The Estimation of Personal Exposures to Air Pollutants for a Community-Based Study of Health Effects in Asthmatics—Design and Results of Air Monitoring

In order to provide reliable pollutant and meteorological exposure estimates for an epidemiological study of asthmatics residing in two Houston neighborhoods, a dedicated three-tier air monitoring system was established. This consisted of fixed site ambient air monitoring at the center of each study area, a mobile van performing simultaneous indoor and outdoor measurements at selected residences of study participants, and a limited amount of direct personal monitoring for half of the participants. Monitored pollutants Included all criteria pollutant gases, as well as aeroallergens, aldehydes, TSP, and IP. Laboratory analyses provided concentrations of sulfate, nitrate, and trace elements. Continuous measurements of several meteorological parameters also were obtained. Intensive quality assurance and data validation efforts resulted in a high percentage of valid data for most pollutants. Ozone was the only measured pollutant that exceeded the NAAQS during the six-month (May to October) study period. The monitoring scheme allowed important pollutant concentration differences to be detected between day and night, between Indoors and outdoors, and among various indoor environments. The use of these monitoring data in combination with personal activity and household characteristics data to generate estimates of personal exposures for the epidemiological analysis will be described in a subsequent paper.     

Effectiveness in the Use of Natural Gas for the Reduction of Atmospheric Emissions: Case Study—Industrial Sector in the Metropolitan Region of Santiago,Chile

Abstract

The purpose of this investigation was to quantify the potential of natural gas to reduce emissions from stationary combustion sources by analyzing the case study of the metropolitan region of Santiago, Chile. For such purposes, referential base scenarios have been defined that represent with and without natural gas settings. The method to be applied is an emission estimate based on emission factors. The results for this case study reveal that stationary combustion sources that replaced their fuel reduced particulate matter (PM) emissions by 61%, sulfur oxides (SO_x) by 91%, nitrogen oxides (NO_x) by 40%, and volatile organic compounds (VOC) by 10%. Carbon mon-oxide (CO) emissions were reduced by 1%. As a result of this emission reduction, in addition to reductions caused by other factors, such as a shift to cleaner fuels other than natural gas, technological improvements, and sources which are not operative, emission reduction goals set forth by the environmental authorities were broadly exceeded.     

The Estimation of Personal Exposures to Air Pollutants for a Community-Based Study of Health Effects in Asthmatics—Exposure Model

Estimates of individual personal exposures to ozone, nitrogen dioxide, pollen, temperature, and relative humidity for a group of asthmatics participating In a health effects study were obtained by means of a modeling approach utilizing fixed site monitoring data, regression relationships between fixed site and indoor and outdoor micro-environment concentrations, study subject activity patterns, and study household characteristics. A considerable improvement in the accuracy of exposure assessment using the exposure model instead of fixed site measurements alone was demonstrated for ozone. This large refinement of ozone exposure estimates was achieved using a simplified approach which emphasized the large differences between Indoor and outdoor micro-environmental concentrations, and assumed relatively little heterogeneity in exposure within either of these two broad micro-environmental categories. Major sources of error in the exposure model for ozone Include: failure to Include Indoor microenvironments with no air conditioning in the development of the model, Inability to accurately apportion within-hour time spent in different microenvironments, and misclassification of hour-specific personal location by study subjects.     

Correction to: Study on habitat suitability of overwintering cranes based on landscape pattern change—a case study of typical lake wetlands in the middle and lower reaches of the Yangtze River

Environmental Science and Pollution Research - The correct corresponding Author of this paper is Bin Dong.     

Study on habitat suitability of overwintering cranes based on landscape pattern change—a case study of typical lake wetlands in the middle and lower reaches of the Yangtze River

Shengjin Lake wetland is located in the middle and lower reaches of the Yangtze River in China. It is a typical lake-type wetland and is also an ideal place for rare cranes to overwintering. The changes of wetland landscape are closely related to the habitat quality of wintering cranes. It is of great significance to study the habitat change of wintering cranes in wetland for wetland ecological restoration and restoration. In this paper, we analyze four kinds of winter cranes and wetland landscape pattern types from the years 1986 to 2015. Also, we adopted the Pearson correlation analysis method to analyze the relationship between wetland landscape types and crane population, and the main landscape types of cranes habitat were obtained. We selected disturbance degree, food richness, vegetation cover, and hydrological condition as the main factors affecting wintering habitat of cranes. We established a habitat suitability index model for wintering cranes and generated habitat suitability assessment maps by ArcGIS. The results show that the change of landscape pattern in Shengjin Lake protected area was obvious, the number of wetland patches increased, the fragmentation degree of landscape increased, the landscape patch difference became smaller, and the diversity index and evenness index increased gradually. From 1986 to 2015, the number of wintering cranes decreased and the habitat suitability index of wintering cranes decreased from 0.845 to 0.465, and the habitat suitability of wintering cranes fell from 13,577.11 to 7424.42 ha, which showed the overall habitat deteriorated significantly and had a positive correlation between the crane population and habitat suitability.

