脉冲电弧液相放电等离子体处理生活污水回用研究

利用脉冲电弧液相放电等离子体技术,采用某小区的生活污水,研究放电脉冲次数、放电峰值电压、曝气量对COD、氨氮去除的影响.随着放电脉冲次数的增加,COD与氨氮去除率逐渐升高,当放电脉冲次数为400次时,COD和氨氮的去除率分别为81.8％、80.3％.随着放电峰值电压的升高与曝气量的增加,COD、氨氮的去除效率增加.在相同放电处理时间下,当峰值电压为18 kV时,曝气量大于4m3/h,COD去除率大于96％,氨氮去除率大于90％,出水水质满足回用标准.     

Visible-light-driven photocatalytic inactivation of bacteriophage f2 by Cu-TiO2 nanofibers in the presence of humic acid

Pathogenic viruses in drinking water are great threats to public health. Visible-light-driven photocatalysis is a promising technology for virus inactivation. However, the existing photocatalytic antiviral research studies have mostly been carried out in single-component systems, neglecting the effect of natural organic matter, which exists widely in actual water bodies. In this paper, electrospun Cu-TiO₂ nanofibers were prepared as photocatalysts, and their photocatalytic antiviral performance in the presence of humic acid (HA) was comprehensively studied for the first time. The properties of the reaction mixture were measured during the reaction. In addition, the safety, reliability and stability of photocatalytic disinfection in the mixed system were evaluated. The results showed that the virus removal efficiency decreased with the increase of the HA concentration. The type of reaction solution, such as PBS buffer solution or water, did not affect the removal efficiency noticeably. Under acidic conditions, the electrostatic forces between photocatalysts and viruses were strengthened, leading to higher virus removal efficiency. As the reaction time went on, the pH value in the solution increased first and then tended to be stable, the conductivity remained stable, and the dissolved oxygen increased first and then decreased. The safety test showed that the concentration of Cu ions released into the solution was lower than specified by the international standards. No photoreactivation was observed, and the addition of HA significantly reduced the reutilization efficiency of the photocatalysts.     

大窑湾疏浚水环境要素变化特征及其相关关系

根据大窑湾后６个泊位疏浚工程本底调查和疏浚监测结果，借助因子分析探讨了疏浚前后水环境要素的变化特征及相关关系，找出了控制污染物分布的主要因子，评价了疏浚对海洋环境的影响。     

硅藻土地区桥梁灌注桩成孔测试研究∗

硅藻土作为一种特殊的黏性土,在分布上具有一定的区域性,目前针对该类型土的工程特性以及硅藻土地区灌注桩成孔方法的研究都较少。以杭绍台高铁项目为工程依托,为了研究硅藻土层中灌注桩的成孔方法,开展了灌注桩成孔方法现场试验;分别采用冲击锤锤击成孔、旋挖干钻成孔和旋挖泥浆护壁成孔三种方法进行施工,对三种方法的成孔质量进行分析对比。研究结果表明:在硅藻土地区施工灌注桩,旋挖干钻成孔工艺施工速度较快,效率高,桩长、桩径、桩位偏差和垂直度均能满足设计要求,成孔后孔壁稳定性好,成孔质量更为可靠;冲击锤法成孔,成孔速度较慢,且存在桩孔扩径现象;旋挖泥浆护壁法成孔后平稳性较差,波动性较大,且存在局部塌孔现象,成孔效果较差。因此建议硅藻土地段优先考虑采用旋挖干钻法施工桥梁灌注桩。     

钙钛矿型催化剂催化湿式氧化处理煤气化废水纳滤浓缩液

采用溶胶-凝胶法制备了Mn掺杂钙钛矿型催化剂LaFexMn1-xO3,并以其为催化剂催化湿式双氧水氧化处理煤气化废水纳滤浓缩液。采用XRD,SEM,FTIR技术对催化剂进行了表征。表征结果显示：制备的催化剂均具有标准的钙钛矿型结构,其中,LaFe0.9Mn0.1O3的结构稳定,比表面积大。实验结果表明：制备的催化剂中LaFe0.9Mn0.1O3的催化活性最高,且稳定性好,连续使用5次后催化活性未见明显减弱;在H2O2投加量3.0 g/L、n（H2O2）∶n（LaFe0.9Mn0.1O3）=12∶1、反应温度160 ℃、反应压力1 MPa、浓缩液pH 3、反应时间60 min的最优条件下,COD、UV254和TOC的去除率分别达到80.9%、95.2%和68.0%,BOD5/COD由0.02提升至0.40,可生化性大幅提高。     

