焦化废水中有机物的识别、污染特性及其在废水处理过程中的降解

采用液-液萃取辅以硅胶、氧化铝净化的方法,并结合GC/MS分析技术,系统分析了焦化废水中有机物的组成.在焦化废水中检测到15类558种有机物.根据有机物的分子结构、废水中的含量、毒性及环境效应,筛选出焦化废水中的特征性有机污染物,以区别于其它工业废水,可作为追溯环境中污染物来源的依据.经物理、生物和化学处理后,焦化废水中大部分有机物被去除,其中,对去除率的主要贡献是生物处理阶段.为了更好地考察生物处理阶段对有机污染物的去除特征,选定酚类、多环芳烃和喹啉类物质作为研究对象,分析了3类特征性污染物在A/O2工艺各单元中的去除状况及组成变化特征.     

Full scale treatment of hazardous wastewater through thermal reduction

An attempt has been made to present the data relating to full scale application of evaporation‐incineration technology for containment of wastewater emanating from H‐acid (mono sodium salt of 1 amino‐8‐hydroxynapthalene 3,6‐disulphonic acid) production with recourse to zero wastewater discharge. The wastewater is acidic with high concentrations of COD and total dissolved salts and BOD/COD ratio of 0.11. NO_x, SO_x, SPM and CO from stack emissions are within the standards stipulated by the statutory bodies.     

Fabrication of highly efficient Bi2WO6/CuS composite for visible-light photocatalytic removal of organic pollutants and Cr(VI) from wastewater

• A novel Bi₂WO₆/CuS composite was fabricated by a facile solvothermal method. • This composite efficiently removed organic pollutants and Cr(VI) by photocatalysis. • The DOM could promoted synchronous removal of organic pollutants and Cr(VI). • This composite could be applied at a wide pH range in photocatalytic reactions. • Possible photocatalytic mechanisms of organic pollutants and Cr(VI) were proposed. A visible-light-driven Bi₂WO₆/CuS p-n heterojunction was fabricated using an easy solvothermal method. The Bi₂WO₆/CuS exhibited high photocatalytic activity in a mixed system containing rhodamine B (RhB), tetracycline hydrochloride (TCH), and Cr (VI) under natural conditions. Approximately 98.8% of the RhB (10 mg/L), 87.6% of the TCH (10 mg/L) and 95.1% of the Cr(VI) (15 mg/L) were simultaneously removed from a mixed solution within 105 min. The removal efficiencies of TCH and Cr(VI) increased by 12.9% and 20.4%, respectively, in the mixed solution, compared with the single solutions. This is mainly ascribed to the simultaneous consumption electrons and holes, which increases the amount of excited electrons/holes and enhances the separation efficiency of photogenerated electrons and holes. Bi₂WO₆/CuS can be applied over a wide pH range (2–6) with strong photocatalytic activity for RhB, TCH and Cr(VI). Coexisiting dissolved organic matter in the solution significantly promoted the removal of TCH (from 74.7% to 87.2%) and Cr(VI) (from 75.7% to 99.9%) because it accelerated the separation of electrons and holes by consuming holes as an electron acceptor. Removal mechanisms of RhB, TCH, and Cr(VI) were proposed, Bi₂WO₆/CuS was formed into a p-n heterojunction to efficiently separate and transfer photoelectrons and holes so as to drive photocatalytic reactions. Specifically, when reducing pollutants (e.g., TCH) and oxidizing pollutants (e.g., Cr(VI)) coexist in wastewater, the p-n heterojunction in Bi₂WO₆/CuS acts as a “bridge” to shorten the electron transport and thus simultaneously increase the removal efficiencies of both types of pollutants.     

酚类化合物在焦化废水处理过程中的降解与转移

研究了4种烷基酚、7种氯酚和2种硝基酚物质在广东韶关钢铁集团焦化废水处理站的浓度演变与转移.针对设计处理量为2000 m.3d-1,生物处理采用A/O1/O2工艺,已经稳定运行5年的实际废水处理工程,同一时间分别采集水样、气样与综合排泥样若干批次,采用GC/MS方法分析酚类物质的浓度.研究结果表明,焦化废水中酚类物质在原水与各个处理工段中均存在成分与浓度的特征分布,烷基酚类物质浓度高但容易通过生物降解去除,氯酚和硝基酚的去除率略低,经生物处理的出水酚类物质浓度均低于5μg.L-1,达到了有关排放标准的要求;所有酚类物质在废水处理过程中存在气相转移的现象,转移污染物浓度分布差异显著,取决于废水本底浓度与该物质的化学性质;污泥样品能够高倍数富集氯酚类物质,在处理与处置工艺的选择方面需要防止扩散.酚类化合物在焦化废水处理过程中的浓度削减主要是生物阶段,气相转移与固相转移可能构成环境风险,未来的水处理工程需要考虑二次污染的消除问题.     

