Catalytic oxidation of CO over Pt/Fe3O4 catalysts: Tuning O2 activation and CO adsorption

• Strong metal-support interaction exists on Pt/Fe₃O₄ catalysts. • Pt metal particles facilitate the formation of oxygen vacancies on Fe₃O₄. • Fe₃O₄ supports enhance the strength of CO adsorption on Pt metal particles. The self-inhibition behavior due to CO poisoning on Pt metal particles strongly impairs the performance of CO oxidation. It is an effective method to use reducible metal oxides for supporting Pt metal particles to avoid self-inhibition and to improve catalytic performance. In this work, we used in situ reductions of chloroplatinic acid on commercial Fe₃O₄ powder to prepare heterogeneous-structured Pt/Fe₃O₄ catalysts in the solution of ethylene glycol. The heterogeneous Pt/Fe₃O₄ catalysts achieved a better catalytic performance of CO oxidation compared with the Fe₃O₄ powder. The temperatures of 50% and 90% CO conversion were achieved above 260°C and 290°C at Pt/Fe₃O₄, respectively. However, they are accomplished on Fe₃O₄ at temperatures higher than 310°C. XRD, XPS, and H₂-TPR results confirmed that the metallic Pt atoms have a strong synergistic interaction with the Fe₃O₄ supports. TGA results and transient DRIFTS results proved that the Pt metal particles facilitate the release of lattice oxygen and the formation of oxygen vacancies on Fe₃O₄. The combined results of O₂-TPD and DRIFTS indicated that the activation step of oxygen molecules at surface oxygen vacancies could potentially be the rate-determining step of the catalytic CO oxidation at Pt/Fe₃O₄ catalysts. The reaction pathway involves a Pt-assisted Mars-van Krevelen (MvK) mechanism.     

Utilization of MSWI fly ash as partial cement or sand substitute with focus on cementing efficiency and health risk assessment

• Washed MSWI fly ash was used as partial cement or sand substitute. • Sand replacing is beneficial for strength, while cement replacement reduces strength. • Cementing efficiency factor and mortar pore structure explain the strength results. • Health risk assessment was conducted for MSWI fly ash blended cement mortar. • CR and HI contributed by different exposures and heavy metals were analyzed. The strength of cement substituted mortar decreases with the increase in fly ash amount, whereas the strength increases when the fly ash is blended as sand substitute. A mortar with highest strength (compressive strength= 30.2 Mpa; flexural strength= 7.0 Mpa) was obtained when the sand replacement ratio was 0.75%. The k value (cementing efficiency) of fly ash varied between 0.36 and 0.15 for the fly ash fraction in binder between 5% and 25%. The k values of fly ash used for sand replacement were all significantly above that used for cement substitution. The macropores assigned to the gaps between particles decreased when the fly ash was used as sand replacement, providing an explanation for the strength enhancement. The waste-extraction procedure (toxicity-sulphuric acid and nitric acid method (HJ/T 299-2007)) was used to evaluate metal leaching, indicating the reuse possibility of fly ash blended mortar. For the mortar with the mass ratio of fly ash to binder of 0.5%, the carcinogenic risks (CR) and non-carcinogenic hazard quotient (HQ) in sensitive scenario for blended mortar utilization were 9.66 × 10^-7 and 0.06, respectively; these results were both lower than the threshold values, showing an acceptable health risk. The CR (9.89 × 10^-5) and HQ (3.89) of the non-sensitive scenario for fly ash treatment exceeded the acceptable threshold values, indicating health risks to onsite workers. The main contributor to the carcinogenic and non-carcinogenic risk is Cr and Cd, respectively. The CR and HQ from inhalation was the main route of heavy metal exposure.     

3种喹诺酮类抗生素在骆马湖饮用水源地沉积物上的吸附特征

为探究喹诺酮类抗生素(QNs)在饮用水源地的吸附特征,2019年6月于江苏骆马湖饮用水源地采集沉积物样品,用5种动力学方程拟合沉积物对诺氟沙星(NOR)、环丙沙星(CIP)和氧氟沙星(OFL)的吸附动力学过程,并用Langmuir和Freundlich模型拟合以上3种QNs的吸附热力学过程,分析了pH、水土比和不同Na~+、Ca~(2+)、Mg~(2+)、Al~(3+)浓度对吸附过程的影响。结果表明:骆马湖沉积物对3种QNs的吸附在8h达到平衡,准二级动力学方程和Langmuir模型能更好地描述3种QNs的吸附动力学和热力学过程。酸性条件下,3种QNs的吸附效果更好,且在pH=5时平衡吸附量最大。平衡吸附量随着水土比的上升而下降。Na~+对吸附的抑制作用不明显,Ca~(2+)和Mg~(2+)的抑制作用较强,而Al~(3+)对吸附表现为促进作用。应在枯水期和南水北调时期加强对骆马湖饮用水源地(尤其是东北部)QNs污染的关注。     

气田甲醇污水处理装置的运行优化

针对延长气田采气一厂甲醇污水处理站运行中换热器/精馏塔塔板结垢严重、甲醇回收率低、处理后水水质不达标等问题,采用水质分析、结垢分析与工艺原因分析等方法,分析原因并采取相应措施。结果表明:预处理效果差、精馏塔分离效果差是造成这些问题的主要原因;采用优化预处理药剂加量、优化加药工艺和优化甲醇回收工艺等措施,使甲醇污水处理装置持续稳定运行,提高了甲醇污水预处理效果,降低了换热器/精馏塔塔板结垢程度,提高了甲醇回收率。处理后水水质稳定,含油量、悬浮固体含量、悬浮物粒径中值均达标,可满足平均空气渗透率≤0.01μm~2地层的回注要求。     

