layer. Detonation propagation and failed detonation propagation were observed in obstructed and unobstructed parts of the channel.     

Experimental study on the suppression of gas explosion using the gas–solid suppressant of CO2/ABC powder

Gas explosion is the leading accident in underground coal mining in China. Using the self-improved 20 L spherical experimental system, the impacts of 8% CO₂, ABC powder at various concentrations and mixture of them on the suppression of mine gas explosion were investigated. The results indicate that cooperative synergism exists between ABC powder and CO₂. Their combination has a better effect than each of the two components acting alone, especially for the gas of larger concentration. When 0.25 g/L ABC powder was mixed with 8% CO₂, the explosion limits were reduced by about 55%, the time to reach the peak explosion pressure was prolonged 3.56 times on average. Meanwhile, the maximum explosion pressure declined on an average of 59.4% and the maximum explosion overpressure rising rate decreased on an average of 91.1%. A combination of 0.20 g/L ABC powder and 8% CO₂ completely suppressed 11% gas explosion. The explosion suppression mechanism of CO₂ and ABC powder were probed theoretically. CO₂ plays a key part in the whole explosion processes, and it can effectively suppress the forward reaction between gas and oxygen. While it is during the middle-later period of explosion processes that ABC powder plays a critical role. The particles decomposed from heated ABC powder such as nitrogen and phosphor will react with free radicals rapidly. Besides, atoms as N, P are capable of participating in chain reaction and reacting with active groups, significantly suppressing the gas explosion.     

Analysis of the experimental results of the initiation of detonation in short tubes with kerosene–oxidizer mixtures

The paper describes the experimental investigation of detonation initiation in a mixture of kerosene–oxidant in a short test tube. Various mixtures of oxygen and nitrogen were used as an oxidant, from pure oxygen to the composition of air. The goal of the study was to determine the minimum diameter of the tube and the minimum level of energy needed for the direct initiation of detonation. As a result of the measurements the pressure courses were obtained for two kinds of cases: with and without (only shock waves) of fuel injection. The results of both kinds of measurements were compared, providing information about the initiation of detonation in a fuel–oxidizer mixture. Brief analyses of the results for different initiators and different oxidizers were performed and compared with the shock wave and Chapman–Jouget velocity.     

On–off control of aeration time in the simultaneous removal of ammonia and manganese using a biological aerated filter system

The biological aerated filter (BAF) system, a new alternative in drinking water treatment, was designed to remove NH₄⁺–N and Mn²⁺ simultaneously. This study aimed to control the aeration time in the BAF system for simultaneous NH₄⁺–N and Mn²⁺ removal to achieve the Malaysian effluent quality regulation for drinking water. The experiment was conducted under four strategies of S1, S2, S3 and S4. The results demonstrated that acceptable levels of NH₄⁺–N and Mn²⁺ were achieved over a 6 h aeration period (S1), producing effluent concentrations of 0.7 mg/L (93.2% removal) and 0.08 mg/L (79.6% removal), respectively. At the initial treatment of S1 and S2, the dissolved oxygen (DO) level rapidly increased until it reached a saturated concentration (6.8 mg/L DO) after 2 h period. Automatic on–off aeration time to maintain 3 mg/L DO set point (S4) resulted with a good effluent quality of NH₄⁺–N and Mn²⁺ compared with the 2 mg/L DO set point (S3) which did not meet the regulated standard limits. Through the automatic on–off aeration time, the saturated and excessive DO levels in the BAF system can be avoided consequently reduce the wastage of energy and electrical consumption for simultaneous NH₄⁺–N and Mn²⁺ removal from drinking water treatment.     

Exploring the severity of bicycle–vehicle crashes using latent class clustering approach in India

