Comment on “Gaseous Sulfur Pollutants from Urban and Natural Sources”

An analysis has been performed of data on particle samplers obtained during 1984 at Rubidoux, California, and Phoenix, Arizona, by the U.S. EPA, with emphasis on prediction of mass collected by the Andersen model 321A and Wedding inlet (previously GMW40CFM) PM₁₀ samplers. The recent interpretation of these data by Rodes et al. ¹ appears to fail to correct adequately for particle bounce, and to severely overestimate the FINE particle mass. The present study uses two completely different algorithms to make these corrections. The results obtained from these two approaches agree within a few percent, and lead to a prediction of the mass collected by the Wedding inlet within 7 percent. The Andersen 321A sampler, on the other hand, overcollects by as much as 34 percent. This analysis, if substantiated, would raise serious questions concerning the adequacy of the presently proposed Federal Reference Method for qualification of PM₁₀ samplers.     

Sulfur Dioxide and Nitrogen Oxides Emissions from U.S. Pulp and Paper Mills, 1980–2005

Abstract

Comprehensive surveys conducted at 5-yr intervals were used to estimate sulfur dioxide (SO₂) and nitrogen oxides (NO_x) emissions from U.S. pulp and paper mills for 1980, 1985, 1990, 1995, 2000, and 2005. Over the 25-yr period, paper production increased by 50%, whereas total SO₂ emissions declined by 60% to 340,000 short tons (t) and total NO_x emissions decreased approximately 15% to 230,000 t. The downward emission trends resulted from a combination of factors, including reductions in oil and coal use, steadily declining fuel sulfur content, lower pulp and paper production in recent years, increased use of flue gas desulfurization systems on boilers, growing use of combustion modifications and add-on control systems to reduce boiler and gas turbine NO_x emissions, and improvements in kraft recovery furnace operations.     

Carbon Monoxide and Sulfur Dioxide Adsorption on— and Desorption from Glass,Plastic, and Metal Tubings

It was planned to install 305 m (1000 ft) of tubing on a television tower to transport ambient air samples from different height levels to pollutant monitoring instruments at ground level. A feasibility study was undertaken to determine the sorption characteristics of sulfur dioxide and carbon monoxide on various conduit materials. Sorption studies were completed on 30.5 m (100 ft) lengths of 1.3 cm (Y2 in) diam tubings of glass, Teflon, tygon, polypropylene, PVC piping, aluminum, and stainless steel. Final tests were completed on 305 m of 1.9 cm (3/4 in) diam stainless steel tubing. The following variables were investigated: tubing diameter, gas concentration, flowrate through the tubing, temperature, humidity, and the effect of sorption with sulfur dioxide and carbon monoxide alone or together. The parameter ranges studied approximated either atmospheric or air sampling conditions. For carbon monoxide, there was no significant difference between the mean inlet and outlet tubing concentrations under the conditions of the study. With sulfur dioxide, there was neither tubing adsorption nor desorption under the experimental parameters studied, except for tygon, PVC, and aluminum. After a conditioning period with sulfur dioxide, tygon, PVC, and aluminum could also be used as air inlet conduits; tygon is not recommended.     

Emissions from the copper–nickel industry on the Kola Peninsula and at Noril'sk,Russia

Published estimates for base metal emissions from the copper–nickel industry on the Kola Peninsula are re-examined in the light of (a) chemical data on the composition of the ores; (b) official emission figures for 1994; and (c) modelled emissions based on dry and wet deposition estimates derived from data for snow and rain samples collected in 1994. The modelled emissions, official emission figures and chemical data are mutually compatible for Ni, Cu and Co and show that previously published figures underestimated the emissions of the major elements, Ni and Cu (though within the same order of magnitude) and overestimated the emissions of As, Pb, Sb and Zn by up to several orders of magnitude, in some cases exceeding the calculated total input to the plants. Published estimates have neglected information on the nature and chemistry of the ores processed in metallurgical industries in the Noril'sk area of Siberia and the Urals. Revised emission estimates for 1994, using knowledge of the chemistry of the ores, are proposed: taken with published information on total emissions up to 2000 these data give an indication of emission levels in more recent years.     

