Environmental audits of hazardous waste disposal and treatment facilities

Hazardous waste generators have a duty of care in ensuring that their wastes are disposed of in an environmentally acceptable manner. Increasingly, generators are being made liable for environmental damage at the site of a waste disposal contractor if their wastes have been accepted by that facility. An audit procedure is described, that permits generators to examine the performance of waste vendors and to assess their potential liability as a result of using the site. Post-audit decisions in estimating the degree of risk and selecting appropriate waste contractors are also discussed.The purpose of this paper is to guide the prospective auditor through the site assessment procedure, highlighting areas of particular concern in relation to present or future potential liabilities. The audit procedure that is described, applies to all types of waste disposal operations in all countries, since the principles of good waste management do not vary.     

Household, hotel and market waste audits for composting in Vietnam and Laos.

In Da Nang and Ha Long, Vietnam and in Vientiane, Laos, there was interest by local authorities in separating and composting waste in order to reduce environmental and health problems at the local landfills and to produce a soil conditioner for local agricultural use. To assist in the planning of composting projects, three studies were carried out to estimate waste quantities and composition. 1. A 9-day audit of waste from 45 vendors in a market in Vientiane, the capital of Laos. The total quantity of waste and the quantity in each of nine categories were estimated for each of six different types of vendors. 2. A 7-day audit of waste disposed by three hotels in the tourist area of Ha Long, Vietnam. Waste quantities were estimated in total, on a per guest basis, and in three main categories: compostables, recyclables and miscellaneous. 3. A 7-day audit of waste collected from 74 households in Da Nang, the fourth largest city in Vietnam. Waste from each household was separated into compostable and non-compostable waste. Over 60% of each waste source comprised compostable waste and this was considered significant enough to warrant further planning of composting operations.     

Hazardous waste incinerators under waste uncertainty: Balancing and throughput maximization via heat recuperation

Hazardous waste incinerators (HWIs) differ substantially from thermal power facilities, since instead of maximizing energy production with the minimum amount of fuel, they aim at maximizing throughput. Variations in quantity or composition of received waste loads may significantly diminish HWI throughput (the decisive profit factor), from its nominal design value. A novel formulation of combustion balance is presented, based on linear operators, which isolates the wastefeed vector from the invariant combustion stoichiometry kernel. Explicit expressions for the throughput are obtained, in terms of incinerator temperature, fluegas heat recuperation ratio and design parameters, for an arbitrary number of wastes, based on fundamental principles (mass and enthalpy balances). The impact of waste variations, of recuperation ratio and of furnace temperature is explicitly determined. It is shown that in the presence of waste uncertainty, the throughput may be a decreasing or increasing function of incinerator temperature and recuperation ratio, depending on the sign of a dimensionless parameter related only to the uncertain wastes. The dimensionless parameter is proposed as a sharp a’ priori waste ‘fingerprint’, determining the necessary increase or decrease of manipulated variables (recuperation ratio, excess air, auxiliary fuel feed rate, auxiliary air flow) in order to balance the HWI and maximize throughput under uncertainty in received wastes. A 10-step procedure is proposed for direct application subject to process capacity constraints. The results may be useful for efficient HWI operation and for preparing hazardous waste blends.     

Fractionation of phosphorus biowastes: characterisation and environmental risk

Phosphorus (P) fertilizer is essential for food production and is a limiting factor in crop yields. However, the role of P in the eutrophication of surface water has long been recognised. During recent years, the input of P from agriculture to surface waters has increased and has been the focus for strategies aimed at mitigating diffuse P losses. As not all forms of P have the same availability, it is important to know the main forms of phosphorus in biowastes, and hence to develop fractionation schemes. The standards, measurements, and testing (SMT) procedure for phosphorus fractionation in freshwater sediments, developed within the framework of the Standards, Measurements, and Testing Program of the European Commission, was applied to 15 biowastes used frequently in agriculture, to obtain total P, inorganic and organic P, apatite P, and non-apatite inorganic P. The Hedley method was applied to determine the water-soluble phosphorus (WSP) in all the biowastes. In addition, the aluminium, calcium, and iron concentrations were quantified and related to the WSP. The results confirm the applicability of the SMT protocol to all kinds of waste usually applied in agriculture. The SMT protocol revealed the existence of large amounts of inorganic P and non-apatite inorganic P, the most-available forms of P for all the biowastes. The comparison of the data for total P (SMT protocol) and WSP (Huang protocol) does not show a good linear relationship between these parameters. Instead, the relationship between [aluminium+calcium+iron] and WSP is a better indication of the availability of P.     

