Effect of NOx Control Processes on Mercury Speciation in Utility Flue Gas

Abstract

The speciation of Hg in coal-fired flue gas can be important in determining the ultimate Hg emissions as well as potential control options for the utility. The effects of NO_x control processes, such as selective catalytic reduction (SCR) and selective non-catalytic reduction (SNCR), on Hg speciation are not well understood but may impact emissions of Hg. EPRI has investigated the reactions of Hg in flue gas at conditions expected for some NO_x control processes. This paper describes the methodology used to investigate these reactions in actual flue gas at several power plants. Results have indicated that some commercial SCR catalysts are capable of oxidizing elemental Hg in flue gas obtained from the inlets of SCR or air heater units. Results are affected by various flue gas and operating parameters. The effect of flue gas composition, including the presence of NH₃, has been evaluated. The influence of NH₃ on fly ash Hg reactions also is being investigated.     

Pilot-Scale Study of the Effect of Selective Catalytic Reduction Catalyst on Mercury Speciation in Illinois and Powder River Basin Coal Combustion Flue Gases

Abstract

A study was conducted to investigate the effect of selective catalytic reduction (SCR) catalyst on mercury (Hg) speciation in bituminous and subbituminous coal combustion flue gases. Three different Illinois Basin bituminous coals (from high to low sulfur [S] and chlorine [Cl]) and one Powder River Basin (PRB) subbituminous coal with very low S and very low Cl were tested in a pilot-scale combustor equipped with an SCR reactor for controlling nitrogen oxides (NO_x) emissions. The SCR catalyst induced high oxidation of elemental Hg (Hg⁰), decreasing the percentage of Hg⁰ at the outlet of the SCR to values <12% for the three Illinois coal tests. The PRB coal test indicated a low oxidation of Hg⁰ by the SCR catalyst, with the percentage of Hg⁰ decreasing from ～96% at the inlet of the reactor to ～80% at the outlet. The low Cl content of the PRB coal and corresponding low level of available flue gas Cl species were believed to be responsible for low SCR Hg oxidation for this coal type. The test results indicated a strong effect of coal type on the extent of Hg oxidation.     

The effect of coal combustion flue gas components on low-level chlorine speciation using EPA method 26A

U.S. Environmental Protection Agency (EPA) Method 26A is the recommended procedure for capturing and speciating halogen (X2) and hydrogen halide (HX) stack emissions from combustion sources. Previous evaluation studies of Method 26A have focused primarily on hydrogen chloride (HCl) speciation. Capture efficiency, bias, and the potential interference of Cl2 at high levels (> 20 ppm [microgram/m3]) and NH4Cl in the flue gas stream have been investigated. It has been suggested that precise Cl2 measurement and accuracy in quantifying HX or X2 using Method 26A are difficult to achieve at Cl2 concentrations < 5 ppm; however, no performance data exist to support this. Coal contains low levels of Cl, in the range of 5-2000 ppmw, which results in the presence of HCl and Cl2 in the products of combustion. HCl is the predominant Cl compound formed in the high-temperature combustion process, and it persists in the gas as the products of combustion cool. Concentrations of Cl2 in coal combustion flue gas at stack temperatures typically do not exceed 5 ppm. For this research, bench-scale experiments using simulated combustion flue gas were designed to validate the ability of Method 26A to speciate low levels of Cl2 accurately. This paper presents the results of the bench-scale tests. The effect of various flue gas components is discussed. The results indicate that SO2 is the only component in coal combustion flue gas that has an appreciable effect on Cl2 distribution in Method 26A impingers, and that Method 26A cannot accurately speciate HCl and Cl2 in coal combustion flue gas without modification.     

氧化锌法处理低浓度SO_2烟气的模拟实验研究

文中介绍了氧化锌法脱硫的基本原理,总结了国内外研究及应用现状,同时详细叙述了模拟实验采用的流程、主要仪器,着重分析了不同SO2浓度下的吸收率以及亚硫酸锌的氧化率与氧化时间、浆液温度的关系,提出了实验过程中发现的问题及可采取的措施,为后期中试以及工业化应用提供了设计依据。     

Effect of pH and Temperature on the Kinetics of Odor Oxidation Using Chlorine Dioxide

Abstract

Increasing public concerns over odors and air regulations in nonattainment zones necessitate the remediation of a wide range of volatile organic compounds (VOCs) generated in the poultry-rendering industry. Currently, wet scrubbers using oxidizing chemicals such as chlorine dioxide (ClO₂) are utilized to treat VOCs. However, little information is available on the kinetics of ClO₂ reaction with rendering air pollutants, limiting wet scrubber design and optimization. Kinetic analysis indicated that ClO₂ does not react with hexanal and 2-methylbutanal regardless of pH and temperature and implied that alde-hyde removal occurs primarily via mass transfer. Contrary to the aldehydes, ethanethiol or ethyl mercaptan (a model compound for methanethiol or methyl mercaptan) and dimethyl disulfide (DMDS) rapidly reacted with ClO₂. The overall reaction was found to be second and third order for ethanethiol and DMDS, respectively. Moreover, an increase in pH from 3.6 to 5.1 exponentially increased the reaction rate of ethanethiol (e.g., k ₂ = 25– 4200 L/mol/sec from pH 3.6 to 5.1) and significantly increased the reaction rate of DMDS if increased to pH 9 (k ₃ = 1.4 × 10⁶ L²/mol²/sec). Thus, a small increase in pH could significantly improve wet scrubber operations for removal of odor-causing compounds. However, an increase in pH did not improve aldehyde removal. The results explain why aldehyde removal efficiencies are much lower than methanethiol and DMDS in wet scrub-bers using ClO₂.     

