线性扫描溶出伏安法同时测定水样中铅镉铜锌

通过多壁碳纳米管-Nafion复合膜修饰电极,建立水样中痕量铅、镉、铜、锌同时测定的线性扫描溶出伏安分析法,优化支持电解质及pH值、修饰剂用量、富集电位及时间等测定条件。实验结果表明,在pH 4.0的NaAc-HAc缓冲液中,-1.20V富集5min后,在电位-1.04V、-0.72V、-0.45V及-0.16V附近分别产生锌、镉、铅、铜的灵敏溶出峰,测定各元素的线性关系良好,相对标准偏差均小于5.4%。该法已成功应用于实际水样中痕量铅、镉、铜、锌的同时测定,加标回收率在93.3%~106.7%之间,结果满意。     

土壤Pb、Cd测定过程中溶样方法的改进

用微波消解土壤,然后电热板加热驱酸的方法对土壤样品进行前期处理的条件,并与标准法相比较,克服了标准法中湿法溶样的缺点,该法溶样完全、简便快速、消耗试剂量少,相对标准偏差均小于4·8%,回收率分别在96·1%~102·3%和94·0%~98·7%之间,具有较好的精密度和较高的回收率。     

微波消解ICP-AES法测定废气中铅镉砷

采用微波消解电感耦合等离子体发射光谱法同时测定废气中的铅、镉、砷,在优化的试验条件下,方法在0 mg/L～5.00 mg/L范围内线性良好,铅、镉、砷的检出限分别为0.250 μg/m3、0.125 μg/m3、0.375 μg/m3(按采样体积400 L、定容体积50 mL计),空白滤筒平行测定6次的RSD为2.3％～10.5％,加标回收率为83％ ～ 112％,与标准方法的测定结果无显著差异.     

APDC-MIBK萃取火焰原子吸收分光光度法测定生活垃圾堆肥产品中铅、镉的研究

通过试验研究,建立了硝酸-氢氟酸-高氯酸消解、APDC-MIBK萃取火焰原子吸收分光光度法测定生活垃圾堆肥产品中的铅、镉.该方法铅的检出限为2mg/kg,镉的检出限为0.2mg/kg(按称取0.5g试样消解定容至50ml计算),用于不同地域堆肥样品测定,铅、镉的相对标准偏差(RsD)分别为2.29%～8.16%和5.17%～11.7%,加标回收率介于86.8%～107.2%和88.0%～108.0%之间.     

施工扬尘环境下短时强降雨屋面径流中砷、汞、铅、镉、锌的污染特征研究

以南京北郊为例,测量分析了屋面径流中砷(As)、汞(Hg)、铅(Pb)、镉(Cd)和锌(Zn)5种元素的浓度、形态特征。结果表明:短时强降雨过程中这5种元素浓度在较大范围内无规则波动,且不同元素间浓度分布存在较大差异;Zn与Pb的平均浓度分别高于《地表水环境质量标准》(GB 3838—2002)的Ⅴ类和Ⅳ类标准限值,污染程度从大到小依次为ZnPbAsHgCd。元素形态分析表明,径流中除Hg外其他4种元素主要以颗粒态形式存在,各元素颗粒态占总形态的平均分数分别为:As,64.5%;Hg,43.7%;Pb,76.5%;Cd,54.6%;Zn,54.3%。     

An evaluation of selenium concentrations in water, sediment, invertebrates, and fish from the Solomon River Basin

The Solomon River Basin is located in north-central Kansas in an area underlain by marine geologic shales. Selenium is an indigenous constituent of these shales and is readily leached into the surrounding groundwater. Portions of the Basin are irrigated primarily through the pumping of selenium-contaminated groundwater from wells onto fields in agricultural production. Water, sediment, macroinvertebrates, and fish were collected from various sites in the Basin in 1998 and analyzed for selenium. Selenium concentrations were analyzed spatially and temporally and compared to reported selenium toxic effect thresholds for specific ecosystem components: water, sediments, food-chain organisms, and wholebody fish. A selenium aquatic hazard assessment for the Basin was determined based on protocol established by Lemly. Throughout the Basin, water, macroinvertebrate, and whole fish samples exceeded levels suspected of causing reproductive impairment in fish. Population structures of several fish species implied that successful reproduction was occurring; however, the influence of immigration of fish from low-selenium habitats could not be discounted. Site-specific fish reproduction studies are needed to determine the true impact of selenium on fishery resources in the Basin. The U.S. Government’s right to retain a non-exclusive, royalty free license in and to any copyright is acknowledged.     