Nanoparticles: Their potential toxicity,waste and environmental management

This literature review discusses specific issues related to handling of waste containing nanomaterials. The aims are (1) to highlight problems related to uncontrolled release of nanoparticles to the environment through waste disposal, and (2) to introduce the topics of nanowaste and nanotoxicology to the waste management community. Many nanoparticles used by industry contain heavy metals, thus toxicity and bioaccumulation of heavy metals contained in nanoparticles may become important environmental issues. Although bioavailability of heavy metals contained in nanoparticles can be lower than those present in soluble form, the toxicity resulting from their intrinsic nature (e.g. their size, shape or density) may be significant. An approach to the treatment of nanowaste requires understanding of all its properties – not only chemical, but also physical and biological. Progress in nanowaste management also requires studies of the environmental impact of the new materials. The authors believe Amara’s law is applicable to the impact of nanotechnologies, and society might overestimate the short-term effects of these technologies, while underestimating the long-term effects. It is necessary to have basic information from companies about the level and nature of nanomaterials produced or emitted and about the expectation of the life cycle time of nanoproducts as a basis to estimate the level of nanowaste in the future. Without knowing how companies plan to use and store recycled and nonrecycled nanomaterials, development of regulations is difficult. Tagging of nanoproducts is proposed as a means to facilitate separation and recovery of nanomaterials.     

Concrete made with treated bottom ash: mechanical and environmental study

Journal of Material Cycles and Waste Management - This investigation evaluated the use of bottom ash in concrete. Two types of bottom ash powder were used: (1) Ground bottom ash (GBA) and (2)...     

循环经济与环境安全

20世纪90年代以来,随着可持续发展战略被普遍采纳,国际社会正把发展循环经济,建立循环型社会作为实现环境与经济协调发展的重要途径.发展循环经济就是节约资源、保护环境,探讨了发展循环经济对提高环境资源利用效率、优化环境资源配置的作用,提示了:循环经济是实现环境安全的根本保障.     

环境权与环境公益诉讼内在关系初探

论述了环境权理论与环境公益诉讼的联系:环境权与环境公益诉讼是互动的关系,实施环境公益诉讼是环境权的内在要求,环境权理论是环境公益诉讼的理论基础,环境公益诉讼是环境权的制度保障,建立环境公益诉讼制度是实现环境权的必由之路.     

The relationship between environmental management strategies and environmental compliance at Marine Corps installations

Environmental compliance requirements periodically impact the military's ability to use all installation resources. In response, environmental management strategies have been developed to ensure compliance and allow site closure. This study examines the relationship between environmental management strategies and environmental compliance at U.S. Marine Corps (USMC) installations via analysis of environmental compliance audit scores. Five environmental scores of interest from 1998 to 2004 audits—which include total compliance, total management, audit management, policy management, and training management—were subjected to statistical analysis. Results showed the USMC met environmental compliance and management standards, despite limited resources. High management strategy scores were moderately correlated with high total compliance scores. Total management scores improved over time, and noncompliance was most often associated with a lack of resources and plans. © 2006 Wiley Periodicals, Inc.     

Waste battery treatment options: Comparing their environmental performance

Waste consumer batteries are recycled using different routes based on hydrometallurgical and pyrometallurgical processes. Two hydrometallurgical and two pyrometallurgical treatment scenarios are compared starting from an average composition of Belgian waste batteries. The environmental performance is compared using life cycle analysis (LCA). The recycling rate is studied through mass balance calculation.Each treatment scenario results in a specific recycling rate. The environmental impact and benefits also vary between the treatment options. There is no such thing as a typical hydrometallurgical or pyrometallurgical treatment. When applying a hydrometallurgical treatment scenario, the focus lies on zinc and iron recycling. When allowing manganese recycling, the energy demand of the hydrometallurgical process increases considerably. Both pyrometallurgical options recycle zinc, iron and manganese. According to the LCA, none of the treatment scenarios performs generally better or worse than the others. Each option has specific advantages and disadvantages. The Batteries Directive 2006/66/EC sets out a recycling rate of 50% for consumer waste batteries. Based on metal recycling alone, the mass balances show that the target is difficult to obtain.     

