Analysis of mobile source air toxics (MSATs)—Near-road VOC and carbonyl concentrations

Exposures to mobile source air toxics (MSATs) have been associated with numerous adverse health effects. While thousands of air toxic compounds are emitted from mobile sources, members of a subset of compounds are considered high priority due to their significant contribution to cancer and noncancer health risks and the contribution of mobile sources to total exposure as evaluated by the U.S. Environmental Protection Agency (EPA) National-Scale Air Toxics Assessments (NATA). These pollutants include benzene, 1,3-butadiene, ethylbenzene, acrolein, acetaldehyde, formaldehyde, naphthalene, polycyclic organic matter, and diesel particulate matter/organic gases. This study provided year-long trends of benzene, 1,3-butadiene, acrolein, acetaldehyde, and formaldehyde in Las Vegas, NV. Results indicated that MSAT concentrations often did not exhibit trends typical of other primary emitted pollutants in this study. Instead, other mobile sources beyond the highway of interest contributed to the measured values, including a major arterial road, a large commercial airport, and a nearby parking lot. The data were compared with relevant census-tract NATA estimates, with estimated ambient 1,3-butadiene concentrations similar to the measured values. Measured benzene values were much lower relative to the NATA total ambient benzene concentrations. Measured acrolein values were much higher relative to the NATA total acrolein concentrations. Measured acetaldehyde and formaldehyde values were also higher relative to the NATA total acetaldehyde and formaldehyde concentrations for all wind conditions and downwind conditions. Some possible explanations for these differences include nearby sources influencing the measured values; meteorological influences that may not be well captured by the NATA modeling regime; chemical reactivity of measured compounds; and additional explanatory variables may be needed for certain urban areas in order to accurately disaggregate anthropogenic air toxics emissions.

Implications: Comparison of air toxics concentrations measured at four long-term near-road sites in Las Vegas, NV, show generally good agreement with the EPA 2005 U.S. Environmental Protection Agency. 2005. National Air Toxics Assessments (NATA)(accessed December 7, 2012) http://www.epa.gov/ttn/atw/natamain/index.html (http://www.epa.gov/ttn/atw/natamain/index.html)  [Google Scholar] NATA total ambient concentrations. Measured concentrations did not compare as well with EPA 2005 U.S. Environmental Protection Agency. 2005. National Air Toxics Assessments (NATA)(accessed December 7, 2012) http://www.epa.gov/ttn/atw/natamain/index.html (http://www.epa.gov/ttn/atw/natamain/index.html)  [Google Scholar] NATA for the on-road mobile portion of the ambient concentrations. This highlights the complexity of air toxic emission sources and impacts in urban areas, especially around large highway facilities; NATA's inability to capture local-scale meteorology and fine-scale ambient gradients; and that additional explanatory variables may be needed for certain urban areas in order to accurately disaggregate anthropogenic air toxics emissions.     

Behavior of pyrimethanil,pyraclostrobin, boscalid,cypermethrin and chlorpyrifos residues on raspberry fruit and leaves of Laszka variety

The purpose of the research conducted was to investigate and evaluate the behavior of pyrimethanil, pyraclostrobin, boscalid, cypermethrin and chlorpyrifos, the active ingredients of selected fungicides and insecticides, on ripe fruit and in fully developed leaves of raspberry of the Laszka variety. The field trial was carried out in the period of one month starting from the first fruit picking. The results obtained indicated that residue levels on the day of the first crop picking did not even approximate the corresponding EU-MRLs (http://ec.europa.eu/sanco_pesticides). Individual substances in raspberry fruits and leaves disappeared at a similar rate. As a result of chlorpyrifos application to the soil, its residue in fruits and leaves occurred for the whole period of fruit bearing, though in fruit they dropped successively. To produce raspberries with residues below or equal to 0.01 μg g^?1, the application of pesticides should be stopped at least 2–3 weeks before the first crop picking, and on condition that an appropriate preparation (active in low doses) is applied to the last treatments.     

