共查询到20条相似文献,搜索用时 492 毫秒
1.
某些特殊物资对温度、湿度等环境条件有特殊的要求,特别是集装箱作为密闭的箱体,其内部环境条件更加恶劣。为了保证进藏特殊物资安全开展集装箱运输,作者在格尔木地区对集装箱内部温、湿度环境条件及其影响因素即大气环境温度、太阳辐射强度和风速进行了测试,最后运用统计分析方法建立了集装箱内部温度数学模型,得出了内部最恶劣温度范围,从而为特殊物资安全进箱提供理论依据。 相似文献
2.
某些特殊货物对温度、湿度等环境条件有特殊的要求,特别是集装箱一般为密闭的箱体,其内部环境条件更加恶劣。成都地区具有高温高湿的气候特点,为了保证这些特殊货物在成都地区安全开展集装箱运输,作者在成都地区对集装箱内部温、湿度环境条件及其影响因素即大气环境温度进行了测试,最后运用统计分析方法建立了集装箱内部温度数学模型,得出了内部最恶劣温度范围,从而为特殊货物安全进箱提供理论依据。 相似文献
3.
热真空设备中与温度相关的试验技术探讨 总被引:1,自引:0,他引:1
以RZHM-1400-AB型热真空试验箱为实例,简述设备主要工作原理。强调其温度传递方式及航天产品在热真空试验中温度参数的重要性。以无数试验数据为依据,着重论证何种类型测温传感器与实际设备相匹配,同时论证选取何种外形的测温传感器为最佳温度测量工具。同时,进一步介绍几种在热真空试验中使用这些测温传感器的方法,以减少不必要的人为测量误差。 相似文献
4.
5.
本文以平遥县城及周边区域环境空气质量监测结果为依据,采用具有全局优化的遗传算法(GA)对平遥县及周边区域大气环境质量污染现状进行评价。用大气污染危害指数的普适公式和参数优化后的污染危害指数公式确定污染危害指数的取值范围与评价级别之间的对应关系,由此得出较符合平遥县及周边区域实际的评价结果,同时针对具体情况对此结果进行简单的分析。 相似文献
6.
7.
温度环境试验及其标准综述(一)温度对装备的影响及温度试验的重要性 总被引:3,自引:0,他引:3
阐述了温度试验在军工产品研制生产中的重要地位和用途,温度环境对装备的主要影响和典型故障模式;介绍了GJB 150/150A、HB 6167/6167A、GB/T 2423等我国主要军用、民用环境试验系列标准中包括的各种典型温度试验程序及其用途和模拟的环境;说明了各种典型试验程序规定或要求的温度试验各种特点和剪裁方法,并汇总列于一个表格中,以便于查阅,列出了温度试验标准中对温度试验箱和测试仪器仪表的要求,最后讨论了受试产品温度稳定、温度试验箱的选用,确保受试产品经受正确的温度条件、受试产品温度响应测量和温度试验中断处理等技术。本文分为四大部分:第一部分阐述温度对装备的影响、故障机理和温度试验的重要性;第二部分阐述了GJB150/150A、HB 6167/6167A和GB/T 2423等主要环境试验标准中的典型温度试验程序;第三部分详细说明了各种温度试验的试验温度和试验持续时间及其区别和剪裁方法;第四部分介绍了各种标准对温度试验设备的要求,温度试验设定点,确保试验温度准确施加和试验中断处理等温度试验技术。本文为其中第一部分。 相似文献
8.
研究了窗口温度下活性炭用于烟气脱硫的控制条件,对影响活性炭烟气脱硫的重要影响因素进行了分析,得出:烟气进口氧气含量为9%左右,温度在190℃左右脱硫率较佳;水蒸气含量增加,脱硫率增大;空塔速度增大,脱硫率降低;活性炭用于工业当中要考虑适当的水蒸气含量和空塔速度以节约成本。 相似文献
9.
本文介绍一种软硬件相结合的高精度智能测温模板.该模板辅以软件使测量放大器的低频噪声受到较好的抑制.同时根据抵消法原理引入自动量程变换,因而不必使用昂贵的高精度A/D变换器即可实现对宽范围温度的高精度测量.文章还介绍了如何发挥软件的特点,对系统的测量误差进行综合校正. 相似文献
10.
11.
12.