Characterization and Identification of the Sources of Chromium, Zinc, Lead, Cadmium, Nickel, Manganese and Iron in Pm10 Particulates at the Two Sites of Kolkata, India

Monitoring of ambient PM₁₀ (particulate matter which passes through a size selective impactor inlet with a 50% efficiency cut-off at 10 μm aerodynamic diameter) has been done at residential (Kasba) and industrial (Cossipore) sites of an urban region of Kolkata during November 2003 to November 2004. These sites were selected depending on the dominant anthropogenic activities. Metal constituents of atmospheric PM₁₀ deposited on glass fibre filter paper were estimated using Inductively Coupled Plasma Atomic Emission Spectrometer (ICP-AES). Chromium (Cr), zinc (Zn), lead (Pb), cadmium (Cd), nickel (Ni), manganese (Mn) and iron (Fe) are the seven toxic trace metals quantified from the measured PM₁₀ concentrations. The 24 h average concentrations of Cr, Zn, Pb, Cd, Ni, Mn and Fe from ninety PM₁₀ particulate samples of Kolkata were found to be 6.9, 506.1, 79.1, 3.3, 7.4, 2.4 and 103.6 ng/m³, respectively. The 24 h average PM₁₀ concentration exceeded national ambient air quality standard (NAAQS) as specified by central pollution control board, India at both residential (Kasba) and industrial (Cossipore) areas with mean concentration of 140.1 and 196.6 μg/m³, respectively. A simultaneous meteorology study was performed to assess the influence of air masses by wind speed, wind direction, rainfall, relative humidity and temperature. The measured toxic trace metals generally showed inverse relationship with wind speed, relative humidity and temperature. Factor analysis, a receptor modeling technique has been used for identification of the possible sources contributing to the PM₁₀. Varimax rotated factor analysis identified four possible sources of measured trace metals comprising solid waste dumping, vehicular traffic with the influence of road dust, road dust and soil dust at residential site (Kasba), while vehicular traffic with the influence of soil dust, road dust, galvanizing and electroplating industry, and tanning industry at industrial site (Cossipore).     

ISS-2锌渣标准样品中Zn、Pb、Cd全量浸取研究及与纯水浸提比较

锌渣标准样品２００目,已经过多家实验室协作定值,通过二种方法可提取样品中的全量Ｐｂ、Ｚｎ、Ｃｄ：（１）１＋９ＨＣｌ,密封,０１２～０１４ＭＰａ,１２１℃,６０ｍｉｎ;（２）１＋９ＨＣｌ,超声波处理,６０ｍｉｎ。     

铅冶炼企业周边大气降尘中铅、镉、砷量及其对土壤的影响

通过在2012年5月-2013年4月1个周期年内,对修复基地和对照点每月大气降尘中铅、镉、砷沉降量的监测,结果表明：修复基地大气降尘中铅、镉、砷含量明显较对照点高,年总沉降量分别是对照点的17．6倍、16．3倍和14．1倍,表明铅冶炼企业对基地大气降尘中铅、镉、砷含量影响显著;大气降尘中铅、镉、砷沉降量受位置和时间影响较大,在相距不到100 m的测点间,沉降量相差1倍以上,冬季主导风明显、地面植被少、二次扬尘大,使处于铅冶炼企业下风向的基地降尘中铅、镉、砷沉降量较大。沉降量时空不均匀与土壤污染不均匀现状一致,也验证了铅冶炼企业是基地大气和土壤重金属污染的主要来源。以降尘缸模拟土壤进行测算,结果表明大气降尘中镉对土壤污染速度最快,风险最大。     

高压密闭消解土壤砷、汞、铅、镉酸体系比较

采用高压密闭消解系统消解土壤,氢化物发生-原子荧光光谱法(HG-AFS)测定As和Hg,石墨炉原子吸收光度法(GF-AAS)测定Pb和Cd,对比了不同消解酸体系对国家土壤标准参考样中As、Hg、Pb、Cd的消解效果。结果表明,盐酸-硝酸体系对As、Hg、Pb和Cd的消解平均回收率分别为26.1%、100.6%、69.7%、87.3%;硝酸-高氯酸-氢氟酸体系中As、Hg、Pb和Cd消解平均回收率分别为109.9%、84.7%、87.5%、90.1%;硝酸-双氧水体系对Hg、Pb、Cd消解平均回收率分别为104.8%、95.1%、93.3%,对As的回收率虽只有69.2%,但数据精密度最好。此外,从简化试验步骤,减少误差,提高检测效率及减少试验危险性等方面综合评价,认为硝酸-双氧水消解体系是采用高压密闭系统消解土壤重金属的最理想酸体系。