     

SimPhy: a simulation game to lessen the impact of phytosanitaries on health and the environment—the case of Merja Zerga in Morocco

Diffuse phytosanitary pollution is a complex phenomenon to manage. Reducing this type of pollution is one of today’s key socio-economic and environmental challenges. At the regional level, few approaches enable the actors concerned to implement agricultural management strategies to reduce the use and impact of phytosanitary products. Our research problem focused on the consequences of intensive agriculture and, in particular, how to evaluate the impact of phytosanitary products on human health and the environment. In this article, we present the SimPhy simulation game which places the actors from a given region directly into a situation in which they manage farms whilst under pressure to reduce phytosanitaries (quantity and toxicity). The application focused on the Merja Zerga catchment area in Morocco. The region is dominated by intensive agriculture which is located upstream from a Ramsar-classified wetland area. The SimPhy simulation game is based on a decision support system-type tool. It allows us to anticipate the impact of regulations on farming systems. It also enables us to analyse the consequences of the actors’ strategies on farm economies, human health and the quality of ecosystems. Initial results from the SimPhy simulation game enabled the technicians from Agricultural Development Center (CDA) themselves to learn about managing agricultural production systems in a dynamic and interactive fashion. With the simulation game, it was possible to learn about the farmer's ability to adapt to new regulatory constraints, and the involved consequences for toxicity risks for human health and the environment.     

Study on the threshold relationship between landscape pattern and water quality considering spatial scale effect—a case study of Dianchi Lake Basin in China

Environmental Science and Pollution Research - It is of great significance to analyze the threshold relationship between landscape pattern and water quality for watershed water environment...     

Deciphering the impact of novel coronavirus pandemic on agricultural sustainability,food security,and socio-economic sectors—a review

Environmental Science and Pollution Research - The Spanish flu, Asian flu, Hong Kong flu, HIV/AIDS, SARS, Ebola, and Swine flu, among others, have had a significant impact on agriculture,...     

A History of the Production and Use of Carbon Tetrachloride,Tetrachloroethylene, Trichloroethylene and 1,1,1-Trichloroethane in the United States: Part 2—Trichloroethylene and 1,1,1-Trichloroethane

Carbon tetrachloride (CTC), tetrachloroethylene (PCE), trichloroethylene (TCE) and 1,1,1-trichloroethane (TCA) were four of the most widely used cleaning and degreasing solvents in the United States. Part 2 of this article describes the history of TCE and TCA. TCE production in the United States began in the early 1920s. TCE was used as a replacement for petroleum distillates in the dry-cleaning industry, and became the solvent of choice for vapor degreasing in the 1930s. TCE’s use as a degreaser decreased in the 1960s due to toxicity concerns and the increasing popularity of TCA. Significant TCA use began in the 1950s with the development of suitable stabilizer formulations. In the 1990s, TCA was phased out under the Montreal Protocol due to its role in stratospheric ozone depletion.     

Vertical profiles of air pollutants in a spruce forest — analysis of adherent water,throughfall and deposits on surrogate surfaces

Vertical profiles of air pollutants were studied in a spruce forest, which is damaged mainly in the upper parts of the canopy. The sampling included plant surface water, throughfall and surrogate surfaces at five different heights. For most components a low amount of precipitation after a dry period yielded in vertical profiles of the plant surface water shaped by the wind speed. If there was enough precipitation to start wash-off, the maximum of the concentrations shifted downwards. An exception was the acidity, which increased continuously from the top to the bottom of the trees. The deposition on vertically orientated surfaces and face up orientated surfaces were in the same order of magnitude, but the deposition on face down orientated surfaces was negligible.     

Spatiotemporal distribution of water environmental capacity—a case study on the western areas of Taihu Lake in Jiangsu Province,China

Currently, the poor water quality in Taihu Lake is a major problem in China, so pollution control in the upstream areas has become a government priority. In Jiangsu Province, pollution emissions around the western areas of Taihu Lake, including Changzhou Municipality and Yixing City, need to be highly restricted, and calculating the water environmental capacity is important if pollution is to be reduced. In this study, 19 control units in these areas were established, and a 0-D mathematical model was used to calculate the water environmental capacity. For three important control units with important cross sections, a 1-D model was established to redress the results. Finally, the total maximum monthly loads of each control unit were obtained using temporal allocation principles. The results suggested that (1) the total pollution control of chemical oxygen demand was 58,894.2 tonnes per annum (t a^?1), with ammonia nitrogen, total nitrogen, and total phosphorus amounting to 3,808, 6,054.6, and 386.6 t a^?1, respectively; (2) water environmental capacity per unit water area in the ambient control units was smaller than that in the middle control units; and (3) the largest water environmental capacity was in June, and the smallest capacity was in December. The study provides important information for local governments, which will enable them to implement pollution control strategies that will improve the water quality in Taihu Lake.     

