The continuous variations of dissolved oxygen (DO), manganese (Mn), pH, and their effect on manganese removal by different water treatment processes are investigated. The results show that the declined DO concentration and pH value in the bottom of reservoir results in the increasing release of Mn from sediment to source water. Manganese concentration increased from 0.1 to 0.4 mg·L-1 under the condition that DO concentration decreased from 12.0 to 2.0 mg·L-1 in raw water. The different water treatment processes exhibited different efficiency on manganese removal. The processes with recycling of the suspended sludge, low elevation velocity in settling tank and slow filter rate, will benefit the manganese removal. During a high release of manganese in raw water, traditional coagulation-sedimentation and filtration could not completely remove Mn, although granular activated carbon filtration (GAC) had been applied. At that case, preoxidation with chlorine or potassium permanganate (KMnO4) was necessary to address the high manganese concentration. 相似文献
Hydrophobic organic contaminants (HOCs)—pyrene, and natural organic matters (NOM) from different sources were taken as the test compounds to investigate the impact of physicochemical characteristics of NOM on HOCs’ partition to the NOM in this study. The effects of solution property, NOM characteristics, and modification by ozone preoxidation on pyrene partition to NOM were systematically evaluated. According to the fluorescence quenching method, the partition coefficient Koc of pyrene to NOM was calculated, which was found to have a great relationship with the aromatic structures and hydrophobic functional groups of the NOM. The NOM characteristic modification corresponding to solution property could influence the interactions between the NOM and pyrene. Preozonation could destroy the aromatic or hydrophobic structures of the NOM and decrease Koc of pyrene. 相似文献
Arsenic (V) adsorption on manganese oxide coated rice wastes was investigated in this study. The modified adsorbents were characterized by Fourier-transform infrared spectroscopy, scanning electron microscopy, and pH measurements to determine the point of zero charge. Batch adsorption equilibrium experiments were conducted to study the effects of pH, contact time, and initial concentration on arsenic removal efficiency. The adsorption capacity of rice waste was significantly improved after modification with permanganate. The Langmuir isotherm model fitted the equilibrium data better than the Freundlich model which confirms surface homogeneity of the adsorbent. Maxima adsorption capacities are determined as 10 and 12 mg/g at pH 3 for manganese oxide coated rice husk and straw, respectively. The adsorption energy indicates that the adsorption process may be dominated by chemisorption. Pseudo-second-order rate equation described the kinetics sorption of arsenic with good correlation coefficients, better than a pseudo-first-order equation. Manganese oxide coated rice husk and straw appear to be promising low cost adsorbents for removing arsenic from water. 相似文献
Conventional methods for water and wastewater treatment are energy-intensive, notably at the stage of coagulation–flocculation, calling for new strategies to predict pollutant reduction because the amount of energy consumed is related to how much of the pollutant is treated. Here we developed a model, named Bio-logic, inspired by ecosystems, where pollutants represent organisms, coagulants are food, and the wider environmental conditions are the living environment. Artificial intelligence was used to learn the biological behavior, which enabled an accurate prediction of the amount of pollutant reduction. Results show that pseudo-biological objects that have a strong affinity for biological food, such as turbidity, total phosphorus, ammonia nitrogen and the potassium permanganate index, induced a strong correlation, between measured pollutant consumption capacity and predicted values. For instance, R2 correlation coefficients are 0.97 for turbidity and 0.92 for the potassium permanganate index in the laboratory; and 0.99 for turbidity, 0.90 for total phosphorus, 0.75 for ammonia nitrogen and 0.63 for the potassium permanganate index in water treatment plants. Overall, our findings demonstrate that artificial intelligence can use the water Bio-logic model to predict the pollutant consumption capacity.
