共查询到20条相似文献,搜索用时 171 毫秒
1.
2.
3.
4.
《化工环保》2016,(2)
对模拟碳纤维生产废水进行"厌氧—好氧"静态小试,根据COD的去除效果确定该碳纤维废水的可生化性。采用"二级厌氧—微氧—好氧"组合工艺进行动态中试,考察废水的处理效果及系统的抗冲击性能。试验结果表明:该工艺对碳纤维生产废水的处理效果较好;系统具有厌氧池出水p H增大的特点,且抗冲击能力较强;在厌氧池水温为28~38℃、好氧池水温不低于15℃、废水流量为100 L/h、进水COD为660 mg/L、进水ρ(氨氮)为4.9 mg/L的条件下,出水COD稳定在50 mg/L以下,ρ(氨氮)稳定在5 mg/L以下,能够满足GB 8978—1996《污水综合排放标准》的要求。 相似文献
5.
6.
7.
将处理柠檬酸废水的内循环厌氧反应器的出水以不同比例回流至水解酸化池,研究了厌氧出水回流对水解酸化过程及厌氧处理过程的影响。实验结果表明:厌氧出水参与水解酸化能明显提高水解酸化池的出水pH及废水的预酸化度,厌氧出水添加比(V(厌氧出水)∶V(废水))为1∶4及以上时,可使水解酸化池的出水pH稳定在4.5以上,同时达到10.0%以上的预酸化度,且对NH3-N的去除能力明显增强;随水解酸化时间的延长,水解酸化池的出水pH先减小后增大,而预酸化度则呈上升趋势;水解酸化3.0 h时,厌氧出水COD降至1 200 mg/L以下。厌氧出水参与水解酸化能增强厌氧反应器中微生物对挥发性脂肪酸的利用率,提高厌氧反应器出水的pH,降低出水COD及其波动幅度,增强厌氧系统的稳定性及自我修复能力。 相似文献
8.
9.
气浮-水解-序批式活性污泥法处理高浓度特种丙烯酸废水 总被引:1,自引:1,他引:0
采用气浮—水解—序批式活性污泥法(SBR)处理高浓度特种丙烯酸废水,研究了投加生活污水对处理效果的影响及厌氧水解时间、SBR曝气时间、污泥负荷等因素对COD去除率的影响,结果表明,按1∶1体积比投加生活污水,厌氧水解时间2d,序批式活性污泥法曝气时间10h(进水后期曝气1h,共曝气11h),污泥负荷小于或等于0.08kg/(kg.d)时,出水COD小于85m g/L,满足处理要求。 相似文献
10.
厌氧条件下染料的生物降解性能与染料废水处理的研究 总被引:34,自引:3,他引:34
首先用间歇法对21种水溶性染料作了厌氧条件下生物降解性能试验,发现大部分染料在不同程度上是可厌氧降解的,只有两种氧杂蒽结构的染料例外。然后对5种阳离子染料和5种其它类型的染料作了连续试验,证实了间歇试验的结果。此外,对一种染料废水作了厌氧-好氧处理试验,得到了较满意的结果。 相似文献
11.
The degradation of cellulose (a substantial component of low- and intermediate-level radioactive waste) under alkaline conditions
occurs via two main processes: a peeling-off reaction and a basecatalyzed cleavage of glycosidic bonds (hydrolysis). Both
processes show pseudo-first-order kinetics. At ambient temperature, the peeling-off process is the dominant degradation mechanism,
resulting in the formation of mainly isosaccharinic acid. The degradation depends strongly on the degree of polymerization
(DP) and on the number of reducing end groups present in cellulose. Beyond pH 12.5, the OH- concentration has only a minor effect on the degradation rate. It was estimated that under repository conditions (alkaline
environment, pH 13.3-12.5) about 10% of the cellulosic materials (average DP = 1000-2000) will degrade in the first stage
(up to 105 years) by the peeling-off reaction and will cause an ingrowth of isosaccharinic acid in the interstitial cement pore water.
