The influence of gill and liver metabolism on the predicted bioconcentration of three pharmaceuticals in fish

The potential for xenobiotic compounds to bioconcentrate is typically expressed through the bioconcentration factor (BCF), which has gained increased regulatory significance over the past decade. Due to the expense of in vivo bioconcentration studies and the growing regulatory need to assess bioconcentration potential, BCF is often calculated via single-compartment models, using K(OW) as the primary input. Recent efforts to refine BCF models have focused on physiological factors, including the ability of the organism to eliminate the compound through metabolic transformation. This study looks at the ability of in vitro biotransformation assays using S9 fractions to provide an indication of metabolic potential. Given the importance of the fish gill and liver in metabolic transformation, the metabolic loss of ibuprofen, norethindrone and propranolol was measured using rainbow trout (Oncorhynchus mykiss) and channel catfish (Ictalurus punctatus) gill and liver S9 fractions. Metabolic transformation rates (k(M)) were calculated and integrated into a refined BCF model. A significant difference was noted between BCF solely based on K(OW) and BCF including k(M). These studies indicate that the inclusion of k(M) in BCF models can bring predicted bioconcentration estimates closer to in vivo values.     

Influence of ozone stress on growth processes, yields and grain quality characteristics among soybean cultivars

Field studies were conducted at USDA Beltsville Agricultural Research Center, Beltsville, Maryland, in 1984 and 1985 using open-top chambers to acquire information on the responses of 12 soybean (Glycine max L. Merr.) cultivars to O3 stress and to examine the interactions between maturity groups and O3 stress. Cultivars representing Groups III, IV, and V were exposed for approximately 3 months to charcoal-filtered air (CF) and nonfiltered air plus 40 nl litre(-1) O3 (NF + O3). Ozone was added 6 h d(-1), 5 d week(-1) for 13 weeks. The CF effectively reduced the accumulative oxidant exposure (AOX) to less than 1.0 microl litre(-1) h and the NF + O3 treatment approximately doubled the ambient AOX (16.7 microl litre(-1) h) to about 30 microl litre(-1) h. The AOX estimates the total O3 exposure above 30 nl litre(-1) during an entire growing season. Plant growth rates and relative growth rates were reduced by 17.0 and 14.4%, respectively, when averaged over cultivars. Based on growth rates, the Group III cultivars were the most affected by O3 stress. Averaged over cultivars, leaf expansion rates, leaf conductance, and transpiration rates were lower in the NF + O3 treatment compared to the CF control; however, wide variation was found with the stomatal results from field observations. Combined over years and cultivars, grain yield was reduced by an average of 12.5% by O3 stress with 3 of 12 cultivars showing significant reductions. Grain protein content was increased by 0.7% by O3 stress, but cultivar differences were equal to the differences caused by the O3 treatments. Grain oil content was unchanged by the O3 treatments. Group IV cultivars showed the greatest decrease in grain yield due to O3 stress. Multiple regression analyses were calculated using the difference between the CF and NF + O3 treatment as a measure of O3 stress. Significant positive relationships were found among net assimilation rates, plant growth rates, relative growth rates, and leaf expansion rates, which suggest that growth analysis characteristics would be useful in addition to yield in air pollution tolerance improvement studies with soybeans.     

Cadmium contamination in orchard soils and fruit trees and its potential health risk in Guangzhou, China

This study examines cadmium (Cd) contamination in orchard soils and fruit trees in Guangzhou, China, and assesses its potential health risk. Soils and tissues samples of three species of fruit trees were collected from three orchards. The average soil Cd concentration was 1.27, 1.84 and 0.68 mg/kg in orchards I, II, and III, respectively. The carambola (Averrhoa carambola) accumulated exceptionally high concentrations of Cd (7.57, 10.84, 9.01 and 2.15 mg/kg dw in root, twig, leaf and fruit, respectively), being 6.0-24 times and 4.0-10 times the corresponding tissue Cd in the longan (Dimocarpus longan) and wampee (Clausena lansium), respectively. Furthermore, all Cd concentrations (0.04-0.25 mg Cd/kg fw) of the fruits exceeded the tolerance limit of cadmium in foods of PR China (0.03 mg/kg fw). Our results indicate that the carambola tree has high Cd accumulation capacity and might be a Cd accumulator; and its fruit, among the three species of fruits studied, also poses the highest potential health risk to local residents.     

