亚铵法制浆造纸厂中段废水处理技术分析研究

通过对采用两级气浮做预处理 ,生物硫化床串联接触氧化做深度处理的治理技术的分析研究 ,结合废水处理工程实例 ,说明了用两级串联气浮 +硫化床 +接触氧化工艺处理造纸中段水技术切实可靠 ,该治理工艺对处理亚铵法麦草制浆造纸中段废水有较强的针对性和可行性。     

化学絮凝-气浮工艺在处理高浓度CTMP制浆造纸废水中的应用

叙述了化学絮凝--气浮处理高浓度CTMP制浆造纸废水工艺及其二段废水排放.实际运行表明,该工艺处理效率高,出水水质稳定,二段废水进入龙岩市污水处理厂与城市生活污水混合,集中处理后达标排放,取得了较好的社会效益和经济效益.     

造纸废水治理投资效益及废物综合利用

介绍了一种造纸废水混凝－氧化处理新技术，其工艺合理、简易可行，治理投资可降低60％以上，运行费用降低50％。     

二噁英类物质CALUX报告基因法在造纸行业的应用探究

选择典型造纸厂,采用化学激活报告基因法(CALUX)测定造纸过程中废水和纸浆中的二噁英类物质,并将部分样品测定结果与高分辨气相色谱-高分辨质谱(HRGC-HRMS)法测定结果作线性回归,换算系数为0.21,表明CALUX可用于造纸行业废水中二噁英类物质的快速筛查。将CALUX用于测定造纸厂废水中二噁英类物质,结果表明用含元素氯的漂白工艺会产生大量二噁英类物质,其中漂白废水中的目标物毒性当量浓度最高,经处理后可达到国家排放标准;而用无元素氯的漂白工艺,二噁英类物质的产生量会大幅降低。     

造纸黑液的回收与综合利用

本文详细分析了造纸黑液的特性，介绍了造纸黑液废水常用的处理方法及造纸黑液废水的回收利用。     

造纸废水的处理技术及研究进展

文章简述了国内外造纸废水常用处理方法,并对各种方法进行了评价和分析.介绍了处理造纸废水的新技术,以及可行性和发展前景.     

造纸废水治理技术可行性分析

自行研究开发了一种造纸废水混凝一氧化处理新技术，并对该技术治理造纸废水的可行性进行了全面论证、分析、评价。     

上海部分城市污水处理厂现状调查

对上海市部分城市水污水处理厂的工艺特点，处理能力，污染物去除率，废水排放达标率进行了调查与分析，指出，必须加强对城市污水处理厂的监督监测，并就污水处理厂的建设，改造提出了一些建议。     

造纸废水中硫化物的测定

我国造纸行业和一些环保部门,多年来一直采用醋酸锌—过滤—碘量法测定造纸废水中的硫化物。但测定值严重偏高。近年来一些环境监测部门以酸化吹气前处理代替沉淀—过滤前处理大大减小测定误差。但当废水中含有酸性条件下可挥发的还原物质如SO_2、R—SH、R—S—R等仍干扰碘量分析。SO_2浓度高于1毫克/升时将干扰比色分析。     

二沉池设计在印染污水处理中的应用

以南通三喜织染有限公司污水处理改造工程为例，阐述生物氧化，挂膜接触和活性污泥回流的复式好氧工艺，增设二沉池、均质、均量池、池底污泥回流，增加生物量，提高生化法处理染色污水的效果．     

城市空气质量周报效用分析

介绍了世界上一些发达国家的空气污染预报的做法和采取的措施,阐述了我国开展空气质量预报的方针和方法,指出了周报是预报的基础工作。叙述了我国空气质量周报的污染参数的选取、污染指数的分级及其浓度限值和污染指数计算及确定,分析并总结了开展城市空气质量周报所发挥的效用是提高公众的环保意识,加大了治理污染的力度,转变了环境监测的职能,促进了环境监测事业的发展     

锅炉烟尘测试中锅炉负荷率的计算方法探讨

GB5468 -91规定 ,锅炉烟尘测试时 ,必须对锅炉的运行负荷进行测试 ,而实际监测过程中 ,许多锅炉房不具备测试的计量条件 ,为了解决这一问题 ,文章提出利用烟气量和空气过剩系数计算锅炉负荷率。在实际监测工作中 ,该方法方便、易于操作 ,所得结果和标准规定方法所得结果有很好的一致性     

水中总硬度测量不确定度的评定

采用EDTA滴定法测定水质总硬度的测量不确定度评定。充分考虑测量重复性、标准溶液的配制、滴定等过程对测量的影响,计算水中总硬度的测量相对合成标准不确定度为1·81×10-3。     

实验室质量管理体系内部审核的实施

在实施GB/T15481-2000 idt ISO/IEC17025:1999标准《检测和校准实验室能力的通用要求》的过程中,通过实验室质量管理体系内部审核的实践与系统分析,识别出内部审核实施阶段的关键环节,提出召开首次会议、收集审核证据、确定审核发现和召开末次会议的技术方法,对提高内部审核的质量和有效性、获得可靠的审核结论具有重要意义。     

Fractionation of heavy metals and assessment of contamination of the sediments of Lake Titicaca

Chemical weathering is one of the major geochemical processes that control the mobilization of heavy metals. The present study provides the first report on heavy metal fractionation in sediments (8–156 m) of Lake Titicaca (3,820 m a.s.l.), which is shared by the Republic of Peru and the Plurinational State of Bolivia. Both contents of total Cu, Fe, Ni, Co, Mn, Cd, Pb, and Zn and also the fractionation of these heavy metals associated with four different fractions have been determined following the BCR scheme. The principal component analysis suggests that Co, Ni, and Cd can be attributed to natural sources related to the mineralized geological formations. Moreover, the sources of Cu, Fe, and Mn are effluents and wastes generated from mining activities, while Pb and Zn also suggest that their common source is associated to mining activities. According to the Risk Assessment Code, there is a moderate to high risk related to Zn, Pb, Cd, Mn, Co, and Ni mobilization and/or remobilization from the bottom sediment to the water column. Furthermore, the Geoaccumulation Index and the Enrichment Factor reveal that Zn, Pb, and Cd are enriched in the sediments. The results suggest that the effluents from various traditional mining waste sites in both countries are the main source of heavy metal contamination in the sediments of Lake Titicaca.     

