燃煤电厂砷排放控制技术研究进展

对煤中砷的赋存状态及煤在燃烧后砷的转化行为进行了分析,并分别从煤的物理洗选、抑制煤中砷元素的挥发、气态砷吸附剂和污控设备协同脱砷等方面,重点论述了国内外对燃煤电厂砷排放控制的最新研究进展。同时提出了控制砷排放的新思路,为今后脱砷技术的进一步研究指明了方向。     

电厂筒仓安全惰化保护装置的研制运用

贮煤筒仓的安全性能关系着电厂的安全运行,为解决筒仓可燃气体浓度增高而导致爆炸问题,可将惰性气体氮气通入筒仓内稀释和置换可燃气体。分析了电厂筒仓安全惰化保护系统的配置及运行情况,为电厂筒仓安全惰化保护装置设计和应用提供参考。     

燃煤电厂烟气中汞的排放与控制研究进展

对煤中微量元素的丰度和赋存状态进行了论述，综述了燃煤烟气中重金属汞的排放、形态转化及分布情况，并重点论述了燃煤烟气中汞的监测和控制方法的最新进展，分析了燃煤电厂在汞控制方面存在的主要问题，并结合我国国情提出了相关建议。     

对我国火电厂烟气自动监测系统应用情况的分析

本文对烟气自动监测系统在10个电厂的安装、运行情况进行了综合评述，针对引进系统作了详细地收资、调查。     

电站油炉改烧水煤浆技术在广东地区的应用

介绍了电站油炉改烧水煤浆技术的背景，对水煤浆技术，水煤浆的环保特性及其发展进行了综述，分析了广东地区已改烧水煤浆的燃油电厂的运行状况，并展望了该技术在广东地区的发展前景。     

顶进式搅拌器的校核与改进

对某电厂烟气脱硫工程所配顶进式搅拌器运行中出现的问题进行了分析,并提出对应的改进方案.     

山西火电厂燃料车间煤尘污染状况与治理

我省直属电厂有十四个,均以煤为燃料,其中除阳泉、恒山、长治等厂为链条炉外,其作均属煤粉炉,输煤系统大致相仿。煤尘源主要在碎煤机、皮带机转接处、卸煤装置及煤场等处。碎煤机运行时多为正压,     

输煤间水雾除尘对锅炉燃烧效率的影响

对某燃煤电厂地下卸煤间的测试结果表明，当燃煤全水分为11％时，即使不采取水雾除尘措施，卸煤间内粉尘浓度也可达到国家职业安全卫生标准，结合该电厂实测数据，应用计算机软件计算了燃煤全水分对锅炉燃烧效率的影响。     

2×600MW机组脱硫石膏亚硫酸钙含量超标原因分析及对策

石灰石—石膏湿法脱硫系统工艺复杂,影响石膏中亚硫酸钙含量的因素很多,各因素之间又相互作用。分析了某电厂2×600MW机组脱硫石膏亚硫酸钙含量超标的原因,在试验研究及系统改造的基础上指出了石灰石原料不合格是石膏品质变差的主要原因。应加强石灰石原料质量监督,以满足脱硫系统要求。     

燃煤电厂应对新标准的氮氧化物控制策略研究

介绍了我国燃煤电厂NOx排放标准及其控制技术发展状况,分析了NOx的排放现状及我国燃煤电厂NOx控制技术的特点及存在问题。结合新标准,提出在环境约束条件下效益―成本最大化的NOx控制策略。     

燃煤电厂汞排放控制技术研究

近年来,燃煤电厂烟气中的汞成为继SO2、NOx和烟尘之后又一公认的大气环境污染物,我国已正式立法控制燃煤电厂汞排放,这使得燃煤电厂汞排放技术的研究迫在眉睫。不同形态汞的理化性质不同,元素态汞（ Hg0）较之氧化态汞（Hg2＋）和颗粒态汞（Hgp）更难去除,因此,脱汞的前提是提高Hg0的氧化率。介绍并简单分析了目前国内外已有的汞排放控制技术：燃烧前控制（清洁燃煤发电技术）、燃烧中控制（煤基添加剂技术和炉膛喷射技术）,和燃烧后控制（利用现有的烟气控制设备协同控制）,并对我国脱汞技术发展方向提出了展望。     

模糊控制理论在湿法脱硫真空皮带脱水机滤布纠偏控制中应用

随着国家节能减排工作的不断深入,燃煤电站脱硫装置的投运容量已占全国燃煤机组的一半左右。靖远第二发电公司4×300MW机组脱硫装置自投运以来多次出现真空皮带脱水机滤布跑偏的现象,造成真空皮带过滤机停车及滤布撕裂等严重后果,影响脱硫装置的正常投运。介绍了通过引进先进的模糊控制理论应用于滤布纠偏控制,并对控制硬件进行相应的改造,成功地解决了靖远第二发电公司湿法脱硫真空皮带脱水机滤布纠偏控制中出现的问题。为燃煤电站湿法脱硫真空皮带脱水机滤布及其他行业相似工艺过程的纠偏控制提供参考。     

电厂燃煤过程中重金属污染及其控制技术研究

综述了燃煤重金属污染问题的严重性和污染途径，对燃煤重金属的种类和危害进行了论述，并重点阐述了国内外采取的控制措施，同时还指出了燃煤重金属污染研究中存在的问题及今后的研究方向。     

