高锰酸钾与接触氧化协同除锰及硬度对除锰效果的影响

针对日益严重的地表水锰污染，本实验采用高锰酸钾与接触氧化的方法协同除锰；通过调配进水中Ca²⁺、Mg²⁺含量模拟我国不同地区硬度差异显著的地表水，探究水体硬度对锰的去除效果的影响.结果表明：Mn²⁺被高锰酸钾氧化并形成"锰质活性滤膜"，可在停药后实现稳定有效除锰.成熟滤池的除锰效果会显著受到硬度的影响，进水硬度在40、200、400 mg·L^-1及700 mg·L^-1（CaCO₃计）时，接触氧化滤池分别在48、56、64 d及72 d实现稳定除锰，而4根滤柱对Mn²⁺去除的极限浓度分别为1.8、1.7、1.2 mg·L^-1及0.7 mg·L^-1.     

湖泊、水库水的强化混凝除藻的试验研究

就高锰酸钾复合药剂强化混凝对湖泊、水库水中藻类的去除进行了研究，试验表明：投加一定量的高锰酸钾复合药剂可显著提高水中藻类的去除率。将经与预氯化、预投加高锰酸钾除藻工艺进行比较，表明高锰 酸钾复合药剂强化混凝除藻效率明显优于传统预氯化、预投加高锰酸钾除藻工艺。     

Chemical cleaning of fouled PVC membrane during ultrafiltration of algal-rich water

Cleaning of hollow-fibre polyvinyl chloride (PVC) membrane with di erent chemical reagents after ultrafiltration of algal-rich water was investigated. Among the tested cleaning reagents (NaOH, HCl, EDTA, and NaClO), 100 mg/L NaClO exhibited the best performance (88.4% 1.1%) in removing the irreversible fouling resistance. This might be attributed to the fact that NaClO could eliminate almost all the major foulants such as carbohydrate-like and protein-like materials on the membrane surface, as confirmed by Fourier transform infrared spectroscopy analysis. However, negligible irreversible resistance (1.5% 1.0%) was obtained when the membrane was cleaning by 500 mg/L NaOH for 1.0 hr, although the NaOH solution could also desorb a portion of the major foulants from the fouled PVC membrane. Scanning electronic microscopy and atomic force microscopy analyses demonstrated that 500 mg/L NaOH could change the structure of the residual foulants on the membrane, making them more tightly attached to the membrane surface. This phenomenon might be responsible for the negligible membrane permeability restoration after NaOH cleaning. On the other hand, the microscopic analyses reflected that NaClO could e ectively remove the foulants accumulated on the membrane surface.     

高锰酸盐复合药剂预氧化缓解超滤膜藻类污染的中试研究

通过中试试验考察了高锰酸盐复合药剂(PPC)预氧化强化混凝/沉淀/超滤的组合工艺的除藻效能以及PPC预氧化对藻类引起的膜污染的缓解作用,并对其机理进行了探讨.试验结果表明,投加0.6mg·L-1PPC能使预处理阶段对藻类的平均去除率提高约28%.组合工艺处理高藻水时,PPC预氧化通过强化预处理,降低膜表面的污染负荷,对藻源污染物引起可逆和不可逆污染均具有一定的缓解作用.化学清洗试验结果表明,碱洗对超滤膜TMP恢复效果远远强于酸洗,因而有机物是超滤膜处理高藻水时的主要污染物质.     

低温条件下絮体破碎再絮凝去除水中颗粒的研究

为了了解低温条件下絮体的形成/破碎/再絮凝过程在适当条件下对絮凝去除水中颗粒物的强化效果,采用PDA2000透光率脉动检测仪对絮凝破碎再絮凝过程进行了在线监测.研究结果表明,当电中和机理占主导作用时(混凝剂投加量小于0.1 mmol·L-1),絮体破碎后能重新絮凝,絮体大小能恢复到破碎之前;而当网捕卷扫机理占主导作用时(混凝剂投加量大于0.2 mmol·L-1),絮体的恢复情况不如电中和条件,再絮凝能力降低.投加适量的腐殖酸会增加絮体破碎前后的分形维数,但过量的腐殖酸则会降低破碎前后絮体的分形维数.絮体破碎再絮凝后其分形维数比破碎前高.腐殖酸的投加量并不会明显影响絮凝和破碎后再絮凝的FI指数.电中和絮体破碎前初始絮凝时间越长破碎后沉后水浊度越低,破碎后其浊度会比破碎前显著减小.较低投量的铝盐就能使得沉后水浊度降到很低,因此可以降低混凝剂投量而达到更好的水处理效果.     

