In situ immobilization of cadmium in soil by stabilized biochar-supported iron phosphate nanoparticles

The potential for nanoscale phosphate amendments to remediate heavy metal contamination has been widely investigated, but the strong tendency of nanoparticles to form aggregates limits the application of this technique in soil. This study synthesized a composite of biochar-supported iron phosphate nanoparticle (BC@Fe₃(PO₄)₂) stabilized by a sodium carboxymethyl cellulose to improve the stability and mobility of the amendment in soil. The sedimentation test and column test demonstrated that BC@Fe₃(PO₄)₂ exhibited better stability and mobility than iron phosphate nanoparticles. After 28 days of simulated in situ remediation, the immobilization efficiency of Cd was 60.2 %, and the physiological-based extraction test bioaccessibility was reduced by 53.9 %. The results of sequential extraction procedures indicated that the transformation from exchangeable (EX) Cd to organic matter (OM) and residue (RS) was responsible for the decrease in Cd leachability in soil. Accordingly, the pot test indicated that Cd uptake by cabbage mustard was suppressed by 86.8 %. Compared to tests using iron phosphate nanoparticles, the addition of BC@Fe₃(PO₄)₂ to soil could reduce the Fe uptake of cabbage mustard. Overall, this study revealed that BC@Fe₃(PO₄)₂ could provide effective in situ remediation of Cd in soil.     

Bioaccumulation of cadmium by the freshwater isopod Asellus aquaticus (L.) from aqueous and dietary sources

Experiments were conducted to determine the kinetics and relative importance of aqueous and dietary uptake of cadmium by the freshwater isopod Asellus aquaticus (L.). Test animals were exposed during 30 days to aqueous Cd in a continuous flow system (exposure levels: 0.2 - 10 microg litre(-1)) and kept on a diet of previously contaminated Elodea sp. (range of Cd concentrations: 2-350 microg g(-1), dry weight). Preceding semi-static experiments on dosage-control of the dietary factor revealed a rapid uptake of Cd by Elodea, with relatively high concentration factors (CF), which ranged from 4.8 to 5.5 (dry weight log (CF) after 16 days). For Asellus uptake from water appeared to be the predominant route. Highly significant bioconcentration of cadmium from water was observed in the animals, even at exposure levels below 1.0 microg litre(-1). In the various treatments, direct uptake from water accounted for 50-98% of the body burdens after 30 days exposure. The experimental results were described with a first order one-compartment bioaccumulation model. Model parameter estimates (mean +/- standard error) were obtained for rate constant of uptake (560 +/- 110 day(-1)), rate constant of elimination (0.032 +/- 0.017 day(-1)) and assimilation efficiency of Cd uptake from food (1.1 +/- 0.7%). The (dry weight) bioconcentration factor (BCF) and bioaccumulation factor (BAF) for extrapolated steady state conditions were estimated at 18 000 (BCF) and 0.08 (BAF). Experiments conducted at two different pH levels (5.9 versus 7.6) revealed no significant effects of pH on the uptake of aqueous Cd by the isopods. The results are discussed in relation to their potential significance to the field situation.     

In situ experimental study of carbon monoxide generation by gasoline-powered electric generator in an enclosed space

On the basis of currently available data, approximately 97% of generator-related carbon monoxide (CO) fatalities are caused by operating currently marketed, carbureted spark-ignited gasoline-powered generators (not equipped with emission controls) in enclosed spaces. To better understand and to reduce the occurrence of these fatalities, research is needed to quantify CO generation rates, develop and test CO emission control devices, and evaluate CO transport and exposure when operating a generator in an enclosed space. As a first step in these efforts, this paper presents measured CO generation rates from a generator without any emission control devices operating in an enclosed space under real weather conditions. This study expands on previously published information from the U.S. Consumer Product Safety Commission. Thirteen separate tests were conducted under different weather conditions at half and full generator load settings. It was found that the CO level in the shed reached a maximum value of 29,300 +/- 580 mg/m3, whereas the oxygen (O2) was depleted to a minimum level of 16.2 +/- 0.02% by volume. For the test conditions of real weather and generator operation, the CO generation and the O2 consumption could be expressed as time-averaged generation/consumption rates. It was also found that the CO generation and O2 consumption rates can be correlated to the O2 levels in the space and the actual load output from the generator. These correlations are shown to agree well with the measurements.     

In situ modification of an aquifer material by a cationic surfactant to enhance retardation of organic contaminants

Sorption of hexadecyltrimethylammonium chloride (HDTMA), a cationic surfactant, on aquifer material from Columbus AFB, Mississippi, U.S.A., was examined. Transport studies using flow-through columns and a box model aquifer showed that an almost stationary zone of HDTMA-modified aquifer material could be produced in situ without a significant decrease in hydraulic conductivity.Perchloroethylene (PCE) and naphthalene sorption isotherms on the HDTMA-modified aquifer material were linear, and sorption coefficients were increased by over two orders of magnitude relative to the unmodified material. The retardation of PCE by insitu emplaced HDTMA zones within a column was examined. Agreement between batch- and column-derived sorption coefficients and breakthrough curve symmetry indicates that local equilibrium was attained. Significant retardation of a naphthalene plume by an in situ emplaced surfactant zone was demonstrated in the box model aquifer system.The experimental results indicate that it is feasible to create in situ a sorbent zone within an aquifer using cationic surfactants. In most situations, the sorbent zone concept needs to be coupled with contaminant degradation processes for sorbent emplacement to be a practical tool in the remediation of groundwater contamination sites. Sorbent zones may be of benefit in the engineering of suitable environments for microbial or abiotic degradation reactions and by providing time slow reactions to occur.     

