表征室外人体暴露的监测网络设计(待续)

对悬浮颗粒物室外人体暴露的测定一直受到可用资源的限制，设计有效的网络就要求对测定方法的选择、采样点的数量、采样时间、采样频率等进行调整。采样位置要求能表征因周围污染源对附近地区和城市最小影响的空间数值。虽然大多数判定PM是否达标的测定方法是每第3天至第6天的24 h监测，但是室外人体暴露的评价要求连续监测一整天，最好有1h或更短时间的监测时段。更详细的粒径大小和化学性质数据也很有必要，因为较小的颗粒及其特殊的化学物质要比总的样品质量更有助于反映对健康的不良影响。     

表征室外人体暴露的监测网络设计(续一)

对悬浮颗粒物室外人体暴露的测定一直受到可用资源的限制，设计有效的网络就要求对测定方法的选择、采样点的数量、采样时间、采样频率等进行调整。采样位置要求能表征因周围污染源对附近地区和城市最小影响的空间数值。虽然大多数判定PM是否达标的测定方法是每第3天至第6天的24h监测，但是室外人体暴露的评价要求连续监测一整天，最好有1h或更短时间的监测时段。更详细的粒径大小和化学性质数据也很有必要，因为较小的颗粒及其特殊的化学物质要比总的样品质量更有助于反映对缝康的不良影响。     

测定环境空气中砷及其化合物的方法改进

对《空气和废气监测分析方法》中砷的采样和测定方法进行了改进,并在云南某炼铜厂环境空气中含砷监测进行了实际验证。结果表明,方法的检出限、精密度、准确度均能满足测定的要求,并且更适合测定高浓度砷。     

我国固体废物监测技术发展现状

简述了我国固体废物环境管理和监测框架体系,回顾了固体废物监测的发展历史,并从采样和制样、浸出毒性的浸出方法、无机污染物和有机污染物测定方法等方面对固体废物监测现状进行了总结。针对固体废物监测体系存在的问题,提出了对采样技术开展更新性研究,尽快将已有的测定方法标准化并建立总量监测方法,开发各类污染物的形态分析方法,以及规范废弃物危险特性试验方法等建议。     

环境空气中细菌总数和霉菌总数监测方法的研究

分别对环境空气中细菌和霉菌监测的不同采样仪器、采样方式、培养条件的结果进行对比分析,并进行差异显著性检验.结果表明,FA-1型和FA-2型采样器的采样结果无显著性差异;细菌和霉菌监测的采样时间以5min为最佳;细菌的培养以48h、37℃±1℃为优,霉菌的培养为96h、28℃±1℃为宜;对实验结果进行精密度检验,均达到了质量控制的要求.     

污染源废气中二噁英监测采样应注意的几个问题

解析废气中二噁英监测采样的现状及不足,针对生活垃圾焚烧炉(炉排炉)、蓄热式焚烧炉(RTO)和危险废物焚烧炉(回转窑)3种不同类型焚烧炉,考察了采样过程中烟道类型、采样时间和采样时间间隔不同对二噁英监测的影响。结果表明,在水平烟道和垂直烟道采样测得二噁英排放浓度水平相当,有垂直烟道时,优先在垂直烟道采样;间隔采样和连续采样二噁英测定结果基本一致,为了便于操作,建议均采用连续采样方式;采样时间上,生活垃圾焚烧炉应保证超过1 h,蓄热式焚烧炉以2 h左右为宜;间歇投料危险废物焚烧炉应尽量满足2 h以上,条件不许可时,可通过增加采样流量缩短采样时间保证采样量,并在危险废物完全燃烧前结束采样工作。     

连续采样与五日法采样效果及费用的对比分析

通过对连续采样与五日法采样五种方法监测结果及所需费用的比较，得出连续采样方法监测结果更具有代表性，合理性，一次性投资大，但运行费用并不高的结论。     

浅议现代垃圾填埋场的大气污染及监测分析方法

造成垃圾填埋场大气污染的两大类污染物,其对环境、人体、动植物、器物和材料都有一定的危害,文章针对现代垃圾填埋场的大气环境污染,以硫化氢、氨、甲硫醇等重点大气污染因子为监测对象,结合实践总结了一部分垃圾填埋场的大气污染监测方案,包括布点原则、采样频率和时间、采样方法和分析技术,该监测方案可为现代垃圾填埋场的大气污染监测提供参考.     

分光光度法测定室内空气中甲醛的方法研究

针对室内空气中甲醛的特点,在环境空气甲醛的测定方法—乙酰丙酮分光光度法(GB/T15516-95)的基础上,进一步优化了该方法的采样时间、采样流量、样品收集器等,使优化后的测定方法更加适应室内空气监测需要的准确性、简便性、快速性的特点。     

宁波市环境监测中心站饮用水源地藻类课题进展顺利

由宁波市环境监测中心站承担的“宁波市饮用水源地藻类和微生物动态档案库建设”课题，从2004年11月起至今，室外采样工作已基本完成，室内有关水质理化指标和生化指标的监测工作正在进行中，课题中有关藻毒素的监测分析，在国内处于领先水平。该课题的研究工作，将为建立宁波市主要饮用水源动态档案库，进一步保障全市的饮用水水源水质增加监控手段。     

Determination of response of real-time SidePak AM510 monitor to secondhand smoke, other common indoor aerosols, and outdoor aerosol

The amount of light scattered by airborne particles inside an aerosol photometer will vary not only with the mass concentration, but also with particle properties such as size, shape, and composition. This study conducted controlled experiments to compare the measurements of a real-time photometer, the SidePak AM510 monitor (SidePak), with gravimetric mass. PM sources tested were outdoor aerosols, and four indoor combustion sources: cigarettes, incense, wood chips, and toasting bread. The calibration factor for rescaling the SidePak measurements to agree with gravimetric mass was similar for the cigarette and incense sources, but different for burning wood chips and toasting bread. The calibration factors for ambient urban aerosols differed substantially from day to day, due to variations in the sources and composition of outdoor PM. A field evaluation inside a casino with active smokers yielded calibration factors consistent with those obtained in the controlled experiments with cigarette smoke.     

