Effects of reductive inorganics and NOM on the formation of chlorite in the chlorine dioxide disinfection of drinking water

Chlorine dioxide (ClO₂) disinfection usually does not produce halogenated disinfection by-products, but the formation of the inorganic by-product chlorite (ClO₂^–) is a serious consideration. In this study, the ClO₂^– formation rule in the ClO₂ disinfection of drinking water was investigated in the presence of three representative reductive inorganics and four natural organic matters (NOMs), respectively. Fe²⁺ and S^2– mainly reduced ClO₂ to ClO₂^– at low concentrations. When ClO₂ was consumed, the ClO₂^– would be further reduced by Fe²⁺ and S^2–, leading to the decrease of ClO₂^–. The reaction efficiency of Mn²⁺ with ClO₂ was lower than that of Fe²⁺ and S^2–. It might be the case that MnO₂ generated by the reaction between Mn²⁺ and ClO₂ had adsorption and catalytic oxidation on Mn²⁺. However, Mn²⁺ would not reduce ClO₂^–. Among the four NOMs, humic acid and fulvic acid reacted with ClO₂ actively, followed by bovine serum albumin, while sodium alginate had almost no reaction with ClO₂. The maximum ClO₂^– yields of reductive inorganics (70%) was higher than that of NOM (around 60%). The lower the concentration of reductive substances, the more ClO₂^– could be produced by per unit concentration of reductive substances. The results of the actual water samples showed that both reductive inorganics and NOM played an important role in the formation of ClO₂^– in disinfection.     

Co-metabolic and biochar-promoted biodegradation of mixed PAHs by highly efficient microbial consortium QY1

Polycyclic aromatic hydrocarbons (PAHs), typical representatives of the persistent organic pollutants (POPs), have become ubiquitous in the environment. In this study, a novel microbial consortium QY1 that performed outstanding PAHs-degrading capacity has been enriched. The degradation characteristics of single and mixed PAHs treated with QY1 were studied, and the effect of biochar on biodegradation of mixed PAHs and the potential of biochar in PAHs-heavy metal combined pollution bioremediation were also investigated. Results showed that, in single substrate system, QY1 degraded 94.5% of 500 mg/L phenanthrene (PHE) and 17.8% of 10 mg/L pyrene (PYR) after 7 days, while in PHE-PYR mixture system, the biodegradation efficiencies of PHE (500 mg/L) and PYR (10 mg/L) reached 94.0% and 96.2%, respectively, since PHE served as co-metabolic substrate to have significantly improved PYR biodegradation. Notably, with the cooperation of biochar, the biodegradations of PHE and PYR were greatly accelerated. Further, biochar could reduce the adverse impact of heavy metals (Cd²⁺, Cu²⁺, Cr₂O₇^2?) on PYR biodegradation remarkably. The sequencing analysis revealed that Methylobacterium, Burkholderia and Stenotrophomonas were the dominant genera of QY1 in almost all treatments, indicating that these genera might play key roles in PAHs biodegradation. Overall, this study provided new insights into the efficient bioremediation of PAHs-contaminated site.     

美国路易斯安那州自然资源损害评估制度及其启示

联邦《石油污染条例》、州《溢油预防和应对法案》和《溢油预防和应对条例》共同构成了美国路易斯安那州自然资源损害评估制度体系,确立了评估活动主导者和参与者明确、程序清晰、客观公正、资金来源有保障,且融合了应急、评估、响应行动于一体的评估制度。我国正在建立的生态环境损害赔偿制度,虽然就损害评估已经形成了部分规范性文件,但多重视的是评估机构的资质管理和具体的评估技术方法,有必要借鉴域外经验,从主体构建、程序设计、多方参与、评估资金、融合评估和应急、恢复行动于一体五个方面完善评估管理制度。     

T2铜在不同海水飞溅条件下的腐蚀性能差异

目的研究T2铜在不同飞溅条件下的腐蚀行为。方法通过对T2铜在三亚热带海水飞溅区进行0.5、1、2 a三个周期的环境试验,采用扫描电子显微镜、X射线衍射仪对其腐蚀产物形貌、物相进行分析,使用电化学工作站对带锈样品进行分析。结果 T2铜在堤岸飞溅区和堤岸内飞溅区腐蚀速率随时间的延长逐渐下降。在飞溅区,不同周期T2铜的腐蚀产物为表面较薄的氧化层,且存在分层现象,主要由外层疏松的绿色Cu2(OH)3Cl和内层致密的棕色Cu_2O组成。不同试验周期,两处飞溅区试样表面的腐蚀产物都较为平整,堤岸飞溅区腐蚀产物层的平均厚度大于堤岸内飞溅区,腐蚀形貌均为均匀腐蚀。两处飞溅区锈层均由Cu_2O和Cu2(OH)3Cl相构成,堤岸飞溅区锈层主要为Cu_2O和Cu2(OH)3Cl相,堤岸内飞溅区锈层主要为Cu_2O相,存在少量Cu2(OH)3Cl相。结论在同一试验地点进行飞溅试验,由于飞溅条件不同,2a内铜的腐蚀速率、腐蚀产物等会存在差异。     

