分体式空调室外机排热对周围环境的影响

利用FLUENT软件研究了在有、无自然风情形下空调室外机射流排热的温度场、速度场随室内、环境温度变化的规律,并通过空调室外机卷吸的空气流量计算疏散空调排热所消耗的自然资源量(以能值表示)。结果表明:(1)在有、无自然风情形下,环境温度变化对空调室外机排热的温度场影响显著。(2)在距射流出口前3m处风速分布一致,之后则有所不同,但整体而言有自然风情形下风速分布较无自然风时衰减更快。(3)室内和环境温度都较高时空调室外机卷吸的空气流量较大,距射流出口3m之后温度每变化1℃时卷吸空气流量基本相同。(4)在室内和环境温度不变时,有自然风时较无自然风时卷吸的空气流量小,无自然风情形下疏散空调排热所消耗的自然资源量是有自然风情形下的1.1倍以上。     

脉冲喷吹扁式方框滤筒除尘器的清灰性能

为探究新型扁式方框滤筒的清灰性能,在自建的脉冲喷吹实验台上,测得不同电磁阀、开孔型号、喷吹距离、喷吹压力下的侧壁压力峰值大小及其分布规律。通过进一步工业附粉,监测除尘器的阻力和清灰后的粉尘残余量,验证找到扁式方框滤筒的最佳喷吹清灰参数组合。结果表明:扁式方框滤筒的最佳开孔型号是7个7 mm孔,喷吹距离为20 mm;对于玉米秸秆粉尘,当过滤风速低于0.6 m·min~(-1)时,在1寸阀、0.2 MPa喷吹压力下可满足对其基本淸灰需求,且风速越小,清灰后的粉尘残余量越少,阻力也越小,低于150 Pa。另外,脉冲清灰过后,未被清除下来的粉尘多集中于扁滤筒的上部且是未正对喷吹孔的位置,如何进一步改善有待之后研究。     

Optimization of Height of Release of Air Pollutants

A number of key projects in the Environmental Protection Agency (EPA) particulate R&;D program having applicability to industry are presented. For electrostatic precipitators (ESP) there is presented the result of work on large diameter discharge electrodes which provide a decrease in penetration of up to a factor of 4 when compared to conventional small diameter electrodes. Also discussed is the multistage ESP which provides a collection efficiency that would require a collecting plate area 4 or 5 times larger with conventional ESP technology. The E-SOX technology makes use of the multistage concept to free up space in the ESP for SO₂ removals of up to 90%. Electrostatically augmented fabric filtration provides a reduction in pressure drop of about 5 0% as compared to conventional fabric filtration. Wind tunnel modeling of windbreaks for material storage piles indicates a potential for providing engineering design data that would allow significant emission reduction caused by wind erosion     

Investigation of the characteristics of the reflectivity of clouds

This paper investigates some of the reflectivity characteristics that clouds (when modelled as solid bodies) must exhibit to be compatible with observations that the reflecting surface of a cloud (i) appears almost equally bright across its face, (ii) is brightest when the cloud is opposite to the Sun but decreases in brightness as the cloud moves to other positions and (iii) increases in brightness with increasing optical thickness of the cloud in the observer's line of sight. These observations, respectively, are shown to imply that the peak value of the bidirectional total reflectivity from a cloud surface (i) increases in inverse proportion to the cosine of the angle between the Sun and the normal to the cloud surface, as the incident angle increases, (ii) appears to be directed back in the direction of the incident radiation, and (iii) increases as optical thickness of the cloud in the observer's line of sight increases. The results could have application in many fields (e.g. modelling diffuse radiance distributions for cloudy skies).     

An application of the theory of kinematics of mixing to the study of tropospheric dispersion

The most common technique used for numerical simulations of tracer mixing is that of the numerical solution of the advection–diffusion equation with the unresolved fluxes parameterized using the similarity theory. Despite correct predictions of the overall directions of transport, models based on a numerical solution of the advection–diffusion equation lack sufficient accuracy to correctly reproduce the coupling of mixing with small scale processes which are sensitive to the microstructure of the tracer distribution. The objective of this paper is to revisit the basic formalism employed in numerical models used to investigate atmospheric tracers. The main mathematical method proposed here is the theory of kinematics of mixing which could be applied effectively for simulations of atmospheric transport processes. At the beginning of the paper, we introduce simple mathematical transformations in order to demonstrate how complex topological structures are created by mixing processes. These idealistic flow systems are essential to explain transport properties of much more complex three-dimensional geophysical flows. An example of the application of the kinematics of mixing to the analysis of tracer transport on a planetary scale is presented in the following sections. The complex filamentary structures simulated in the numerical experiment are evaluated using some commonly applied statistical measures in order to compare the results with the data published in the literature. The results of the experiment are also analysed with the help of simple conceptual models of fluid filaments. The microstructure of the tracer distribution introduced in the paper is essential to increase our understanding of atmospheric transport and to develop more realistic parameterizations of small-scale mixing. The presented results could also be used to improve calculations of the coupling between microphysical processes and tracer mixing.     

Estimation of uncertainty of sampling for analysis of pesticide residues

Abstract

A computer model was used to take random samples from primary sample populations obtained from field trials to simulate the uncertainty of sampling for residue analysis of plant commodities and soil. The results indicate about 40%, 30% and 20% relative uncertainty when random samples of size 5, 10 and 25 are taken respectively, from a single lot. Therefore the sample size should be the same for establishing and enforcing legal limits.     

扬中生态环境建设的思考与实践

结合扬中生态环境的基本情况和存在的不足，进行了具体分析，对扬中未来生态建设的发展方向提出了建议及实施措施。     

次氯酸钠发生器的研制

介绍了电解法生产次氯酸钠的原理 ,并在原有生产工艺的基础上进行了重新设计和对设备的重新选择、改造 ,得出了各个工艺参数的最佳值 ,生产出高品质的次氯酸钠     

实验室质量管理体系内部审核的实施

在实施ISO／IEC17025：1999标准《检测和校准实验室能力的通用要求》过程中，通过实验室质量管理体系内部审核的实践与系统分析，识别出内部审核实施阶段的关键环节，提出召开首次会议、收集审核证据、确定审核发现和召开末次会议的技术方法，对提高内部审核的质量和有效性、获得可靠的审核结论具有重要意义。     

实验室质量管理体系内部审核的策划

在实施ISO／IEC 17025：1999标准《检测和校准实验室能力的通用要求》过程中，通过实验室质量管理体系内部审核的实践与系统分析，识别出内部审核策划阶段的关键环节，提出审核范围确定、审核计划和抽样方案制订的质量控制要求，为有序高效地实施内部审核提供了技术方法。     

Characterization of products of ozonolysis of acrylonitrile in liquid phase

In order to elucidate the reaction mechanism of the ozonolysis of acrylonitrile in the liquid phase, characterization of reaction products has been attempted. One of the products, which was volatile, has been found to be formaldehyde by derivatizing with dimedone. The infrared and mass spectra of the derivative corresponded with that of alkylidene dimedone. Three other reaction products were isolated by TLC using silica gel, CHCl₃:MeOH (80:20). These have been tentatively identified as glyoxal, epoxide of acrylonitrile and acetamide from their mass spectra. Based on these findings a reaction pathway for the formation of formaldehyde is proposed to be that described by Criegee.