Enhanced phytoremediation of PAHs-contaminated soil from an industrial relocation site by Ochrobactrum sp.

Environmental Science and Pollution Research - Nowadays, the remediation of polycyclic aromatic hydrocarbons (PAHs)-contaminated soil has received wide attention. In this work, Ochrobactrum sp....     

In situ bioelectrokinetic remediation of phenol-contaminated soil by use of an electrode matrix and a rotational operation mode

In situ bioremediation is a safe and cost-effective technology for the cleanup of contaminated sites, but its remediation rate is usually very slow. This study attempted to accelerate the process of bioremediation by employing non-uniform electrokinetic transport processes to mix organic pollutants and degrading bacteria in soils under in situ conditions (namely, in situ bioelectrokinetic remediation) by use of an electrode matrix and a rotational operation mode. A bench-scale non-uniform electrokinetic system with periodic polarity-reversal was developed for this purpose, and tested by using a sandy loam spiked with phenol as a model organic pollutant. The results demonstrated that non-uniform electrokinetic processes could enhance the in situ biodegradation of phenol in the soil, the efficiency of which depended upon the operational mode of the electric field. Compared with the unidirectional operation and the bidirectional operation, the rotational operation could effectively stimulate the biodegradation of phenol in the soil if adopting appropriate time intervals of polarity-reversal and electrode matrixes. A reversal interval of 3.0 h and a square-shaped electrode matrix with four electrode couples appeared appropriate for the in situ biodegradation of phenol, at which a maximum phenol removal of 58% was achieved in 10d and the bioremediation rate was increased about five times as compared to that with no electric field applied. The results also showed that adopting a small polarity-reversal interval and an appropriate electrode array could produce a high and uniform removal of phenol from the soil. It is believed that in situ bioelectrokinetic remediation holds the potential for field application.     

In situ biodegradation determined by carbon isotope fractionation of aromatic hydrocarbons in an anaerobic landfill leachate plume (Vejen,Denmark)

Concentrations and isotopic compositions (13C/12C) of aromatic hydrocarbons were determined in eight samples obtained from the strongly anoxic part of the leachate plume downgradient from the Vejen Landfill (Denmark), where methanogenic, sulfate-reducing and iron-reducing conditions were observed. Despite the heterogeneous distribution of the compounds in the plume, the isotope fractionation proved that ethylbenzene and m/p-xylene were subject to significant biodegradation within the strongly anoxic plume. The isotope fractionation factors (alphaC) for the degradation of the m/p-xylene (1.0015) and ethylbenzene (1.0021) obtained from the field observations were similar to factors previously determined for the anaerobic degradation of toluene and o-xylene in laboratory experiments, and suggest that in situ biodegradation is one major process controlling the fate of these contaminants in this aquifer. The isotope fractionation determined for 1,2,4-trimethylbenzene and 2-ethyltoluene suggested in situ biodegradation; however, the isotopic composition did not correlate well with the respective concentration as expressed by the Rayleigh equation. Some other compounds (1,2,3-trimethylbenzene, o-xylene, naphthalene and fenchone) did not show significant enrichments in delta13C values along the flow path. The compound concentrations were too low for accurate isotope analyses of benzene, toluene, 1- and 2-methylnaphthalene, while interferences in the chromatography made it impossible to evaluate the isotopic composition for 4-ethyltoluene, 1,3,5-trimethylbenzene and camphor.In addition to demonstrating the potential of assessing isotopic fractionation as a means for documenting the in situ biodegradation of complex mixtures of aromatic hydrocarbons in leachate plumes, this study also illustrates the difficulties for data interpretation in complex plumes and high analytical uncertainties for isotope analysis of organic compounds in low concentration ranges.     

In situ biomonitoring of the genotoxic effects of mixed industrial emissions using the Tradescantia micronucleus and pollen abortion tests with wild life plants: demonstration of the efficacy of emission controls in an eastern European city

Aim of the study was to monitor changes of genotoxic activity of urban air caused by an incinerator and a petrochemical plant in Tradescantia micronucleus (Trad-MCN) and pollen fertility assays with wild plants (Chelidonium majus, Clematis vitalba, Cichorium intybus, Linaria vulgaris, Robinia pseudoacacia). While in the first sampling period (1997-2000) significantly (on average 80%) more MN were found at the polluted site in comparison to controls from a rural area, no significant effects were observed during a later period (between 2003 and 2005). A similar pattern was observed in the pollen abortion assays in which the most pronounced effects were found in chicory and false acacia. The differences of the results obtained in the two periods can be explained by a substantial reduction of air pollution by use of new technologies. In particular the decrease of SO(2) emissions may account for the effects seen in the present study.