Heavy metal and Pb isotopic compositions of aquatic organisms in the Pearl River Estuary, South China

The accumulation of trace metals in aquatic organisms may lead to serious health problems through the food chain. The present research project aims to study the accumulation and potential sources of trace metals in aquatic organisms of the Pearl River Estuary (PRE). Four groups of aquatic organisms, including fish, crab, shrimp, and shellfish, were collected in the PRE for trace metal and Pb isotopic analyses. The trace metal concentrations in the aquatic organism samples ranged from 0.01 to 2.10 mg/kg Cd, 0.02 to 4.33 mg/kg Co, 0.08 to 4.27 mg/kg Cr, 0.15 to 77.8 mg/kg Cu, 0.17 to 31.0 mg/kg Ni, 0.04 to 30.7 mg/kg Pb, and 8.78 to 86.3 mg/kg Zn (wet weight). High concentrations of Cd were found in crab, shrimp and shellfish samples, while high concentration of Pb was found in fish. In comparison with the baseline reference values in other parts of the world, fish in the PRE had the highest elevated trace metals. The results of Pb isotopic compositions indicated that the bioaccumulation of Pb in fish come from a wide variety of food sources and/or exposure pathways, particularly the anthropogenic inputs.     

Uptake of weakly hydrophobic nitroaromatics from water by semipermeable membrane devices (SPMDs) and by goldfish (Carassius auratus)

Semipermeable membrane devices (SPMDs) filled with triolein, and goldfish (Carassius auratus) were simultaneously exposed to nine weakly hydrophobic nitroaromatics in a laboratory continuous-flow experiment. The results showed that the device concentrated the compounds in most cases to a larger extent than fish and that the overall uptake rate constants (Kmu) and average pollutant sampling rates (R(S)) were similar. We conclude that the SPMDs may be used to determine the levels of weakly hydrophobic nitroaromatics in water. It is obvious, however, that more researches at laboratory in order to establish kinetic database for a wide spectrum of compounds varying in lipophilicity and other properties are needed to elucidate various theoretical and practical aspects of the use of membranes in the environmental research and for related practical applications.     

Higher pH and faster decomposition in biowaste composting by increased aeration

Composting of source separated municipal biowaste has at several plants in Scandinavia been hampered by low pH. In this study the hypothesis that increased aeration would improve the process was tested in full-scale experiments at two large composting plants. The O2 concentrations were high (>15%) even at the low aeration rates, so the prevailing low pH was not due to an anaerobic process environment. In spite of this, increased aeration rates at the start of the process resulted in higher microbial activity, increased pH and a more stable compost product. At one plant the decomposition rate varied in proportion to the aeration rate, to the extent that the temperatures and O2 concentrations were similar during the early processes even though aeration rates varied between 10 and 50 m3/(h, m3 compost). However, increased aeration caused severe drying of the compost, but at one plant the addition of water was adequate to prevent drying. In conclusion, by increasing the aeration rates and adding water to compensate for drying, it was possible to shorten the time needed to produce a stable compost product and thus to increase the efficiency of the composting plants.     

Improvements of nano-SiO2 on sludge/fly ash mortar

Sewage sludge ash has been widely applied to cementitious materials. In this study, in order to determine effects of nano-SiO(2) additives on properties of sludge/fly ash mortar, different amounts of nano-SiO(2) were added to sludge/fly ash mortar specimens to investigate their physical properties and micro-structures. A water-binding ratio of 0.7 was assigned to the mix. Substitution amounts of 0%, 10%, 20%, and 30% of sludge/fly ash (1:1 ratio) were proposed. Moreover, 0%, 1%, 2%, and 3% of nano-SiO(2) was added to the mix. Tests, including SEM and compressive strength, were carried out on mortar specimens cured at 3, 7, and 28 days. Results showed that sludge/fly ash can make the crystals of cement hydration product finer. Moreover, crystals increased after nano-SiO(2) was added. Hence, nano-SiO(2) can improve the effects of sludge/fly ash on the hydration of mortar. Further, due to the low pozzolanic reaction active index of sludge ash, early compressive strengths of sludge/fly ash mortar were decreased. Yet, nano-SiO(2) could help produce hydration crystals, which implies that the addition of nano-SiO(2) to mortar can improve the influence of sludge/fly ash on the development of the early strength of the mortar.     