Removal of odors and VOCs in municipal solid waste comprehensive treatment plants using a novel three-stage integrated biofilter: Performance and bioaerosol emissions

• TSIBF was composed of ABRS, FRS and HBRS. • THIBF can effectively remove various odors, VOCs and bioaerosols. • Different reaction segments in TSIBF can remove different types of odors and VOCs. • TSIBF can reduce the emission of bioaerosols through enhanced interception. A novel three-stage integrated biofilter (TSIBF) composed of acidophilic bacteria reaction segment (ABRS), fungal reaction segment (FRS) and heterotrophic bacteria reaction segment (HBRS) was constructed for the treatment of odors and volatile organic compounds (VOCs)from municipal solid waste (MSW) comprehensive treatment plants. The performance, counts of predominant microorganisms, and bioaerosol emissions of a full-scale TSIBF system were studied. High and stable removal efficiencies of hydrogen sulfide, ammonia and VOCs could be achieved with the TSIBF system, and the emissions of culturable heterotrophic bacteria, fungi and acidophilic sulfur bacteria were relatively low. The removal efficiencies of different odors and VOCs, emissions of culturable microorganisms, and types of predominant microorganisms were different in the ABRS, FRS and HBRS due to the differences in reaction conditions and mass transfer in each segment. The emissions of bioaerosols from the TSIBF depended on the capture of microorganisms and their volatilization from the packing. The rational segmentation, filling of high-density packings and the accumulation of the predominant functional microorganisms in each segment enhanced the capture effect of the bioaerosols, thus reducing the emissions of microorganisms from the bioreactor.     

Simultaneous removal of hydrogen sulfide and volatile organic sulfur compounds in off-gas mixture from a wastewater treatment plant using a two-stage bio-trickling filter system

A two-stage BTF system was established treating odorous off-gas mixture from a WWTP. The two-stage BTF system showed resistance for the lifting load of H₂S and VOSC. Miseq Illumina sequencing showed separated functional microbial community in BTFs. Avoiding H₂S inhibition and enhancement of VOSC degradation was achieved. Key control point was discussed to help industrial application of the system. Simultaneous removal of hydrogen sulfide (H₂S) and volatile organic sulfur compounds (VOSCs) in off-gas mixture from a wastewater treatment plant (WWTP) is difficult due to the occasional inhibitory effects of H₂S on VOSC degradation. In this study, a two-stage bio-trickling filter (BTF) system was developed to treat off-gas mixture from a real WWTP facility. At an empty bed retention time of 40 s, removal efficiencies of H₂S, methanethiol, dimethyl sulfide, and dimethyl disulfide were 90.1, 88.4, 85.8, and 61.8%, respectively. Furthermore, the effect of lifting load shock on system performance was investigated and results indicated that removal of both H₂S and VOSCs was slightly affected. Illumina Miseq sequencing revealed that the microbial community of first-stage BTF contained high abundance of H₂S-affinity genera including Acidithiobacillus (51.43%), Metallibacterium (25.35%), and Thionomas (8.08%). Analysis of mechanism demonstrated that first stage of BTF removed 86.1% of H₂S, mitigating the suppression on VOSC degradation in second stage of BTF. Overall, the two-stage BTF system, an innovative bioprocess, can simultaneously remove H₂S and VOSC.     

Flocculation behaviors of a novel papermaking sludge-based flocculant in practical printing and dyeing wastewater treatment

•PSBF performed better than PAC and PAM in CODCr removals. •PSBF was more insensitive to changing pH than PAC and PAM. •PAC could remove humic acid-like pollutants and dye particles. •PSBF was efficient in removing tryptophan-like pollutants from PPDW. •A secondary coagulation-flocculation process (PAC→PSBF) is proposed here. In our previous studies, several papermaking sludge-based flocculants (PSBFs) were synthesized from wood pulp papermaking sludge. The structure-activity relationships of the PSBFs have been investigated in simulated dye wastewater treatment, but their efficiencies in practical printing and dyeing wastewater (PPDW) treatment are unknown. Herein, an PSBF was prepared, and its performance is discussed in comparison to polyaluminium chloride (PAC) and polyacrylamide (PAM) in PPDW treatment. The PSBF was used in three ways: as an independent flocculant, as a PAC aid, or used to treat the effluent of the PAC system. The results indicated that adding PSBF alone produced similar color and chemical oxygen demand (COD_Cr) removals as the PAC system alone, but PSBF performed better than PAC when the pH of PPDW was higher than 7.0. Adding PSBF as a PAC aid improved the color, COD_Cr and turbidity removals, but the elimination efficiencies were slightly lower than those of the PAC+ PAM system. However, when PSBF was used as a flocculant to treat the effluent of the PAC system (PAC→PSBF), the effluent qualities were enhanced. Compared with the PAC system, the color and COD_Cr removals of PAC→PSBF system increased by 16.21% and 13.26%, respectively. The excitation and emission matrix fluorescence results indicated that PSBF removed tryptophan-like pollutants more efficiently than PAC. Considering the pH requirements of the subsequent bioreactor treatment in practice, the PAC→PSBF system were also investigated at the PPDW pH level of 7.0. Its maximum removal efficiencies of color, COD_Cr and turbidity were 90.17%, 32.60% and 82.50%, respectively.