Usability of non-standard lower anchor configurations for child restraint system (CRS) installation

Abstract

Objectives: The objective of this study was to determine whether the amount of tension required for proper child restraint system (CRS) installation varies with lower anchor spacing and to determine whether nonexperts can produce adequate tension on wider-than-standard lower anchor configurations.

Methods: CRSs were installed by certified child passenger safety technicians (CPSTs; n?=?6 subjects, n?=?72 installations) and nonexperts (n?=?30 subjects, n?=?120 installations) on a mock-up vehicle seat fixture with lower anchors set at 11 (standard), 15, 19, and 23 in. apart from one another. Each CPST installed a rear-facing (RF) infant base, RF convertible, and forward-facing (FF) convertible into each of the 4 spacing configurations in random order. The CPSTs were instructed to tighten the lower connector strap until the tension was exactly at the threshold between passing and failing the 1-in. test. Each nonexpert installed one CRS model into all 4 spacing conditions in random order. Nonexperts were instructed to install the CRS to the best of their ability. The tension produced on the lower connector strap was recorded via load cell in the lower anchor assembly of the vehicle seat. Resultant tension magnitudes were compared across spacing conditions using matched pair t-tests. The CPSTs’ mean 1-in. test threshold values were compared to tensions produced by nonexperts. Installations were visually evaluated for errors and qualitative usability feedback was collected via survey.

Results: CPSTs installed the infant base with higher tensions in the 15-, 19-, and 23-in. configurations compared to the standard 11-in. configuration (P = .034, .032, and .003, respectively). The nonexperts installed the infant base with higher tension in the 15- and 23-in. configurations compared to the 11-in. configuration (P = .004 and .026, respectively). The RF convertible and FF convertible installations showed no significant differences in tension among any of the spacing configurations for either group. Only 19% of the nonexperts’ installations were tight enough to pass CPST thresholds, and the pass rate did not vary with respect to lower anchor spacing. In feedback surveys, the nonexpert group did not show a consistent preference for either standard or wider-than-standard lower anchor configurations.

Conclusions: The amount of tension required to pass the 1-in. rule did not vary with lower anchor spacing configurations for the RF and FF convertible CRS, but the infant base required more tension in wider anchor configurations. Nonexperts tended to produce less than ideal tension in all configurations, although their tension magnitudes increased for the infant base in wider configurations.     

Effects of Topographical Heterogeneity and Dispersal Limitation on Species Turnover in a Temperate Mountane Ecosystem: a Case Study in the Henan Province,China

Species turnover patterns can be inconsistent due to differences in the dispersal ability of different growth forms. Here, species of trees, shrubs, herbs, and bryophytes in the Xiaoqinling National Nature Reserve in China were analyzed to determine patterns of species turnover along an elevation and spatial gradient. Variance partitioning was used to assess the relative contribution of topographic heterogeneity and dispersal limitation to species turnover. Our results suggest that the effect of dispersal limitation is more important than topographic heterogeneity on species turnover in temperate mountane ecosystems in the study area. Dispersal limitation has a greater effect on trees species turnover than on shrubs, herbs or bryophytes species turnover.     

Socio-environmental consideration of phosphorus flows in the urban sanitation chain of contrasting cities

Understanding how cities can transform organic waste into a valuable resource is critical to urban sustainability. The capture and recycling of phosphorus (P), and other essential nutrients, from human excreta is particularly important as an alternative organic fertilizer source for agriculture. However, the complex set of socio-environmental factors influencing urban human excreta management is not yet sufficiently integrated into sustainable P research. Here, we synthesize information about the pathways P can take through urban sanitation systems along with barriers and facilitators to P recycling across cities. We examine five case study cities by using a sanitation chains approach: Accra, Ghana; Buenos Aires, Argentina; Beijing, China; Baltimore, USA; and London, England. Our cross-city comparison shows that London and Baltimore recycle a larger percentage of P from human excreta back to agricultural lands than other cities, and that there is a large diversity in socio-environmental factors that affect the patterns of recycling observed across cities. Our research highlights conditions that may be “necessary but not sufficient” for P recycling, including access to capital resources. Path dependencies of large sanitation infrastructure investments in the Global North contrast with rapidly urbanizing cities in the Global South, which present opportunities for alternative sanitation development pathways. Understanding such city-specific social and environmental barriers to P recycling options could help address multiple interacting societal objectives related to sanitation and provide options for satisfying global agricultural nutrient demand.

