A Comparison of Various Sources of Automotive Emissions

Chlorinated phenolic hydrocarbons are used as intermediate chemicals in the manufacture of 2,4-D (2,4-Dichlorophenoxy-acetic Acid) and related herbicides. These chemicals have an unusual odor with an extremely low threshold level of detection and consequently the manufacture and handling of these compounds poses a difficult odor control problem. Chipman Chemical Company at its Portland, Oregon plant has developed a system of fume collection and caustic soda solution scrubbing capable of removing phenolic compounds in the plant exhaust air to an acceptable level from an odor release standpoint. This article describes the development, present status, and projected future improvements of this odor control system.     

Photodegradation of an azo dye of the textile industry

An advanced oxidation treatment, UV/H2O2, was applied to an azo dye, Hispamin Black CA, widely used in the Peruvian textile industry. Rates of color removal and degradation of the dye have been evaluated. A strongly absorbing solution was completely decolorized after 35 min of treatment, and after 60 min an 82% reduction of the total organic carbon (TOC) was obtained. It has been found that the degradation rate increased until an optimum value, beyond which the reagent exerted an inhibitory effect. The degradation rate was also function of pH.     

Feasibility of iron scraps for enhancing nitrification of domestic wastewater at low temperatures

Environmental Science and Pollution Research - The development of an effective approach to improve low-temperature nitrification of domestic wastewater remains an important issue that needs to be...     

The prediction of the numbers of violations of standards and the frequency of air pollution episodes using extreme value theory

Extreme value theory is discussed in a manner suitable for scientists working in the air pollution area. The method of application of the theory is described by means of an example analysis on an ozone data set and the theory is applied to several data sets collected in Brisbane, Queensland, Australia. The theory is used to predict the number of violations of WHO and U.S. standards expected in the year following data collection. Comparison of these predictions with the relevant observations shows that the theory does quite well. Ways of using extreme value theory as an air quality management tool are suggested.     

An integrated test strategy for the assessment of anaerobic biodegradability of wastewaters

The anaerobic biodegradability of wastewaters from different chemical plants was determined by an integrated test strategy consisting of an anaerobic toxicity test, a static anaerobic biodegradation test and a continuously operated fixed bed reactor test. This integrated procedure offered a useful tool for screening wastewaters for anaerobic biodegradability. Four different wastewaters were tested for anaerobic toxicity and biodegradability. One wastewater was used in subsequent testing in a fixed bed reactor which aimed to illustrate a potential design of an anaerobic treatment plant.     

Application of enzyme-mediated cellulose nanofibers from lemongrass waste for the controlled release of anticancer drugs

Environmental Science and Pollution Research - In the present study, an application of cellulose nanofibers has been established for the controlled release of an anticancer drug, i.e.,...     

Comparative study of microbial dechlorination of chlorinated ethenes in an aquifer and a clayey aquitard

In order to determine whether natural attenuation of chlorinated ethenes by microbial activity occurs in aquitards, sediments at a site contaminated with tetrachloroethene were vertically studied by drilling. The distribution of microbes (Dehalococcoides group and anaerobic hydrogen producers) and the ability of the sediments to sustain microbial dechlorination were determined in an aquitard as well as in an aquifer. Close-spaced sampling revealed the existence of large populations of Dehalococcoides and H(2)-producing bacteria, especially in the organic-rich clayey aquitard rather than in the aquifer. The vinyl chloride reductase gene was also detected in the clay layer. Furthermore, incubation experiments indicated that the clay sediment could sustain transformations of tetrachloroethene at least to vinyl chloride. In contrast, no significant transformation was observed in the aquifer sand. Our results indicate that dechlorination of tetrachloroethene by bacteria can take place in an organic-rich clayey aquitard, and that organic-rich clay may also be important in the natural attenuation in an adjacent aquifer, possibly supplying a carbon source or an electron donor.     

Application of photocatalysis as a post treatment method of a heterotrophic-autotrophic denitrification reactor effluent

The aim of this study is the application of photocatalysis as an effective post treatment scheme for the removal of the organic matter and bacteria released by an innovative biological denitrification process referred to as heterotrophic-autotrophic denitrification, which combines heterotrophic and autotrophic denitrification processes. Photocatalytic treatment was applied using TiO2 as a photocatalyst in the loading range of 0.25-2.00 g l(-1) for irradiation periods up to 60 min using a black light fluorescent lamp with an intensity of I(0)=1309 microW cm(-2). The photocatalytic inactivation data were modelled to pseudo first order kinetics as well as by the areal rates to evaluate the photocatalyst loading effect. Chlorination was used as a final disinfection step to attain an overall inactivation of total coliforms as well as to the formation of very low level of trihalomethanes.     

