EROSIONAL POTENTIAL OF STREAMS IN URBANIZING AREAS1

ABSTRACT: In urbanizing areas, the usual increase in flood flows also increases erosional capability of streams. In order to evaluate such tendencies quantitatively, 25 stream reaches were studied, and were classified as to whether erosion of the channel and banks was light, medium, or heavy. Analysis of characteristics indicated that (1) densely developed areas are correlated with greater erosion, (2) wide stream buffers of natural vegetation are correlated with lesser erosion, and (3) there is no definite correlation of erosion to slope or characteristics of soil. Erosional stream instability can be avoided by retention of storm water runoff, creating additional channel roughness or reducing channel slope during floods by drop structures, such as culverts, which restrict flow. Channel straightening and general bank protection should be minimized in such streams. Design of culverts should take such effects into consideration.     

The Role of Observer Variation in Determining Rosgen Stream Types in Northeastern Oregon Mountain Streams1

Abstract: Consistency in determining Rosgen stream types was evaluated in 12 streams within the John Day Basin, northeastern Oregon. The Rosgen classification system is commonly used in the western United States and is based on the measurement of five stream attributes: entrenchment ratio, width‐to‐depth ratio, sinuosity, slope, and substrate size. Streams were classified from measurements made by three monitoring groups, with each group fielding multiple crews that conducted two to three independent surveys of each stream. In only four streams (33%) did measurements from all crews in all monitoring groups yield the same stream type. Most differences found among field crews and monitoring groups could be attributed to differences in estimates of the entrenchment ratio. Differences in entrenchment ratio were likely due to small discrepancies in determination of maximum bankfull depth, leading to potentially large differences in determination of Rosgen’s flood‐prone width and consequent values of entrenchment. The result was considerable measurement variability among crews within a monitoring group, and because entrenchment ratio is the first discriminator in the Rosgen classification, differences in the assessment of this value often resulted in different determination of primary stream types. In contrast, we found that consistently evaluated attributes, such as channel slope, rarely resulted in any differences in classification. We also found that the Rosgen method can yield nonunique solutions (multiple channel types), with no clear guidance for resolving these situations, and we found that some assigned stream types did not match the appearance of the evaluated stream. Based on these observations we caution the use of Rosgen stream classes for communicating conditions of a single stream or as strata when analyzing many streams due to the reliance of the Rosgen approach on bankfull estimates which are inherently uncertain.     

Application of Rosgen’s BANCS Model for NE Kansas and the Development of Predictive Streambank Erosion Curves1

Sass, Christopher K. and Tim D. Keane, 2012. Application of Rosgen’s BANCS Model for NE Kansas and the Development of Predictive Streambank Erosion Curves. Journal of the American Water Resources Association (JAWRA) 48(4): 774‐787. DOI: 10.1111/j.1752‐1688.2012.00644.x Abstract: Sedimentation of waterways and reservoirs directly related to streambank erosion threatens freshwater supply. This study sought to provide a tool that accurately predicts annual streambank erosion rates in NE Kansas. Rosgen (2001, 2006) methods were employed and 18 study banks were measured and monitored from 2007 through 2010 (May‐June). Bank profiles were overlaid to calculate toe pin area change due to erosional processes. Streambanks experienced varied erosion rates from similar Bank Erosion Hazard Index (BEHI)‐Near Bank Stress (NBS) combinations producing R² values of 0.77 High‐Very High BEHI rating and 0.75 Moderate BEHI rating regarding predictive erosion curves for NE Kansas. Moderate ratings demonstrated higher erosion rates than High‐Very High ratings and BEHI trend lines intersected at lower NBS ratings, suggesting a discrepancy in the fit of the model to conditions in the NE Kansas region. BEHI model factors were evaluated and assessed for additional influences exerted in the region. Woody vegetation adjacent to the stream seemed to provide the most variation in erosion rates. This study’s findings allowed us to calibrate and modify the existing BEHI model according to woody vegetation occurrence levels along streambanks with high clay content. Modifications regarding vegetation occurrence of the BEHI model was completed and the results of these modifications generated new curves resulting in R² values of 0.84 High‐Very High BEHI and 0.88 Moderate BEHI ratings.     

