Experimental analysis of thermal performance of evacuated tube and flat-plate solar air collectors at different air flow rates

The thermal performances of an evacuated tube collector (ETC) and flat-plate solar air collector (FPC) are experimentally investigated at different air flow rates. To investigate the performance of the ETC and FPC, experimental set-ups were fabricated. Air was used as a working fluid and tested at the same climatic conditions. The ETC had 15 evacuated tubes with a surface area of 1.66 m². The experimental set-up consisted of a header with a hollow pipe (square pipe) in the centre through which the air flowed. The flat-plate collector had a surface area of 1.35 m². The FPC had a black painted absorber sheet which divides the collector into two sections. The air flowed through the upper and the lower sections parallel to the collector to minimize the overall heat loss. The temperature of the outlet air depends on several factors along with the airflow rate and the intensity of the solar radiation. It was found that during the day at high flow rates, the efficiency of the ETC varies from 0.12 to 0.5, and for the flat plate it was from 0.29 to 0.68. The maximum temperature of the air was 56.7°C for the ETC and 25.7°C for the FPC.     

The performance of solar powered desiccant dehumidifier in India: an experimental investigation

The regeneration and adsorption of desiccant wheel for producing the dry air was experimentally investigated. The air needed for regeneration was heated in an evacuated tube solar collector with surface area 4.44 m². The desiccant wheel is regenerated at the temperature in the range of 43.9–72.6°C. The regeneration and adsorption performances are affected by the regeneration temperature, wheel rotation, air flow rate (process and regeneration) and ambient conditions. By comparing the adsorption and regeneration performance at different air flow rate and constant rph, it was found that maximum adsorption and regeneration rates are obtained at air flow rate of 210.789 kg/h. Regeneration temperature directly affects the effectiveness of the desiccant wheel. Maximum desiccant wheel effectiveness of regeneration sector and adsorption sector is obtained at air flow rate of 105.394 kg/h. The regeneration performance of desiccant wheel with evacuated tube solar air collector is suitable for the Indian climate.     

Analysis of the energy demand of the Chilean mining industry and its coverage with solar thermal technologies

The mining industry represents more than half of Chile’s foreign exchange earnings and its increasing expansion will demand a continuous development of its energy supplies. Mostly, all the mines in Chile are located in the desert regions, having a large surface with one of the highest solar radiations levels and clearest skies in the world. Covering the mining industry’s energy demand with solar energy is thus an obvious and promising approach. In this paper, the implementation of solar thermal heating is studied in every mining process and the solar thermal electricity generation for the entire mine demand is considered as well. The work concludes that the installation of flat plate collectors to heat water for mine processes, especially for electrowinning, is strongly recommended. Additionally, the installation of solar thermal power plants can satisfy the mining electricity demand.     

Economic viability and optimization of solar microgrids with hybrid storage in a non-interconnected zone in Colombia

Environment, Development and Sustainability - A developing country that does not have adequate energy solutions in non-interconnected zones (ZNIs) undoubtedly experiences adverse effects in terms...