Innovative application of facile single pot green synthesized CuO and CuO@APTES nanoparticles in nanopriming of Vigna radiata seeds

Environmental Science and Pollution Research - Nanopriming is an emerging field of science which uses nanoparticles in solution to improve parameters of seed vigor. This leads to an initial...     

Combustion and thermal destruction of hexanes in the presence of inorganic and organic chlorine

Hexane was burned in an atmosphere containing an equal molar quantity of hydrogen chloride. Combustion characteristics and partial combustion products were compared to the combustion of pure 1-chlorohexane in air. The product distribution and burning properties were nearly identical.     

The effect of copper sulphate on some biochemical parameters of rainbow trout

Copper sulphate has an adverse effect on some biochemical parameters of trout Salmo gairdneri. The main targets of damage are: (a)Tissue necrosis as demonstrated by increased ASAT and ALAT levels in blood plasma. (b)Inhibition of acetylcholinesterase activity. There is also a general stress effect as reflected by an elevated blood glucose level.     

Removal of low concentrations of ammonium and humic acid from simulated groundwater by Vermiculite/Palygorskite mixture

Contaminants in water are classified into different types based on their physical and chemical properties. Thus, more than one type of sorbents may be needed for their removal. In this article, a combination of vermiculite with palygorskite was studied for their simultaneous removal of ammonium and humic acid from simulated groundwater. Batch results showed that the Langmuir model described ammonium adsorption well with an adsorption capacity of 22 mg/g while the humic acid adsorption data fitted to the linear adsorption better, suggesting different removal mechanisms of these two types of contaminants. Kinetic studies showed an instantaneous removal of ammonium and humic acid. A column packed with mixture of equal volumes of vermiculite and palygorskite could treat 100 pore volumes for ammonium removal at an initial concentration of 10 mg/L and 500 pore volumes for humic acid removal at an initial concentration of 20 mg/L before the effluent concentrations exceeded the standard.     

Waterborne agrichemicals compromise the anti-predatory behavior of zebrafish

Environmental Science and Pollution Research - Due to human activities, there is an increasing presence of agrochemicals residues in water bodies, which could be attributed to an increased use of...     

The Application of the Karl Fischer Oven for the Determination of Water in Consumer Products

Abstract

The direct Karl Fischer (KF) titration method has known interferences for measuring water content. In addition, in analyzing some paints, KF can fail to produce an accurate analysis. The California Air Resources Board (GARB) staff has developed a KF procedure that can be used to determine the water content of consumer products. The procedure uses an oven accessory to the titration system, and is based on a distillation method developed by the California Polytechnical University at San Luis Obispo (Cal Poly). Samples are diluted in l-methoxy-2-propanol (MPA), and an aliquot is injected into an enclosed oven system, where the MPA/water azeotrope is swept directly into the KF titration vessel. The technique is accurate and precise and, thus far, proves to be a fast and reliable method for analysis.     

An in situ study of the effect of nitrate on the reduction of trichloroethylene by granular iron

The effect of nitrate on the reduction of TCE by commercial granular iron was investigated in column experiments designed to allow for the in situ monitoring of the iron surface film with Raman spectroscopy. Three column experiments were conducted; one with an influent solution of 100 mg/l nitrate+1.5 mg/l TCE, and two control columns, one saturated directly with 100 mg/l nitrate solution, the other pre-treated with Millipore water prior to the introduction of a 100 mg/l nitrate solution. In the presence of nitrate, TCE adsorbed onto the iron, but there was little TCE reduction to end-products ethene and ethane. The iron used (Connelly, GPM, Chicago) is a product typical of those used in permeable granular iron walls. The material is covered by an air-formed high-temperature oxidation film, consisting of an inner layer of Fe(3)O(4), and an outer, passive layer of Fe(2)O(3). In the control column pre-treated with Millipore water, the passive Fe(2)O(3) layer was removed upon contact with the water in a manner consistent with an autoreduction reaction. In the TCE+nitrate column and the direct nitrate saturation column, nitrate interfered with the removal of the passive layer and maintained conditions such that high valency protective corrosion species, including Fe(2)O(3) and FeOOH, were stable at the iron surface. The lack of TCE reduction is explained by the presence of these species, as they inhibit both mechanisms proposed for TCE reduction by iron, including catalytic hydrogenation, and direct electron transfer.     