TSP-PM10-PM2.5-2型中流量大气颗粒物采集系统的开发和应用

自行开发并研制了TSP-PM10-PM2.5-2型中流量TSP、PM10、PM2.5大气颗粒物采集系统,是目前中国唯一可以采集TSP、PM10、PM2.5样品并提供足够的样品量进行大气颗粒物化学成分分析的中流量大气颗粒物采集器.该系统精心设计和加工的限流孔可以保持完全固定的流量,保证切割粒径的稳定,减小采样的误差并方便操作.该系统已经成功地应用于20多个城市和地区大气颗粒物的监测和研究中,为研究大气颗粒物的污染状况和来源提供了有效的技术手段和支持.     

Evaluation of a portable nephelometer against the Tapered Element Oscillating Microbalance method for monitoring PM(2.5)

Monitoring personal exposure to particle matter (PM(2.5)) in ambient air requires performing measurements using portable monitors. In this work, the portable nephelometer SidePak? AM510 Personal Aerosol Monitor manufactured by TSI Inc. was evaluated against a Tapered Element Oscillating Microbalance (TEOM) equipped with a Filter Dynamics Measurements System (FDMS). Conventionally, the SidePak is calibrated with respect to the Arizona Road Test Dust and then multiplied by an environmental calibration factor to yield mass concentration. To adapt this calibration to specific field conditions, we present an implementation of this calibration by introducing a growing factor correction which takes into account relative humidity and the dry and wet portions of the refractive index estimated from TEOM-FDMS measurements. PM(2.5) sampling with several SidePaks AM510 was carried out in background and rural sites in the Po Valley (Italy). Modeled SidePak data were plotted vs. reference TEOM-FDMS data which show a good agreement.     

Particulate Matter Over A Seven Year Period in Urban and Rural Areas Within, Proximal and Far from Mining and Power Station Operations in Greece

Lignite mining operations and lignite-fired power stations result in major particulate pollution (fly ash and fugitive dust) problems in the areas surrounding these activities. The problem is more complicated, especially, for urban areas located not far from these activities, due to additional contribution from the urban pollution sources. Knowledge of the distribution of airborne particulate matter into size fraction has become an increasing area of focus when examining the effects of particulate pollution. On the other hand, airborne particle concentration measurements are useful in order to assess the air pollution levels based on national and international air quality standards. These measurements are also necessary for developing air pollutants control strategies or for evaluating the effectiveness of these strategies, especially, for long periods. In this study an attempt is made in order to investigate the particle size distribution of fly ash and fugitive dust in a heavy industrialized (mining and power stations operations) area with complex terrain in the northwestern part of Greece. Parallel total suspended particulates (TSP) and particulate matter with an aerodynamic diameter less than 10 μm (PM10) concentrations are analyzed. These measurements gathered from thirteen monitoring stations located in the greater area of interest. Spatial, temporal variation and trend are analyzed over the last seven years. Furthermore, the geographical variation of PM10 – TSP correlation and PM10/TSP ratio are investigated and compared to those in the literature. The analysis has indicated that a complex system of sources and meteorological conditions modulate the particulate pollution of the examined area.     

Development of monitoring technology for airborne particulate matter

Particulate matter suspended in the air has adverse effects onhuman health. Its level of concentration is an important parameter in evaluating the degree of hazard it poses to the atmosphere. Conventional methods used in measuring particulatematter are often filter-based, which indicates some disadvantagesbecause such a base requires labor and time. In this study, to achieve real-time measurements, a new electrical method was developed for measuring PM10 and PM2.5 concentrations. The basicprinciple is to electrically charge particles passing through thePM inlet using a corona charger and measure the currents createdby charged particles to obtain the number concentration of particulate matter. A new type inlet based on the particle cupimpactor configuration was designed and its performance was evaluated. A unipolar diffusion charger was developed and thecharger's efficiency was determined experimentally in terms ofPn, which represents the penetration through the charger,P, times the average charge number acquired by a particle,n, for different particle sizes. The correlation was constructed between the PM10 (or the PM2.5) mass concentrationsand the electrical currents due to particles, which were chargedby the diffusion charger.     

乌鲁木齐市冬季大气颗粒物PM_(10) 和PM_(2.5)污染水平及相关性研究

为研究乌鲁木齐市冬季采暖期间大气颗粒物污染特征,通过采样和在线监测二种手段分析了2015年1~2月大气颗粒物样品,采用重量法分析颗粒物质量浓度,并对其相关性进行分析。结果表明:依据《环境空气质量标准》(GB 3095-2012),采样期间乌鲁木齐市大气PM_(10) 和PM_(2.5)的日均质量浓度均超过了国家二级标准,颗粒物污染严重;PM_(10) 和PM_(2.5)存在显著相关性,PM_(2.5)和PM_(10) 浓度的比值均大于0.5,采暖期PM2.5对乌鲁木齐市大气颗粒物贡献显著。     

环境空气PM_(2.5)和PM_(10)监测分析质量保证及其评价

为保证四城市ＰＭ２５和ＰＭ１０的监测数据准确,具有可比性,本研究规定了滤膜的选择、称量操作步骤的要求和滤膜称量的质控指标。研究结果表明,粗细颗粒物样品的采集和称量操作可行,监测数据准确、可靠,具有可比性。