Noise generated by multiple-jet nozzles with conical profiles 287

Conical multiple-jet nozzles, which reduce the risk of nozzle openings being blocked, are tested for their effectiveness in noise reduction. Nozzles with different exit spacings are tested. It is found that the multiple-jet design significantly decreases noise levels in the audible range by shifting emitted sound power to higher and ultrasonic frequencies. No significant difference in noise characteristics between exits distributed on a flat plane and beveled exits on a conical surface is observed. When the exits are more densely distributed, there is a trend of spectra shifting back toward the low frequency. This phenomenon is found to increase sound levels in a certain range of frequencies much lower than the peak one. Although this increase contributes little to the total emitted sound power, it is an important factor in determining the sound levels of audible noise.     

Analysis of noise pollution in an andesite quarry with the use of simulation studies and evaluation indices

This paper presents the verification of two partial indices proposed for the evaluation of continuous and impulse noise pollution in quarries. These indices, together with the sound power of machines index and the noise hazard index at the workstation, are components of the global index of assessment of noise hazard in the working environment of a quarry. This paper shows the results of acoustic tests carried out in an andesite quarry. Noise generated by machines and from performed blasting works was investigated. On the basis of acoustic measurements carried out in real conditions, the sound power levels of machines and the phenomenon of explosion were determined and, based on the results, three-dimensional models of acoustic noise propagation in the quarry were developed. To assess the degree of noise pollution in the area of the quarry, the continuous and impulse noise indices were used.     

A study in hospital noise - a case from Taiwan.

Hospitals are places that allow patients to rest and recover, and therefore must be quiet inside and in the surrounding neighborhood. One medical center was chosen as a sample hospital. This hospital was a tertiary care center during the 2003 outbreak of the severe acute respiratory syndrome (SARS) in Taiwan. The measurement results show that the noise level in the wards and stations was between 50.3 and 68.1 dB which exceeded the suggested hospital ward sound level. The quietest units were the Surgical Intensive Care Unit and recovery rooms with a noise level lower than 50 dB during the night. The higher noise levels were in the hall and pharmacy which were highly populated areas. This study analyzed the causes of this excessive noise and used noise reduction methods. The paired t test was performed and the results showed improvement methods were successful. This study found the noise levels reached 98.5-107.5 dB in power generator rooms and air-conditioning facilities, and suggests employees use ear plugs.     

A global index of acoustic assessment of machines-results of experimental and simulation tests

A global index of machines was developed to assess noise emitted by machines and to predict noise levels at workstations. The global index is a function of several partial indices: sound power index, index of distance between the workstation and the machine, radiation directivity index, impulse and impact noise index and noise spectrum index. Tests were carried out to determine values of the global index for engine-generator; the inversion method for determining sound power level was used. It required modelling each tested generator with one omnidirectional substitute source. The partial indices and the global index were simulated, too. The results of the tests confirmed the correctness of the simulations.     

冷却塔的噪声特性与控制

以某小区冷却塔的噪声治理为例,通过对其噪声数据的测量,详细分析了冷却塔噪声的主要来源和特性,并从消声、吸声、隔声等方面阐述了一种实用的控制措施。结果表明,此方案不仅降噪效果明显,而且能够完全满足设备所需通风量和温度的要求,在工程实际过程中取得了良好的降噪效果。     

高海拔矿井风机气动噪声数值模拟及实验研究

为研究高海拔矿井风机气动噪声规律,建立小型轴流风机三维物理模型,利用CFD软件对环境气压分别为1,0.9,0.8,0.7,0.6及0.5 atm时的风机模型进行定常模拟、非定常模拟及噪声计算,并通过自主设计的压变实验装置对上述不同环境气压条件下风机转数分别为500,1 000,1 500和2 000 rpm时的风机噪声进行测试,分析风机叶片附近监测点噪声频谱曲线及压变环境风机噪声实验数据,结果表明:风机转数和环境气压是影响风机气动噪声的2个重要因素;环境气压P一定时,风机转数n越大,各频率下的风机气动噪声声压级SPL越大,且风机噪声总声压级Lp和平均声压级Lavg均随风机转数n的增大呈对数函数增加;风机转数n不变时,随着海拔高度的升高,环境气压P降低,各频段下风机气动噪声声压级SPL均将减小,且风机噪声总声压级Lp和平均声压级Lavg随环境气压值P的降低呈线性函数减小,环境气压每降低0.1 atm,二者分别降低1.47和1.29 dB。     

On Evaluation and Localization of Auditory Warning Devices for Adequate Audibility

This paper presents an analytic procedure to assist safety practitioners in evaluating the audibility of an existing auditory warning system in their workplaces. Two alarm location models are described: (a) a model with an unknown signal sound level, and (b) a model with a known signal sound level. A heuristic algorithm to determine a minimum number of alarm devices and their locations so that the warning signals can be clearly heard by workers is also proposed. The algorithm considers the ambient noise level, noise levels generated by individual machines, locations where workers are likely to be present, and noise levels at worker locations. From the numerical examples and the computation experiment, both the optimization and heuristic approaches yield solutions that satisfy the 15-dBA constraints. The heuristic approach is efficient in solving large alarm location problems due its capability to find near-optimal solutions within reasonable computation time.     

柴油发电机房的噪声控制技术

柴油发电机组是一种广泛使用的备用供电设备,机组引发的环境噪声污染问题日益得到重视.对某电信局紧急备用的柴油发电机组进行噪声频谱特性分析和周围环境状况的分析,针对性地提出吸声、隔声、消声、减振以及通风散热的治理措施.经过治理后,达到了环境噪声Ⅱ类区域排放标准的要求,同时也满足了柴油发电机组工作时的通风散热要求.     