INFLUENCE OF TWO WOODY RIPARIAN SPECIES ON CRITICAL CONDITIONS FOR STREAMBANK STABILITY: UPPER TRUCKEE RIVER,CALIFORNIA1

Over the past 35 years, a trend of decreasing water clarity has been documented in Lake Tahoe, attributable in part to the delivery of fine grained sediment emanating from upland and channel erosion. A recent study showed that the Upper Truckee River is the single largest contributor of sediment to Lake Tahoe, with a large proportion of the sediment load emanating from streambanks. This study combines field data with numerical modeling to identify the critical conditions for bank stability along an unstable reach of the Upper Truckee River, California. Bank failures occur during winter and spring months, brought on by repeated basal melting of snow packs and rain‐on‐snow events. Field studies of young lodgepole pines and Lemmon's willow were used to quantify the mechanical, hydrologic, and net effects of riparian vegetation on streambank stability. Lemmon's willow provided an order of magnitude more root reinforcement (5.5 kPa) than the lodgepole pines (0.5 kPa); the hydrologic effects of the species varied spatially and temporally and generally were of a smaller magnitude than the mechanical effects. Overall, Lemmon's willow provided a significant increase in bank strength, reducing the frequency of bank failures and delivery of fine grained sediment to the study reach of the Upper Truckee River.     

PRECISION OF CHANNEL WIDTH AND POOL AREA MEASUREMENTS1

ABSTRACT: The precision of width and pool area measurements has rarely been considered in relation to downstream or at section hydraulic geometry, fisheries studies, long-term or along a continuum research studies, or agency monitoring techniques. We assessed this precision and related it to other stream morphologic characteristics. Confidence limits (95 percent) around mean estimates with four transects (cross-sections perpendicular to the channel center-line) ranged from ± 0.4 to 1.8 m on streams with a width of only 2.2 m. To avoid autocorrelation, transects should be spaced about three channel widths apart. To avoid stochastic inhomogeneity, reach length should be about 30 channel widths or ten transects to optimize sampling efficiency. Precision of width measurements decreased with decreased depth and increased with stream size. Both observations reflect variability caused by features such as boulders or coarse woody debris. Pool area precision increased with pool area reflecting increased precision for flat, wide streams with regular pool-rime sequences. The least precision occurred on small, steep streams with random, boulder or coarse woody debris formed pools.     

Grazed Riparian Management and Stream Channel Response in Southeastern Minnesota (USA) Streams

The U.S. Department of Agriculture-Natural Resources Conservation Service has recommended domestic cattle grazing exclusion from riparian corridors for decades. This recommendation was based on a belief that domestic cattle grazing would typically destroy stream bank vegetation and in-channel habitat. Continuous grazing (CG) has caused adverse environmental damage, but along cohesive-sediment stream banks of disturbed catchments in southeastern Minnesota, short-duration grazing (SDG), a rotational grazing system, may offer a better riparian management practice than CG. Over 30 physical and biological metrics were gathered at 26 sites to evaluate differences between SDG, CG, and nongrazed sites (NG). Ordinations produced with nonmetric multidimensional scaling (NMS) indicated a gradient with a benthic macroinvertebrate index of biotic integrity (IBI) and riparian site management; low IBI scores associated with CG sites and higher IBI scores associated with NG sites. Nongrazed sites were associated with reduced soil compaction and higher bank stability, as measured by the Pfankuch stability index; whereas CG sites were associated with increased soil compaction and lower bank stability, SDG sites were intermediate. Bedrock geology influenced NMS results: sites with carbonate derived cobble were associated with more stable channels and higher IBI scores. Though current riparian grazing practices in southeastern Minnesota present pollution problems, short duration grazing could reduce sediment pollution if managed in an environmentally sustainable fashion that considers stream channel response.     

REHABILITATION OF WATERSHEDS WITH INCISING CHANNELS1

ABSTRACT: Channel incision is a pervasive problem that threatens infrastructure, destroys arable land, and degrades environmental resources. A program initiated in 1983 is developing technology for rehabilitation of watersheds with erosion and sedimentation problems caused by incision. Demonstration projects are located in 15 watersheds in the hills of northwest Mississippi. Watershed sizes range from 0.89 to 1,590 km², and measured suspended sediment yields average about 1,100 t km^-2-yr^-1. Water quality is generally adequate to support aquatic organisms, but physical habitat conditions are poor. Rehabilitation measures, which are selected and laid out using a subjective integration of hydraulic and geotechnical stability analyses, include grade controls, bank protection, and small reservoirs. Aquatic habitat studies indicate that stone-protected stilling basins below grade-control weirs and habitats associated with drop pipes and stone spur dikes are assets to erosion-damaged streams. Additional recovery of habitat resources using modified stone stabilization designs, woody vegetation plantings, and reservoir outlets designed to provide non-zero minimum flows is under investigation.     