In the second stage (105-106 years), alkaline hydrolysis will control the further degradation of the cellulose. The potential role of microorganisms in
the degradation of cellulose under alkaline conditions could not be evaluated. Proper assessment of the effect of cellulose
degradation on the mobilization of radionuclides basically requires knowing the concentration of isosaccharinic acid in the
pore water. This concentration, however, depends on several factors such as the stability of ISA under alkaline conditions,
sorption of ISA on cement, formation of sparingly soluble ISA-salts, etc. A discussion of all the relevant processes involved,
however, is far beyond the scope of the presented overview. 相似文献
12.
Deepak Srivastava 《Journal of Polymers and the Environment》2004,12(1):27-33
Six film samples of low-density polypropylene (LDPE)/linear LDPE (LLDPE)/high-density polypropylene (HDPE) with varying ratios of LDPE (20–45 ... wt%) and LLDPE (25–50 wt%) having a fixed amount of HDPE at 30 wt% were prepared by blown film extrusion technique. The samples were aged at four different temperatures, 55°, 70°, 85°, and 100°C, for four different time periods in the interval of between 150 hours and up to 600 hours. The change in the structure of various constituents and the formation of various oxygenated (peroxy and hydroperoxy) and unsaturated groups during thermo-oxidative degradation was discussed by infrared spectroscopy. The visiosity-average molecular weight was found to have decreased slowly in the initial aging hours and temperatures, whereas it decreased by 10% with its previous value tensile strength that is, 100°C when aged for 600 hours. The tensile strength of the sample first increased by 67% at 55°C and 89% at 70°C up to 450 hours, whereas the values increased by 52.5% at 85°C and 33.9% at 100°C when aged for 150 hours and then decreased. The percentage elongation at break increased by 2.7% at 55°C and 10.7% at 70°C for 150 and 300 hours of aging, respectively, whereas the percentage decreased when aged at 85°C and 100°C for up to 600 hours of aging. The values of gel content (percent) increased and initial degradation temperature decreased with aging time and temperature. 相似文献
13.
J.L. Torero Stephen M. OlenickJ.P. Garo J.P. Vantelon 《Spill Science & Technology Bulletin》2003,8(4):379-390
The burning rate of a slick of oil on a water bed is characterized by three distinct processes, ignition, flame spread and burning rate. Although all three processes are important, ignition and burning rate are critical. The former, because it defines the potential to burn and the latter because of the inherent possibility of boilover. Burning rate is calculated by a simple expression derived from a one-dimensional heat conduction equation. Heat feedback from the flame to the surface is assumed to be a constant fraction of the total energy released by the combustion reaction. The constant fraction (χ) is named the burning efficiency and represents an important tool in assessing the potential of in situ burning as a counter-measure to an oil spill. By matching the characteristic thermal penetration length scale for the fuel/water system and an equivalent single layer system, a combined thermal diffusivity can be calculated and used to obtain an analytical solution for the burning rate. Theoretical expressions were correlated with crude oil and heating oil, for a number of pool diameters and initial fuel layer thickness. Experiments were also conducted with emulsified and weathered crude oil. The simple analytical expression describes well the effects of pool diameter and initial fuel layer thickness permitting a better observation of the effects of weathering, emulsification and net heat feedback to the fuel surface. Experiments showed that only a small fraction of the heat released by the flame is retained by the fuel layer and water bed (of the order of 1%). Ignition has been studied to provide a tool that will serve to assess a fuels ease to ignite under conditions that are representative of oil spills. Two different techniques are used, piloted ignition when the fuel is exposed to a radiant heat flux and flash point as measured by the ASTM D56 Tag Closed Cup Test. Two different crude oils were used for these experiments, ANS and Cook Inlet. Crude oils were tested in their natural state and at different levels of weathering, showing that piloted ignition and flash point are strong functions of weathering level. 相似文献
14.
