某机载PCB模块环境适应性设计与分析

本文介绍了某机载印制板模块插件的环境适应性设计,其中包括抗振设计、电磁防护设计以及防腐蚀设计等内容,并分析了印制板插件冷板接地与不接地两种情况下产生的电磁干扰的原因,同时还介绍了镁合金冷板防腐蚀设计措施和试验结果.     

河北省祖山风景区崩塌灾害特征与防治对策研究

以祖山为例,阐述了崩塌地质灾害的机理、特征和现状,并利用传递系数法对崩塌稳定性进行了计算和评价,采用削方卸载、修建抗崩塌挡土墙、构筑排水沟与格构等工程设施的防治对策及工程措施,取得了预期的效果。     

Carbon dioxide and methane fluxes in the littoral zones of two lakes,east Antarctica

During the summertime of 2007/2008, carbon dioxide (CO₂) and methane (CH₄) fluxes across air–water interface were investigated in the littoral zones of Lake Mochou and Lake Tuanjie, east Antarctica, using a static chamber technique. The mean fluxes of CO₂ and CH₄ were ?70.8 mgCO₂ m^?2 h^?1 and 144.6 μgCH₄ m^?2 h^?1, respectively, in the littoral zone of Lake Mochou; The mean fluxes were ?36.9 mgCO₂ m^?2 h^?1 and 109.8 μgCH₄ m^?2 h^?1, respectively, in the littoral zone of Lake Tuanjie. Their fluxes showed large temporal and spatial dynamics. The CO₂ fluxes showed a significantly negative correlation with daily total radiation (DTR) and a weakly negative correlation with air temperature and water temperature, indicating that sunlight intensity controlled the magnitude of CO₂ fluxes from the open lakes. The CH₄ fluxes significantly correlated with local air temperature, water table and total dissolved solids (TDS), indicating that they were the predominant factors influencing CH₄ fluxes. Summertime CO₂ budgets in the littoral zones of Lake Mochou and Lake Tuanjie were estimated to be ?152.9 gCO₂ m^?2 and ?79.7 gCO₂ m^?2, respectively, and net CH₄ emissions were estimated to be 312.3 mgCH₄ m^?2 and 237.2 mgCH₄ m^?2, respectively. Our results show that shallow, open, alga-rich lakes might be strong summertime CO₂ absorbers and small CH₄ emitters during the open water in coastal Antarctica.     

TiO_2对几种农药在土壤中光降解的催化作用

以太阳光为光源,研究了TiO2添加量、土壤厚度对毒死蜱、苯线磷、克百威、多菌灵在土壤中光催化降解的影响,并分析了毒死蜱、苯线磷初始浓度对其光催化降解的影响。结果表明,这4种农药的光降解均符合准一级动力学方程,随着TiO2添加量从0mg/kg增加到200mg/kg,光催化降解一级动力学常数逐渐增加。这4种农药在不同厚度含有TiO2的土壤中的光催化降解率不同;在土壤厚度较大的情况下,相应的半衰期也较长;在土壤中添加毒死蜱、苯线磷浓度相对较低的情况下,其对应的光催化降解较快。     

Characterization of plutonium in deep-sea sediments of the Sulu and South China Seas

Anthropogenic Pu isotopes are important geochemical tracers for sediment studies. Their distributions and sources in the water columns as well as the sediments of the North Pacific have been intensively studied; however, information about Pu in the Southeast Asian seas is limited. To study the isotopic composition of Pu, and thus to identify its sources, we collected sediment core samples in the South China Sea and the Sulu Sea during the KH-96-5 Cruise of the R/V Hakuho Maru. We analysed the activities of ^239+240Pu and the atom ratios of ²⁴⁰Pu/²³⁹Pu using isotope dilution sector-field inductively coupled plasma mass spectrometry (SF-ICP-MS). The ²⁴⁰Pu/²³⁹Pu atom ratios in the sediments of both areas (inventory weighted mean: 0.251 for the South China Sea and 0.280 for the Sulu Sea) were higher than the global fallout value (0.178 ± 0.019), suggesting the existence of Pu from the Pacific Proving Grounds in the North Pacific. Low inventories of ^239+240Pu in sediments were observed in the South China Sea (3.75 Bq/m²) and the Sulu Sea (1.38 Bq/m²). Most of the Pu input is still present in the water column. Scavenging and benthic mixing processes were considered to be the main processes controlling the distribution of Pu in the deep-sea sediments of both study areas.     