坨一站稳定压缩机泵房噪声治理

根据油气集输泵站稳定压缩机泵房噪声污染的现状，提出了采用空间吸声体降低噪声和采用田声降低噪声的技术方案，分析了实施后的效果和推广应用前景。     

建筑工程中的噪声防治研究

介绍了建筑施工噪声的危害以及噪声的来源,通过在新加坡圣淘沙环球影视城工程中的噪声监测工作,着重介绍了不同时段和不同地段的噪声声级测量方法,掌握了施工区域内的噪声声级水平,根据测量结果分析给出了建筑施工中的噪声控制措施.     

空分站大型空压机组的噪声治理

介绍了洛阳分公司空压车间空分站大型空压机组的噪声治理,采用局部敞开式隔声罩隔音降噪,选用合适的吸声材料,效果明显.     

Determining Attenuation of Impulse Noise With an Electrical Equivalent of a Hearing Protection Device

Determining the effectiveness of impulse noise attenuation with hearing protection devices (HPDs) is an important part of their selection. Measuring impulse noise parameters under an HPD would involve exposing subjects to impulses with a high peak sound pressure level. This paper presents a computational method of determining impulse noise parameters under the cups of earmuffs. Calculations are done using the transfer function of earmuffs, determined with Shaw’s electrical equivalent of an HPD, taking into account the design parameters of earmuffs. The developed method was used for calculations in the presence of impulse noise generated by gunshots. To verify the computational method, the results of these calculations were compared with the results of measurements.     

铁路扩能改造工程声环境影响预测分析

以某铁路扩能改造工程项目为例,根据具体工况条件,采用模式预测法进行既有铁路噪声预测和验证,并利用验证的预测方法进行改造后铁路噪声影响预测。预测结果表明,与既有铁路实际监测值相比,改造后噪声值昼间降低0.4～3.4 dB(A),夜间降低2.0～4.8 dB(A),说明铁路电气化改造对沿线噪声敏感点的改善较为明显。     

武汉工业大学水泵房噪声治理

分析了水泵房噪声产生的机理,提出以隔声为主,辅以消声、吸声、绿化等综合治理措施,实现了治理达标目的。     

单兵用主动式听力保护技术研究现状分析

战场噪声是造成单兵听力损伤的重要原因,通常要求单兵处于大于85dBA的噪声环境中需佩戴听力保护装置。听力保护装置通常包括耳罩式和耳塞式。新型单兵用耳塞式听力保护装置具有听力保护、环境声音的监听、持续及脉冲噪声抑制、通信接入等多种功能。     

Noise variability in underground room and pillar coal mines

Noise in an underground coal mine has dominant components generated mainly from 3 sources: (a) continuous mining machines, (b) roof bolters, and (c) cars/vehicles used to transport personnel and/or coal. Each of these 3 noise sources also has a number of well-defined sub-sources with their own noise characteristics. Sound level meters were used to collect noise data in the form of instantaneous readings and also to check calibration of other sound measuring instruments. The most useful information was obtained from a spectrum analysis of continuous digital recordings of noise over time. This paper discusses the variability or dynamics of generated noise in both frequency and time domains in relation to several independent variables related to coal extraction and transportation processes.     

过滤材料声学性能的实验研究*

为探讨纤维过滤材料的吸声效果,扩展吸声材料的选择范围,并为噪声粉尘一体化控制提供指导,通过实验分析不同等级一般通风用纤维层滤料的过滤性能和吸声性能,研究叠加方式及空腔设置等对滤料吸声性能的影响。研究结果表明:一定条件下,滤料的过滤效率越高吸声性能越好;单层滤料吸声效果较差,通过多层叠加,可显著提升吸声效果,达到吸声材料水平;不同等级滤料组合叠加,按过滤效率降序排列整体吸声性能更好。滤料作为吸声材料应用时,在其后侧设置空腔可明显增强吸声效果;兼顾过滤和降噪时,考虑粗效对中效滤料的保护作用,可在粗效加中效滤料后再附加粗效滤料,达到在不显著增加阻力的同时改善吸声性能的目标。     

微穿孔板吸声结构设计参数研究进展

为推进健康城市防噪降噪工作,预防和减少噪声污染对人们健康产生的危害和不良影响,研究声学材料-微穿孔板吸声结构设计参数对降噪防噪的促进作用。首先,采用文献综述方法,以传统微穿孔板基本理论和基本特性为基础,根据国内外研究现状,按照改变板结构、微孔结构和空腔结构等设计参数进行分类;其次,分析不同改变方式对微穿孔板吸声性能的影响;最后,归纳总结可提升微穿孔板降噪功效的不同方法。研究结果表明:合理改变微穿孔板吸声结构设计参数是预防和改善噪声污染的有效方法,研究结果可为健康城市防噪降噪工作提供参考依据及理论支撑。     

城际铁路环境影响评价中道路交通噪声现状评价与预测

在统计某县公路类型、规模的基础上,选择代表性区段测试高速公路、国道、省道、县道、乡道、村道交通噪声影响状况,计算了达到不同声环境功能区的控制距离要求.研究结果表明,该县境内平均道路交通噪声水平昼间、夜间均可满足《声环境质量标准》(GB 3096-2008)中4a类声环境功能区标准要求.现状条件下若要达到1类声环境功能区...     

马钢第二烧结厂3号烧结机风机房噪声污染分析与对策

马钢二烧结厂对3号烧结机风机房噪声采取了隔声、消声等措施,有效地降低了噪声污染,使总声压级从97dB降至55dB,保护了职工的身体健康.