Analysis of Motorcycle Exhaust Regular Testing Data—A Case Study of Taipei City

Abstract

In Taiwan, a continuous increase in the number of motorcycles has made exhaust pollution one of the major emission sources of air pollutants. The regular testing program carried out by the Republic of China Environmental Protection Agency was designed to reduce air pollutant emissions by enhancing maintenance and repair. During the execution period, abundant testing results were accumulated to discuss pollutant emissions from motorcycles. Exhaust testing data of motorcycles in Taipei City from 1996 to 2005 were chosen as the basic data to survey changes in motorcycle exhaust. Effects of motorcycle age and mileage on exhaust pollution were studied. The introduction of advanced emission standards enhances the elimination of high-emitting motorcycles. The testing data indicate that the testing rate rose from approximately 50 to 70% and the failure rate changed from approximately 15 to 10%. The operation cycles of two-stroke motorcycles make them high-emitting vehicles. Concentrations of carbon monoxide and hydrocarbons are higher in two-stroke motorcycle exhaust than that in four-stroke motorcycles. In contrast, the concentration of carbon dioxide produced from complete oxidation processes is lower in exhaust from two-stroke motorcycles. Therefore, failure rates of two-stroke motorcycles are higher than those of four-stroke motorcycles and were also observed to deactivate more easily. On the basis of analytical results of testing data, we found that failure rates show a gradually increasing trend for motorcycles older than 3 yr or used for mileages greater than 10,000 km, and failure rates are highly correlated to the age/mileage of motorcycles. We reason that the accumulation of age or mileage means accumulating usage time of engines and emission control systems. Concentrations of pollutant emissions would increase because of engine wear and emission control system deactivation. After discussing changes of failure rates and pollutant emissions, some suggestions are proposed to improve the testing rate and effectiveness of regular testing.     

Atmospheric Sample Pumps —A Possible Source of Error in Total Hydrocarbon,Methane, and Carbon Monoxide Measurement

Errors in measurement due to the use of pressure pumps to feed atmospheric samples to combination total hydrocarbon, methane, and carbon monoxide detectors are pointed out. The type of errors involved are detected only by a comparison study of monitors. The use of vacuum pumps as a superior method of sample introduction is discussed.     

New particle formation of ternary droplets in the atmosphere — a steady-state nucleation kinetics approach

A self-consistent expression for the kinetics of ternary nucleation is developed based on the nucleation flux theory derived by Langer, 1969, Annals of Physics 54, 258–275. The method for obtaining the ternary nucleation flux is based on the solution of a Fokker–Planck equation for the concentration of clusters where both number and cluster energy fluctuations are included. The theory is applied to a nonideal solution of water–sulphuric acid that is nonideally mixed with ammonia. The nucleation rates predicted for this ternary system studied show a considerable increase on the nucleation rate compared to the binary water–sulphuric acid system for gaseous concentrations of ammonia which are likely to occur in the atmosphere. The results of the present study are in qualitative agreement with current laboratory and theoretical studies where a considerable enhancement in the nucleation rate is observed with the addition of tens of parts per trillion by volume of NH₃ in the binary H₂SO₄–H₂O system.     

Light Scattering Characteristics of Aerosols as a Function of Relative Humidity: Part I—A Comparison of Measured Scattering and Aerosol Concentrations Using the Theoretical Models

ABSTRACT

The Southeastern Aerosol and Visibility Study (SEAVS) was undertaken to characterize the size-dependent composition, thermodynamic properties, and optical characteristics of the ambient atmospheric particles in the southeastern United States. The field portion of the study was carried out from July 15 to August 25, 1995.

As part of the study a relative humidity controlled inlet was built to raise or lower the relative humidity to predetermined levels before the aerosol was passed into an integrating nephelometer or particle-sizing device. Five other integrating nephelometers were operated in various configurations, two of which were fitted with a 2.5 μm inlet. Fine particle (<2.5 μm) samplers were operated to measure concentrations of sulfate, nitrate, and ammonium ions, organic and elemental carbon, and fine soil. Mass size distributions were measured with an eight-stage, single orifice cascade impactor.     

New insight into molecular interaction of heavy metal pollutant—cadmium(II) with human serum albumin

Cadmium (Cd) is an extremely toxic metal commonly found as an environmental contaminant from industrial and agricultural sources, posing severe risks to human health. In this study, the binding mechanism of Cd(II)–human serum albumin (HSA) complex and the effect of Cd(II) on the conformational stability and structural state of HSA were comprehensively investigated through a series of efficient and appropriate methods. X-ray photoelectron spectroscopy accurately described the microenvironmental changes around protein C, N, and O atoms in the presence of Cd(II). Fluorescence results indicated that the probable mechanism of Cd(II)–HSA interaction is a static quenching process. Fourier transform infrared spectroscopy and dynamic light scattering showed Cd(II) complexation altered HSA conformation and the microenvironments of Trp and Tyr residues, accompanied by the size increases of HSA aggregates. This research will be helpful for understanding the toxic effects of Cd(II) on protein function in vivo.

Light Scattering Characteristics of Aerosols at Ambient and as a Function of Relative Humidity: Part II—A Comparison of Measured Scattering and Aerosol Concentrations Using Statistical Models

ABSTRACT

The eastern United States national parks experience some of the worst visibility conditions in the nation. To study these conditions, the Southeastern Aerosol and Visibility Study (SEAVS) was undertaken to characterize the size-dependent composition, thermodynamic properties, and optical characteristics of the ambient atmospheric particles. It is a cooperative three-year study that is sponsored by the National Park Service and the Electric Power Research Institute and its member utilities. The field portion of the study was carried out from July 15 to August 25, 1995.

