Wet and dry deposition of sulfur and nitrogen compounds in Ontario

Measurements have been made of sulfur and nitrogen compounds in precipitation since 1980 and in air since 1981 in Ontario. This paper presents results of the atmospheric deposition measurement program to the end of 1985. As is to be expected from the distribution of emission sources, annual concentrations of SO₄²⁻ andNO₃⁻ in precipitation, and of SO₂,SO₄²⁻ andNO₃⁻ in air are higher in southern Ontario than in northern Ontario. The corresponding distribution pattern for deposition is similar to that of concentration. A wet SO₄²⁻ deposition rate of 20 kg ha¹⁻ y¹⁻, a value considered critical for the acidification of sensitive water bodies, is exceeded in all of central and southern Ontario. On a province-wide basis, sulfur wet deposition is about four times higher than sulfur dry deposition. For nitrogen, wet and dry deposition are more comparable, though the former is still higher. The S- and N-species display different seasonal trends in concentration and deposition reflecting a dependence on meteorological factors, and on the associated chemical transformation rates. On the other hand, year to year variations are small.     

Energy and exergy optimization of food waste pretreatment and incineration

With the aim of upgrading current food waste (FW) management strategy, a novel FW hydrothermal pretreatment and air-drying incineration system is proposed and optimized from an energy and exergy perspective. Parameters considered include the extracted steam quality, the final moisture content of dehydrated FW, and the reactor thermal efficiency. Results show that optimal working condition can be obtained when the temperature and pressure of extracted steam are 159 °C and 0.17 MPa, the final moisture content of dehydrated FW is 10%, and the reactor thermal efficiency is 90%. Under such circumstance, the optimal steam energy and exergy increments reach 194.92 and 324.50 kJ/kg-FW, respectively. The novel system is then applied under the local conditions of Hangzhou, China. Results show that approximately 2.7 or 11.6% (from energy or exergy analysis perspective) of electricity can be additionally generated from 1 ton of MSW if the proposed novel FW system is implemented. Besides, comparisons between energy and exergy analysis are also discussed.

     

Accumulation and elimination kinetics of di-, tri- and tetra chlorobiphenyls by goldfish after dietary and aqueous exposure

Bioaccumulation kinetics of five di-, tri- and tetrachlorobiphenyls from water and food were studied in laboratory experiments with goldfish (Carassius auratus). First order rate constants for uptake from water and clearance were determined after simultaneous administration of the five compounds in constant concentration, and were related to bioconcentration factors obtained in a static fish-water equilibration system. Biomagnification by retention of the PCB's from food was studied in a separate experiment.The difference in clearance rates for the chlorobiphenyls is the main reason for the different bioconcentration and biomagnification factors.Absorption efficiencies from water and food are higher than 40%. Clearance half lives vary from 10 days for 2,5-dichlorobiphenyl to 60 days for 2,3′,4′5-tetrachlorobiphenyl, which is correlalated with the decreasing aqueous solubilities of the compounds. Bioconcentration factors are between 0.4 × 10⁶ and 1.5 × 10⁶, biomagnification factors between 0.2 and 1.7, based on extractable lipids. Substitution of chlorine in the position para to the phenyl-phenyl bond influences hydrophobicity and bioaccumulation of the PCB's more strongly than substitution in ortho position.A kinetic model is developed which accounts for the influence of the lipid content of the fish on the clearance rate of a chemical. Reproducible determination of the bioconcentration potential of environmental chemicals is possible by use of an “internal bioaccumulation standard” in a kinetic test system. Food chain accumulation in fish is likely to be an important process only for persistent chemicals with extremely low water solubility.     