Establishing aquatic restoration priorities using a watershed approach

Since the passage of the Clean Water Act in 1972, the United States has made great strides to reduce the threats to its rivers, lakes, and wetlands from pollution. However, despite our obvious successes, nearly half of the nation's surface water resources remain incapable of supporting basic aquatic values or maintaining water quality adequate for recreational swimming. The Clean Water Act established a significant federal presence in water quality regulation by controlling point and non-point sources of pollution. Point-sources of pollution were the major emphasis of the Act, but Section 208 specifically addressed non-point sources of pollution and designated silviculture and livestock grazing as sources of non-point pollution. Non-point source pollutants include runoff from agriculture, municipalities, timber harvesting, mining, and livestock grazing. Non-point source pollution now accounts for more than half of the United States water quality impairments. To successfully improve water quality, restoration practitioners must start with an understanding of what ecosystem processes are operating in the watershed and how they have been affected by outside variables. A watershed-based analysis template developed in the Pacific Northwest can be a valuable aid in developing that level of understanding. The watershed analysis technique identifies four ecosystem scales useful to identify stream restoration priorities: region, basin, watershed, and site. The watershed analysis technique is based on a set of technically rigorous and defensible procedures designed to provide information on what processes are active at the watershed scale, how those processes are distributed in time and space. They help describe what the current upland and riparian conditions of the watershed are and how these conditions in turn influence aquatic habitat and other beneficial uses. The analysis is organized as a set of six steps that direct an interdisciplinary team of specialists to examine the biotic and abiotic processes influencing aquatic habitat and species abundance. This process helps develop an understanding of the watershed within the context of the larger ecosystem. The understanding gained can then be used to identify and prioritize aquatic restoration activities at the appropriate temporal and spatial scale. The watershed approach prevents relying solely on site-level information, a common problem with historic restoration efforts. When the watershed analysis process was used in the Whitefish Mountains of northwest Montana, natural resource professionals were able to determine the dominant habitat forming processes important for native fishes and use that information to prioritize, plan, and implement the appropriate restoration activities at the watershed scale. Despite considerable investments of time and resources needed to complete an analysis at the watershed scale, the results can prevent the misdiagnosis of aquatic problems and help ensure that the objectives of aquatic restoration will be met.     

Fine‐Sediment Loadings to Lake Tahoe1

Abstract: Over the past 35 years, a trend of decreasing water clarity has been documented in Lake Tahoe, attributable in part to the delivery of fine‐grained sediments emanating from upland and channel sources. The overall objective of the research reported here was to determine the amount of fine sediment delivered to Lake Tahoe from each of the 63 contributing watersheds. The research described in this report used combinations of field‐based observations of channel and bank stability with measured and simulated data on fine‐sediment loadings to estimate fine‐sediment loadings from unmonitored basins throughout the Lake Tahoe Basin. Loadings were expressed in the conventional format of mass per unit time but also in the number of particles finer than 20 μm, the latter for future use in a lake‐clarity model. The greatest contributors of fine sediment happened to be those with measured data, not requiring extrapolation. In descending order, they are as follows: Upper Truckee River [1,010 tonnes per year (T/year)], Blackwood Creek (846 T/year), Trout Creek (462 T/year), and Ward Creek (412 T/year). Summing estimated values from the contributing watersheds provided an average, annual estimate of fine‐sediment (<0.063 mm) loadings to the lake of 5,206 T/year. A total of 7.79E + 19 particles in the 5‐20 μm fraction were calculated to enter Lake Tahoe in an average year with the Upper Truckee River accounting for almost 25% of the total. Contributions from Blackwood, Ward, Trout, and Third creeks account for another 23% of these very fine particles. Thus, these five streams making up about 40% of the basin area, account for almost 50% of all fine‐sediment loadings to the lake. Contribution of fine sediment from streambank erosion were estimated by developing empirical relations between measured or simulated bank‐erosion rates with a field‐based measure of the extent of bank instability along given streams. An average, annual fine‐sediment loading from streambank erosion of 1,305 T/year was calculated. This represents about 25% of the average, annual fine‐sediment load delivered to the lake from all sources. The two largest contributors, the Upper Truckee River (639 T/year) and Blackwood Creek (431 T/year), account for slightly more than 80% of all fines emanating from streambanks, representing about 20% of the fine sediment delivered to Lake Tahoe from all sources. Extrapolations of fine‐sediment loadings to the unmonitored watersheds are based on documented empirical relations, yet contain a significant amount of uncertainty. Except for those values derived directly from measured data, reported results should be considered as estimates.     

A PROGRAM TO CALCULATE CHANNEL SCOUR AND FILL1

ABSTRACT: A computer program written in BASIC calculates net changes in stream channel cross-sections. Calculations are based on dividing the channel cross-section into discrete regions of scour and fill. Internal boundaries of these regions (along the x-axis of the cross-section) are determined by the location of vertical depth measurements taken at two distinct times. The right and left boundaries of the cross-section can be specified so that scour or fill can be calculated for any portion of the profile desired.