The study design, instrumental configuration, and estimation of aerosol types from particle measurements is presented in a companion paper. In the companion paper, we compare measurements of scattering at ambient conditions and as functions of relative humidity to theoretical predictions of scattering. In this paper, we make similar comparisons, but using statistical techniques. Statistically derived specific scattering associated with sulfates suggest that a reasonable estimate of sulfate scattering can be arrived at by assuming nominal dry specific scattering and treating the aerosols as an external mixture with ammoniation of sulfate accounted for and by the use of Tang's growth curves to predict water absorption. However, the regressions suggest that the sulfate scattering may be underestimated by about 10%. Regression coefficients on organics, to within the statistical uncertainty of the model, suggest that a reasonable estimate of organic scattering is about 4.0 m²/g.

A new analysis technique is presented, which does not rely on comparing measured to model estimates of scattering to evoke an understanding of ambient aerosol growth properties, but rather relies on measurements of scattering as a function of relative humidity to develop actual estimates of f(RH) curves. The estimates of the study average f(RH) curve for sulfates compares favorably with the theoretical f(RH) curve for ammonium bisulfate, which is in turn consistent with the study average sulfate am-moniation corresponding to a molar ratio of NH₄/SO₄ of approximately one. The f(RH) curve for organics is not significantly different from one, suggesting that organics are weakly to nonhygroscopic.     

Analysis of the influence of urban form and materials on sensible heat flux — a case study of Japan's largest housing development “Tama New Town”

In this study, the relationship between the form and materials of urban blocks and sensible heat flux from total surfaces was analyzed in the case of `Tama New Town', which is one of the largest housing developments in Japan and is under continuing development. First, urban blocks were divided into five categories depending on the building plot types. The characteristics of the form and thermal properties of each building, as well as the land cover condition (area of vegetation, bare soil, asphalt pavement, and built area) of each category was considered. Furthermore, 6 urban blocks were selected for numerical simulation of heat balance of the total surfaces, and sensible heat flux from the total surfaces of each urban block on clear sky summer day was calculated. It was confirmed that the influence of the direction that buildings faced and floor area ratio was as great as that of building materials upon the amount of sensible heat flux in each urban block.     

Characteristics and distribution of microplastics in shoreline sediments of the Yangtze River,main tributaries and lakes in China—From upper reaches to the estuary

Environmental Science and Pollution Research - Microplastics (MPs) pervade the environment and increasingly threaten both natural ecosystems and human health. In this study, we investigated MP...     

Aerial application of copper for dothistroma control in New Zealand’s planted forests—effect on stream environments

Environmental Science and Pollution Research - Limited information is available on the risk to aquatic environments from the aerial application of copper fungicides to treat dothistroma needle...     

Correction to: Characteristics and distribution of microplastics in shoreline sediments of the Yangtze River,main tributaries and lakes in China—From upper reaches to the estuary

Environmental Science and Pollution Research -     

An Air Quality Data Analysis System for Interrelating Effects,Standards, and Needed Source Reductions: Part 13— Applying the EPA Proposed Guidelines for Carcinogen Risk Assessment to a Set of Asbestos Lung Cancer Mortality Data

Abstract

The Clean Air Act Amendments of 1990 (CAAA-90) list 189 hazardous air pollutants (HAPs) for which “safe” ambient concentrations are to be determined. The primary purpose of this paper is to develop two mathematical models, lognormal and logarithmic, that effectively express excess lung cancer mortality as a function of asbestos concentration for an example set of data and also to suggest using these two models for additional HAPs. The secondary purpose of this paper is to calculate a “safe” asbestos concentration by first assuming a default linear extrapolation (to one excess death per million people, as specified for carcinogenic HAPs). The resulting “safe” concentration is an impossible-to-achieve 1/1000 of present background asbestos concentrations. A letter to the editor and a response in this Journal issue use additional asbestos data that suggest that the “safe” concentration should be about 730 times higher than first calculated here and that a default nonlinear extrapolation should be used instead, with the “safe” concentration proportional to the desired mortality level raised to the 0.39 power. These results suggest that the most important problem in setting a “safe” concentration for each carcinogenic HAP is to determine the correct nonlinear extrapolation to use for each HAP.     

Investigation on the Chemical Structure of Nonextractable Residues of the Fungicide Cyprodinil in Spring Wheat Using 13C-C1-Phenyl-Cyprodinil on 13C-Depleted Plants—An Alternative Approach to Investigate Nonextractable Residues

Abstract

¹³C-labelled cyprodinil was applied on ¹³C-depleted wheat plants with 27-fold field application rate. A control experiment applying same amounts of ¹⁴C-cyprodinil showed that main portions of the residues were detected in the cellulose (15% NER), hemicellulose (28.3% NER), and lignin fraction (23.3% NER). 16.7% were detected in water soluble polymers, 6% in both, pectin and protein fraction, and 4% in the starch containing fraction. Free cyprodinil was detectable by TLC in all fractions except lignin. A direct characterization of the residues in vivo by CP-MAS was not successful. Cell wall fractions were further analysed by liquid state NMR to determine the structure of the mobilized highly polymer/polar residues: Within lignin, where most of the residues were located at field application rate, neither intact cyprodinil nor its metabolites could not be detected. The ¹³C-label introduced was probably incorporated in the polymer as natural lignin monomers and thus are not considered as bound residues according to IUPAC definition.