Research on the nonlinear dynamic relationship between FDI and CO2 emissions in the “One Belt,One Road” countries

Environmental Science and Pollution Research - This study examines the relationship between FDI and CO2 emissions in a nonlinear framework using data from countries along the “One Belt, One...     

Benefits to rare plants and highway safety from annual population reductions of a “native invader,” white-tailed deer, in a Chicago-area woodland

Overabundant white-tailed deer are one of the most serious threats to woodland plant communities in the Chicago area. Moreover, the abundant deer in a highly populated area causes economic harm and poses hazards to human safety through collisions with vehicles. The artificial conditions causing the overabundance and resulting consequences qualify the white-tailed deer in the Chicago area to be considered as “native invaders”. We examined the benefits of culling deer at a Chicago-area woodland preserve by comparing browse rates on four endangered plant species from years before culling began with years with culling. We also examined deer–vehicle collision and traffic flow rates on area roads from years before culling began and years with culling to assess whether population reductions may have benefited road safety in the area. All four endangered plant species (three orchid species and sweet fern) had lower browse rates in years with culls, although the decreased browsing rates were statistically distinguishable for only two of the species (grass pink orchid and sweet fern). After first verifying that traffic flow rates did not decrease from pre-cull years to years with culls, we analyzed the Illinois Department of Transportation data from area roads based on deer–vehicle collisions causing >US$500 in damage and showed a one-third reduction in deer–vehicle collisions. An economic analysis showed a cost savings during the cull years of US$0.6 million for reducing browsing to just these four monitored plant species and the reduction in deer–vehicle collisions.     

The need to implement an efficient biomass fractionation and full utilization based on the concept of “biorefinery” for a viable economic utilization of microalgae

In the present work, microalgae strains, such as Scenedesmus obliquus and Phaeodactylum tricornutum grown in indoor/outdoor photobioreactors (PBRs) and in open ponds (this is the first study on such strains cultivated in the local Southern Italy climatic conditions), were fully analyzed for their protein content, carbohydrates, lipids, and fatty acid profile in order to assess their potential use for the production of biofuels, chemicals, and omega-3, and as animal feed and human food. They are compared with Nannochloropsis sp. (commercial sample) which was fully analyzed in our laboratory and Chlorella (literature data). An economic evaluation was carried out, demonstrating that the cultivation of microalgae for the production of only biofuels will not match the economic standards. Conversely, if chemicals are also produced applying the biorefinery concept and using wastewater as a source of nutrients, it will be possible to have a good positive return from microalgae.     

Comment on “Irreversible sorption of trace concentrations of perfluorocarboxylic acids to fiber filters used for air sampling” by Arp and Goss (Atmospheric Environment 42, 6869–6872, 2008)

This discussion paper reflects concerns as to the technical arguments set forth in the Arp and Goss paper. The authors of the paper, Arp and Goss, hypothesize that vapor phase perfluorocarboxylic acids (PFAs) are irreversibly sorbed to the surface of air sampling filters, and that this sorption erroneously biases vapor/particle speciation measurements toward the particle phase. These authors also suggest a surface treatment of the filters is necessary. As authors of some of the experimental data used in the Arp paper, we believe Arp and Goss have misstated the case for irreversible adsorption, and that untreated filters provide adequate vapor/particle speciation results for PFAs. Additional field data are offered to help prove the point.     

Response to “Using of ‘pseudo-second-order model’ in adsorption”, comment letter on “Phenol removal from wastewater by adsorption on zeolitic composite” [Bizerea Spiridon et al., Environ Sci Pollut Res (2013) 20:6367–6381]

This letter is a response to the issues put forth by Dr. Y.S. Ho with regard to the article “Phenol removal from wastewater by adsorption on zeolitic composite” as reported by Bizerea Spiridon et al. (Environ Sci Pollut Res 20:6367–6381, 2013). The response proposes to clarify the error slipped in the typewritten linearized equation of the pseudo-second-kinetic model and the reason for using secondary reference regarding this model.