Size distributions of aerosol and water-soluble ions in Nanjing during a crop residual burning event

To investigate the impact on urban air pollution by crop residual burning outside Nanjing, aerosol concentration, pollution gas concentration, mass concentration, and water-soluble ion size distribution were observed during one event of November 4-9, 2010. Results show that the size distribution of aerosol concentration is bimodal on pollution days and normal days, with peak values at 60-70 and 200-300 nm, respectively. Aerosol concentration is 10⁴ cm^-3. nm^-1 on pollution days. The peak value of spectrum distribution of aerosol concentration on pollution days is 1.5-3.3 times higher than that on a normal day. Crop residual burning has a great impact on the concentration of fine particles. Diurnal variation of aerosol concentration is trimodal on pollution days and normal days, with peak values at 03:00, 09:00 and 19:00 local standard time. The first peak is impacted by meteorological elements, while the second and third peaks are due to human activities, such as rush hour traffic. Crop residual burning has the greatest impact on SO₂ concentration, followed by NO₂, O₃ is hardly affected. The impact of crop residual burning on fine particles (< 2.1 μm) is larger than on coarse particles (> 2.1 μm), thus ion concentration in fine particles is higher than that in coarse particles. Crop residual burning leads to similar increase in all ion components, thus it has a small impact on the water-soluble ions order. Crop residual burning has a strong impact on the size distribution of K⁺, Cl^-, Na⁺, and F^- and has a weak impact on the size distributions of NH₄⁺, Ca²⁺, NO₃^- and SO₄^2-.     

土壤优先流的理论研究和试验分析

在活动流场模型的基础上建立了新的溶质运移控制方程,研究了流场分形特征参数的计算方法;采用4组染色示踪试验资料,分析了活动流场模型模拟土壤水流运动和溶质运移宏观非均匀特征的适用性.模拟分析表明,活动流场模型能较准确地捕捉到土壤中的优先流特别是不稳定流的宏观运动特征;土壤存在大孔隙结构的情况下,水流和溶质将更快的迁移到深层土壤,活动流场模型模拟计算的入渗深度偏小,但大于连续性模型的模拟计算结果;当土壤中的大孔隙结构较少时,活动流场模型模拟预测的土壤含水率分布和溶质浓度分布与实测结果比较一致.     

Nutritionally relevant elements in staple foods: influence of arable site versus choice of variety

Eighteen representative sites for the Austrian grain-growing and eight for the potato-growing zones (soils and crops) were investigated. On each site, total element contents (B, Ba, Ca, Cd, Co, Cu, Fe, K, Li, Mg, Mn, Mo, Na, P, Sr and Zn) were determined in 4–12 varieties of winter wheat (n = 136), 6 varieties of spring durum wheat (n = 30), 5 varieties of winter durum wheat (n = 15), 7 varieties of rye (n = 49), 5 varieties of spring barley (n = 30) and 5 varieties of potatoes (n = 40). Element accumulations in grain species and potato tubers varied significantly with site conditions, with the main exceptions for B in potatoes and wheat as well as for Zn, Cu and Co in durum wheat. On average, across all investigated sites, differences in varieties occurred concerning the elements Ca, Cd, Ba, Sr and Zn (except Zn in potatoes and winter durum). A rough estimation revealed that an average Austrian consumer of wheat, rye and potatoes meets more than 50% of the needs of daily element intake for K, P and Mg, between 36 and 72% for Fe, Zn and Cu, and more than 100% for Co, Mo and Mn. In particular, the elements Ca and Na have to be added from other sources.