Assessment of the effectiveness of scup bycatch-reduction regulations in the Loligo squid fishery

Discard reduction is a component of the statutory requirements of the Sustainable Fisheries Act. One species of concern is scup, Stenotomus chrysops, discarded in the Loligo pealei fishery. Initially, regulations were imposed restricting the fishery in time and space to avoid areas and times associated with high scup discarding. Modified gear was required in 2003 on any boat fishing in areas otherwise closed to the fishery to reduce scup discarding. The purpose of this study was to evaluate the success of the 2003 net regulations and the potential influence of time-area closures (GRAs) in achieving a reduction in scup discarding. The regulations are based on three expectations. (1) Reduction in discarding in the Loligo squid fishery will materially reduce total scup discarding. (2) Exclusion of Loligo squid fishing vessels from the GRAs will result in these vessels fishing in areas that inherently produce fewer scup discards without equivalently increasing discarding in other sensitive species. (3) The use of a square-mesh large-mesh section in the extension will reduce scup discarding to the extent that otherwise would be achieved if the boats fished outside the GRAs without the economic cost imposed by redeploying the fleet. Analysis of the NMFS-NEFSC observer database offers no support for the belief that Expectation 1 has been met. Squid catches were too low to sustain a directed fishery in the northern GRA during this study. Thus, had this area been open, limited scup discarding would have occurred. In this study, squid catches averaged 1025 kg tow(-1) in the southern GRA. Thus, had the GRA been open, Loligo fishing would have taken place. Yet, in the 34 tows taken by two vessels, not a single scup was caught. Redeployment of the fleet clearly increased scup discarding in 2003. Thus, Expectation 2 was not met. Field tests demonstrated that the implemented net modification can produce reduced catches of mostly smaller-sized finfish without impairing squid catch, but the data also indicate that this result may not be routinely achieved. Thus, Expectation 3 was not completely met. Implementation of the 2003 net regulation was likely premature, in that the specification was not adequate to guarantee the desired results. The history of the scup discarding issue in the Loligo squid fishery demonstrates that discard reduction cannot be accomplished without adequate prior evaluation of the sources of discards, without the requisite and concomitant experimental evaluation of the results of regulatory reform, and without adequate commercial-scale testing of prospective reforms prior to implementation.     

Development and validation of a method for analysis of "dioxin-like" PCBs in environmental samples from the steel industry

A method, previously used for determination of 2,3,7,8-substituted polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzofurans (PCDFs), has been modified for quantitative analysis of "dioxin-like" polychlorobiphenyls (PCBs) in environmental samples from the steel industry. The existing sample clean-up procedure, involving liquid chromatography on multi-layered silica and Florisil columns, has been extended to include a third chromatography stage on a basic alumina stationary phase. The additional clean-up stage is required for PCB analysis in order to eliminate interferences from relatively large concentrations of saturated cyclic and aliphatic hydrocarbons. Samples were analysed for WHO-12 congeners using high resolution gas chromatography/high resolution mass spectrometry (HRGC/HRMS) and standard solutions of the method US EPA 1668A. Replicate analysis of method blanks revealed background contamination for PCBs 118, 105 and 77, which are generally abundant in ambient air. These contaminants were taken into account using a subtraction method. The entire procedure was validated by replicate analysis (N = 3) of a certified reference sediment. The RSD for each WHO-12 congener was below 15%, 13C12-labelled PCB internal standard recoveries were in the range 70-95%. A waste dust sample collected in the electrostatic precipitator of a UK sinter plant was analysed for determination of PCDD/Fs and WHO-12 PCBs and exhibited a PCDD/F I-TEQ of 148.5 +/- 21.2 ngkg(-1) and a WHO-TEQ of 7.2 +/- 1.5 ngkg(-1). WHO-12 congeners contributed only 4.6% to the overall TEQ and PCB 126 was the major congener contributing to the WHO-TEQ (96%). The contribution to the overall TEQ of the waste dust sample was mainly attributed to PCDF followed by PCDD, which accounted for 86.6% and 8.7% to the overall TEQ, respectively.     

Post-explosion observations of experimental mine and laboratory coal dust explosions

The Pittsburgh Research Laboratory (PRL) of the National Institute for Occupational Safety and Health (NIOSH) and the Mine Safety and Health Administration (MSHA) conducted joint research on dust explosions by studying post-explosion dust samples. The samples were collected after full-scale explosions at the PRL Lake Lynn Experimental Mine (LLEM), and after laboratory explosions in the PRL 20-L chamber and the Fike 1 m³ chamber. The dusts studied included both high- and low-volatile bituminous coals. Low temperature ashing for 24 h at 515 °C was used to measure the incombustible content of the dust before and after the explosions. The data showed that the post-explosion incombustible content was always as high as, or higher than the initial incombustible content. The MSHA alcohol coking test was used to determine the amount of coked dust in the post-explosion samples. The results showed that almost all coal dust that was suspended within the explosion flame produced significant amounts of coke. Measurements of floor dust concentrations after LLEM explosions were compared with the initial dust loadings to determine the transport distance of dust during an explosion. All these data will be useful in future forensic investigations of accidental dust explosions in coal mines, or elsewhere.     

