Anomalous transport of colloids and solutes in a shear zone

Transport experiments with colloids and radionuclides in a shear zone were conducted during the Colloid and Radionuclide Retardation experiment (CRR) at Nagra's Grimsel Test Site. Breakthrough curves of bentonite colloids and uranine, a non-sorbing solute, were measured in an asymmetric dipole flow field. The colloid breakthrough is earlier than that of uranine. Both breakthrough curves show anomalously long late time tails and the slope of the late time tails for the colloids is slightly higher. Anomalous late time tails are commonly associated with matrix diffusion processes; the diffusive interaction of solutes transported in open channels with the adjacent porous rock matrix or zones of stagnant water. The breakthrough curves for different colloid size classes are very similar and show no signs of fractionation due to their (size-dependent) diffusivity. It is proposed that tailing of the colloids is mainly caused by the structure of the flow field and that for the colloid transport, matrix diffusion is of minor importance. This has consequences for the interpretation of the uranine breakthrough. Comparisons of experimental results with numerical studies and with the evaluation of the colloid breakthrough with continuous time random theory imply that the tailing in the conservative solute breakthrough in this shear zone is not only caused by matrix diffusion. Part of the tailing can be attributed to advective transport in fracture networks and advection in low velocity regions. Models based on the advection-dispersion equation and matrix diffusion do not properly describe the temporal and spatial evolution of colloid and solute transport in such systems with a consistent set of parameters.     

The effect of a biofilm on solute diffusion in fractured porous media

At sites in fractured rock where contamination has been exposed to the rock matrix for extended periods of time, the amount of contaminant mass residing in the matrix can be considerable. Even though it may be possible to diminish concentrations by the advection of clean water through the fracture features, back diffusion from mass held in the matrix will lead to a continuing source of contamination. In such an event, the development of a biofilm (a thin film of microbial mass) on the wall of the fractures may act to limit or prevent the back diffusion process. The objective of this preliminary study is to explore the influence imparted by the presence of a biofilm on the process of matrix diffusion. The investigation was conducted using radial diffusion cells constructed from rock core in which biofilm growth was stimulated in a central reservoir. Once biofilms were developed, forward diffusion experiments were conducted in which a conservative solute migrated from the central reservoir into the intact rock sample. Diffusion experiments were performed in a total of 11 diffusion cell pairs where biofilm growth was stimulated in one member of the pair and inhibited in the other. The effect of the presence of a biofilm on tracer diffusion was determined by comparison of the diffusion curves produced by each cell pair. A semi-analytical model that accounts for the presence of a biofilm was used to investigate the effect of the biofilm on mass transfer due to changes in the effective porosity, effective diffusion coefficient, and the depth of penetration of the biofilm into the intact rock. The results show that the biofilm acted to plug the rock matrix, rather than forming a discrete layer on the reservoir surface. The reduction in effective porosity due to the biofilm ranged from 6% to 52% with the majority of the samples in the 30% to 50% range. Based on the present results, with more efficient biofilm stimulation, it is reasonable to assume that a more complete plugging of the microcrack porosity might be possible, leaving a much thicker and efficient barrier than could be achieved via a surface biofilm.     

Migration of colloids in discretely fractured porous media: effect of colloidal matrix diffusion

Numerical simulations of colloid transport in discretely fractured porous media were performed to investigate the importance of matrix diffusion of colloids as well as the filtration and remobilization of colloidal particles in both the fractures and porous matrix. To achieve this objective a finite element numerical code entitled COLDIFF was developed. The processes that COLDIFF takes into account include advective-dispersive transport of colloids, filtration and remobilization of colloidal particles in both fractures and porous matrix, and diffusive interactions of colloids between the fractures and porous matrix. Three sets of simulations were conducted to examine the importance of parameters and processes controlling colloid migration. First, a sensitivity analysis was performed using a porous block containing a single fracture to determine the relative importance of various phenomenological coefficients on colloid transport. The primary result of the analysis showed that the porosity of the matrix and the process of colloid filtration in fractures play important roles in controlling colloid migration. Second, simulations were performed to replicate and examine the results of a laboratory column study using a fractured shale saprolite. Results of this analysis showed that the filtration of colloidal particles in the porous matrix can greatly affect the tailing of colloid concentrations after the colloid source was removed. Finally, field-scale simulations were performed to examine the effect of matrix porosity, fracture filtration and fracture remobilization on long-term colloid concentration and migration distance. The field scale simulations indicated that matrix diffusion and fracture filtration can significantly reduce colloid migration distance. Results of all three analyses indicated that in environments where porosity is relatively high and colloidal particles are small enough to diffuse out of fractures, the characteristics of the porous matrix that affect colloid transport become more important than those of the fracture network. Because the properties of the fracture network tend to have greater uncertainty due to difficulties in their measurement relative to those of the porous matrix, prediction uncertainties associated with colloid transport in discretely fractured porous media may be reduced.     