Tree bark as a passive air sampler to indicate atmospheric polybrominated diphenyl ethers (PBDEs) in southeastern China

The different barks were sampled to discuss the influence of the tree species, trunk circumference, and bark thickness on the accumulation processes of polybrominated diphenyl ethers (PBDEs) from air into the bark. The results of different PBDE concentrations indicated that barks with a thickness of 0–3 mm collected from weeping willow, Camphor tree, and Masson pine, the trunk circumferences of which were 100 to 150 cm, were better PBDEs passive samplers. Furthermore, tree bark and the corresponding air samples were collected at Anji (AJ), Hangzhou (HZ), Shanghai (SH), and Wenling (WL) to investigate the relationship between the PBDE concentrations in bark and those in air. In addition, the significant correlation (r ²?=?0.906; P?<?0.05) indicated that atmospheric PBDEs were the principle source for the accumulation of PBDEs in the barks. In this study, the log K _BA (bark–air partition coefficient) of individual PBDE congeners at the four sites were in the range from 5.69 to 6.79. Finally, the total PBDE concentration in WL was 5 to 20 times higher than in the other three cities. The result indicated that crude household workshops contributed a heavy amount of PBDEs pollution to the environment, which had been verified by the spatial distribution of PBDEs levels in barks collected at Wenling (range, 26.53–1317.68 ng/g dw). The good correlation between the PBDE concentrations in the barks and the air samples and the variations of the PBDE concentrations in tree barks collected from different sites reflected that the bark could be used as a passive sampler to indicate the atmospheric PBDEs.     

Influence of soil and hydrocarbon properties on the solvent extraction of high-concentration weathered petroleum from contaminated soils

Petroleum ether was used to extract petroleum hydrocarbons from soils collected from six oil fields with different history of exploratory and contamination. It was capable of fast removing 76–94 % of the total petroleum hydrocarbons including 25 alkanes (C₁₁–C₃₅) and 16 US EPA priority polycyclic aromatic hydrocarbons from soils at room temperature. The partial least squares analysis indicated that the solvent extraction efficiencies were positively correlated with soil organic matter, cation exchange capacity, moisture, pH, and sand content of soils, while negative effects were observed in the properties reflecting the molecular size (e.g., molecular weight and number of carbon atoms) and hydrophobicity (e.g., water solubility, octanol–water partition coefficient, soil organic carbon partition coefficient) of hydrocarbons. The high concentration of weathered crude oil at the order of 10⁵ mg kg^?1 in this study was demonstrated adverse for solvent extraction by providing an obvious nonaqueous phase liquid phase for hydrocarbon sinking and increasing the sequestration of soluble hydrocarbons in the insoluble oil fractions during weathering. A full picture of the mass distribution and transport mechanism of petroleum contaminants in soils will ultimately require a variety of studies to gain insights into the dynamic interactions between environmental indicator hydrocarbons and their host oil matrix.     

突变灰盖鬼伞过氧化物酶降解刚果红的响应面法优化分析简

酶法降解偶氮染料刚果红是一个复杂的过程,受温度、pH、酶量、刚果红浓度和双氧水浓度显著影响。为研究各因素及因素间交互作用对刚果红降解影响,提高刚果红的降解率,分别使用单因素法和响应面分析法对刚果红降解条件进行了优化。单因素实验结果显示灰盖鬼伞过氧化物酶降解刚果红的最适条件为：pH 5.0、32℃、酶量4.98 U、双氧水0.1 mmol/L、刚果红20 mg/L,此时刚果红最高降解率为34.84%。然后选双氧水浓度、刚果红浓度和灰盖鬼伞过氧化物酶量作为3个因素,通过中心组合设计实验,用响应面法对刚果红降解进行优化分析,最后得到一个拟合度良好的二次多项方程模型（R²=0.9900）。方差分析结果显示,刚果红浓度和酶量是影响最显著的因素,双氧水与酶以及染料与酶之间的交互作用极显著。响应面分析优化后的反应体系为：双氧水浓度0.15 mmol/L,刚果红浓度为27.21 mg/L,酶为2.0 7 U,在此条件下,刚果红降解率达58.13%。     

锰铜铈氧化物催化剂氧化NO性能及动力学研究

实验以TiO2为载体采用浸渍法制备CuOx/TiO2、CeOx/TiO2、CuCeOx/TiO2和MnCuCeOx/TiO2催化剂,考察这些催化剂氧化NO活性,探究Cu、Ce摩尔比和添加Mn元素对CuCeOx/TiO2催化剂氧化NO活性的影响,使用扫描电镜观察催化剂表面结构。研究发现,Cu、Ce元素配合后的CuCeOx/TiO2催化剂氧化活性明显好于单独含Cu、Ce的催化剂,当Cu、Ce摩尔比为Cu:Ce=1∶2时,CuCeOx/TiO2催化剂氧化活性最好,在NO浓度500×10-6,O210%,空速为24 000 h-1,350℃时,NO氧化度为0.62;添加Mn元素可以提高CuCeOx/TiO2催化剂低温氧化活性,250℃时,MnCuCe/Ti-3和MnCuCe/Ti-5催化剂氧化度为0.53和0.69,300℃时,MnCuCe/Ti-3和MnCuCe/Ti-5催化剂氧化度均为0.76;此外,实验还研究了NO在MnCuCe/Ti-3催化剂上反应的动力学方程。