Inhibition and promotion of trace pollutant adsorption within electrostatic precipitators

Among the technologies available for reducing mercury emissions from coal-fired electric utilities is the injection of a powdered sorbent, often some form of activated carbon, into the flue gas upstream of the particulate control device, most commonly an electrostatic precipitator (ESP). Detailed measurements of mercury removal within ESPs are lacking due to the hazardous environment they pose, increasing the importance of analysis and numerical simulation in understanding the mechanisms involved. Our previous analyses revealed that mercury adsorption by particles suspended in the gas and mercury adsorption by particles collected on internal ESP surfaces are not additive removal mechanisms but rather are competitive. The present study expands on this counterintuitive finding. Presented are results from numerical simulations reflecting the complete range of possible mass transfer boundary conditions representing mercury adsorption by the accumulated dust cake covering internal ESP collection electrodes. Using the two mercury removal mechanisms operating concurrently and interdependently always underperforms the sum of the two mechanisms’ individual contributions.

Implications: The dual use of electrostatic precipitators (ESPs) for particulate removal and adsorption of trace gaseous pollutants such as mercury is increasing as mercury regulations become more widespread. Under such circumstances, mercury adsorption by particles suspended in the gas and mercury adsorption by particles collected on internal ESP surfaces are competitive. Together, the two mercury removal mechanisms always underperform the sum of their two independent contributions. These findings can inform strategies sought by electric utilities for reducing the usage costs of mercury sorbents.     

The International Association for Danube Research (IAD)—portrait of a transboundary scientific NGO

Introduction

The International Association for Danube Research (IAD), a legal association (Verein) according to Austrian law, presently consists of 13 member countries and 12 expert groups covering all water-relevant scientific disciplines. IAD, founded in 1956, represents a traditional and significant stakeholder in the Danube River Basin, fulfilling an important task towards an integrative water and river basin management requested by the EU Water Framework Directive.

Discussion

IAD, stretching between basic and applied research, adapted its strategy after the major political changes in 1989. IAD fosters transdisciplinary and transboundary projects to support integrative Danube River protection in line with the governmental International Commission for the Protection of the Danube River (ICPDR) in which IAD has had observer status since 1998. Recent scientific outputs of IAD encompass, amongst others, a water quality map of the Danube and major tributaries, the Sturgeon Action Plan, hydromorphological mapping of the Drava, a macrophyte inventory, and a Mures River study. Further information about IAD can be found on our website http://www.iad.gs.

     

Comparison of Emission of Dioxins and Furans from Gasohol- and Ethanol-Powered Vehicles

ABSTRACT

The exhaust emissions of 17 polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofurans (PCDD/Fs) were investigated in two spark-ignition light-duty vehicles, one gasohol-fueled and a flexible-fuel one fueled with hydrated ethanol. Gasohol is a mixture of gasoline and 22% ethanol. The influence of fuel type and quality, lubricant oil type, and use of fuel additives on the formation of these compounds was tested using standardized U.S. Federal Test Procedure (FTP)-75 cycle tests. The sampling of the PCDD/Fs followed the recommendations of a modified U.S. Environmental Protection Agency (EPA) Method 23 (http://www.epa.gov/ttn/emc/promgate/m-23.pdf) and the analysis basically followed the U.S. EPA Method 8290 (http://www.epa.gov/osw/hazard/testmethods/sw846/pdfs/8290a.pdf). Results showed that emission factors of PCDD/Fs for the gasohol vehicle varied from undetected to 0.068 pg international toxic equivalency (I-TEQ) km^?1 (average of 0.0294 pg I-TEQ km^?1), whereas in the ethanol vehicle they varied from 0.004 to 0.157 pg (I-TEQ) km^?1 (average of 0.031 pg I-TEQ km^?1). In the gasohol-powered vehicle, the use of fuel additive diminished the emission of Octachlorodibenzo-p-dioxin (OCDD) significantly, whereas in the ethanol vehicle no significant associations were observed between the investigated variables and the emissions.

IMPLICATIONS The objective of this work was to analyze differences in emissions from a traditional fossil fuel (gasoline) and an alternative renewable fuel (ethanol from sugarcane), and the influence of fuel additives and lubricant oils on the formation of chlorinated dioxins and furans in spark-ignition light-duty gasohol and ethanol vehicles. Renewable fuels are very important in terms of climate change but the risk to the population's health must not increase. Thus the results of this work could help in the development of environmental impact studies as well as orienting policy-makers in formulating strategies for air pollution control.     