A History of the Production and Use of Carbon Tetrachloride,Tetrachloroethylene, Trichloroethylene and 1,1,1-Trichloroethane in the United States: Part 1—Historical Background; Carbon Tetrachloride and Tetrachloroethylene

Carbon tetrachloride (CTC), tetrachloroethylene (PCE), trichloroethylene (TCE) and 1,1,1-trichloroethane (TCA) were four of the most widely used cleaning and degreasing solvents in the United States. These compounds were also used in a wide variety of other applications. The history of the production and use of these four compounds is linked to the development and growth of the United States' synthetic organic chemical industry, and historical events that affected the development and use of chlorinated solvents in general. Part 1 of this article includes a discussion of the historical background common to each of the four solvents, followed by discussion on the history of CTC and PCE. In the early years of the 20th century, CTC became the first of the four solvents to come into widespread use. CTC was used as a replacement for petroleum distillates in the dry-cleaning industry, but was later replaced by PCE. In the 1990s, CTC was phased out under the Montreal Protocol due to its role in stratospheric ozone depletion.     

An Air Quality Data Analysis System for Interrelating Effects,Standards, and Needed Source Reductions: Part 13— Applying the EPA Proposed Guidelines for Carcinogen Risk Assessment to a Set of Asbestos Lung Cancer Mortality Data

Abstract

The Clean Air Act Amendments of 1990 (CAAA-90) list 189 hazardous air pollutants (HAPs) for which “safe” ambient concentrations are to be determined. The primary purpose of this paper is to develop two mathematical models, lognormal and logarithmic, that effectively express excess lung cancer mortality as a function of asbestos concentration for an example set of data and also to suggest using these two models for additional HAPs. The secondary purpose of this paper is to calculate a “safe” asbestos concentration by first assuming a default linear extrapolation (to one excess death per million people, as specified for carcinogenic HAPs). The resulting “safe” concentration is an impossible-to-achieve 1/1000 of present background asbestos concentrations. A letter to the editor and a response in this Journal issue use additional asbestos data that suggest that the “safe” concentration should be about 730 times higher than first calculated here and that a default nonlinear extrapolation should be used instead, with the “safe” concentration proportional to the desired mortality level raised to the 0.39 power. These results suggest that the most important problem in setting a “safe” concentration for each carcinogenic HAP is to determine the correct nonlinear extrapolation to use for each HAP.     

The Nanticoke shoreline diffusion experiment,June 1978—IV. A. Oxidation of sulphur dioxide in a power plant plume. B. Ambient concentrations and transport of sulphur dioxide,particulate sulphate and nitrate,and ozone

The oxidation rate of sulphur dioxide to sulphate in the Nanticoke coal-fired power plant plume was measured at distances of 3–43 km during fumigation conditions in June 1978; the average rate was 4 % h⁻¹. Airborne measurement of SO₂, O₃, b_scat, paniculate sulphate and paniculate nitrate were made over Lake Erie during the same period. These were compared to 4-day back-trajectories: south to south-westerly trajectories associated with the western or back side of high pressure systems led to high concentrations and the north to north-westerly trajectories associated with the eastern or front side of high pressure systems correlated with low pollutant concentrations.     

A cheap protocol for colour measure and for diagnostic in planning a cultural heritage restoration. Case study: main façade of Palazzo Governi (Cagliari,Sardinia, Italy)

Due to the bad state of conservation, “Palazzo Governi”, a seventeenth-century building located in the old town district of “Stampace” in Cagliari (Sardinia, Italy), was subjected to restoration. Thus, according to the Italian Law n. 1089, the main façade colour must be reproduced, and therefore, its identification was required. The available samples looked fairly degraded, in particular as an easy plaster to crumble; so, some other analyses able to identify the degradation cause were performed. Two different approaches were adopted to attain the first goal, the visual colour assessment by a sensory panel (subjective) and the instrumental measurement by colorimetry (objective). Ion chromatography and inductively coupled plasma–optical emission spectroscopy analyses, as well as conductivity and pH measurements, were performed to evaluate the presence of water-soluble salts inside the plaster, as possible cause of degradation; the binder/aggregate ratio was also evaluated. A full mineralogical and petrographic characterisation of the materials constituting the samples, as well as the identification of their stratigraphy and some other morphologic and structural features suitable to highlight eventual forms of degradation, were performed by optical microscopy. Scanning electron microscopy coupled to X-ray microanalysis was been also used in order to confirm and/or to integrate data obtained by optical microscopy. The samples have been compared with two samples coming from two other buildings, also located in Sardinia, that looked in good conservation state. The results evidenced that the causes of degradation come from a high salt (especially sulphate) content and a scarce presence of binder in the plaster that can be imputed to a wrong initial composition and/ or to a leaching by acidic rain.