Atrazine and alachlor transport in claypan soils as influenced by differential antecedent soil water content

Increased attention to ground water contamination has encouraged an interest in mechanisms of solute transport through soils. Few studies have investigated the effect of the initial soil water content on the transport and degradation of herbicides for claypan soils. We investigated the effect of claypan soils at initial field capacity vs. permanent wilting level on atrazine and alachlor transport. The soil studied was Mexico silt loam (fine, smectitic, mesic Aeric Vertic Epiaqualf) with a subsoil clay content, primarily montmorillonite, of >40%. Strontium bromide, atrazine, and alachlor were applied to plots; half were at field capacity (Wet treatment), and half were near the permanent wilting point (Dry treatment). Soil cores were removed at selected depths and times, and cores were analyzed for bromide and herbicide concentrations. Bromide, atrazine, and alachlor were detected at the 0.90-m depth in dry plots within 15 d after experiment initiation. Bromide was detected 0.15 m deeper (P < 0.05) in the Dry compared with the Wet treatment at 1, 7, and 60 d after application and >0.30 m deeper (P < 0.01) in the Dry treatment at 15 and 30 d after application; similar treatment results were found for atrazine and alachlor, although on fewer dates with significant differences. The mobility order of the applied chemicals was bromide > atrazine > alachlor. The atrazine apparent half-life was significantly longer in the Dry plots compared with the Wet plots. The retardation factor determined from the relative velocity of each herbicide to that of bromide was higher for alachlor than for atrazine. This study identifies the impact that shrinkage cracks have for different moisture conditions on preferential transport of herbicides in claypan soils.     

New measurements of cyanobacterial toxins in natural waters using high performance liquid chromatography coupled to tandem mass spectrometry

The presence and levels of the cyanobacterial toxins microcystin-LR, anatoxin-a, and cylindrospermopsin were measured in various Wisconsin waters where algal nuisance or bloom conditions were noted. Out of 74 samples analyzed, 36 had detectable levels of microcystin-LR (49%), and four had detectable levels of anatoxin-a (5%). Cylindrospermopsin, the toxin produced by Cylindrospermopsis (a warm water species that has been moving its range northward, including to Wisconsin), was not detected in the field samples tested. Concentrations of microcystin-LR ranged from 1.2 to 7600 microg L(-1). Anatoxin-a ranged from 0.68 to 1750 microg L(-1), which is the highest concentration reported from around the world. Cyanobacterial toxins, because of their high potency, deserve continued scrutiny by resource managers and public health officials responsible for recreational waters.     

Extractability of elements in sugar maple xylem along a gradient of soil acidity

Dendrochemistry has been used for the historical dating of pollution. Its reliability is questionable due primarily to the radial mobility of elements in sapwood. In the present study, the extractability of seven elements was characterized to assess their suitability for the monitoring of environmental conditions. Nine mature sugar maple trees (Acer saccharum Marsh.), a wide-ranging species in eastern North America that has suffered decline in past decades, were sampled in three Quebec watersheds along a soil acidity gradient. Five-year groups of annual tree rings were treated by sequential chemical extractions using extractants of varying strength (deionized H2O, 0.05 M HCl, and concentrated HNO(3)) to selectively solubilize the elements into three fractions (water-soluble, acid-soluble, and residual). Monovalent K; divalent Ba, Ca, Cd, Mg, Mn; and trivalent Al cations were found mostly in the water-soluble, acid-soluble, and residual fractions, respectively. Forms more likely to be mobile within the tree (water-soluble and acid-soluble) do not seem to be suitable for temporal monitoring because of potential lateral redistribution in sapwood rings. However, certain elements (Cd, Mn) were responsive to current soil acidity and could be used in spatial variation monitoring. Extractability of Al varied according to soil acidity; at less acidic sites, up to 90% of Al was contained in the residual form, whereas on very acidic soils, as much as 45% was found in the water-soluble and acid-soluble fractions. Sequential extractions can be useful for determining specific forms of metals as key indicators of soil acidification.