现代煤化工行业挥发性有机物管控问题分析

分析了现代煤化工行业存在的VOCs管控相关产业政策、标准要求与产业发展不匹配,泄漏检测与修复(LDAR)工作推进缓慢、VOCs排放量核算不准确和VOCs治理工作难开展等问题。提出如下建议:在LDAR工作方面,重新认识LDAR工作、源头控制和增加泄漏情况数据统计环节;在VOCs排放量核算方面,全面识别企业VOCs排放源项、准确收集VOCs核算所需参数和控制采样分析误差;在VOCs治理方面,尽快制定VOCs排放有关标准、识别VOCs管控重点和开发VOCs过程及末端治理技术。     

燃煤痕量元素转化、排放及控制的研究进展

综述了煤燃烧过程中痕量元素转化、排放规律及实用的控制技术,重点介绍了当前最受关注的汞排放控制技术,并反映了量子化学在燃煤痕量元素研究中的最新应用。分析了燃煤痕量元素研究存在问题及发展方向。     

Co-combustion of dried sewage sludge and coal in a pulverized coal boiler

More than 1.1 million tons of municipal and industrial sewage sludge is produced annually in Poland. Most of this sewage sludge is landfilled or used for recultivation and fertilization of soil. After accession of Poland to the EU, large investments are planned for wastewater treatment, so it is expected that the amount of sewage sludge produced in Poland will grow in the near future. It is well known that the combustion of sewage sludge is becoming a more and more popular utilization method of such waste. Unfortunately, the current situation in Poland makes it impossible to incinerate the sewage sludge because of a lack of incinerators. One possible solution for Poland is the co-firing of dried sewage sludge in existing coal-fired utility boilers. This article presents results of initial Polish industrial trials of dried municipal sewage sludge and hard coal co-combustion in an OP-230 pulverized coal boiler. Such a solution was shown to be technically viable and not to require changes to the existing technological system. Cocombustion of sewage sludge with coal in power plants seems to be the best solution for sludge utilization in the near future in Poland.     

Wastewater remediation using coal ash

 Small-scale domestic septic tanks discharge excess nutrients such as phosphorus and nitrogen, as well as pathogens, which can degrade local water supplies. Unfortunately, traditional chemical and physical treatments are not practicable for single-home dwellings. This work reports on a potentially attractive solution to protect local water supplies by using a low-cost industrial waste, coal ash, for contaminant removal. Coal ash is produced as a consequence of electric power generation. The majority of the ash is disposed of in landfills and surface impoundments, or stored on- or off-site, producing large hills or leveling valleys. Only a small portion of the ash is ever utilized, mainly by cement industries and road construction. For example, in Canada less than 25% is used. Therefore, if useful applications can be found, an opportunity exists to make better use of this waste material. Bench-scale laboratory experiments and full-scale field tests show that coal ash has the capacity to remove phosphorus from domestic waste water. The experimental and field data demonstrate that phosphate levels and calcium levels can be correlated, although not in a simple manner. In addition, the ash in packed beds removed total suspended solid (TSS), biological oxygen demand (BOD), ammonia nitrogen (NH₃—N), total Kjeldahl nitrogen (TKN), and E. coli. The removal of E. coli was close 100% in the cases studied. Received: May 20, 2002 / Accepted: October 5, 2002     

壳牌煤气化技术的应用前景分析

介绍了壳牌煤气化技术的工艺特点和发展现状,分析论述了分布式能源系统技术,将煤气化与分布式能源系统两种技术完美结合,是当今煤-电-化组合的优良模式.     

Influence of flue-gas desulfurization systems on coal combustion by-product quality at kentucky power stations burning high-sulfur coal

Two Kentucky power plants burning similar blends of high-sulfur western Kentucky and southern Indiana coal provide a unique opportunity to examine the variations in coal combustion by-products due to differences in the method of wet flue-gas desulfurization (FGD). One plant employed carbide lime-based scrubbing for two units and a dual-alkali process for the third unit. The second plant employed a Mississippian limestone from Kentucky for all four units. This study provides an example of optical and SEM petrographic techniques, supplemented by chemical analyses, applied to the study of, at least from the geologic perspective, non-traditional materials. The coal sources comprise a blend of high volatile C and B bituminous, high vitrinite (85–90%, mmf), high-sulfur (> 3%, dry) coals. The fly ash is dominated by glassy phases (70–80%) with about 5–10% spinel (predominately magnetite), 3–10% quartz, and 4–10% isotropic coke comprising the remaining portion of the ash. SEM observations indicate that the glassy particles exhibit a bimodal size distribution with sub-micron glass spheres and a population of larger (several 10s of microns) spheres. The bottom ash has higher proportions of spinels and mullite, with negligible carbon forms, compared to the fly ash from the same units. Fly ashes were observed to be lower in Fe and higher in Al, Si, and S compared to the bottom ashes. Carbide lime, a by-product of acetylene manufacture, soda ash, and limestone were the reagents used in the flue-gas desulfurization processes. The primary FGD by-product is a calcium sulfite slurry which is vacuum filtered and mixed with fly ash and, usually, lime, to form a stable product for disposal. The FGD by-products have some potential, as yet unrealized, for utilization.     

应用水煤浆洁净燃烧技术控制燃煤工业锅炉SO2污染--中国燃煤工业锅炉SO2污染综合防治对策(五)

研究了水煤浆洁净燃料及其在燃煤工业锅炉上控制SO2污染的应用。主要内容包括水煤浆洁净燃烧技术概况，生产方法、分类及其物理性能，燃烧系统的工艺过程及其技术性能，水煤浆锅炉的特点及经济效益。研究表明：水煤浆洁净燃烧技术燃烧效率高，燃尽率高，炉渣含碳量低，烟尘和SO2排放浓度低。水煤浆洁净燃烧技术是燃煤工业锅炉理想的替代技术。