Potential effects of Thiram on medicago ‐ R. meliloti symbiotic association†

Abstract

The effects of Thiram and 2 commercial Thiram formulations on the growth and respiration of rhizobia were tested to compare the extent of bacteriostasis under controlled conditions. Although bacteriostasis was measurable at all concentrations tested, liquid cultures grew to maximum optical density in Thiram suspensions containing less than 10 μg/ml. Percentage germination, root elongation, and subsequent nodulation by R. meliloti of 2 cultivars of alfalfa, were determined in thiram suspensions to determine potential physiological effects of the fungicide on the host plant. Conditions were identified which produced enhancement or inhibition of germination, root elongation and development of nodular nitrogenase activity. At concentrations of the fungicide recommended for seed application, only minor, temporary bacteriostasis was observed as a possible negative effect while germination rates of fungi‐contaminated seed were markedly increased.     

A Versatile Electrochemical Monitor for Air-Quality Measurements

An electrochemical instrument of the type commonly used to monitor total oxidants was adapted to measure acid gases such as SO₂, HCI, and HCO₂H. By using chemical methods of treating the air sample prior to absorption, it is possible to monitor for specific oxidants and acids. Measurements of NO, NO_x, and SO₂ during smog-chamber experiments were found to be in good agreement with measurements made by other methods.     

The Influence of Flame-Generated Free Radicals on the Thermal Oxidation of Waste Gases

Studies of the thermal oxidation of waste gases were carried out in two variants. During the first, the destruction of waste gases was facilitated by hydrogen flame-generated radicals. During the other variant, this flame was not used, but the same temperature was maintained as in the first one. The waste gases used were mixtures of toluene with air and methane with air of 200 and 400 ppm concentrations, respectively. The experiments were performed in a flow reactor within the temperature range of 800 to 1330 K. The efficiency of oxidation of methane and toluene obtained during the first variant was considerably higher than that obtained in the second one. This was due to the promotional effect of the hydrogen flame.     

Highlights of the Second International Conference on Managing Hazardous Air Pollutants

As the time approaches for the U.S. Environmental Protection Agency (EPA) to evaluate whether risks from electric utility trace substance emissions are of concern, attention is focused on research to clarify the many issues surrounding this topic. Accordingly, more than 230 representatives of industry, government, international research and academic institutions, equipment manufacturers, and engineering service firms attended the Second International Conference on Managing Hazardous Air Pollutants, which was held in Washington, D.C., on July 13–15,1993. Sponsored by the Electric Power Research Institute (EPRI) in cooperation with the EPA, U.S. Department of Energy (DOE), PowerGen, Coal Research Division of the International Energy Agency, and Canadian Electrical Association, the conference featured more than 50 presentations that both asked and answered questions about utility emission sources, the atmospheric fate of emitted substances, health and environmental studies, risk assessment, and control technologies. The diversity of the audience produced a stimulating exchange of findings, interpretations, and assessments of remaining uncertainties. This exchange provided valuable direction for ongoing research activities worldwide.     

Static Leaching of Solidified/Stabilized Hazardous Waste from the Soliditech Process

WILT, ANS 16.1 and TCLP leach tests were performed on solidified/stabilized (s/s) wastes treated by Soliditech, Inc. of Houston, Texas as part of a U.S. EPA SITE demonstration project conducted in December 1988 at the Imperial Oil Company/ Champion Chemical Company Superfund site in Morganville, New Jersey. All three leaching tests performed on the s/s wastes indicated that the primary contaminants of concern (lead and PCBs) were not leachable. The ANS 16.1 static leach test for the s/s wastes provided diffusion coefficients (D_e) for Al, Ca, and Na that were comparable to those obtained from the WILT test. However, plots of the ANS 16.1 data indicated that wetting of the samples confounded the static leaching process. The large column WILT D_e was used to estimate that less than 0.8 μg/cm² lead would leach from a one-cubic yard block of s/s waste in contact with groundwater over a 60-month leaching period. This corresponds to concentrations less than 10 μg/L lead in the water contacting the block of s/s waste.     