Abstract This study reports on new particle formation (NPF) and characteristic features observed from a rural site falling in the rainshadow of the Western Ghats in peninsular India. A total of 35 NPF events observed during August 2018 - January 2019 are classified and analyzed here. The apparent formation rates ranged from 0.2 to 10.0?cm–3 s–1, while the growth rates of nucleation mode particles ranged from 1.2 to 13.8?nm h–1. The frequency of occurrence was least during August (core monsoon) and highest during post-monsoon. The local winds were calm and southeasterly to easterly (from the urban centre) supplying the essential precursor gases during October and November, leading to a frequent occurrence of nucleation events. Observations suggest that an increased condensation sink could limit the NPF while promoting Aitken mode growth. The newly formed particles accounted for about 10–80% of the total aerosol concentration. These newly formed particles were able to act as cloud condensation nuclei after growing to approximately 50?nm with an average activation fraction of 0.4. 相似文献
Metabolites of algae such as geosmin, 2-methylisoborneol etc. are reported to induce pungent odors into drinking water and attract additional scientific attention. Recently, in China, taste and odor outbreaks in drinking water supply have become increasingly common. In source water affected by eutrophication, dimethyl trisulfide, speculated to be produced by decayed algae, was found to be the source of taste and odor issues and can be removed effectively by usual oxidation agents. In this experimental study, batch scale tests were carried out focusing on the removal of dimethyl trisulfide. Reaction kinetics of dimethyl trisulfide oxidized by potassium permanganate in water had been studied; influence factors such as pH, organic substrate, other existed taste, and odor contaminant in equivalent concentration were also discussed. Results showed that dimethyl trisulfide can be removed by potassium permanganate efficiently; the ratio can reach more than 70% with oxidant dosage of 4 mg·L-1 and contact time prolonged to 120 min. The dimethyl trisulfide decomposition followed a second-order kinetics pattern with a rate constant k = 0.00213 L·(min·mg)-1. Typically, the degradation rate of dimethyl trisulfide was increased with the increasing KMnO4 dosage, but dramatically dropped with the increasing levels of humic acid (1.8–4.5 mg·L-1) and other odor-causing compounds (e.g. β-cyclocitral, 0–1886.0 μg·L-1). Solution pH (5.2–9.0) and initial dimethyl trisulfide concentration did not significantly affected the degradation. This study demonstrates that KMnO4 oxidation is an effective option to remove dimethyl trisulfide from water. 相似文献
• NOM formed more C-DBPs while amino acids formed more N-DBPs during chlorination• Aspartic acid and asparagine showed the highest toxicity index during chlorination• Dichloroacetonitrile might be a driving DBP for cytotoxicity and genotoxicity• Dichloroacetonitrile dominated the toxicity under different chlorination conditions Chlorination, the most widely used disinfection process for water treatment, is unfortunately always accompanied with the formation of hazardous disinfection byproducts (DBPs). Various organic matter species, like natural organic matter (NOM) and amino acids, can serve as precursors of DBPs during chlorination but it is not clear what types of organic matter have higher potential risks. Although regulation of DBPs such as trihalomethanes has received much attention, further investigation of the DBPs driving toxicity is required. This study aimed to identify the important precursors of chlorination by measuring DBP formation from NOM and amino acids, and to determine the main DBPs driving toxicity using a theoretical toxicity evaluation of contributions to the cytotoxicity index (CTI) and genotoxicity index (GTI). The results showed that NOM mainly formed carbonaceous DBPs (C-DBPs), such as trichloromethane, while amino acids mainly formed nitrogenous DBPs (N-DBPs), such as dichloroacetonitrile (DCAN). Among the DBPs, DCAN had the largest contribution to the toxicity index and might be the main driver of toxicity. Among the precursors, aspartic acid and asparagine gave the highest DCAN concentration (200 g/L) and the highest CTI and GTI. Therefore, aspartic acid and asparagine are important precursors for toxicity and their concentrations should be reduced as much as possible before chlorination to minimize the formation of DBPs. During chlorination of NOM, tryptophan, and asparagine solutions with different chlorine doses and reaction times, changes in the CTI and GTI were consistent with changes in the DCAN concentration. 相似文献
A novel, functionalized bubble surface can be obtained in dissolved air flotation (DAF) by dosing chemicals in the saturator. In this study, different cationic chemicals were used as bubble surface modifiers, and their effects on natural organic matter (NOM) removal from river water were investigated. NOM in the samples was fractionated based on molecular weight and hydrophobicity. The disinfection byproduct formation potentials of each fraction and their removal efficiencies were also evaluated. The results showed that chitosan was the most promising bubble modifier compared with a surfactant and a synthetic polymer. Tiny bubbles in the DAF pump system facilitated the adsorption of chitosan onto microbubble surfaces. The hydrophobic NOM fraction was preferentially removed by chitosan-modified bubbles. Decreasing the recycle water pH from 7.0 to 5.5 improved the removal of hydrophilic NOM with low molecular weight. Likewise, hydrophilic organic compounds gave high dihaloacetic acid yields in raw water. An enhanced reduction of haloacetic acid precursors was obtained with recycle water at pH values of 5.5 and 4.0. The experimental results indicate that NOM fractions may interact with bubbles through different mechanisms. Positive bubble modification provides an alternative approach for DAF to enhance NOM removal.
