Internationally harmonized approach to biomonitoring trace element atmospheric deposition

The International Atomic Energy Agency (IAEA) has been systematically supporting work on biomonitoring air pollution using plants since 1997. Such studies are presently being supported by the IAEA in 14 countries within a co-ordinated research project. The main emphasis of this project is on (1) identification of suitable biomonitors of atmospheric pollution for local and/or regional application, and (2) their validation for general environmental monitoring, whenever possible. Although the participants are using different plants as biomonitors in their research in geographically and climatically diverse parts of the world, they are harmonising sampling approaches and analytical procedures. In this paper, an overview of these activities is given, along with the details, where possible. In all of these activities, proficiency testing and analytical quality assurance are important issues, which merit special attention. Within the scope of an intercomparison exercise, two lichen materials were distributed among the participating laboratories and a proficiency test was organised. The results obtained proved satisfactory performance for most participating laboratories.     

Use of 15N-depleted artificial compost in bound residue studies

Association of bound residues to soil humic matter may be accomplished by different binding mechanisms such as sequestration in hydrophobic interiors of the organic material or covalent linkage to the organic matter. The structures and chemical environments of compounds can be observed by NMR spectroscopy. We applied 15N-NMR spectroscopy to study the soil-bound residues of 15N-labeled simazine. As the 15N-isotope has a low sensitivity and natural abundance 15N-NMR experiments require long measurement times and often result in low signal-to-noise (S/N) ratios. Therefore, in addition to the use of 15N-labeled simazine, 15N-depleted compost was used to reduce the amount of background signal and enhance the sensitivity. The compost was produced from maize and wheat plants grown on sand with 15N-depleted NH4NO3 as sole nitrogen source. The plants were freeze-dried, ground and mixed with sand for composting. After a composting period of 224 days analysis of the compost revealed a 15N-content of 267 ppm as opposed to a natural abundance of 3650 ppm. Characterization of this artificial compost produced parameter values similar to those of a natural compost. The 13C-NMR-spectra of the humic and fulvic acids during different stages of maturity showed that there was a shift from single-bond functional groups to more complex double-bond and aromatic structures. Experiments with this compost showed an increased signal intensity. The improved sensitivity made it possible to obtain interpretable NMR signals in contrast to experiments with 15N-simazine on native soil where no signals were detectable. The data indicated that the bound residues of simazine are composed of metabolites resulting from N-dealkylation and triazine ring destruction. Silylation of the bound residues showed a very strong binding of the residues to the matrix as only a small fraction could be solubilized.     

Der VG?D 2005 im überblick

Ohne Zusammenfassung     

Remote monitoring of air pollutant emissions from point sources by a mobile lidar/sodar system

This paper describes remote monitoring of air pollutant emissions by a mobile lidar (light detection and ranging)/ sodar (sound detection and ranging) system. First, measurements are carried out in the flue gas plume of a public power plant. The investigations focus mainly on quantifying SO2 emissions, but the uncertainties of such measurements are also emphasized. Furthermore, an example providing valuable data sets for the development and validation of plume dispersion models is outlined with measurements of the dilution of SO2 along the plume axis. Series of repeated determinations of SO2 emissions show a large variation in the obtained flux values, with moderate margins of error. Incomplete recording of the plume within the individual lidar scans, induced by strong looping movements of the flue gas plume, predominantly causes the variations of flux values. Therefore, the highest flux values determined are considered to be the most exact. This is verified by a comparison of measured fluxes with in situ measurements made by the plant operators. The results further indicate that lidar measurements illustrate the location and dimension of aerosol plumes better than the location and dimension of the plumes of gaseous compounds. The wind direction affecting the plume at any moment can be determined faster by lidar than by sodar because the latter requires much longer time intervals of signal averaging. Measurements show higher concentrations of SO2 compared with results from a Gaussian plume model for periods of less than 5 min after dispersion. The findings emphasize the suitability of remote sensing for detecting emissions and for investigating the propagation and dilution of air pollutant plumes.     

Application of ground-based Lidar for studies of the dynamics of ozone in a mountainous basin

A ground-based Differential Absorption Lidar was employed to study the dynamics of atmospheric O3 within the planetary boundary layer of a basin in the 'Fichtelgebirge' mountains, NE Bavaria. In particular, the night-time dynamics of O3 linked to the ground were investigated. The Lidar system measured vertical profiles of O3 up to 1 km above ground. For detailed analysis of the night-time dynamics of ozone, supplementary data from three ground-based stations (measuring mixing ratios of O3 and NO(x), as well as meteorological parameters) are essential. The Lidar results could be evaluated with these data from various altitudes above the basin floor. For the station with the largest (vertical) distance to the ground-based Lidar, the agreement was very good at all times. The Lidar method proved to be useful for examining the spatial distribution of O3. The observed night-time decrease of O3 at the bottom of the basin was due to deposition and to advection of air masses containing less O3 from the mountain slopes.     