Emissions of Sulfur Trioxide from Coal-Fired Power Plants

Abstract

Emissions of sulfur trioxide (SO₃) are a key component of plume opacity and acid deposition. Consequently, these emissions need to be low enough to not cause opacity violations and acid deposition. Generally, a small fraction of sulfur (S) in coal is converted to SO₃ in coal-fired combustion devices such as electric utility boilers. The emissions of SO₃ from such a boiler depend on coal S content, combustion conditions, flue gas characteristics, and air pollution devices being used. It is well known that the catalyst used in the selective catalytic reduction (SCR) technology for nitrogen oxides control oxidizes a small fraction of sulfur dioxide in the flue gas to SO₃. The extent of this oxidation depends on the catalyst formulation and SCR operating conditions. Gas-phase SO₃ and sulfuric acid, on being quenched in plant equipment (e.g., air preheater and wet scrubber), result in fine acidic mist, which can cause increased plume opacity and undesirable emissions. Recently, such effects have been observed at plants firing high-S coal and equipped with SCR systems and wet scrubbers. This paper investigates the factors that affect acidic mist production in coal-fired electric utility boilers and discusses approaches for mitigating emission of this mist.     

Errors in coarse particulate matter mass concentrations and spatiotemporal characteristics when using subtraction estimation methods

In studies of coarse particulate matter (PM_10-2.5), mass concentrations are often estimated through the subtraction of PM_2.5 from collocated PM₁₀ tapered element oscillating microbalance (TEOM) measurements. Though all field instruments have yet to be updated, the Filter Dynamic Measurement System (FDMS) was introduced to account for the loss of semivolatile material from heated TEOM filters. To assess errors in PM_10-2.5 estimation when using the possible combinations of PM₁₀ and PM_2.5 TEOM units with and without FDMS, data from three monitoring sites of the Colorado Coarse Rural–Urban Sources and Health (CCRUSH) study were used to simulate four possible subtraction methods for estimating PM_10-2.5 mass concentrations. Assuming all mass is accounted for using collocated TEOMs with FDMS, the three other subtraction methods were assessed for biases in absolute mass concentration, temporal variability, spatial correlation, and homogeneity. Results show collocated units without FDMS closely estimate actual PM_10-2.5 mass and spatial characteristics due to the very low semivolatile PM_10-2.5 concentrations in Colorado. Estimation using either a PM_2.5 or PM₁₀ monitor without FDMS introduced absolute biases of 2.4 µg/m³ (25%) to –2.3 µg/m³ (–24%), respectively. Such errors are directly related to the unmeasured semivolatile mass and alter measures of spatiotemporal variability and homogeneity, all of which have implications for the regulatory and epidemiology communities concerned about PM_10-2.5. Two monitoring sites operated by the state of Colorado were considered for inclusion in the CCRUSH acute health effects study, but concentrations were biased due to sampling with an FDMS-equipped PM_2.5 TEOM and PM₁₀ TEOM not corrected for semivolatile mass loss. A regression-based model was developed for removing the error in these measurements by estimating the semivolatile concentration of PM_2.5 from total PM_2.5 concentrations. By estimating nonvolatile PM_2.5 concentrations from this relationship, PM_10-2.5 was calculated as the difference between nonvolatile PM₁₀ and PM_2.5 concentrations.

Implications: Errors in the estimation of PM_10-2.5 concentrations using subtraction methods were shown to be related to the unmeasured semivolatile mass when using certain combinations of TEOM instruments. For the northeastern Colorado region, the absolute bias associated with this error significantly affects mean and 95th percentile values, which would affect assessment of compliance if PM_10-2.5 is regulated in the future. Estimating PM_10-2.5 mass concentrations using nonvolatile mass concentrations from collocated PM₁₀ and PM_2.5 TEOM monitors closely estimates the total PM_10-2.5 mass concentrations. A corrective model that removes the described error was developed and applied to data from two sites in Denver.