温度和湿度试验是环境试验中最重要的试验。对温度、湿度试验设备参数的测量,在考虑经济合理和满足规定测量不确定度的情况下,本文阐述测量中的一般要求、测量仪器的选择、提高测量准确度的方法等。 相似文献
13.
14.
对ZTH020U型高低温湿热试验箱低温试验测量审核不满意的原因进行了分析,并提出了相应的措施。后续参比试验在此基础上,均未出现不满意的结果。 相似文献
15.
Chi-Yuan Lee Fang-Bor Weng Ten-Lom Chen Fan-Hsuan Liu 《International Journal of Green Energy》2016,13(6):624-629
This study developed an integrated (flow, voltage, and temperature) micro sensor using the micro-electro-mechanical systems (MEMS) technology. It was inserted into the high temperature proton exchange membrane fuel cell (HT-PEMFC) for local real-time measurement. The integrated micro sensor is made of 40 µm thick stainless steel base material, and its protective layer is formed by polyimide (PI) that has better temperature resistance. The integrated micro sensor has three functions, and is favorably characterized by small size, good acid resistance and temperature resistance, quick response, real-time measurement, and being able to be put in any place for measurement. After calibration, and its reliability confirmed, the integrated micro sensor is inserted into the HT-PEMFC for local microcosmic measurement. 相似文献
16.
E. B. Preud'homme H. G. Stefan 《Journal of the American Water Resources Association》1992,28(6):1077-1082
ABSTRACT: Records of hourly water temperatures for two streams in the Upper Mississippi River basin were used to find the error between instantaneous measurements of stream water temperatures and true daily averages. The instantaneous summer water temperature measurements were assumed to be collected during daylight hours, and measurement times were selected randomly. The absolute error at the 95 percent confidence level of randomly collected stream water temperatures was less than 0.9°C for a 1 to 5m deep large river, but as large as 3.6°C for a 0.3 to lm deep small stream. Temperature readings of morning samples were usually below daily average values, and afternoon readings were usually above. Daily mean water temperatures were obtained with less than 0.23°C standard deviation from true daily averages if the daily maximum and minimum water temperatures were averaged. Sample results were obtained for the open water (summer) season only, since diurnal water temperature fluctuations in ice covered streams are usually negligible. 相似文献
17.
Robert L. Beschta R. Lynn Taylor 《Journal of the American Water Resources Association》1988,24(1):19-25
ABSTRACT: The Salmon Creek Watershed drains 325 km2 of forested terrain in the Cascade Mountains of western Oregon. Over a 30–year period (from 1955 to 1984) average daily maximum and minimum stream temperatures, calculated from the 10 warmest days of each year, have risen 6°C and 2°C, respectively. In contrast, a small decrease in maximum air temperatures was found over the same period. Regression analysis indicated a highly significant (p < 0.01) relationship between a cumulative index of forest harvesting and maximum stream temperatures. Maximum temperatures also tended to increase for several years following major peak flow events. The interaction between harvest activity (logging and road construction), changing forest and riparian management practices and the occurrence of natural hydrologic events (peak flows and associated mass soil movements) tend to obscure specific cause-and-effect relationships regarding long-term changes in maximum stream temperature. 相似文献
18.
本文简要介绍了环境与可靠性试验领域试验设备系列检定标准HB 6783、GB/T 5170。以本单位某型温湿度试验箱验收为例,详细介绍了HB 6783、GB/T 5170系列温湿度试验设备检定/检验标准在温湿度试验箱性能指标验收中的应用,通过对比应用总结,指出综合比较不同检定标准中温湿度性能指标的检定项目、方法,结合本单位产品试验需求应用,是制定温湿度试验箱性能指标验收方法的最佳途径。 相似文献
19.
本文探讨了依据环境试验箱的在温度校准时所得的数据来评定其温度性能不确定度的方法,该方法简单、可操作性强,为环境试验的质量控制提供了科学依据。 相似文献
20.
Jay R. Stauffer 《Journal of the American Water Resources Association》1981,17(3):504-507
The bluespotted sunfish, Enneacanthus gloriosus (Holbrook), had a final temperature preferendum of 31.5 C. Fish acclimated to 30 C avoided 36 C. The analysis of acute temperature preference data and the relationship between final temperature preferendum and upper avoidance temperatures are discussed. 相似文献