IntroductionBicyclists are vulnerable users in the shared asset like roadways. However, people still prefer to use bicycles for environmental, societal, and health benefits. In India, the bicycle plays a role in supporting the mobility to more people at lower cost and are often associated with the urban poor. Bicyclists represents one of the road user categories with highest risk of injuries and fatalities. According to the report by the Ministry of Road Transport and Highways (Accidents, 2017) in India, there is a sharp increase in the number of fatal victims for bicyclists in 2017 over 2016. The number of cyclists killed jumped from 2,585 in 2016 to 3,559 in 2017, a 37.7% increase. Method: Few studies have only investigated the crash risk perceived by the bicyclists while interacting with other road users. The present paper investigates the injury severity of bicyclists in bicycle-vehicle crashes that occurred in the state of Tamilnadu, India during the nine year period (2009–2017). The analyses demonstrate that dividing bicycle-vehicle collision data into five clusters helps in reducing the systematic heterogeneity present in the data and identify the hidden relationship between the injury severity levels of bicyclists and cyclists demographics, vehicle, environmental, temporal cause for the crashes. Results: Latent Class Clustering (LCC) approach was used in the present study as a preliminary tool for the segmentation of 9,978 crashes. Later, logistic regression analysis was used to identify the factors that influence bicycle crash severity for the whole dataset as well as for the clusters that were obtained from the LCC model. Results of this study show that combined use of both techniques reveals further information that wouldn’t be obtained without prior segmentation of the data. Few variables such as season, weather conditions, and light conditions were significant for certain clusters that were hidden in the whole dataset. This study can help domain experts or traffic safety researchers to segment traffic crashes and develop targeted countermeasures to mitigate injury severity.     

Characteristics of direct causes and human factors in major gas explosion accidents in Chinese coal mines: Case study spanning the years 1980–2010

Major accidents from gas explosions have a high rate of occurrence in Chinese coal mines. The frequency of major gas explosion accidents between the years 1980–2000, and the years 2001–2010 was reviewed. Case studies were also compared. The study of direct causes indicates that during the period 2001–2010 the proportion of accidents caused by deliberate violation was reduced by 31.13% compared with data from 1980 to 2000. However the proportion of accidents caused by mismanagement rose by 32.38% during this period. Direct causes of high occurrence rate accidents include deliberate violations such as illegal blasting, conducting maintenance with the power on, and mismanagement behaviors such as chaotic electromechanical management and chaotic ventilation management. The study of environmental characteristics shows that the proportion of accidents occurring in the heading faces increased by 27.18%. The study of human factors indicates that deliberate violation behaviors showed a high utility–high cost factor. Mismanagement behaviors showed strong correlation with responsibility awareness and weak correlation with technological ability.     

Inhibiting effects of gas–particle mixtures containing CO2, Mg(OH)2 particles,and NH4H2PO4 particles on methane explosion in a 20-L closed vessel

The main risk factors from methane explosion are the associated shock waves, flames, and harmful gases. Inert gases and inhibiting powders are commonly used to prevent and mitigate the damage caused by an explosion. In this study, three inhibitors (inert gas with 8.0 vol% CO₂, 0.25 g/L Mg(OH)₂ particles, and 0.25 g/L NH₄H₂PO₄ particles) were prepared. Their inhibiting effects on methane explosions with various concentrations of methane were tested in a nearly spherical 20-L explosion vessel. Both single-component inhibitors and gas–particle mixtures can substantially suppress methane explosions with varying degrees of success. However, various inhibitors exhibited distinct reaction mechanisms for methane gas, which indicated that their inhibiting effects for methane explosion varied. To alleviate amplitude, the ranking of single-component inhibitors for both explosion pressure (P_ex) and the rate of explosion pressure rise [(dP/dt)_ex] was as follows: CO₂, NH₄H₂PO₄ particles, and Mg(OH)₂ particles. In order of decreasing amplitude, the ranking of gas‒particle mixtures for both P_ex and (dP/dt)_ex was as follows: CO₂–NH₄H₂PO₄ mixture, CO₂‒Mg(OH)₂ mixture, and pure CO₂. Overall, the optimal suppression effect was observed in the system with the CO₂–NH₄H₂PO₄ mixture, which exhibited an eminent synergistic effect on methane explosions. The amplitudes of P_ex with methane concentrations of 7.0, 9.5, and 11.0 vol% decreased by 37.1%, 42.5%, and 98.6%, respectively, when using the CO₂–NH₄H₂PO₄ mixture. In addition, an antagonistic effect was observed with CO₂‒Mg(OH)₂ mixtures because MgO, which was generated by the thermal decomposition of Mg(OH)₂, can chemically react with water vapor and CO₂ to produce basic magnesium carbonate (xMgCO₃·yMg(OH)₂·zH₂O), thereby reducing the CO₂ concentration in a reaction system. This research revealed the inhibiting effects of gas‒particle mixtures (including CO₂, Mg(OH)₂ particles, and NH₄H₂PO₄ particles) on methane explosions and provided primary experimental data.