MWNTs/TiO2对典型氯苯类化合物的光催化降解研究

研究复合光催化剂MWNTs/TiO2对典型氯苯类有机化合物光催化降解动力学及主要光降解路径.结果表明,同一初始浓度和相同光催化降解实验条件下,60min时典型氯苯类有机化合物的光降解率均达到90%以上.其中六氯苯和五氯苯的光催化降解速率常数分别为0.0664h-1和0.0670h-1,其大小明显高于其它氯苯类化合物.1,二氯苯的光催化降解反应速率常数仅为0.0430h4--1,在典型氯苯类化合物中最小.三氯苯的3种同分异构体——1,3-三氯苯、24-三氯苯和1,5-三氯苯的光催化降解速率常数分别为0.0547h2,1,,3,-1、0445h0.-1和0.0439h-1.六氯苯的主要光催化降解路径为:HCB→PeCB→1,2,3,5-TeCB→1,2,4-TCB→1,4-DCB.     

粉煤灰和活性污泥对好氧填埋渗滤液组分的影响

通过在好氧反应器中添加粉煤灰和活性污泥来加速固体废物的降解。实验结果表明,添加粉煤灰不但改善了氧气扩散,而且增强了反应器对各种污染物的去除能力,对渗滤液中COD、NH4+、NO3-的去除率分别达到75%、68%和65%以上;添加活性污泥引入了一定量的微生物,也有利于固体废物的降解,渗滤液中COD、NH4+、NO3-的去除率分别达到了90%、65%和77%。因此,通过添加粉煤灰和活性污泥来加速固体废物降解是可行的。     

电化学氧化预处理垃圾渗滤液的可行性研究

文章采用电化学氧化技术预处理渗滤液,在以钛涂钌铱为阳极、不锈钢为阴极,极板距离1.5cm,电流密度60mA/cm2,不外加电解质的情况下,电解120min,渗滤液的COD去除率达到48.6%,NH4+离子浓度去除率达53.6%,BOD5/COD比值由0.15提高到0.38,达到了较好的预处理效果。     

浅谈简化测定总磷的方法

采用简单快速的方法消解水体中浊度或色度的干扰,在制备总磷标准时可省略消解操作步骤,实验结果不受影响。     

汽车用材料——PA66及其玻璃纤维复合材料在不同介质中的老化行为研究

在三种介质（二次水，汽油，乙二醇，50℃温度）条件下对PA66及PA66／GF进行95天左右的人工模拟材料在汽车使用环境下的加速试验，对不同老化时间的PA66及PA66／GF试样进行了宏观力学测试及吸湿性测试，并进一步利用示差扫描量热法（DSC），红外光谱及扫描电镜等手段分析老化前后试样的微观结构及组织差异。结合老化前后试样的力学性能变化，揭示了PA66及复合材料的老化规律和机理。实验表明，PA66及PA66／GF在三种介质中拉伸强度呈现下降趋势。其主要机理是介质溶液对试样渗入的结果影响，降低了分子间的相互作用力（范德华力）从而使材料机械性能下降；同时未发现化学作用对材料的力学性能有明显的变化。     

石油降解菌XD-1产表面活性剂的性能

从含油废水中筛选分离到1株原油降解菌XD-1,鉴定为假单胞菌（Pseuomonas sp.）.初步实验表明菌XD-1具有较强的产表面活性剂乳化原油的作用,对该菌的产表面活性剂性能进行了研究.实验证明,菌XD-1所产表面活性剂为脂肽类物质,菌在生长对数期产表面活性剂,表面活性剂的产生为生长相关型;充足的碳源是产表面活性剂的必需条件,菌利用原油为碳源时能持续大量地产表面活性剂;原油和尿素为产表面活性剂的最适碳源和氮源,菌XD-1产表面活性剂的最佳营养培养基组成为葡萄糖10 g,尿素4 g,磷酸二氢钾1 g,微量元素液4 mL,水1 L,pH 8.0.