Sensitivity of the DERMA long-range Gaussian dispersion model to meteorological input and diffusion parameters

The Danish Emergency Response Model of the Atmosphere (DERMA) is described and applied to the first ETEX experiment. By using analysed low-resolution numerical weather-prediction data from the global model of the European Centre for Medium-range Weather Forecast (ECMWF) as well as higher-resolution data from two versions of the High Resolution Limited Area Model (HIRLAM), which are operational at the Danish Meteorological Institute (DMI), the sensitivity of DERMA to the resolution of meteorological data is analysed by comparing DERMA results with concentration measurements. Furthermore, the sensitivity to boundary-layer height and diffusion parameters is studied. These parameters include the critical bulk Richardson number, which is used to estimate the atmospheric boundary-layer height, the horizontal eddy diffusivity and the Lagrangian turbulence time scale. The parameters, which provide the best performance of DERMA, are 0.25 for the critical bulk Richardson number, 6×10³ m² s^-1 for the horizontal eddy diffusivity, and 3 h for the Lagrangian time scale. DERMA is much more sensitive to boundary-layer parameters when using high-resolution DMI-HIRLAM data than when using data of lower resolution from the ECMWF. Finally, the bulk Richardson number method of boundary-layer height calculation applied to DMI-HIRLAM data is verified directly against routine radiosondes released under the tracer gas plume. The boundary-layer height estimates based on analysed NWP model data agree well with observations, and the agreement deteriorates as a function of forecast length.     

Case study II: application of the divalent cation bridging theory to improve biofloc properties and industrial activated sludge system performance-using alternatives to sodium-based chemicals.

The objective of this study was to investigate the application of the divalent cation bridging theory (DCBT) as a tool in the chemical selection process at an activated sludge plant to improve settling, dewatering, and effluent quality. According to the DCBT, to achieve improvements, the goal of chemical selection should be to reduce the ratio of monovalent-to-divalent (M/D) cations. A study was conducted to determine the effect of using magnesium hydroxide [Mg(OH)2] as an alternative to sodium hydroxide (NaOH) at a full-scale industrial wastewater treatment plant. Floc properties and treatment plant performance were measured for approximately one year during two periods of NaOH addition and Mg(OH)2 addition. A cost analysis of plant operation during NaOH and Mg(OH)2 use was also performed. During NaOH addition, the M/D ratio was 48, while, during Mg(OH)2 addition, this ratio was reduced to an average of approximately 0.1. During the Mg(OH)2 addition period, the sludge volume index, effluent total suspended solids, and effluent chemical oxygen demand were reduced by approximately 63, 31, and 50%, respectively, compared to the NaOH addition period. The alum and polymer dose used for clarification was reduced by approximately 50 and 60%, respectively, during Mg(OH)2 addition. The dewatering properties of the activated sludge improved dewatering as measured by decreased capillary suction time and specific resistance to filtration (SRF), along with an increase in cake solids from the SRF test. This corresponded to a reduction in the volume of solids thickened by centrifuges at the treatment plant, which reduced the disposal costs of solids. Considering the costs for chemicals and solids disposal, the annual cost of using Mg(OH)2 was approximately 30,000 dollars to 115,000 dollars less than using NaOH, depending on the pricing of NaOH. The results of this study confirm that the DCBT is a useful tool for assessing chemical-addition strategies and their potential effect on activated sludge performance.     

An experimental ecotoxicological study and its application to the behavioural study of organic mercury (CH3HgCl) in the environment: influence of temperature and pH

Laboratory experiments were carried out to study the influence of temperature (24, 28 and 30 °C) and pH (1–10) on organic mercury (CH₃HgCl) transfer and accumulation in an experimental ecotoxicological model. We followed the evolution of CH₃HgCl in a basic model (water+air) by varying temperature and pH. In a second step, we completed the model by adding sediment and fish. We added CH₃HgCl to water at the beginning of each experiment which was repeated at least three times. Results demonstrated that mercury was released from methylmercury into the air regardless of water pH and its concentration in the air increased with increasing pH. By contrast, in presence of sediment, almost all the mercury was fixed onto the sediment and no mercury was traced in air or in water. Interestingly, in the presence of sediment, the life span of fish under methylmercury exposure lasted longer despite their higher mercury body level content at their death. These results indicate that water is a bad exposure indicator for aquatic pollution. In case of chronic pollution, sediments, fish and aquatic plants are more appropriate indicators.     

Case study I: application of the divalent cation bridging theory to improve biofloc properties and industrial activated sludge system performance-direct addition of divalent cations.

