用废变压器油吸收废气中的二甲苯

以废变压器油作为吸收剂对二甲苯废气进行吸收处理,考察了影响二甲苯气体去除率的因素。实验结果表明:二甲苯废气流量为350 L/h、废变压器油喷淋量为40 L/h、进口二甲苯废气平日质量浓度为935 mg/m~3、吸收温度为18℃、吸收时间为50 min时,出口二甲苯气体质量浓度为35 mg/m~3,二甲苯去除率高达96.3%,小于GB16297—1996《大气污染物综合排放标准》中二甲苯质量浓度90 mg/m~3的排放标准。     

天津城市污水泵站恶臭气体组分浓度及污染现状

为了解天津城市污水泵站恶臭的污染程度,选取天津市一个典型的城市污水泵站进行为期3天的采样,采集该污水泵站距离污染源强不同距离处的恶臭气体样品,用气相色谱-质谱联用仪（GS-MS）和分光光度法对采集样品的组分含量进行检测,比较了恶臭排放源点和不同距离处的恶臭组分的浓度特征和污染现状。结果表明,该泵站恶臭污染物质以硫化氢、二氯甲烷和苯系物为主,还有一些烯烃和芳香烃衍生物;恶臭物质的浓度变化范围是n.d.~0.073 7 mg/m³,大部分恶臭物质浓度一般由高至低表现为源点>下风向5 m,源点>背景值,环境空气采样点与恶臭排放源相比,其降幅明显;虽然检测到的恶臭组分较多,但是其浓度与《恶臭污染物排放标准》（GB 14554—1993）等标准中规定的排放限值相比,均未超标。     

Exploring the spatial-temporal variations and policy-based driving force behind groundwater contamination and remediation research in past decades

Environmental Science and Pollution Research - Groundwater has been recognized as one of the most critical and vulnerable natural sources which is utilized in potable water supply, agricultural...     

微电解-生化法处理大蒜废水工程实例

针对大蒜废水特点,采用了铁屑微电解-UASB-接触氧化工艺进行处理.运行结果表明:在设计进水水质、水量范围内,COD、BOD5、氨氮和ss去除率分别为98%、99%、70%和98%,出水各项指标均达到GB 8978--1996<污水综合排放标准>中的一级排放标准,系统运行费用为1.19元/m3.     

Removal of trace Cr(VI) from aqueous solution by porous activated carbon balls supported by nanoscale zero-valent iron composites

Environmental Science and Pollution Research - In this study, porous activated carbon balls supported by nanoscale zero-valent iron composites (Fe@PACB-700) were used for the first time for the...     

Soil labile and recalcitrant carbon and nitrogen dynamics in relation to functional vegetation groups along precipitation gradients in secondary grasslands of South China

Environmental Science and Pollution Research - Soil labile and recalcitrant carbon (C) and nitrogen (N) are strongly controlled by plant inputs and climatic conditions. However, the interrelation...     

微电解-催化氧化法处理高浓度甲醇废水

采用微电解一催化氧化法处理某化工厂的高浓度甲醇生产废水。实验结果表明：在进水pH为2．0、铁炭质量比为2、微电解时间为14h、空气流量为500mL／min的条件下,废水经微电解处理后,出水COD由原来的约7000mg/L降至约1000mg／L,COD去除率达85％以上;在过滤后微电解出水COD约为950mg／L、微电解出水pH为6．5、空气流量为300mL／min、催化氧化时间为3h时的条件下,经催化氧化处理后,出水COD降至100mg/L以下,出水水质达到GB8978--1996《污水综合排放标准》的二级标准。     

泡沫分离法处理含Cr~(6+)废水

采用间歇式泡沫分离法处理含Cr~(6+)废水,考察了各因素对Cr~(6+)去除效果的影响。通过正交实验分析确定的废水处理最佳工艺条件:废水pH 4.00,气体流量0.90 L/min,阳离子表面活性剂加入量300 mg/L。进水Cr~(6+)质量浓度为10 mg/L时,间歇运行的Cr~(6+)去除率为97.80%,连续运行的Cr~(6+)去除率为95.89%,出水均可达标排放。动力学实验结果表明,泡沫分离法去除Cr~(6+)的过程符合一级动力学的特征。对泡沫分离柱放大后的废水连续流实验分析结果表明,泡沫分离Cr~(6+)的效果比较稳定,但分离设备对废水处理效果有一定的影响。     

Synthesis of hybrid carbon nanotubes using Brassica juncea L. application to photodegradation of bisphenol A

Hyperaccumulators contain tubular cellulose and heavy metals, which can be used as the sources of carbon and metals to synthesize nanomaterials. In this paper, carbon nanotubes (CNTs), Cu_0.05Zn_0.95O nanoparticles, and CNTs/Cu_0.05Zn_0.95O nanocomposites were synthesized using Brassica juncea L. plants, and the ultraviolet (UV)-light-driven photocatalytic degradations of bisphenol A (BPA) using them as photocatalysts were studied. It was found that the outer diameter of CNTs was around 50 nm and there were a few defects in the crystal lattice. The synthesized Cu_0.05Zn_0.95O nanocomposites had a diameter of around 40 nm. Cu_0.05Zn_0.95O nanocomposites have grown on the surface of the CNTs and the outer diameter of them was around 100 nm. The synthesized hybrid carbon nanotubes using B. juncea could enhance the efficiency of photocatalytic degradation on BPA. The complete equilibration time of adsorption/desorption of BPA onto the surface of CNTs, Cu_0.05Zn_0.95O nanoparticles, and CNTs/Cu_0.05Zn_0.95O nanocomposites was within 30, 20, and 30 min, and approximately 14.9, 8.7, and 17.4 % BPA was adsorbed by them, respectively. The combination of UV light irradiation (90 min) with CNTs, Cu_0.05Zn_0.95O nanoparticles, and CNTs/Cu_0.05Zn_0.95O nanocomposites could lead to 48.3, 75.7, and 92.6 % decomposition yields of BPA, respectively. These findings constitute a new insight for synthesizing nanocatalyst by reusing hyperaccumulators.     

城市下水污泥焚烧过程中二次污染物排放特性的试验研究

在0.15 MWt循环流化床燃烧试验台上进行了城市下水污泥与煤的混烧试验,分析了烟气中的二次污染物排放特性.分析结果表明,利用循环流化床焚烧城市下水污泥时,添加辅助燃料(如煤)及改变焚烧条件,不仅可以达到稳定燃烧的目的,而且有利于抑制焚烧中二次污染物(如CO及二恶英等有机污染物)的生成.分析了焚烧污泥污染物的排放特性,为采用焚烧方式处理城市下水污泥提供了基础性试验数据.