A novel composite adsorbent, hydroxyapatite/manganese dioxide (HAp/MnO2), has been developed for the purpose of removing lead ions from aqueous solutions. The combination of HAp with MnO2 is meant to increase its adsorption capacity. Various factors that may affect the adsorption efficiency, including solution pH, coexistent substances such as humic acid and competing cations (Ca2+, Mg2+), initial solute concentration, and the duration of the reaction, have been investigated. Using this composite adsorbent, solution pH and coexistent calcium or magnesium cations were found to have no significant influence on the removal of lead ions under the experimental conditions. The adsorption equilibrium was described well by the Langmuir isotherm model, and the calculated maximum adsorption capacity was 769 mg·g−1. The sorption processes obeyed the pseudo-second-order kinetics model. The experimental results indicate that HAp/MnO2 composite may be an effective adsorbent for the removal of lead ions from aqueous solutions. 相似文献
Periwinkle shell, an abundant and inexpensive natural resource, was used to prepare activated carbon by physicochemical activation with potassium hydroxide (KOH) and carbon dioxide (CO2) as the activating agents at 850 °C for 2 h. The adsorption equilibrium and kinetics of methylene blue dye on such carbon were then examined at 25 °C. Adsorption isotherm of the methylene blue (MB) on the activated carbon was determined and correlated with common isotherm equations. The equilibrium data for methylene blue adsorption well fitted to the Langmuir equation, with maximum monolayer adsorption capacity of 500.00 mg/g. Two simplified kinetic models including pseudo-first-order and pseudo-second-order equation were selected to follow the adsorption processes. The adsorption of methylene blue on activated carbon derived from periwinkle shell could best be described by the pseudo-second-order equation. The kinetic parameters of this best-fit model were calculated and discussed. 相似文献
The formation of a dynamic membrane (DM) was investigated using polyethylene glycol (PEG) (molecular weight of 35000 g/mol, concentration of 1 g/L). Two natural organic matters (NOM), Dongbok Lake NOM (DLNOM) and Suwannee River NOM (SRNOM) were used in the ultrafiltration experiments along with PEG. To evaluate the effects of the DM with PEG on ultrafiltration, various transport experiments were conducted, and the analyses of the NOM in the membrane feed and permeate were performed using high performance size exclusion chromatography, and the effective pore size distribution (effective PSD) and effective molecular weight cut off (effective MWCO) were determined. The advantages of DM formed with PEG can be summarized as follows: (1) PEG interferes with NOM transmission through the ultrafiltration membrane pores by increasing the retention coefficient of NOM in UF membranes, and (2) low removal of NOM by the DM is affected by external factors, such as pressure increases during UF membrane filtration, which decreases the effective PSD and effective MWCO of UF membranes. However, a disadvantage of the DM with PEG was severe flux decline; thus, one must be mindful of both the positive and negative influences of the DM when optimizing the UF performance of the membrane. 相似文献
To develop a novel granular adsorbent to remove arsenic and antimony from water, calcined Mg/Al-layered double-hydroxide (CLDH)-incorporated polyethersulfone (PES) granular adsorbents (PES-LDH) were prepared using a core-shell method having 25% PES in an N,N-dimethylformamide solution. The PES-LDH displayed a spherical hollow shape having a rough surface and the average particle size of 1–2 mm. On the PES-LDH surface, nanosized CLDH (100–150 nm) was successfully immobilized by consolidation between PES and CLDH. The adsorption of Sb(V) by PES-LDH was found to be more favorable than for As(V), with the maximum adsorption capacity of As(V) and Sb(V) being 7.44 and 22.8 mg/g, respectively. The regeneration results indicated that a 0.5 M NaOH and 5 M NaCl mixed solution achieved an 80% regeneration efficiency in As(V) adsorption and desorption. However, the regeneration efficiency of Sb(V) gradually decreased due to its strong binding affinity, even though the PES-LDH showed much higher Sb(V) adsorption efficiency than As(V). This study suggested that PES-LDH could be a promising granular adsorbent for the remediation of As(V) and Sb(V) contained in wastewater.
The removal of 17β-estradiol (E2) in laccase catalyzed oxidative coupling processes was systematically studied in this work. We focused on the influence of pH and natural organic matter (NOM) on the performance of the enzymatic treatment processes. It was found that the optimal pH for E2 removal was between 4 and 6. The removal of E2 was slightly inhibited in the presence of NOM. Enzymatic transformation of E2 was second-order in kinetics with first-order to both the concentrations of the enzyme and contaminant. Mass spectrum (MS) analysis suggested that coupling products were formed through radical-radical coupling mechanism. The results of this study demonstrated that laccase catalyzed oxidative coupling process could potentially serve as a treatment strategy to control steroid estrogens. 相似文献