The objectives of this study were to examine the application of the divalent cation bridging theory (DCBT) to improve settling, dewatering, and effluent quality in pilot-scale reactors and a full-scale system treating an industrial wastewater. This was accomplished by lowering the monovalent-to-divalent (M/D) cation ratio by direct divalent cation addition. Research has shown that the M/D ratio is a potential indicator for settling and dewatering problems at wastewater treatment plants, and M/D ratios above 2 have been associated with poor settling, dewatering, and effluent quality. The M/D ratio of the wastewater in this study ranged from 6 to 20. The cations studied were calcium and magnesium. Results showed that the addition of calcium improved floc properties compared to control reactors with no calcium addition. The reductions in sludge volume index, effluent chemical oxygen demand (COD), and effluent total suspended solids (TSS) were approximately 35, 34, and 55%, respectively, when the M/D ratio was decreased to approximately 2:1. In addition, the cake solids from a belt filter press simulator increased by 72% and the optimum polymer dose required for conditioning was reduced by 70% in the reactor fed the highest calcium concentration when compared to control reactors with no calcium addition. The addition of calcium also decreased the negative effect of high filamentous organism numbers. In general, the addition of magnesium (Mg2+) had similar effects on effluent quality and dewatering properties, although some differences were measured. A full-scale test using calcium addition was performed. Measurements of effluent quality and floc properties were performed before, during, and after the calcium (Ca2+) addition period. The average M/D ratio during these periods was 6.2, 4.6, and 14.0, respectively. The addition of Ca2+ decreased the effluent five-day biochemical oxygen demand, effluent TSS, and effluent COD. The increased Ca2+ concentration also improved dewatering measured by a decrease in specific resistance to filtration and capillary suction time. Overall, the addition of divalent cations to the pilot- and full-scale activated sludge systems improved floc properties and the data fit well with the DCBT.     

等浓度配比法研究苯酚、硝基苯和问硝基苯胺对发光菌的联合毒性作用

分别测定了苯酚、硝基苯和间硝基苯胺对发光菌的单一毒性，以及等浓度配比和等毒性配比的二元及三元混合体系的联合毒性，采用相加指数法对其联合效应进行了评价。结果表明，等浓度比和等毒性比混合体系的联合作用结果一致：苯酚＋间硝基苯胺二元体系为协同作用，其他各体系为相加作用。为简化联合毒性实验方法，建议在研究相关系列化合物的联合毒性作用机制中，可采用等浓度配比方法。     

An experimental ecotoxicological study and its application to the behavioural study of organic mercury (CH3HgCl) in the environment: influence of temperature and pH

Laboratory experiments were carried out to study the influence of temperature (24, 28 and 30 °C) and pH (1–10) on organic mercury (CH₃HgCl) transfer and accumulation in an experimental ecotoxicological model. We followed the evolution of CH₃HgCl in a basic model (water+air) by varying temperature and pH. In a second step, we completed the model by adding sediment and fish. We added CH₃HgCl to water at the beginning of each experiment which was repeated at least three times. Results demonstrated that mercury was released from methylmercury into the air regardless of water pH and its concentration in the air increased with increasing pH. By contrast, in presence of sediment, almost all the mercury was fixed onto the sediment and no mercury was traced in air or in water. Interestingly, in the presence of sediment, the life span of fish under methylmercury exposure lasted longer despite their higher mercury body level content at their death. These results indicate that water is a bad exposure indicator for aquatic pollution. In case of chronic pollution, sediments, fish and aquatic plants are more appropriate indicators.     

An improved method to study the impact of pesticide sprays on small song birds

Abstract

Four test groups of small songbirds (Zebra Finch, Poephila guttata) were sprayed in a chamber with varying concentrations of fenitrothion. Exposure levels were assessed by monitoring air concentrations, deposits of the active ingredient (AI) on glass plates and droplets/cm² on Kromekote® cards. All indices of exposure were linearly correlated and the mean AI deposit on glass plates for the four groups tested were equivalent to 38, 51, 139 and 255 g/ha or 14%, 18%, 50% and 91% of the highest permissible emitted rate for broadscale forest spraying in Canada. Significant depression in body weights and brain acetylcholinesterase levels were noted only for the highest exposure group. Fenitrothion residues in blood were detectable only at the highest exposure level, and in liver at the two higher levels. Carcass and feather residues were much higher than those in blood and liver, and were detectable at all exposure levels but the residues did not increase linearly with exposure. For one of the spray groups, we were able to compute an equivalent acute oral dose based on matching acetylcholinesterase inhibition.     

An integrated tool to assess the role of new planting in PM10 capture and the human health benefits: A case study in London

The role of vegetation in mitigating the effects of PM₁₀ pollution has been highlighted as one potential benefit of urban greenspace. An integrated modelling approach is presented which utilises air dispersion (ADMS-Urban) and particulate interception (UFORE) to predict the PM₁₀ concentrations both before and after greenspace establishment, using a 10 × 10 km area of East London Green Grid (ELGG) as a case study. The corresponding health benefits, in terms of premature mortality and respiratory hospital admissions, as a result of the reduced exposure of the local population are also modelled. PM₁₀ capture from the scenario comprising 75% grassland, 20% sycamore maple (Acer pseudoplatanus L.) and 5% Douglas fir (Pseudotsuga menziesii (Mirb.) Franco) was estimated to be 90.41 t yr⁻¹, equating to 0.009 t ha⁻¹ yr⁻¹ over the whole study area. The human health modelling estimated that 2 deaths and 2 hospital admissions would be averted per year.