高锰酸钾净水的氧化副产物研究

在高锰酸钾预氧化条件下 ,对北京京密引水渠水和松花江水进行混凝处理 ,并将原水与出水水样经色谱 质谱联用仪分析 ,以 1997年美国国家环保局 (USEPA)提出的饮用水规程和健康建议为标准 ,初步探讨了高锰酸钾净水过程中产生的副产物是否对人体有毒害作用 .试验结果表明 :在试验条件下 ,尚未发现高锰酸钾氧化生成USEPA规定的有毒有害副产物 ,并认为其原因可能与高锰酸钾氧化作用方式以及氧化过程中生成的新生态水合二氧化锰的吸附作用有关 .     

臭氧-固定化生物活性炭滤池深度处理石化废水的试验研究

针对石化废水中不同特征污染物,采用人工分离筛选去除COD和油工程菌6株、硝化工程菌10株(亚硝化细菌5株、硝化细菌5株)构建高效混合菌群,通过臭氧固定化生物活性炭滤池除污染效能中试研究表明,该系统深度处理石化难降解有机废水是可行的,能同时实现去除COD、油类、NH3 N等污染物的功效,对COD、油类、NH3 N和色度的平均去除率分别为73 0%、90 5%、81 2%和90%,相应的出水分别为33 2mg/L、0 4mg/L、4 5mg/L和10倍,各项指标均达到了国家循环冷却水的用水要求,它的推广应用必将带来显著的环境效益、社会效益和经济效益。     

腐殖酸在水合二氧化锰表面的吸附行为

研究了腐殖酸在水合MnO2 (S) (δMnO2 )表面的吸附行为 .考察了不同分子量分布范围腐殖酸的吸附性能 ,探讨了阳离子对吸附行为的影响及其可能作用机理 ,并利用FTIR光谱对吸附行为进行了光谱学研究 .结果发现 ,具有较高分子量的腐殖酸HAa 的吸附去除率比具有较低分子量的腐殖酸HAb 高 3 0 % ,表明腐殖酸分子量越大越倾向于吸附在δMnO2 表面 .Ca2 + 较Mg2 + 更能促进腐殖酸在δMnO2 表面的吸附 ;紫外 -可见吸收光谱分析表明Ca2 + 较Mg2 + 具有更强的与腐殖酸络合的能力 ;此外 ,ζ电位测定发现 ,1 0mmol·L- 1 Mg2 + 使δMnO2 的 ζ电位由 -3 7mV(pH =7 9)升高至 -9mV(pH =6 5 ) ,而 1 0mmol·L- 1 Ca2 + 则使ζ电位升高至 + 7mV(pH =7 2 ) .FTIR光谱的结果证实了腐殖酸在δMnO2 表面的吸附 ,并表明腐殖酸的羧基及δMnO2 的表面羟基 (Mn OH)在吸附过程中起着重要作用 .上述结果表明 ,腐殖酸性质、背景阳离子等因素对腐殖酸的吸附行为有重要影响     

Metabolic uncoupler, 3,3′,4′,5-tetrachlorosalicylanilide addition for sludge reduction and fouling control in a gravity-driven membrane bioreactor

• Effects of metabolic uncoupler TCS on the performances of GDMBR were evaluated. • Sludge EPS reduced and transformed into dissolved SMP when TCS was added. • Appropriate TCS increased the permeability and reduced cake layer fouling. • High dosage aggravated fouling due to compact cake layer with low bio-activity. The gravity-driven membrane bioreactor (MBR)system is promising for decentralized sewage treatment because of its low energy consumption and maintenance requirements. However, the growing sludge not only increases membrane fouling, but also augments operational complexities (sludge discharge). We added the metabolic uncoupler 3,3′,4′,5-tetrachlorosalicylanilide (TCS) to the system to deal with the mentioned issues. Based on the results, TCS addition effectively decreased sludge ATP and sludge yield (reduced by 50%). Extracellular polymeric substances (EPS; proteins and polysaccharides) decreased with the addition of TCS and were transformed into dissolved soluble microbial products (SMPs) in the bulk solution, leading to the break of sludge flocs into small fragments. Permeability was increased by more than two times, reaching 60–70 L/m²/h bar when 10–30 mg/L TCS were added, because of the reduced suspended sludge and the formation of a thin cake layer with low EPS levels. Resistance analyses confirmed that appropriate dosages of TCS primarily decreased the cake layer and hydraulically reversible resistances. Permeability decreased at high dosage (50 mg/L) due to the release of excess sludge fragments and SMP into the supernatant, with a thin but more compact fouling layer with low bioactivity developing on the membrane surface, causing higher cake layer and pore blocking resistances. Our study provides a fundamental understanding of how a metabolic uncoupler affects the sludge and bio-fouling layers at different dosages, with practical relevance for in situ sludge reduction and membrane fouling alleviation in MBR systems.     

Microbial community composition and electricity generation in cattle manure slurry treatment using microbial fuel cells: effects of inoculum addition

Environmental Science and Pollution Research - Microbial fuel cell (MFC) is a sustainable technology to treat cattle manure slurry (CMS) for converting chemical energy to bioelectricity. In this...