Linear and non-linear relationships between soil sorption and hydrophobicity: model, validation and influencing factors

The hydrophobic parameter represented by the octanol/water partition coefficient (log P) is commonly used to predict the soil sorption coefficient (K_oc). However, a simple non-linear relationship between log K_oc and log P has not been reported in the literature. In the present paper, soil sorption data for 701 compounds was investigated. The results show that log K_oc is linearly related to log P for compounds with log P in the range of 0.5-7.5 and non-linearly related to log P for the compounds in a wide range of log P. A non-linear model has been developed between log K_oc and log P for a wide range of compounds in the training set. This model was validated in terms of average error (AE), average absolute error (AAE) and root-mean squared error (RMSE) by using an external test set with 107 compounds. Nearly the same predictive capacity was observed in comparison with existing models. However, this non-linear model is simple, and uses only one parameter. The best model developed in this paper is a non-linear model with six correction factors for six specific classes of compounds. This model can well predict log K_oc for 701 diverse compounds with AAE = 0.37. The reasons for systemic deviations in these groups may be attributed to the difference of sorption mechanism for hydrophilic/polar compounds, low solubility for highly hydrophobic compounds, hydrolysis of esters in solution, volatilization for volatile compounds and highly experimental errors for compounds with extremely high or low sorption coefficients.     

道路径流SS和COD污染特征及出流规律

选择芜湖市火车站点进行长期监测,采集降雨7次;同时选择5个不同功能区,采集典型降雨1次。探讨了道路径流中总固体悬浮物(SS)和化学需氧量(COD)的污染特征、影响因素及出流规律,结果表明,7次降雨事件SS和COD平均值范围分别为198～1 529 mg/L和66～367 mg/L。SS和COD污染较为严重。SS在不同功能区中大小顺序为:工业区>居民区>商业区>交通区>文教区,总COD大小顺序为:工业区>交通区>居民区>商业区>文教区,溶解态COD大小顺序为:工业区>交通区>商业区>文教区>居民区,颗粒态COD大小顺序为:工业区>居民区>交通区>文教区>商业区。工业活动对地表径流SS和COD含量影响最大。SS受降雨历时影响较大,溶解态COD受平均雨强影响较大,颗粒态COD受最大雨强影响较大。不同降雨强度下,SS、溶解态COD及颗粒态COD的出流规律不同,降雨强度对径流初期效应的影响显著。     

Sorption of apolar and polar organic contaminants by waste tire rubber and its chars in single- and bi-solute systems

Single- and bi-solute sorption of organic compounds [1,3-dichlorbenzene (DCB), 1,3-dinitrobenzene (DNB) and 2,4-dichlorophenol (DCP)] on ground tire rubber and its chars was studied. The chars were prepared by pyrolyzing tire rubber at different temperatures (200-800 °C). Their surface area, aromaticity and hydrophobicity increase greatly with pyrolytic temperature, and the polymeric phase is partly converted into a condensed phase. The sorption of DNB and DCP increases with pyrolytic temperature and is characterized by a transition from a partition dominant to an adsorption dominant process. However, the sorption of DCB linearly decreases with the pyrolytic temperature. The enhanced adsorption of DNB and DCP on carbonized phase is primarily attributed to nonhydrophobic interactions such as π-π electron-donor-acceptor interactions and/or H bonding. The higher partition of DCB to polymeric phase is attributed to its high hydrophobicity. Competitive sorption between DCB and DCP on the tire chars is highly dependent on dissociation of the latter.     

Analysis of a solar still with photovoltaic modules and electrical heater - Energy and exergy approach

The availability of drinkable water, along with food and air, is a fundamental human necessity. Because of the presence of higher amounts of salt and pollution, direct use of water from sources such as lakes, sea, rivers, and subsurface water reservoirs is not normally suggested. Solar is still a basic technology that can use solar energy to transform accessible waste or brackish water into drinkable water. Exergy analysis is a strong inferential technique for evaluating the performance of thermal systems. Exergy is becoming more popular as a predictive tool for analysis, and there is a rising interest in using it. In this paper, performance analysis on the aspect of energy and exergy from the proposed solar still (PSS) (conventional solar still with the photovoltaic modules-AC heater) was analyzed on three different water depths (W_d) conditions (1, 2, and 3 cm). Using a solar still with an electric heater, the daily potable water production was found as 8.54, 6.37, and 4.43 kg, for the variations in water depth (W_d) of 1, 2, and 3 cm respectively. The energy and exergy efficiency of the PSS at the W_d of 1, 2, and 3 cm were 75.67, 51.45, and 37.21% and 5.08, 2.29, and 1.03%, respectively. At 1 cm W_d, PSS produced the maximum freshwater yield as compared to the other two water depths. When the W_d is increased from 1 to 2 cm and from 1 to 3 cm, the yield is decreased up to 27.3 and 52.7%, respectively. Similarly, the energy and exergy efficiency is decreased up to 36.8 and 53.2% and 50.4 and 80.6%, respectively. The water cost of the modified solar still is calculated as 0.028 $/kg for the least water thickness.