“湖泛”恶臭物质分析及来源浅析

介绍了中国南方"湖泛"中的恶臭物质及检测情况,采用常规分析和气相色谱-质谱(GC-MS)对"湖泛"水样进行检测,认为"湖泛"恶臭物主要是氨和硫醚类物质。根据"湖泛"发生的时间及频次,结合南方地区农业水稻秧田的农药使用情况,推断氨基甲酸酯类农药的使用可能是"湖泛"发生的诱因。     

贵州黔东南州三板溪水库春季拟多甲藻水华特征

2011年3月13日对贵州省黔东南州三板溪水库进行春季浮游植物调查的结果表明,三板溪水库Ⅱ号采样点(下革东)发生以佩纳形拟多甲藻为优势种的拟多甲藻水华,细胞密度高达1.15×10⁷cell/L;板溪水库总氮的最低值为2.09 mg/L,总磷的最低值为0.95 mg/L,三板溪水库的总氮、总磷含量较丰富,不存在总氮或总磷是限制性因子;通过SPSS16.0统计软件分别进行Pearson 积距相关系数分析表明,氮磷比是三板溪水库发生拟多甲藻水华的主要影响原因。     

Environmental Assessment of the Impact of Ozone to the Neuston of the Sea-Surface Microlayer of the Gulf of Mexico

Substantial amounts of NOx (146 000 t/y) and total hydrocarbons (294 000 t/y) are released to the marine atmosphere by the large number of oil and gas operations over Federal waters of the Gulf of Mexico (GOM). Under appropriate meteorological conditions these emissions react to form ozone (0–54 g/m3 over-water) which can affect the marine environment. Using a dry deposition model, this work examines the amount of ozone derived from oil and gas offshore operations and deposited in the sea surface of the Gulf of Mexico, and assesses its impact on the neuston of the sea-surface microlayer. Surface integrated estimates of ozone deposited from oil and gas operations over the sea surface ranges from 400 kg to 1800 kg which results in sea surface concentrations of 15 g/m3. This estimate and the actual toxic ozone levels suggest no acute, toxic impacts to the neuston. However, indirect effects may occur through changes to the pelagic foodwebs and organic carbon pathways. Another potential pathway for ozone impacting the environment is through the production of bromate. Based on the concentrations and time scales (11–139 days) only sublethal effects appear to occur, but uncertainties associated with this assessment need to be further studied. From an ecological perspective, the environmental impacts and risks of NOx and VOC discharges from offshore platforms need to be assessed for neuston and other components of the marine ecosystem.     

Evaluation of method of preparation of passive diffusion tubes for measurement of ambient nitrogen dioxide

This study was carried out in response to suggestions that the measurement of NO(2) by Palmes-type passive diffusion tubes (PDT) is affected by the method of preparation of the triethanolamine (TEA) absorbent coating on the grids. The following combinations of factors were investigated: TEA solvent (acetone or water), volume composition of TEA in solvent (50% or 20%), and grid coating method (dipping in solution prior to assembly or pipetting solution on after assembly). Duplicate PDTs prepared by each of the 8 methods were exposed in parallel, in urban air, for a total of 80 separate 1 week exposures. NO(2) concentrations derived from PDTs prepared by pipetting methods were significantly less precise than concentrations from dipping methods, with mean RSDs for duplicate measurements of 13.8% and 8.5%, respectively (n= 316 each category). Pipetting methods using solutions of 50% TEA composition were particularly imprecise (mean RSD 17.2%). Data from PDTs prepared by pipetting methods were systematically more poorly correlated with each other and with data from co-located chemiluminescence analysers, than corresponding data from PDTs prepared by dipping methods, indicating that more consistent accuracy was also obtained by the latter PDTs. The statistical evidence suggested that PDTs prepared by pipetting 50% TEA in water generally gave lower NO(2) concentrations. Although this is in agreement with a previous study, it is also possible that such an observation here may be a statistical artefact given the demonstrably poorer precision of this method. The general tendency of PDTs to show positive bias in NO(2) measurement in urban air in 1 week exposures was again evident in this study (mean biases at roadside and urban centre locations of +35% (n= 475) and +18% (n= 112), respectively) consistent with augmentation of within-tube NO(2) flux by chemical reaction between co-diffusing NO and O(3). Overall, it is recommended that the pipetting method of PDT grid preparation is avoided, or at least investigated further, because of the apparent degradation in precision and accuracy of NO(2) measurement. Potential reasons for the effect are discussed.     

实验室质量管理体系内部审核的策划

在实施GBT15481-2000(idtISOIEC17025:1999)标准《检测和校准实验室能力的通用要求》的过程中,通过实验室质量管理体系内部审核的实践与系统分析,识别出内部审核策划阶段的关键环节,提出审核范围确定、审核计划和抽样方案制订的技术方法,为有序高效地实施内部审核提供了行动指南。