     

Reducing external costs of nitrogen pollution by relocation of pig production between regions in the European Union

This paper tests the hypothesis that relocation of pig production within the EU27 can reduce the external costs of nitrogen (N) pollution. The external cost of pollution by ammonia and nitrate from agriculture in the European Union (EU27) in 2008 was estimated at 61–215 billion € (0.5 to 1.8% of the GDP). Per capita it ranged from more than 1000 € in north-west EU27 to 50 € in Romania. The average contribution of pig production was 15%. Using provincial data (224 NUTS2 regions in EU27), the potential reduction of external N cost by relocation of pig production was estimated at 14 billion € (10% of the total). Regions most eligible for decreasing the pig stock were in western Germany, Flemish region, Denmark, the Netherlands and Bretagne, while Romania is most eligible for increasing pig production. Relocating 20 million pigs (13% of the total EU stock) decreased average external costs per capita from 900 to 785 € in the 13 NUTS2 regions where pigs were removed and increased from 69 to 107 € in 11 regions receiving pigs. A second alternative configuration of pig production was targeted at reducing exceedance of critical N deposition and closing regional nutrient cycles. This configuration relocates pigs within Germany and France, for example from Bretagne to Northern France and from Weser-Ems to Oberbayern. However, total external cost increases due to an increase of health impacts, unless when combined with implementation of best N management practices. Relocation of the pig industry in the EU27 will meet many socio-economic barriers and realisation requires new policy incentives.     

Packed in-tube solid phase microextraction with graphene oxide supported on aminopropyl silica: Determination of target triazines in water samples

On-line in-tube solid phase microextraction (in-tube SPME) coupled to high performance liquid chromatography and tandem mass spectrometry (HPLC-MS/MS) was successfully applied to the determination of selected triazines in water samples. The method based on the employment of a packed column containing graphene oxide (GO) supported on aminopropyl silica (Si) showed that the extraction phase has a high potential for triazines extraction aiming to its physical-chemical properties including ultrahigh specific surface area, good mechanical and thermal stability and high fracture strength. Injection volume and loading time were both investigated and optimized. The method validation using Si-GO to extract and concentrate the analytes showed satisfactory results, good sensitivity, good linearity (0.2–4.0 µg L^?1) and low detection limits (1.1–2.9 ng L^?1). The high extraction efficiency was determined with enrichment factors ranging from 1.2–2.9 for the lowest level, 1.3–4.9 intermediate level and 1.2–3.0 highest level (n = 3). Although the analytes were not detected in the real samples evaluated, the method has demonstrated to be efficient through its application in the analysis of spiked triazines in ground and mineral water samples.     

The search for an alternative to piped water and sewer systems in the Alaskan Arctic

Forty-two communities in rural Alaska are considered unserved or underserved with water and sewer infrastructure. Many challenges exist to provide centralized piped water and sewer infrastructure to the homes, and they are exacerbated by decreasing capital funding. Unserved communities in rural Alaska experience higher rates of disease, supporting the recommendation that sanitation infrastructure should be provided. Organizations are pursuing alternative solutions to conventional piped water and sewer in order to maximize water use and reuse for public health. This paper reviews initiatives led by the State of Alaska, the Alaska Native Tribal Health Consortium, and the Yukon Kuskokwim Health Corporation to identify and develop potential long-term solutions appropriate and acceptable to rural communities. Future developments will likely evolve based on the lessons learned from the initiatives. Recommendations include Alaska-specific research needs, increased end-user participation in the design process, and integrated monitoring, evaluation, and information dissemination in future efforts.     

PCB exposure and potential future cancer incidence in Slovak children: an assessment from molecular finger printing by Ingenuity Pathway Analysis (IPA®) derived from experimental and epidemiological investigations

The risk of cancer due to PCB exposure in humans is highly debated. In eastern Slovakia, high exposure of the population to organochlorines (especially PCBs) was associated with various disease and disorder pathways, viz., endocrine disruption, metabolic disorder & diabetes, and cancer, thereby disturbing several cellular processes, including protein synthesis, stress response, and apoptosis. We have evaluated a Slovak cohort (45-month children, at lower and higher levels of PCB exposure from the environment) for disease and disorder development to develop early disease cancer biomarkers that could shed new light on possible mechanisms for the genesis of cancers under such chemical exposures, and identify potential avenues for prevention.

Microarray studies of global gene expression were conducted from the 45-month-old children on the Affymetrix platform followed by Ingenuity Pathway Analysis (IPA®) to associate the affected genes with their mechanistic pathways. High-throughput qRT-PCR TaqMan low-density array (TLDA) was performed to further validate the selected genes on the whole blood cells of the most highly exposed children from the study cohort (n = 71).