     

Bromo- and bromochloro-dibenzo-p-dioxins and dibenzofurans in the environment

At least 36 million pounds of brominated flame retardants are used in the U.S. annually. Most if not all of these materials enter the waste stream via landfilled plastic waste, municipal incinerator fly ash, or automotive fluff waste. Analytical methodology is summarized which is suitable for environmental monitoring of these wastes, and the significance of the analytical results is discussed.     

Seasonal monoterpene and sesquiterpene emissions from Pinus taeda and Pinus virginiana

Seasonal volatile organic compound emission data from loblolly pine (Pinus taeda) and Virginia pine (Pinus virginiana) were collected using branch enclosure techniques in Central North Carolina, USA. P. taeda monoterpene emission rates were at least ten times higher than oxygenated monoterpene and sesquiterpene emissions in all seasons. α-pinene and β-pinene were the most abundant emissions, while β-caryophyllene had the highest sesquiterpene emission rate from this species. β-phellandrene was the dominant compound emitted from P. virginiana, followed by the sesquiterpene β-caryophyllene. Sesquiterpene emissions from P. virginiana have not been reported in the literature previously. Summer sesquiterpene emissions from P. virginiana were nearly as high as monoterpene emissions, but were 4–12 times lower than monoterpene emissions in the other seasons. Oxygenated monoterpenes and 2-methyl-3-buten-2-ol were emitted at higher rates from P. taeda than from P. virginiana. Temperature response of the pinenes from P. taeda is similar to previously reported values used in emission models, while that for other compounds falls at the lower end of the previously reported range. Temperature response of all compounds from P. virginiana is in reasonable agreement with previously reported values from other pine species. There is evidence of light dependence of sesquiterpene emission after accounting for temperature response from both species. This effect is somewhat stronger in P. taeda. Bud break, needle expansion, and needle fall (and therefore wind events) seemed to increase monoterpene emission during non-summer seasons. In some instances springtime monoterpene emissions were higher than summertime emissions despite cooler temperatures. Emissions of individual compounds within monoterpene, oxygenated monoterpene, and sesquiterpene classes were highly correlated with each other. Compounds from different classes were much less correlated within each species. This is due to a varying temporal emission patterns for each BVOC class and suggests different production, storage, and emission controls for each. Analysis of enclosure blanks and diurnal patterns indicates that, despite precautions, disturbance due to the enclosure technique may still impact monoterpene emission rate estimates. This did not appear to affect sesquiterpene emissions.     

Nitrogen and phosphorus removal for swine wastewater by ammonium crystallization and intermittent aeration process

Abstract

A process on crystallized precipitation of ammonium by adding magnesium salt and phosphate was carried out to improve C/N ratio in swine wastewater. After completion of crystallized precipitation of ammonium, an intermittent aeration process with aeration and non‐aeration periods alternated at interval of 1:1 hr day^‐1 is used for the improved swine wastewater (T‐N/BOD=0.14: BOD=8200 mg/liter and T‐N=1166 mg/liter). The results obtained from the experiment show that the removal ratios of T‐N and NH₄‐N are 91% and 99%, respectively. T‐P is not removed, while the removal ratio of PO₄‐P is 60% as 3% of CaCl₂ liquid is added. The results also indicate that dilution with water is effective to improve the removal of phosphorus even if raw swine wastewater contains high concentrations of T‐N, T‐P, BOD, and TOC.