钠盐量影响下DD6单晶高温合金的高温热腐蚀规律研究

目的 开展镍基单晶高温合金DD6在950 ℃下的热盐腐蚀试验(95%Na2SO4+5%NaCl)，探明涂盐量和涂盐方式(周期涂盐和单次涂盐)对DD6高温热腐蚀的影响规律和机理。方法 结合扫描电子显微镜、X射线能量色散谱、X射线衍射等设备，对不同涂盐量及涂盐方式下DD6的表面及横截面形貌进行观察分析，分析不同涂盐量和涂盐方式下DD6的高温热腐蚀机理。结果 DD6在950 ℃下主要发生碱性熔融热腐蚀，同时伴随氧化、硫化和氯化等过程。高温热腐蚀使得DD6合金表面生成的保护性氧化膜被熔融态的腐蚀介质破坏，导致O、S、Cl等外部元素通过氧化膜的缺陷进入DD6基体中，在合金的亚表面发生内氧化、内硫化以及内氯化反应，横截面上出现明显的腐蚀层，其主要由氧化物以及硫化物组成。随着热腐蚀的进行，DD6表面物质发生了剥蚀，沉积盐量的增加导致剥蚀现象越加严重，合金内部致密的组织结构也被破坏，横截面上出现了大量孔洞、裂纹等缺陷。在相同涂盐量下，周期涂盐法使得DD6的腐蚀程度高于单次涂盐法。结论 DD6高温热腐蚀行为与涂盐量及涂盐方式密切相关，相同涂盐方式下，涂盐量越大，DD6热腐蚀更加严重。涂盐量一定时，周期涂盐法使得DD6的热腐蚀剧烈程度大于单次涂盐法，且DD6在上述热腐蚀条件下均发生剥蚀破坏。     

Etiology and management of early pregnancy renal anhydramnios: Is there a place for serial amnioinfusions?

Early pregnancy renal anhydramios (EPRA) comprises congenital renal disease that results in fetal anhydramnios by 22 weeks of gestation. It occurs in over 1 in 2000 pregnancies and affects 1500 families in the US annually. EPRA was historically considered universally fatal due to associated pulmonary hypoplasia and neonatal respiratory failure. There are several etiologies of fetal renal failure that result in EPRA including bilateral renal agenesis, cystic kidney disease, and lower urinary tract obstruction. Appropriate sonographic evaluation is required to arrive at the appropriate urogenital diagnosis and to identify additional anomalies that allude to a specific genetic diagnosis. Genetic evaluation variably includes karyotype, microarray, targeted gene testing, panels, or whole exome sequencing depending on presentation. Patients receiving a fetal diagnosis of EPRA should be offered management options of pregnancy termination or perinatal palliative care, with the option of serial amnioinfusion therapy offered on a research basis. Preliminary data from case reports demonstrate an association between serial amnioinfusion therapy and short-term postnatal survival of EPRA, with excellent respiratory function in the neonatal period. A multicenter trial, the renal anhydramnios fetal therapy (RAFT) trial, is underway. We sought to review the initial diagnosis ultrasound findings, genetic etiologies, and current management options for EPRA.     

Innovations in the water chain – experiences in The Netherlands

Innovations in water chain are discussed based on experiences in the Netherlands. The available and new technological options, as well as their dissemination in the Netherlands, are presented for the prevailing system with add-on technologies (elongation), and for the emerging separation system with technologies at the source. Numerous new options are available for both systems but these options are rarely used. The low use is explained using economic theories and with practical examples from the Netherlands. In order to foster innovations, the mainstream, evolutionary, and behavioral theories pinpoint respectively the pricing of common goods, broad support of concerted action, and support for innovators’ entry. These actions may all be needed. Experiences with a stakeholder cluster in water management suggest that markets for high value water use invoke innovations and low-cost technology adaptations. The systematic development of services that foster high value water-based activities is recommended.     

Fetoscopic tracheal occlusion for treatment of non-isolated congenital diaphragmatic hernia

Fetoscopic endotracheal occlusion (FETO) is a prenatal treatment that may increase survival in severe congenital diaphragmatic hernia (CDH). In the USA, FETO is offered for isolated severe left-sided CDH in the context of an FDA-approved feasibility study. FETO in non-isolated cases of severe CDH is only performed with a compassionate use exemption from US regulatory bodies. Anomalies frequently associated with CDH include congenital cystic lesions of the lung and cardiac defects. We describe two cases of non-isolated severe left-sided CDH that underwent prenatal FETO, survived after birth and underwent postnatal surgical repair. The potential benefit of FETO in this setting is discussed. © 2017 John Wiley & Sons, Ltd.