A Method for Removal of CO from Exhaust Gas Using Pulsed Corona Discharge

ABSTRACT

An experimental study of the oxidation of CO in exhaust gas from a motorcycle has been carried out using plasma chemical reactions in a pulsed corona discharge. In the process, some main parameters, such as the initial CO concentration, amplitude and frequency of pulses, residence time, reactor volume, and relative humidity (RH), as well as their effects on CO removal characteristics, were investigated. O₃, which is beneficial to reducing CO, was produced during CO removal . When the exhaust gas was at ambient temperature, more than 80% CO removal efficiency was realized at an initial concentration of 288 ppm in a suitable range of the parameters.     

A Combined Ca(OH)2/NH3 Flue Gas Desulfurization Process for High Sulfur Coal: Results of a Pilot Plant Study

The removal of SO₂ with atomization of a slaked lime slurry and supplemental injection of gaseous NH₃ were tested in a conventional spray dryer/baghouse system for SO₂ concentrations of 2000 ppm and 3000 ppm and a 30° F approach to saturation. Results at 3000 ppm of SO₂ showed an average SO₂ removal efficiency of 90.3 percent at a combined stoichiometric ratio of 0.95-1.10 and an average overall sorbent utilization of 91.6 percent. The overall molal ratio of NH₃/SO₂ reaction was found to be 2:1 under the test conditions Particle size analyses, and EP toxicity tests were conducted on the products of the reactions.     

测定空气中甲醇的毛细管气相色谱方法研究

使用HP—Wax毛细管柱进行水样分析，甲醇和乙醇分离效果好，该方法的精密度和准确度高，每0.2μL的最低检出限为0．7ng。此法利用了化学工作站，使得分析更简单、方便。     

The Effect of Analytical Method on Indicated Atmospheric SO2 Concentration

Atmospheric samples collected in several American cities were analyzed for SO₂ concentration using various analytical methods. The methods were: (1) electroconductivity, (2) West-Gaeke, (3) West-Gaeke with membrane prefdter, (4) West-Gaeke with glass-fiber prefilter, (5) hydrogen peroxide, (6) hydrogen peroxide with membrane prefilter, and (7) hydrogen peroxide with glass-fiber prefilter. The relationships among SO₂ data produced by these methods were evaluated statistically. Where statistical differences among methods, at the 95% confidence level, were determined then relationships were further delineated. Factors considered in these comparisons were: (1) location, {2) time of day, (8) concentration range, (4) particulate concentration, and (5) humidity. Laboratory evaluations of these methods show that each method is subject to different interfering substances. Laboratory evaluations of these methods show that each method is subject to different interfering substances. The relationship among methods obtained in these studies will complement these data and perhaps provide for further laboratory and field evaluation of methods used to measure SO₂. The relationship among SO₂ data produced by these methods should be useful in relating atmospheric SO₂ concentration to its effects and to those involved in establishing ambient air quality standards.     

Effect of Gas and Kerosene Space Heaters on Indoor Air Quality: A Study in Homes of Santiago,Chile

Abstract

The impact of outdoor and indoor pollution sources on indoor air quality in Santiago, Chile was investigated. Toward this end, 16 homes were sampled in four sessions. Each session included an outdoor site and four homes using different unvented space heaters (electric or central heating, compressed natural gas, liquefied petroleum gas, and kerosene). Average outdoor fine particulate matter (PM_2.5) concentrations were very high (55.9 μg·m^-3), and a large fraction of these particles penetrated indoors. PM_2.5 and several PM_2.5 components (including sulfate, elemental carbon, organic carbon, metals, and polycyclic aromatic hydrocarbons) were elevated in homes using kerosene heaters. Nitrogen dioxide (NO₂) and ultrafine particles (UFPs) were higher in homes with combustion heaters as compared with those with electric heaters or central heating. A regression model was used to assess the effect of heater use on continuous indoor PM_2.5 concentrations when windows were closed. The model found an impact only for kerosene heaters (45.8 μg m^-3).     

Effect of Coal Mine Soil Contamination on the Elemental Uptake and Distribution in Two Edible Amaranthus Species,A. dubius and A. hybridus

The impact of coal mine dump contaminated soil on the elemental uptake by two edible plants, namely, Amaranthus dubius (red herbs) and Amaranthus hybridus (green herbs), was studied by investigating their response and ability to tolerate and accumulate varying levels of elements in their roots and shoots. The vegetation was grown on varying amounts of contaminated soil, viz. 0%, 5%, 15%, 25% w/w using coal mine dump soil. The soil was analyzed for soil pH, cation exchange capacity (CEC), soil organic matter (SOM), moisture content, and selected heavy metals. The distribution of six metals, namely, Pb, Cd, Hg, Ni, Mn, and Fe, in roots, stem, and leaves of the plants was determined in two stages of growth after 5 weeks and 10 weeks. All soil and plant samples were microwave digested and subjected to heavy metal analysis using the ICP-OES, GFAAS, and CVAAS. The pH of the coal mine dump contaminated soil decreased with an increase in contamination. Both the SOM and CEC values decreased, which increases the availability of elements, by providing more binding sites in the soil. Relatively, the red herbs had higher elemental concentrations than the green herbs. Both plants recorded high manganese accumulation. No mercury was detected in the soils or plants.