Automotive Exhaust Emission Levels by Geographic Area and Vehicle Make A Nationwide Survey

Gross average automotive exhaust emissions data collected by the Atlantic Richfield Clean Air Caravan during the summer of 1970 showed only slight geographical variations when the specific makes were ignored. When considering specific makes, significant differences were found on an average emissions basis. Vehicle population—emission distributions showed wide variations in the 50% population levels and in the percent of vehicles with emissions greater than specified values. Hydrocarbon (HC) and carbon monoxide (CO) data are given on a gross basis for the 1970, 1968-69, 1966-67, and pre-1966 model year group vehicles. Average HC and CO emissions and vehicle population-Idle emissions distribution curves are included for specific make vehicles in selected areas.     

Product Guide/1975

Measurements conducted on full-scale hazardous waste incinerators have occasionally shown a relationship between carbon monoxide (CO) emissions and emissions of toxic organic compounds. In this study, four mixtures of chlorinated C₁ and C₂ hydrocarbons were diluted in commercial-grade heptane and burned in a water-cooled turbulent flame reactor (TFR) under two different excess air levels. No correlation between CO and organic emissions could be discerned. Reasons for this lack of observable correlations are discussed in terms of combustion and chemical reaction kinetic theory.     

Methylcyclopentadienyl Manganese Tricarbonyl as an Antiknock: Composition and Fate of Manganese Exhaust Products

Methylcyclopentadienyl manganese tricarbonyl (MMT) has been marketed as a combustion improver for fuel oil and turbine fuel. Use concentrations for this purpose are about 0.025 g manganese/gal in fuel oil and 0.08 to 0.5 g/gal in turbine fuels. In addition, it has been used to a small extent in gasoline.     

Fine Paniculate Removal and S02 Absorption with a Two Stage Wet Scrubber

This paper includes results from pilot plant studies and early field demonstration units and a discussion of the application of the limestone wet scrubbing process to a low sulfur syb-butuminous coal. This latter application required the development of a hybrid two stage scrubber to enable collection of the fine particulate matter as well as removal of a significant amount of the sulfur dioxide.     

Cooling Towers and the Environment

Measurements of natural draft cooling tower plume behavior, as well as meteorological variables, were obtained from aircraft flights near major power plants of the American Electric Power System. Persistence of the visible plume to great distances depends essentially on ambient humidity. Atmospheric stability at plume elevation was also important. Cooling tower-induced fog at ground-level was never observed in any of the tests, and aerodynamic downwash of the visible plume was absent also. The cooling towers did cause modification of natural clouds and they occasionally shadowed some local areas from the sun. Merging of the stack and cooling tower plumes was a common occurrence.     

The Analysis of Airborne Sulfate

This report reviews the current state of analytical methodology for sulfate in airborne particles. Methods for determination of total aerosol sulfate and total soluble sulfate are assessed. A more detailed review of the relatively new techniques for quantitative speciation of airborne sulfate then follows. Size distribution methodology and filter sampling difficulties relating to the collection of airborne sulfate-containing particles are enumerated. Experiments are suggested which use new, improved, and potentially applicable sulfate speciation techniques to obtain a better understanding of the generation, transport, transformation and removal processes that, in turn, determine the identity and concentrations of sulfate species in ambient air.     

Biological Effects of Carbon Monoxide vs. Whole Emissions from Engine with Catalyst

The introduction of oxidizing catalytic converters in the exhaust system of automobiles has been found to be effective in reducing carbon monoxide, total hydrocarbons, and some other components of tailpipe emissions. The utilization of these converters, however, has also caused further oxidation of sulfur compounds producing an increased amount of sulfur trioxide (SO₃) which yields sulfuric acid and sulfates.¹ Studies on the biological effects of these sulfur compounds are in progress in our laboratory and preliminary findings are reported separately. This paper compares the biological effects of exposure to whole emissions from engines with and without converter and exposure to carbon monoxide alone.     

Weekday-Weekend Pollutant Studies of the Los Angeles Basin

Pollutant data from the Los Angeles Basin were analyzed for weekday-weekend differences for the smog months of June through September 1972 and 1973. The pollutants investigated were oxidant, NO, NO₂, total hydrocarbons (HC), CO, and particulates. In order to maintain the diurnal variation, the concentration percentiles were calculated for each weekday and weekend hour.     

Turbulent Plume in a Turbulent Cross Flow: Comparison of Wind Tunnel Tests with Field Observations

Plume rise downwind of a large stationary gas turbine was measured in the field and the conditions were then scaled in the laboratory. For the laboratory, the plume exit conditions, wind velocity and temperature profiles, and wind direction were matched. It was found that for high temperature exhaust, the buoyancy is best matched by calculating a dimensionless density difference. With properly calculated buoyancy length scales, the plume trajectories were compared and were found to agree quite well. The probability distributions of the entrainment constant and the average values of the entrapment constant with downwind distance were compared. The field data showed about 15% greater plume rise. The median entrainment constant was about 10% greater for the lab test and the shape of the probability distribution matched very closely.     

Studies on the Effects of Saline Aerosols of Cooling Tower Origin on Plants

A research program was undertaken to develop information that could be used to estimate the risk of adverse effects of saline cooling tower drift on native and cultivated flora in the Indian Point, New York area. Eleven species of woody plants were exposed at 85 % relative humidity to a saline mist with 95% of the particles between 50 and 150 nm in diameter. Three biological factors—stage of development, species, and phenotype—determined the susceptibility of plants to saline aerosols when the occurrence of any lesion on the foliage was used as a measure of response. The effects of stage of development on the incidence and severity of foliar lesions depended upon the kind of plant. In deciduous woody species, the youngest leaves were most susceptible, but in conifers, the year-old needles were most susceptible. Canadian hemlock was the most susceptible species and witch hazel was the least susceptible. Median effective doses for these two species, although undetermined, could be more than 100-fold different (less than 2.4, the lowest used, and greater than 264 ng CI cm^-2, respectively). Other species, ranked in decreasing order of susceptibility were: white ash, white flowering dogwood, forsythia, chestnut oak, silk tree, black locust, red maple, eastern white pine, and golden rain free. Phenofypic variation within a species was not so great—within a 10 to 20-fold increase in dose the incidence of injury went from 0 to 100%. Exposures with bush bean showed that the relative humidity (RH) during or after the exposure period affected the incidence of saline induced foliar injury. A change from 50 to 85% RH doubled the effectiveness of the saline mist. It was also found that compared to particles between 50 and 150 jum in diameter, an increase in the fraction of particles above 150 /xm increased the toxicity of the mist.