Evaluation of urban photochemical models for regulatory use

There has been an increasing recognition of the need to evaluate, systematically and quantitatively, the performance of air quality models used for regulatory purposes. However, previous evaluations of urban photochemical models have not tested the ability of the model to predict the change in ozone that will result from a given change in emissions, a necessary feature for a model to be used for regulatory purposes. Instead, the evaluations have tested the models' ability to reproduce ozone production for a variety of meteorological conditions. This paper presents an evaluation of the Urban Airshed Model based on Denver, Colorado data that includes both changes in daily maximum ozone due to changes in meteorology, and changes in daily maximum ozone due to changes in emissions. It is shown that the emissions change testing produces an assessment of the Urban Airshed Model that is fairly independent of the one based on meteorological change. Important inferences about model performance do not carry over from one case to the other. Thus, an emissions change testing should be included in assessing whether an urban photochemical model is good enough for regulatory use.     

Characterization of emissions during the heating of tyre contaminated scrap

In order to characterize the compounds (type and quantities) emitted during melting of organic contaminated scrap and to investigate the mechanism of their formation, an experimental set-up has been designed and built to study precisely the influence of temperature and gas atmosphere in the conditions of an electric arc furnace. These experiments lead to the determination of mass balances (C, H, O, S) and to the quantification of unburnt compounds (tars, carbon monoxide, volatile organic compounds (VOCs), benzene, toluene, ethylbenzene and xylenes (BTEX), polyaromatic compounds (PAHs)). Degradation conditions (gas atmosphere and temperature) corresponding to different areas in the electric furnace have also been investigated. Such experiments lead to a better understanding of degradation mechanisms; this interpretation is not possible from investigations performed in an industrial furnace since there are many uncontrolled parameters (large dispersion of the results).     

Dynamic Calibration of an Acid Aerosol Analyzer

A method is described for dynamic calibration of an acid aerosol analyzer based on a commercial modification of the Thomas Autometer and manufactured by the Instrument Development Company. This automated instrument removes acid aerosol from an air stream by sonic impaction, and the sulfuric acid collected is determined conductometrically. An all-glass aerosol generator based on the reaction of water vapor with sulfur trioxide vapor released from fuming sulfuric acid was built for the calibration. Air samples were withdrawn for instrument calibration before and after the concentration of the acid aerosol was determined by titration. The apparent particle size as determined by an Andersen sampler ranged from 2.0 microns to less than 0.68 micron and exhibited a sharp peak with mass median diameter at 1.3 microns in the distribution curve. The size of the aerosol, within certain limits, could be controlled by humidity. Data indicated a linear response with an aerosol collection efficiency of 80 percent in the important respirable size range.     

The concept of circular economy strategy in food waste management for the optimization of energy production through anaerobic digestion

Environmental Science and Pollution Research - Food waste management (FWM) is considered to be an extremely important social issue besides an environmental one. Worldwide, it is estimated that 1.3...     

Engineering risk assessment for emergency disposal projects of sudden water pollution incidents

Without an engineering risk assessment for emergency disposal in response to sudden water pollution incidents, responders are prone to be challenged during emergency decision making. To address this gap, the concept and framework of emergency disposal engineering risks are reported in this paper. The proposed risk index system covers three stages consistent with the progress of an emergency disposal project. Fuzzy fault tree analysis (FFTA), a logical and diagrammatic method, was developed to evaluate the potential failure during the process of emergency disposal. The probability of basic events and their combination, which caused the failure of an emergency disposal project, were calculated based on the case of an emergency disposal project of an aniline pollution incident in the Zhuozhang River, Changzhi, China, in 2014. The critical events that can cause the occurrence of a top event (TE) were identified according to their contribution. Finally, advices on how to take measures using limited resources to prevent the failure of a TE are given according to the quantified results of risk magnitude. The proposed approach could be a potential useful safeguard for the implementation of an emergency disposal project during the process of emergency response.