Determination of lipid peroxidation and cytotoxicity in calcium, magnesium, titanium and hectorite (SHCa-1) suspensions

This paper reports data on the relative ability of CaO, CaCl₂, MgO, MgCl₂, TiO₂, and hectorite (SHCa-1) to induce oxidative stress (as determined by lipid peroxidation, LP) in biological matrices. The effectiveness of structural (oxide form) versus soluble Ca and Mg to induce LP is compared. An assessment on cytotoxicity as affected by soluble and structural Ca, Mg, TiO₂ and SHCa-1 is also addressed. LP was screened and monitored using the Thiobarbituric Acid Reactive Substances (TBARS). The extent of TBARS production was found to vary with the type and initial concentration of the soluble or structural cation, Ca or Mg respectively. Obtained results showed higher magnitude values for the latter set of experiments. In the presence of TiO₂ no significant TBARS production was detected pointing out a negligible effect of TiO₂ on LP. At solid concentrations ca. 100 ppm, CaO appears to be more effective than SHCa-1 to induce LP. By contrast at ca. 25 ppm, MgO appears to be more effective than the clay mineral. The SHCa-1 LP-inducing activity has been proven to closely relate to structural Ca. The prevalence of mechanisms that may induce LP but not cytotoxicity (as determined by cell growth inhibition) was also addressed. Results on cell growth inhibition as affected by soluble and structural Ca, Mg, TiO₂ and hectorite provide evidence to support that structural Ca or Mg brings about significantly higher variations than soluble Ca.     

Immunosuppression in the infaunal bivalve Scrobicularia plana environmentally exposed to mercury and association with its accumulation

This study aimed to test the hypothesis whether mercury (Hg) activates or suppresses inappropriately the immunity of the bivalve Scrobicularia plana inhabiting a Hg contaminated area (Laranjo basin, Ria de Aveiro, Portugal). Immunity endpoints, as well as lipid peroxidation (LPO) as a sign of damage, were evaluated in parallel with total Hg burden. Bivalves from both moderately (MO) and highly (HI) contaminated sites displayed higher haemolymph Hg load and reduced plasma agglutination. Increased haemocytes density and decreased phagocytosis were observed at HI, whereas increased oxidative burst activity (OBA) was observed at MO, pointing out that the immunotoxicity is a result of Hg direct contact involving no ROS intervention. OBA observed at MO was concomitantly associated to peroxidative damage as depicted by LPO increase in haemocytes and haemolymph plasma. Thus, S. plana can be suggested as a suitable bioindicator of metal pollution in coastal areas on the basis of Hg bioaccumulation and immunotoxicity responses.     

Occurrence and distribution of pharmaceuticals in surface water, suspended solids and sediments of the Ebro river basin, Spain

The occurrence of 43 pharmaceuticals belonging to predominant therapeutic classes and their distribution in surface water, suspended solids and sediments has been investigated in the Ebro river basin in the Northeast of Spain. WWTP effluents were found to be a main source of contamination and the spatial distribution was affected by the river flow at the sampling point and corresponding dilution factor, resulting in higher concentrations and higher loads in small tributary rivers than in the Ebro river. The study showed that some compounds are preferentially found bound to suspended solids and not detected in river water. Generally, compounds with basic characteristics (pKa > 7) showed higher tendency to bind to suspended solids. The sediment samples generally presented lower concentrations than suspended solids.     

Atmospheric fate of non-volatile and ionizable compounds

A modified version of the Multimedia Activity Model for Ionics MAMI, including two-layered atmosphere, air-water interface partitioning, intermittent rainfall and variable cloud coverage was developed to simulate the atmospheric fate of ten low volatility or ionizable organic chemicals. Probabilistic simulations describing the uncertainty of substance and environmental input properties were run to evaluate the impact of atmospheric parameters, ionization and air-water (or air-ice) interface enrichment.The rate of degradation and the concentration of OH radicals, the duration of dry and wet periods, and the parameters describing air-water partitioning (K_AW and temperature) and ionization (pK_a and pH) are the key parameters determining the potential for long range transport. Wet deposition is an important removal process, but its efficiency is limited, primarily by the duration of the dry period between precipitation events.Given the underlying model assumptions, the presence of clouds contributes to the higher persistence in the troposphere because of the capacity of cloud water to accumulate and transport non-volatile (e.g. 2,4-D) and surface-active chemicals (e.g. PFOA). This limits the efficiency of wet deposition from the troposphere enhancing long-range transport.     

Soil nitrogen transformations under elevated atmospheric CO₂ and O₃ during the soybean growing season

We investigated the influence of elevated CO₂ and O₃ on soil N cycling within the soybean growing season and across soil environments (i.e., rhizosphere and bulk soil) at the Soybean Free Air Concentration Enrichment (SoyFACE) experiment in Illinois, USA. Elevated O₃ decreased soil mineral N likely through a reduction in plant material input and increased denitrification, which was evidenced by the greater abundance of the denitrifier gene nosZ. Elevated CO₂ did not alter the parameters evaluated and both elevated CO₂ and O₃ showed no interactive effects on nitrifier and denitrifier abundance, nor on total and mineral N concentrations. These results indicate that elevated CO₂ may have limited effects on N transformations in soybean agroecosystems. However, elevated O₃ can lead to a decrease in soil N availability in both bulk and rhizosphere soils, and this likely also affects ecosystem productivity by reducing the mineralization rates of plant-derived residues.     