S. Urstadt J. Augusta R. -J. Müller W. -D. Deckwer 《Journal of Polymers and the Environment》1995,3(3):121-131
Establishing carbon balances has been proven to be an applicable and powerful tool in testing biodegradability of polymers. In controlled degradation tests at a 4-L scale with the model polymer poly(-hydroxybutyrate) (PHB), it was shown that the degree of degradation could not be determined with satisfactory accuracy from CO2 release alone. Instead, the course of degradation was characterized by means of establishing carbon balances for the degradation of PHB withAcidovorax facilis and a mixed culture derived from compost. Different analytical methods for determining the different carbon fractions were adapted to the particular test conditions and compared. Quantitative determination of biomass and residual polymer were the main problems in establishing carbon balances. Amounts of biomass derived from protein measurements depend strongly on assumptions of the protein content of the biomass. Selective oxidation of biomass with hypochlorite was used as alternative, but here problems arose from insoluble metabolic products. Determination of soluble components with the method of chemical oxygen demand (COD) also includes empirical assumptions but seems acceptable if the dissolved carbon fraction is in the range of some 10% total carbon. Results confirm both analytical assays and theoretical approaches, in ending up at values very close to 100%, within an acceptable standard deviation range under test conditions comparable to standard test practice.Paper presented at the Bio/Environmentally Degradable Polymer Society—Third National Meeting, June 6–8, 1994, Boston, Massachusetts. 相似文献
15.
This article presents a mathematical model which describes the sodium chromate (VI) production process with the use of chromic waste as a substitution of natural raw materials. This model is a function of selected process parameters common for all of the examined alternatives and based on equations of material balance. Optimization of the elaborated technological alternatives of the production process with use of recycling of chromic waste has been evaluated by determining the extreme value of the quality indicator WJ. This indicator defines the quantity of waste created in the process. Optimization results enabled the selection of the optimal technological solution from all of the alternatives possible for use in industrial practice. Negative values of the indicator prove that there is the possibility of introducing to the process a larger quantity of waste than the one obtained in the process and transported to the storage heaps. 相似文献
16.
17.
18.
Methyleneureas are condensation products of urea and formaldehyde of different molecular mass and solubility; they are used in large amounts both as resins, binders, and insulating materials for industrial applications, as well as a slow-release nitrogen fertilizer for greens, lawns, or in bioremediation processes. In the present study, the microbial breakdown of these products was investigated. The nitrogen was released as ammonia and urea, and the formaldehyde released immediately oxidized via formiate to carbon dioxide. The enzymatic mechanism of metabolization of methyleneureas was studied in microorganisms isolated from soil, which were able to use these compounds as the sole source of nitrogen for growth. A strain of the Gram-negative bacterium Ralstonia paucula (formerly Alcaligenes sp. CDC group IVc-2) completely degraded methylenediurea and dimethylenetriurea to urea, ammonia, formaldehyde, and carbon dioxide. The enzyme initiating this degradation (methylenediurease) was purified and turned out to be different from the previously described enzyme from Ochrobactrum anthropi with regard to its regulation of expression and physicobiochemical properties. Fungal degradation of methyleneureas may occur via the formation of organic acids, thus leading to a nonenzymatic degradation of methyleneureas, which are unstable under acidic conditions. 相似文献
19.
M. van der Zee J. H. Stoutjesdijk P. A. A. W. van der Heijden D. de Wit 《Journal of Polymers and the Environment》1995,3(4):235-242
The biodegradability of oxidized starch and inulin has been studied in relation to the degree of periodate oxidation to dialdehyde derivatives, by measuring oxygen consumption and mineralization to carbon dioxide. A higher degree of oxidation of dialdehyde starch and dialdchyde inulin results in a lower rate at which the polymers are biodegraded. It is demonstrated that the biodegradation rate of dialdehyde inulin derivatives decreases more than that of equivalent starch derivatives. The differences in biodegradation behavior between dialdehyde starch and dialdehyde inulin, resulting from comparable modifications, are discussed in terms of conformational structure. 相似文献
20.
Arvind Viswanathan 《Journal of Polymers and the Environment》1999,7(4):185-190
Octenyl succinate starch of degree of substitution (ds) 0.03, 0.07, and 0.11 was synthesized in an aqueous medium. These compounds were then tested for the susceptibility to enzymatic degradation. The multiple-enzyme regime of -amylase, amyloglucosidase, and pullulanase was chosen for the evaluation. This combination of enzymes had been proven to degrade 99.5% of unmodified starch to glucose and hence was chosen for this study. It was found that even small amounts of subsituent caused a considerable decrease in the extent of degradation. The net extent of degradation decreased with increasing ds. Surprisingly, the amount of glucose from all three substituted substrates was quite similar, suggesting the effect small amounts of subtituent had on the enzymatic activity. 相似文献