Development and testing of radionuclide transport models for fractured rock: examples from the Nagra/JNC Radionuclide Migration Programme in the Grimsel Test Site, Switzerland

The joint Swiss National Co-operative for the Disposal of Radioactive Waste (Nagra)/Japan Nuclear Cycle Development Institute (JNC) Radionuclide Migration Programme has now been on-going for over a decade in Nagra's Grimsel Test Site (GTS). The main aim of the programme has been the direct testing of radionuclide transport models in as realistic manner as possible. Although it will never be possible to fully test these models due to the large time and distance scales involved, tests of the model assumptions in scaled down but otherwise realistic conditions will contribute to developing confidence in the predictive power of the models. In this paper, the Nagra/JNC approach is highlighted with examples from a large programme of field, laboratory and natural analogue studies based around the GTS. The successes and failures are discussed as in the general approach to the thorough testing of predictive transport codes which will be used in repository performance assessment (PA). Some of the work is still on-going and this represents the first presentation of a unique set of results and conclusions.     

Solute transport in crystalline rocks at Äspö — II: Blind predictions, inverse modelling and lessons learnt from test STT1

Based on the results from detailed structural and petrological characterisation and on up-scaled laboratory values for sorption and diffusion, blind predictions were made for the STT1 dipole tracer test performed in the Swedish Äspö Hard Rock Laboratory. The tracers used were nonsorbing, such as uranine and tritiated water, weakly sorbing ²²Na⁺, ⁸⁵Sr²⁺, ⁴⁷Ca²⁺and more strongly sorbing ⁸⁶Rb⁺, ¹³³Ba²⁺, ¹³⁷Cs⁺.Our model consists of two parts: (1) a flow part based on a 2D-streamtube formalism accounting for the natural background flow field and with an underlying homogeneous and isotropic transmissivity field and (2) a transport part in terms of the dual porosity medium approach which is linked to the flow part by the flow porosity.The calibration of the model was done using the data from one single uranine breakthrough (PDT3). The study clearly showed that matrix diffusion into a highly porous material, fault gouge, had to be included in our model evidenced by the characteristic shape of the breakthrough curve and in line with geological observations.After the disclosure of the measurements, it turned out that, in spite of the simplicity of our model, the prediction for the nonsorbing and weakly sorbing tracers was fairly good. The blind prediction for the more strongly sorbing tracers was in general less accurate. The reason for the good predictions is deemed to be the result of the choice of a model structure strongly based on geological observation. The breakthrough curves were inversely modelled to determine in situ values for the transport parameters and to draw consequences on the model structure applied. For good fits, only one additional fracture family in contact with cataclasite had to be taken into account, but no new transport mechanisms had to be invoked. The in situ values for the effective diffusion coefficient for fault gouge are a factor of 2–15 larger than the laboratory data. For cataclasite, both data sets have values comparable to laboratory data. The extracted K_d values for the weakly sorbing tracers are larger than Swedish laboratory data by a factor of 25–60, but agree within a factor of 3–5 for the more strongly sorbing nuclides. The reason for the inconsistency concerning K_ds is the use of fresh granite in the laboratory studies, whereas tracers in the field experiments interact only with fracture fault gouge and to a lesser extent with cataclasite both being mineralogically very different (e.g. clay-bearing) from the intact wall rock.