考虑黏结性退化的锈蚀PC梁抗弯承载力计算方法∗

钢绞线锈蚀降低了其与混凝土间的黏结性,导致钢绞线与其周围混凝土间的变形不协调,影响预应力混凝土梁的抗弯性能。采用快速锈蚀试验得到了不同锈蚀程度的16个有箍筋和无箍筋拉拔试件,通过拉拔试验得到了试件开始滑移及破坏时的拉拔力;回归了黏结折减系数与锈蚀率之间的关系式,并将其融入到预应力混凝土梁的抗弯承载力分析模型中,提出了考虑黏结性退化的锈蚀预应力混凝土梁抗弯承载力计算方法。试验结果表明：有箍筋试件的黏结强度大于无箍筋试件;随着钢绞线锈蚀水平的增大,箍筋对黏结强度退化的约束作用逐渐减小;黏结折减系数随锈蚀率的增加呈指数函数规律递减。将理论值与本文及已有文献中锈蚀预应力混凝土梁抗弯性能试验结果进行了比较,计算结果表明本方法预测精度较高,最大误差在6%以内,验证了本抗弯承载力计算方法的适用性,可为服役预应力混凝土桥梁抗弯承载力评估提供参考。     

电厂屏式过热器弯头开裂原因失效分析

通过外观检查、硬度、金相等检测方法,从金属管壁超温运行、蒸汽侧氧化行为、析出相及冷弯变形对组织性能影响等方面分析了某电厂1 000 MW超超临界机组屏式过热器弯头开裂原因,得出TP347HFG弯头开裂的主要原因是弯头组织富含较多的σ相、NbC等硬脆析出相,同时冷弯加工导致管子内部产生残余应力,加剧了弯头脆性开裂的倾向。     

硫化锰纳米颗粒高效去除重金属镉

中国镉污染问题日益严峻,开发高效的镉吸附剂,是解决环境镉污染问题的重要技术手段。采用共沉淀方法合成了硫化锰纳米颗粒,研究了其对重金属镉的吸附行为,并采用X射线衍射(XRD)、扫描电镜(SEM)、高分辨透射电镜(HR-TEM)、比表面积(BET)等技术手段探究了硫化锰纳米颗粒的形貌、化学组分以及镉的去除机制。结果表明,MnS纳米颗粒呈球状,平均粒径100 nm,比表面积30.56 m~2·g~(-1)。MnS纳米颗粒对Cd~(2+)的吸附动力学数据较好地符合伪二级动力学模型;吸附等温线数据较好地符合Langmuir模型,说明MnS对Cd2+的吸附是以化学吸附为主的单分子层吸附。使用Langmuir拟合的MnS饱和最大镉吸附量为349.6 mg·g~(-1),在众多镉吸附材料中处于前列。对于模拟工厂重金属废水的处理,MnS纳米颗粒可以在5 h内使镉的浓度由60 mg·L~(-1)降至国家规定排放线以下(0.1 mg·L~(-1)),且吸附过程中水体pH稳定,对水体干扰小。在多种重金属离子共存的情况下,仍可以达到接近100%的Cd~(2+)去除率。硫化锰相对稳定,在空气中放置30 d仍有80%的镉去除率。较高的离子交换量形成CdS沉淀是MnS高效去除镉的主要原因。     

基于复式记账的土地资源资产核算与报表编制研究

借鉴会计学复式记账核算的优点,在国际资源核算体系的基础上,根据我国自然资源资产核算需求,提出土地资源资产核算的复式记账体系和报表编制框架。研究认为,基于复式记账的土地资源资产核算和报表编制要以“摸清家底、反映自然资源负债、提供土地资源审计和绩效考核信息”为目标,明确区、县级自然资源局为土地资源资产受托管理和进行土地资源资产核算与报表编制的核算单位。在界定土地资源资产、负债和权益相关概念的基础上,提出土地资源资产属性变化的核算内容和每次土地资源资产实物量变化必须遵循占补平衡的基本原则,进行过程核算。以YC县土地资源资产变化为例,对土地资源资产变化进行了基于复式记账的土地资源资产核算与报表编制实证研究,确定核算的事项类型和特征及其借贷核算流程,编制出土地资源资产负债表,并同时进行实物量核算和价值量核算的报表编制,结果表明:YC县土地资源资产实物量1485 km^2,2018年末价值量5639874.22万元、经济权益5271874.22万元、生态权益367991.6万元,土地资源负债8.40万元,通过土地资源资产用途调整,土地资源资产价值量增加21319.42万元,但在调整过程中,形成了土地资源负债0.07 km^2(8.4万元),在以后土地整治中需要增加园地。     

两种电压模式下GIS内部异物动态特性研究

异物是引发GIS设备内部击穿故障最主要的原因之一,运行电压下GIS设备内部异物受电场力作用发生随机运动,现场检测难以确定内部异物的特征。本文针对GIS设备内部异物开展力学特性分析,建立126 kV GIS等效模型,并仿真比对交流电压及脉冲电压作用下GIS内部异物的动态轨迹。研究结果表明交流电压下GIS设备内部异物颗粒的跳动轨迹呈现无规律特征,施加特定脉冲电压条件作用时,GIS内部异物跳动规律可控,其跳动高度及时间间隔基本一致。