Supplemental Materials: Supplemental materials are available for this paper. Go to the publisher's online edition of the Journal of the Air & Waste Management Association.     

Windsor, Ontario exposure assessment study: design and methods validation of personal, indoor, and outdoor air pollution monitoring

The Windsor, Ontario Exposure Assessment Study evaluated the contribution of ambient air pollutants to personal and indoor exposures of adults and asthmatic children living in Windsor, Ontario, Canada. In addition, the role of personal, indoor, and outdoor air pollution exposures upon asthmatic children's respiratory health was assessed. Several active and passive sampling methods were applied, or adapted, for personal, indoor, and outdoor residential monitoring of nitrogen dioxide, volatile organic compounds, particulate matter (PM; PM-2.5 pm [PM2.5] and < or =10 microm [PM10] in aerodynamic diameter), elemental carbon, ultrafine particles, ozone, air exchange rates, allergens in settled dust, and particulate-associated metals. Participants completed five consecutive days of monitoring during the winter and summer of 2005 and 2006. During 2006, in addition to undertaking the air pollution measurements, asthmatic children completed respiratory health measurements (including peak flow meter tests and exhaled breath condensate) and tracked respiratory symptoms in a diary. Extensive quality assurance and quality control steps were implemented, including the collocation of instruments at the National Air Pollution Surveillance site operated by Environment Canada and at the Michigan Department of Environmental Quality site in Allen Park, Detroit, MI. During field sampling, duplicate and blank samples were also completed and these data are reported. In total, 50 adults and 51 asthmatic children were recruited to participate, resulting in 922 participant days of data. When comparing the methods used in the study with standard reference methods, field blanks were low and bias was acceptable, with most methods being within 20% of reference methods. Duplicates were typically within less than 10% of each other, indicating that study results can be used with confidence. This paper covers study design, recruitment, methodology, time activity diary, surveys, and quality assurance and control results for the different methods used.     

Effectiveness of emission control technologies for auxiliary engines on ocean-going vessels

Large auxiliary engines operated on ocean-going vessels in transit and at berth impact the air quality of populated areas near ports. This paper presents new information on the comparison of emission ranges from three similar engines and the effectiveness of three control technologies: switching to cleaner burning fuels, operating in the low oxides of nitrogen (NOx) mode, and selective catalytic reduction (SCR). In-use measurements of gaseous (NOx, carbon monoxide [CO], carbon dioxide [CO2]) and fine particulate matter (PM2.5; total and speciated) emissions were made on three auxiliary engines on post-PanaMax class container vessels following the International Organization for Standardization-8178-1 protocol. The in-use NOx emissions for the MAN B&W 7L32/40 engine family vary from 15 to 21.1 g/kW-hr for heavy fuel oil and 8.9 to 19.6 g/kW-hr for marine distillate oil. Use of cleaner burning fuels resulted in NOx reductions ranging from 7 to 41% across different engines and a PM2.5 reduction of up to 83%. The NOx reductions are a consequence of fuel nitrogen content and engine operation; the PM2.5 reduction is attributed to the large reductions in the hydrated sulfate and organic carbon (OC) fractions. As expected, operating in the low-NOx mode reduced NOx emissions by approximately 32% and nearly doubled elemental carbon (EC) emissions. However, PM2.5 emission factors were nearly unchanged because the EC emission factor is only approximately 5% of the total PM2.5 mass. SCR reduced the NOx emission factor to less than 2.4 g/kW-hr, but it increased the PM2.5 emissions by a factor of 1.5-3.8. This increase was a direct consequence of the conversion of sulfur dioxide to sulfate emissions on the SCR catalyst. The EC and OC fractions of PM2.5 reduced across the SCR unit.