Raman and SERS spectra of thiamethoxam and the Ag3–thiamethoxam complex: an experimental and theoretical investigation

Dutch water boards have a well-established program for monitoring pesticide contamination of surface waters. These monitoring data have been processed into a graphic format accessible online and designed to provide insight into pesticide presence in Dutch surface waters and trends over time: the Pesticides Atlas (http://www.pesticidesatlas.nl). With this tool one can easily get maps of where a pesticide is being measured and where it might possibly constitute an environmental problem over the years. Presently, results of the periods 1997/1998 until 2005/2006 are available at the level of individual active ingredients. At a national level, the percentage of pesticides concentrations that exceed the maximum tolerable risk has declined 30% to 38% over the years 2003/2004 compared with 1997/1998. This means that surface water quality in the Netherlands has improved with respect to pesticides, however there are still many locations at which the measured concentrations exceed the environmental quality standards. The results on linking land use to pesticides concentrations were shown to assist in optimization of monitoring programs. By developing the present Internet tool, many new opportunities for environmental risk assessment and risk management were identified, e.g. optimization of monitoring strategies and communication to policymakers.     

Adsorption of mercury by activated carbon prepared from dried sewage sludge in simulated flue gas

Conversion of sewage sludge to activated carbon is attractive as an alternative method to ocean dumping for the disposal of sewage sludge. Injection of activated carbon upstream of particulate matter control devices has been suggested as a method to remove elemental mercury from flue gas. Activated carbon was prepared using various activation temperatures and times and was tested for their mercury adsorption efficiency using lab-scale systems. To understand the effect of the physical property of the activated carbon, its mercury adsorption efficiency was investigated as a function of its Brunauer–Emmett–Teller (BET) surface area. Two simulated flue gas conditions, (1) without hydrogen chloride (HCl) and (2) with 20 ppm HCl, were used to investigate the effect of flue gas composition on the mercury adsorption capacity of activated carbon. Despite very low BET surface area of the prepared sewage sludge activated carbons, their mercury adsorption efficiencies were comparable under both simulated flue gas conditions to those of pinewood and coal activated carbons. After injecting HCl into the simulated flue gas, all sewage sludge activated carbons demonstrated high adsorption efficiencies, that is, more than 87%, regardless of their BET surface area.

Implications: We tested activated carbons prepared from dried sewage sludge to investigate the effect of their physical properties on their mercury adsorption efficiency. Using two simulated flue gas conditions, we conducted mercury speciation for the outlet gas. We found that the sewage sludge activated carbon had mercury adsorption efficiency comparable to pinewood and coal activated carbons, and the presence of HCl minimized the effect of physical property of the activated carbon on its mercury adsorption efficiency.     

Molecular probes and microarrays for the detection of toxic algae in the genera Dinophysis and Phalacroma (Dinophyta)

Dinophysis and Phalacroma species containing diarrheic shellfish toxins and pectenotoxins occur in coastal temperate waters all year round and prevent the harvesting of mussels during several months each year in regions in Europe, Chile, Japan, and New Zealand. Toxicity varies among morphologically similar species, and a precise identification is needed for early warning systems. Molecular techniques using ribosomal DNA sequences offer a means to identify and detect precisely the potentially toxic species. We designed molecular probes targeting the 18S rDNA at the family and genus levels for Dinophysis and Phalacroma and at the species level for Dinophysis acuminata, Dinophysis acuta, and Dinophysis norvegica, the most commonly occurring, potentially toxic species of these genera in Western European waters. Dot blot hybridizations with polymerase chain reaction (PCR)-amplified rDNA from 17 microalgae were used to demonstrate probe specificity. The probes were modified along with other published fluorescence in situ hybridization and PCR probes and tested for a microarray platform within the MIDTAL project (http://www.midtal.com). The microarray was applied to field samples from Norway and Spain and compared to microscopic cell counts. These probes may be useful for early warning systems and monitoring and can also be used in population dynamic studies to distinguish species and life cycle stages, such as cysts, and their distribution in time and space.