Evaluation of material recycling for plastics: environmental aspects

“Zero emissions” is a concept envisaging the creation of a sustainable society with minimal disposal of resources. In order to realize zero emissions for plastics, it is important to establish a method for quantitatively evaluating candidate recycling processes. In this study, the principle of the substitution factor (SF) is introduced. A quantitative evaluation of the recycling process for plastics was then carried out. The production process for monofilament plastics was examined. The recycling of plastics discarded during the production process could be substituted in small amounts for virgin materials, giving reduced CO₂ emissions. Furthermore, production using recycled material mixed with virgin material was more effective in reducing CO₂ emissions than when recycled materials only were used. Received: November 19, 1999 / Accepted: November 28, 2000     

Urban observatories opportunities for environmental monitoring: solid wastes

Towns concentrate around 50% of world-wide population and the trend is oriented to underscore an urban profile of population. In addition, towns have become important for their economic contribution to the Gross Internal Product. The negative side of towns is the environmental and social impacts as a result of productive and domestic activities, besides the lack of available data. In order to overcome these shortcomings, the United Nations has established a project of urban monitoring throughout the Global Network of Urban Observatories; Mexico joined the project in 2005. The Local Urban Observatory of Mexicali has the task to produce information about cities that is useful to design public policies. Some of this information deals with a set of environmental indicators in the United Nations Habitat Agenda, which includes solid wastes. Therefore, this paper deals with two main topics; firstly, from the Habitat Agenda, a comparative urban analysis of waste production and coverage of domestic waste collection services; secondly, from the Local Agenda, the identification and ranking of environmental problems according to public perception coming from people involved in the municipal planning and decision making process. Results will be used to develop local indicators and public environmental policies.     

Regional material management and environmental protection

The goal of environmental protection is to prevent damage by early recognition of possible hazards. In the present paper, the potential of materials accounting techniques to forewarn of critical loadings on water, air and soil is assessed. For this purpose, the anthropogenic and natural contributions to the metabolism of a region are measured and estimated respectively. The control of man-made material fluxes to the environment is discussed with regard to a waste management concept based on sustainable fluxes of emissions and final storage quality of landfill materials. According to the results, regional material balances are powerful tools for integrated waste management: they allow the setting of priorities in waste management by identifying important material quantities and qualities, they are the base for the design and evaluation of waste treatment technologies, they are necessary for environmental impact statements, and they allow the recognition and minimization of the overall flux of materials from the anthroposphere to the environment.     

清洁生产与环境管理体系

通过对清洁生产和环境管理体系两个概念的比较，阐明了二者的异同和在企业生产与管理过程中将二者融合的可能性。     

Literature review: Electrodialytic remediation and potential environmental applications of oil fly ash

Oil fly ash (OFA) contains environmentally toxic heavy metal and substituted polycyclic aromatic hydrocarbons. This review discusses the physical and chemical properties of OFA and presents information from other types of fly ash that can be used as concepts for the remediation and uses of OFA. Electrokinetic remediation is useful to remove some of the heavy metals for broader uses of the fly ash in agriculture, for making construction material, for contaminated wastewater treatment, and also for carbon dioxide sequestration. This review can be useful to develop approaches for the remediation and environmental management of OFA. © 2012 Wiley Periodicals, Inc.     

Negotiating for assistance and cost control: Effectively interacting with environmental regulatory agencies

Regulatory agencies are involved in analysis of plans for, and results of, virtually every environmental site investigation and remediation project. Controlling the cost of such projects is largely dependent on arriving at a reasonable scope of work. Regulatory approval is heavily influenced by the approach, cooperation, level of expertise, communication skills, preparation, and diplomacy of those who interact directly with agency personnel. Agencies also can be sources of assistance in obtaining the cooperation of other responsible parties. This article discusses a practical approach to maximize assistance, cooperation, and collaboration from regulatory agencies.     

The environmental and biosecurity characteristics of livestock carcass disposal methods: A review

Livestock mortalities represent a major waste stream within agriculture. Many different methods are used throughout the world to dispose of these mortalities; however within the European Union (EU) disposal options are limited by stringent legislation. The legal disposal options currently available to EU farmers (primarily rendering and incineration) are frequently negatively perceived on both practical and economic grounds. In this review, we assess the potential environment impacts and biosecurity risks associated with each of the main options used for disposal of livestock mortalities in the world and critically evaluate the justification for current EU regulations. Overall, we conclude that while current legislation intends to minimise the potential for on-farm pollution and the spread of infectious diseases (e.g. transmissible spongiform encephalopathies, bacterial pathogens), alternative technologies (e.g. bioreduction, anaerobic digestion) may provide a more cost-effective, practical and biosecure mechanism for carcass disposal as well as having a lower environmental footprint. Further social, environmental and economic research is therefore warranted to assess the holistic benefits of alternative approaches for carcass disposal in Europe, with an aim to provide policy-makers with robust knowledge to make informed decisions on future legislation.