Screening and Scenarios of Traffic Emissions at Trier,Germany

SCOPE AND BACKGROUND: In the course of the European Council Directive on permissible air pollutant limit values, valid starting from 2005 there is an urgent call for action, particularly for fine dust (PM10). Current investigations (Junk & Helbig 2003, Reuter & Baumüller 2003) show that the limit values in certain places in congested areas are exceeded. Only if it is possible to locate these Hot Spots purposeful measures to reduce the ambient air pollution can be conducted. For an efficient identification of these Hot Spots numerical computer models or establishing special measurements networks are too expensive. Using the statistical model STREET 5.0 (KTT 2003) a cost-effective screening of the air pollution situation caused by the traffic can be done. METHODS: STREET is based on the 3-dimensional micro-scale non-hydrostatic flow- and dispersion model MISCAM (Eichhorn 1989). The results of over 100.000 different calculations with MISCAM are stored in a Database and used to calculate the emissions with STREET. In collaboration with the city council of Trier more than 150 streets were investigated, mapped, and calculated. A special urban climate measuring network supplies the necessary meteorological input data about the wind field and precipitation events in the valley of the Moselle. Information about road width and road orientation as well as building density was derived from aerial photographs. Traffic censuses and mobile air pollutants measurements supplied the remaining input data. We calculated the mean annual air pollutant concentrations for NO2, CO, SO2, O3, benzene as well as PM10. RESULTS: A comparison of the model results with the values obtained from the stations of the central emission measuring network of Rhineland-Palatinate (ZIMEN, annual report 2002) shows very good agreements. The model was not only used to calculate the annual air pollutant but also for urban planning and management. The absolute level of the air pollutant is mainly dependent on the amount of traffic in the street canyons. Therefore four different case-scenarios with varying quantity of traffic were calculated and interpreted for each street. The results of the calculation show that on the basis of the mean values for both NO2 and benzene, it is not to be expected that the limits PERSPECTIVES: Furthermore the model can be used to find the maximum tolerable numbers of cars for a street without exceeding the air pollutant thresholds.     

Anthropogenic threats to evolutionary heritage of angiosperms in the Netherlands through an increase in high-competition environments

Present biodiversity comprises the evolutionary heritage of Earth's epochs. Lineages from particular epochs are often found in particular habitats, but whether current habitat decline threatens the heritage from particular epochs is unknown. We hypothesized that within a given region, humans threaten specifically habitats that harbor lineages from a particular geological epoch. We expect so because humans threaten environments that dominated and lineages that diversified during these epochs. We devised a new approach to quantify, per habitat type, diversification of lineages from different epochs. For Netherlands, one of the floristically and ecologically best-studied regions, we quantified the decline of habitat types and species in the past century. We defined habitat types based on vegetation classification and used existing ranking of decline of vegetation classes and species. Currently, most declining habitat types and the group of red-listed species are characterized by increased diversification of lineages dating back to Paleogene, specifically to Paleocene-Eocene and Oligocene. Among vulnerable habitat types with large representation of lineages from these epochs were sublittoral and eulittoral zones of temperate seas and 2 types of nutrient-poor, open habitats. These losses of evolutionary heritage would go unnoticed with classical measures of evolutionary diversity. Loss of heritage from Paleocene-Eocene became unrelated to decline once low competition, shade tolerance, and low proportion of non-Apiaceae were accounted for, suggesting that these variables explain the loss of heritage from Paleocene-Eocene. Losses of heritage from Oligocene were partly explained by decline of habitat types occupied by weak competitors and shade-tolerant species. Our results suggest a so-far unappreciated human threat to evolutionary heritage: habitat decline threatens descendants from particular epochs. If the trends persist into the future uncontrolled, there may be no habitats within the region for many descendants of evolutionary ancient epochs, such as Paleogene.     

Procedural rationality and ethical theory

This paper is based on one given by Professor Faludi at the Conference on Planning Theory at Torino, Italy in 1986. It answers criticisms of his procedural planning theory voiced by various theorists and enjoined by the authors of the call for papers for the conference. The paper argues that the misgivings voiced by critics have their parallel in ethical theory and develops the view that procedural rationality and utilitarianism share an ethical principle. The paper concludes with a call for an end to sterile debate and an acceptance of different modes of argument.     

Effects of new technologies with special regard for the implementation process per se

The aim of this study was to investigate the effects of the implementation process to new technologies [e.g. drawing board/computer-aided design (CAD), microfiche/electronic data processing] on the employees concerned. Since the emphasis of the study lay in the intrinsic relationship of the implementation process with stress reactions, the parameters were measured at the place of work in a longitudinal design. Employees (n = 279) in seven companies (work fields: CAD, clerical work, telephone information desk) were tested three times — two months prior to, during, and 12 months after implementation. Aspects of strain and satisfaction were taken into account at each measurement phase. A special test-instrument was designed to describe the ’style of implementation‘ (manner in which implementation took place) particular to each company. The level of strain was found to increase during the implementation process. The amount of this increase was found to correlate with the company's style of implementation as well as with the type of the individual's work activity. The highest levels were found among those employees little included in the implementation process and those whose work is described as monotonous.