TP53, MYC, BCL2, and LRP12 differential gene expressions suggested strong relationships between potential future tumor promotion and PCB exposure in Slovak children. The IPA analysis further detected the most important signaling pathways, including molecular mechanism of cancers, prostate cancer signaling, ovarian cancer signaling, P53 signaling, oncostatin M signaling, and their respective functions (viz., prostate cancer, breast cancer, progression of tumor, growth of tumor, and non-Hodgkin’s disease). The results suggest that PCB exposures, even at the early age of these children, may have lifelong consequences for the future development of chronic diseases.

     

Deriving fuel-based emission factor thresholds to interpret heavy-duty vehicle roadside plume measurements

Remote sensing devices have been used for decades to measure gaseous emissions from individual vehicles at the roadside. Systems have also been developed that entrain diluted exhaust and can also measure particulate matter (PM) emissions. In 2015, the California Air Resources Board (CARB) reported that 8% of in-field diesel particulate filters (DPF) on heavy-duty (HD) vehicles were malfunctioning and emitted about 70% of total diesel PM emissions from the DPF-equipped fleet. A new high-emitter problem in the heavy-duty vehicle fleet had emerged. Roadside exhaust plume measurements reflect a snapshot of real-world operation, typically lasting several seconds. In order to relate roadside plume measurements to laboratory emission tests, we analyzed carbon dioxide (CO₂), oxides of nitrogen (NO_X), and PM emissions collected from four HD vehicles during several driving cycles on a chassis dynamometer. We examined the fuel-based emission factors corresponding to possible exceedances of emission standards as a function of vehicle power. Our analysis suggests that a typical HD vehicle will exceed the model year (MY) 2010 emission standards (of 0.2 g NO_X/bhp-hr and 0.01 g PM/bhp-hr) by three times when fuel-based emission factors are 9.3 g NO_X/kg fuel and 0.11 g PM/kg using the roadside plume measurement approach. Reported limits correspond to 99% confidence levels, which were calculated using the detection uncertainty of emissions analyzers, accuracy of vehicle power calculations, and actual emissions variability of fixed operational parameters. The PM threshold was determined for acceleration events between 0.47 and 1.4 mph/sec only, and the NO_X threshold was derived from measurements where after-treatment temperature was above 200°C. Anticipating a growing interest in real-world driving emissions, widespread implementation of roadside exhaust plume measurements as a compliment to in-use vehicle programs may benefit from expanding this analysis to a larger sample of in-use HD vehicles.

Implications: Regulatory agencies, civil society, and the public at large have a growing interest in vehicle emission compliance in the real world. Leveraging roadside plume measurements to identify vehicles with malfunctioning emission control systems is emerging as a viable new and useful method to assess in-use performance. This work proposes fuel-based emission factor thresholds for PM and NOx that signify exceedances of emission standards on a work-specific basis by analyzing real-time emissions in the laboratory. These thresholds could be used to prescreen vehicles before roadside enforcement inspection or other inquiry, enhance and further develop emission inventories, and potentially develop new requirements for heavy-duty inspection and maintenance (I/M) programs, including but not limited to identifying vehicles for further testing.     

Seasonal and diurnal measurements of carbon monoxide and nonmethane hydrocarbons at Mt. Wilson,California: Indirect evidence of atomic Cl in the Los Angeles basin

We present a study of the seasonal and diurnal variability of carbon monoxide and selected volatile organic compounds in the Los Angeles area. Measurements were made during four different nine-day field campaigns in April/May, September, and November, 2007, and February, 2008, at the Mt. Wilson sampling site, which is located at an elevation of approximately 1700 m in the San Gabriel Mountains overlooking Pasadena and the Los Angeles basin. The results were used to characterize the Mt. Wilson site as a representative location for monitoring integrated Los Angeles basin emissions, and, by reference to carbon monoxide emissions, to estimate average annual emissions. The considerable seasonal variability of many hydrocarbons, in both their measured mixing ratios and their relationship to carbon monoxide, was indicative of variable source strengths. Most interestingly, perturbation of C₄ hydrocarbon ratios suggested an enhanced role for chlorine chemistry during the month of September, likely as the result of Los Angeles’ coastal location. Such coastal influence was confirmed by observations of enhanced mixing ratios of marine halocarbons, as well as air mass back trajectories.