Use of recycled fine aggregate in concretes with durable requirements

The use of construction waste materials as aggregates for concrete production is highly attractive compared to the use of non-renewable natural resources, promoting environmental protection and allowing the development of a new raw material. Several countries have recommendations for the use of recycled coarse aggregate in structural concrete, whereas the use of the fine fraction is limited because it may produce significant changes in some properties of concrete. However, during the last decade the use of recycled fine aggregates (RFA) has achieved a great international interest, mainly because of economic implications related to the shortage of natural sands suitable for the production of concrete, besides to allow an integral use of this type of waste. In this study, the durable behaviour of structural concretes made with different percentage of RFA (0%, 20%, and 30%) is evaluated. Different properties related to the durability of concretes such as absorption, sorptivity, water penetration under pressure, and carbonation are determined. In addition, the results of compressive strength, static modulus of elasticity and drying shrinkage are presented. The obtained results indicate that the recycled concretes have a suitable resistant and durable behaviour, according to the limits indicated by different international codes for structural concrete.     

Trace elements and microbiological parameters in farmed Nile tilapia with emphasis on muscle,water, sediment and feed

Fish may bioaccumulate contaminants from the aquatic environment and extend them to the food chain provoking risks to human health. This study evaluated the microbiological parameters of the pond´s water and trace elements concentrations in samples of water, sediment, feed and muscle of farmed Nile tilapia used for human consumption in southern Brazil. A total of 240 fish were collected from 12 tilapia farms. Sediment, tank water and dry ration used in the animals' diet were collected for analysis. Analysis were performed by Energy Dispersion X-ray Fluorescence (EDXRF), Inductively Coupled Plasma Mass Spectrometer (ICP-MS), Induced Coupled Plasma Optical Emission Spectrometer (ICP-OES), and Atomic Absorption Spectrometer (AAS-VGA). In addition, the microbiological analysis of the water was carried out. The concentrations of Se, I, Fe, Cu and Zn in fish muscle were higher than the recommended by the Brazilian legislation, considering the advised daily intake for adults. The arsenic element had concentrations above the limit stipulated by the present Brazilian legislation, observed in all samples of muscle, sediment and tank water highlighting a possible environmental and fish contamination by the toxic element. Moreover, the arsenic concentration in the water presented a positive correlation (ρ?=?0.33) with arsenic in the muscle, suggesting that tilapia is a good environmental bioindicator, once they properly reflect the levels of arsenic in the water. It is suggested to perform an arsenic speciation for quantification of the inorganic form and accurate assessment of the degree of toxicity in the muscle samples and risks it can bring to human health. Regarding the other potentially toxic elements (Hg, Pb and Cd), and microbiological analysis of water it was verified that the consumption of the fish in question does not raise risks, since the values are within a quality benchmark established by law. The concentration of total and fecal coliforms in pond´s water in the facilities was in agreement with the microbiological indexes required by the legislation of CONAMA class II. Western region presented the lowest concentrations of fecal coliforms when compared to the other regions. There was no significant difference in the microbiological counts of total heterotrophic bacteria, Vibrio spp. and Pseudomonas spp. among the regions.     

Forecasting model to assess the potential of secondary lead production from lead acid battery scrap

Environmental Science and Pollution Research - Lead acid battery (LAB) scrap management is an important issue both environmentally and economically. The recovery of lead from battery scrap leads to...     

Microplastic distribution in surface sediments along the Spanish Mediterranean continental shelf

Environmental Science and Pollution Research - Microplastics (MPs) are widely recognised as a contaminant of emerging concern in the marine environment. This work provides original data of the...     

Biomass consumption and CO2, CO and main hydrocarbon gas emissions in an Amazonian forest clearing fire

Biomass consumption and CO₂, CO and hydrocarbon gas emissions in an Amazonian forest clearing fire are presented and discussed. The experiment was conducted in the arc of deforestation, near the city of Alta Floresta, state of Mato Grosso, Brazil. The average carbon content of dry biomass was 48% and the estimated average moisture content of fresh biomass was 42% on wet weight basis. The fresh biomass and the amount of carbon on the ground before burning were estimated as 528 t ha^?1 and 147 t ha^?1, respectively. The overall biomass consumption for the experiment was estimated as 23.9%. A series of experiment in the same region resulted in average efficiency of 40% for areas of same size and 50% for larger areas. The lower efficiency obtained in the burn reported here occurred possibly due to rain before the experiment. Excess mixing ratios were measured for CO₂, CO, CH₄, C₂–C₃ aliphatic hydrocarbons, and PM_2.5. Excess mixing ratios of CH₄ and C₂–C₃ hydrocarbons were linearly correlated with those of CO. The average emission factors of CO₂, CO, CH₄, NMHC, and PM_2.5 were 1,599, 111.3, 9.2, 5.6, and 4.8 g kg^?1 of burned dry biomass, respectively. One hectare of burned forest released about 117,000 kg of CO₂, 8100 kg of CO, 675 kg of CH₄, 407 kg of NMHC and 354 kg of PM_2.5.